1000 resultados para Pre-compounding
Resumo:
Fibre-reinforced mouldings are of growing interest to the rotational moulding industry due to their outstanding price performance ratio. However, a particular problem that arises when using reinforcements in this process is that the process is low shear and good mixing of resin and reinforcement is not optimum under those conditions. There is also a problem of the larger/heavier reinforcing agents segregating out of the powder to lay up on the inner part surface. In this paper we report on studies to incorporate, short glass fibres into rotationally moulded parts. Four different approaches were investigated; direct addition of fibre in between two powder shots, addition of a layer of pre-compounded polyethylene-glass fibre pellets between two powder shots, addition of a layer of pre-compounded polyethylene-glass fibre powder between two powder shots and a single layer of glass-reinforced, pre-compounded powder. Results indicate that pre-compounding is necessary to gain performance enhancement and the single layer part made from glass-reinforced, pre-compounded powder exhibited the highest tensile and flexural modulus.
Resumo:
In this study, a bench scale forward osmosis (FO) process was operated using two commonly available FO membranes in different orientations in order to examine the removal of foulants in the coal seam gas (CSG) associated water, the water flux and fouling behaviours of the process were also investigated. After 48 h of fouling simulation experiment, the water flux declined by approximately 55 and 35% of its initial level in the TFC-PRO and CTA-PRO modes (support layer facing the feed), respectively, while the flux decline in the TFC-FO and CTA-FO modes (active layer facing the feed) was insignificant. The flux decline in PRO modes was caused by the compounding effects of internal concentration polarisation and membrane fouling. However, the declined flux was completely recovered to its initial level following the hydraulic cleaning using deionised water. Dissolved organic carbon (DOC), adenosine tri-phosphate (ATP) and major inorganic scalants (Ca, Mg and silica) in the CSG feed were effectively removed by using the FO process. The results of this study suggest that the FO process shows promising potential to be employed as an effective pre-treatment for membrane purification of CSG associated water.
Resumo:
Purpose – Virtual prototyping technologies linked to building information models are commonplace within the aeronautical and automotive industries. Their use within the construction industry is now emerging. The purpose of this paper is to show how these technologies have been adopted on the pre-tender planning for a typical construction project. Design/methodology/approach – The research methodology taken was an “action research” approach where the researchers and developers were actively involved in the production of the virtual prototypes on behalf of the contractor thereby gaining consistent access to the decisions of the planning staff. The experiences from the case study were considered together with similar research on other construction projects. Findings – The findings from the case studies identify the role of virtual prototyping in components modelling, site modelling, construction equipment modelling, temporary works modelling, construction method visualization and method verification processes. Originality/value – The paper presents a state-of-the-art review and discusses the implications for the tendering process as these technologies are adopted. The adoption of the technologies will lead to new protocols and changes in the procurement of buildings and infrastructure.
Resumo:
This research thesis focuses on the experiences of pre-service drama teachers and considers how process drama may assist them to reflect on key aspects of professional ethics such as mandatory codes or standards, principled moral reasoning, moral character, moral agency, and moral literacy. Research from higher education provides evidence that current pedagogical approaches used to prepare pre –professionals for practice in medicine, engineering, accountancy, business, psychology, counselling, nursing and education, rarely address the more holistic or affective dimensions of professional ethics such as moral character. Process drama, a form of educational drama, is a complex improvisational group experience that invites participants to create and assume roles, and select and manage symbols in order to create a fictional world exploring human experience. Many practitioners claim that process drama offers an aesthetic space to develop a deeper understanding of self and situations, expanding the participant’s consciousness and ways of knowing. However, little research has been conducted into the potential efficacy of process drama in professional ethics education for pre-professionals. This study utilizes practitioner research and case study to explore how process drama may contribute to the development of professional ethics education and pedagogy.
Resumo:
Various reasons have been proffered for female under-representation in tertiary information technology (IT) courses and the IT industry with most relating to cultural moirés. The 2006 Geek Goddess calendar was designed to alter IT’s “geeky image” and the term is used here to represent young women enrolled in pre-service IT teaching courses. Their special mix of IT and teaching draws on conflicting stereotypes and represents a micro-climate which is typically lost in studies of IT occupations because of the aggregation of all IT roles. This paper will report on a small-scale investigation of female students (N=25) at a university in Queensland (Australia) studying to become teachers of secondary IT subjects. They are entering the IT industry, gendered as a “male” occupation, through the safe space of teaching a discipline allied to feminine qualities of nurturing. They are “geek goddesses” who – perhaps to balance the masculine and feminine of these occupations - have decided to go to school rather than into corporations or government.
