Qualidade de vida em adolescentes com escoliose idiopática no tratamento com colete

Projeto de Graduação apresentado à Universidade Fernando Pessoa como parte dos requisitos para obtenção do grau de Licenciada em Fisioterapia

Using narrow beam profiles to quantify focal spot size, for accurate Monte Carlo simulations of SRS/SRT systems

This study investigates the variation of photon field penumbra shape with initial electron beam diameter, for very narrow beams. A Varian Millenium MLC (Varian Medical Systems, Palo Alto, USA) and a Brainlab m3 microMLC (Brainlab AB. Feldkirchen, Germany) were used, with one Varian iX linear accelerator, to produce fields that were (nominally) 0.20 cm across. Dose profiles for these fields were measured using radiochromic film and compared with the results of simulations completed using BEAMnrc and DOSXYZnrc, where the initial electron beam was set to FWHM = 0.02, 0.10, 0.12, 0.15, 0.20 and 0.50 cm. Increasing the electron-beam FWHM produced increasing occlusion of the photon source by the closely spaced collimator leaves and resulted in blurring of the simulated profile widths from 0.26 to 0.64 cm, for the MLC, from 0.12 to 0.43 cm, for the microMLC. Comparison with measurement data suggested that the electron spot size in the clinical linear accelerator was between FWHM = 0.10 and 0.15 cm, encompassing the result of our previous output-factor based work, which identified a FWHM of 0.12. Investigation of narrow-beam penumbra variation has been found to be a useful procedure, with results varying noticeably with linear accelerator spot size and allowing FWHM estimates obtained using other methods to be verified.

The importance of accurate beam data measurement for SRT/SRS treatment planning

Introduction This study investigated the sensitivity of calculated stereotactic radiotherapy and radiosurgery doses to the accuracy of the beam data used by the treatment planning system. Methods Two sets of field output factors were acquired using fields smaller than approximately 1 cm2, for inclusion in beam data used by the iPlan treatment planning system (Brainlab, Feldkirchen, Germany). One set of output factors were measured using an Exradin A16 ion chamber (Standard Imaging, Middleton, USA). Although this chamber has a relatively small collecting volume (0.007 cm3), measurements made in small fields using this chamber are subject to the effects of volume averaging, electronic disequilibrium and chamber perturbations. The second, more accurate, set of measurements were obtained by applying perturbation correction factors, calculated using Monte Carlo simulations according to a method recommended by Cranmer-Sargison et al. [1] to measurements made using a 60017 unshielded electron diode (PTW, Freiburg, Germany). A series of 12 sample patient treatments were used to investigate the effects of beam data accuracy on resulting planned dose. These treatments, which involved 135 fields, were planned for delivery via static conformal arcs and 3DCRT techniques, to targets ranging from prostates (up to 8 cm across) to meningiomas (usually more than 2 cm across) to arterioveinous malformations, acoustic neuromas and brain metastases (often less than 2 cm across). Isocentre doses were calculated for all of these fields using iPlan, and the results of using the two different sets of beam data were evaluated. Results While the isocentre doses for many fields are identical (difference = 0.0 %), there is a general trend for the doses calculated using the data obtained from corrected diode measurements to exceed the doses calculated using the less-accurate Exradin ion chamber measurements (difference\0.0 %). There are several alarming outliers (circled in the Fig. 1) where doses differ by more than 3 %, in beams from sample treatments planned for volumes up to 2 cm across. Discussion and conclusions These results demonstrate that treatment planning dose calculations for SRT/SRS treatments can be substantially affected when beam data for fields smaller than approximately 1 cm2 are measured inaccurately, even when treatment volumes are up to 2 cm across.