Resumo:
Fair Work Australia is to provide the institutional framework for the Australian industrial relations system from January 2010. Its creation provides the opportunity to improve minimum labour standards’ enforcement in Australia. However, the experience of the past must be appreciated and traditional assumptions about the operation of the Australian enforcement system discarded if the new institution is to be effective in its role. This paper focuses on the role of unions in enforcement as well as institutional location issues to expose a number of central enforcement problems that those seeking to establish new systems and processes should consider. A number of recommendations in respect of the structure of Fair Work Australia and the continuing role of unions are suggested.
Resumo:
Objective-To establish the demographic, health status and insurance determinants of pre-hospital ambulance non-usage for patients with emergency medical needs. Methods-Triage category, date of birth, sex, marital status, country of origin, method and time of arrival, ambulance insurance status, diagnosis, and disposal were collected for all patients who presented over a four month period (n=10 229) to the emergency department of a major provincial hospital. Data for patients with urgent (n=678) or critical care needs (n=332) who did not use pre-hospital care were analysed using Poisson regression. Results-Only a small percentage (6.6%) of the total sample were triaged as having urgent medical needs or critical care needs (3.2%). Predictors of usage for those with urgent care needs included age greater than 65 years (prevalence ratio (PR)=0.54; 95% confidence interval (CI)= 0.35 to 0.83), being admitted to intensive care or transferred to another hospital (PR=0.62; 95% CI=0.44 to 0.89) or ward (PR=0.72; 95% CI=0.56 to 0.93) and ambulance insurance status (PR=0.67; 95% CI=052 to 0.86). Sex, marital status, time of day and country of origin were not predictive of usage and non-usage. Predictors of usage for those with critical care needs included age 65 years or greater (PR=0.45; 95% CI=0.25 to 0.81) and a diagnosis of trauma (PR=0.49; 95% CI=0.26 to 0.92). A non-English speaking background was predictive of non-usage (PR=1.98; 95% CI=1.06 to 3.70). Sex, marital status, time of day, triage and ambulance insurance status were not predictive of non-usage. Conclusions-Socioeconomic and medical factors variously influence ambulance usage depending on the severity or urgency of the medical condition. Ambulance insurance status was less of an influence as severity of condition increased suggesting that, at a critical level of urgency, patients without insurance are willing to pay for a pre-hospital ambulance service.
Resumo:
The outcomes of a two-pronged 'real-world' learning project, which aimed to expand the views of pre-service teachers about learning, pedagogy and diversity, will be discussed in this paper. Seventy-two fourth-year and 22 first-year students, enrolled in a Bachelor of Education degree in Queensland, Australia, were engaged in community sites outside of university lectures, and separate from their practicum. Using Butin's conceptual framework for service learning, we show evidence that this approach can enable pre-service teachers to see new realities about the dilemmas and ambiguities of performing as learners and as teachers. We contend that when such 'real-world' experiences have different foci at different times in their four-year degree, pre-service teachers have more opportunities to develop sophisticated understandings of pedagogy in diverse contexts for diverse learners.
Resumo:
Although the internationalisation process of the firm has been well researched since the 1970s, the behaviour of firms prior to internationalisation has not received commensurate research attention.This paper argues that a focus on firms’ pre-internationalisation activities will not only offer an additional important perspective to the study of firm internationalisation but it will also address a significant research gap in studies that are theoretically based on the so-called stages models. During the pre-internationalisation phase, a firm is exposed to stimuli factors that may trigger an impulse for foreign market expansion. Decision makers’ perceptions of stimuli, their attitudinal commitment towards internationalisation, the firms’ resources and capabilities, as well as the mediating effect of lateral rigidity comprise a learning process that leads a firm towards readiness to initiate an internationalisation decision. This paper advances the concept of internationalisation readiness and proposes a method for developing an Internationalisation Readiness Index.