Atomic Layer Deposition of Electroluminescent ZnS, SrS, and BaS Thin Films

The light emitted by flat panel displays (FPD) can be generated in many different ways, such as for example alternating current thin film electroluminescence (ACTFEL), liquid crystal display (LCD), light emitting diode (LED), or plasma display panel (PDP) technologies. In this work, the focus was on ACTFEL devices and the goal was to develop new thin film processes for light emitting materials in ACTFEL devices. The films were deposited with the atomic layer deposition (ALD) method, which has been utilized in the manufacturing of ACTFEL displays since the mid-1980s. The ALD method is based on surface-controlled self-terminated reactions and a maximum of one layer of the desired material can be prepared during one deposition cycle. Therefore, the film thickness can be controlled simply by adjusting the number of deposition cycles. In addition, both large areas and deep trench structures can be covered uniformly. During this work, new ALD processes were developed for the following thin film materials: BaS, CuxS, MnS, PbS, SrS, SrSe, SrTe, SrS1-xSex, ZnS, and ZnS1-xSex. In addition, several ACTFEL devices were prepared where the light emitting material was BaS, SrS, SrS1-xSex, ZnS, or ZnS1-xSex thin film that was doped with Ce, Cu, Eu, Mn, or Pb. The sulfoselenide films were made by substituting the elemental selenium for sulfur on the substrate surface during film deposition. In this way, it was possible to replace a maximum of 90% of the sulfur with selenium, and the XRD analyses indicated that the films were solid solutions. The polycrystalline BaS, SrS, and ZnS thin films were deposited at 180-400, 120-460, and 280-500 °C, respectively, and the processes had a wide temperature range where the growth rate of the films was independent of the deposition temperature. The electroluminescence studies showed that the doped sulfoselenide films resulted in low emission intensity. However, the emission intensities and emission colors of the doped SrS, BaS, and ZnS films were comparable with those found in earlier studies. It was also shown that the electro-optical properties of the different ZnS:Mn devices were different as a consequence of different ZnS:Mn processes. Finally, it was concluded that because the higher deposition temperature seemed to result in a higher emission intensity, the thermal stability of the reactants has a significant role when the light emitting materials of ACTFEL devices are deposited with the ALD method.

Self-recruiting species (SRS) from farmer managed aquatic systems: are they important to the livelihoods of rural communities?

Why are SRS important? The answer is to be found in this well-structured survey under: SRS as food source; SRS as additional source of cash income; Role of SRS in social capital. An analysis of the threats to SRS and the potential management options for farmer managed aquatic systems are also available in this survey along with the following definition of SRS: SRS are defined as aquatic animals that can be harvested from farmer managed aquatic systems without regular stocking. (PDF contains 4 pages)

Memoria historica da Estrada de Ferro Central do Brazil / organizada por Manuel Fernandes Figueira ; e publicada por ordem da Directoria e autorisação do Ministério da Industria, Viação e Obras Publicas por occasião de celebrar-se aos 29 de março de 1908 o 50º anniversavio da inauguração do trafego do primeiro trecho, sob as vistas dos Srs. Drs. João José de S. Paulo ..., Carlos Euler, ..., e José Ascanio Burlamaqui, ..., sendo o director da estrada Dr. Aarão Reis

Referência: Fundação Biblioteca Nacional.

Fallas do throno, desde o anno de 1823 ate o anno de 1872, acompanhadas dos respectivos votos de graças da Camara Temporaria e de differentes informações e esclarecimentos / colligidas na Secretaria da Camara dos Srs. Deputados

Contém uma relação de todos os deputados brasileiros desde as cortes portuguesas e a constituinte até a 14ª legislatura ordinária.

Relatorios e Synopses dos trabalhos parlamentares da Câmara dos Srs. Deputados : organizados na Secretaria da mesma Camara : 1869 - 1874

Sinopse dos trabalhos da Câmara dos Deputados, de 1869 a 1874.

Relatorio e synopse dos trabalhos da Camara dos Srs. Deputados : na 1ª e 2ª sessão do anno de 1879

Sinopse dos trabalhos da Câmara dos Deputados, em 1879.

Relatorio e synopse dos trabalhos da Câmara dos Srs. Deputados : na sessão do anno de 1874 : acompanhada de differentes documentos e mapas estatísticos, organizados na Secretaria da mesma Camara

Sinopse dos trabalhos da Câmara dos Deputados, em 1874.

Relatorio e synopse dos trabalhos da Camara dos Srs. Deputados : na 1ª e 2ª sessão do anno de 1877 : acompanhada de differentes documentos, e mappas estatisticos, organisados na Secretaria da mesma Camara

Sinopse dos trabalhos da Câmara dos Deputados, em 1877.