Efficient Voltage/Current Spike Reduction by Active Gate Signaling

This paper presents an Active Gate Signaling scheme to reduce voltage/current spikes across insulated gate power switches in hard switching power electronic circuits. Voltage and/or current spikes may cause EMI noise. In addition, they increase voltage/current stress on the switch. Traditionally, a higher gate resistance is chosen to reduce voltage/current spikes. Since the switching loss will increase remarkably, an active gate voltage control scheme is developed to improve efficiency of hard switching circuits while the undesirable voltage and/or current spikes are minimized.

Analytical Expression for RMS DC Link Capacitor Current in a Three-Level Inverter

An analytical expression is derived for calculating the rms current through the DC link capacitor in a three level inverter. The output current of the inverter is assumed to sinusoidal. Variations in the capacitor rms current with modulation index as well as line side power factor are studied. The worst case current stress on the capacitor is determined. This is required for sizing the capacitor and is useful for predicting the capacitor losses and life. The analytical expression derived is validated through simulations and experimental results at a number of operating points.

Electric measurements with constant current: A practical method for characterizing dielectric films

This article assesses the use of the constant current (CC) method for characterizing dielectric films. The method is based on charging the sample with a constant current (current stress) and measuring the corresponding voltage rise under the closed circuit condition. Our article shows that the CC method is an alternative to the constant voltage stressing method to study the electric properties of nonpolar, ferroelectric, and polar polymers. The method was tested by determining the dielectric constant of polytetrafluoroethylene, and investigating the electric conduction in poly(ethylene terephthalate). For the ferroelectric polymer poly(vinylidene fluoride), it is shown that hysteresis loops and the dependence of the ferroelectric polarization on the electric field can be obtained. (C) 2001 American Institute of Physics.

Mapping and characterisation of the inter-reefal benthic assemblages of the Torres Strait

A comprehensive survey of the benthic assemblages of the Torres Strait was conducted in order to provide critical baseline information for regional marine planning, assessing the environmental sustainability of fisheries and understanding the ecosystems of the region. Over 150 sites throughout the region were sampled with a modified prawn trawl, towed underwater video, pipe dredge and epibenthic sled. This manuscript provides a broad overview of the activities undertaken and data collected. Two thousand three hundred and seventy-two different nominal species were sampled by the trawl and sled, only 728 by both gears. The towed video was not able to provide the same level of taxonomic resolution of epibenthic taxa, but was particularly useful in areas where the seabed was too rough to be sampled. Data from the trawl, sled and video were combined to characterise the epibenthic assemblages of the region. Data from the towed video was also used to provide a characterisation of the inter-reefal benthic habitats, which was then analysed in combination with physical covariate data to examine relationships between the two. Levels of mud and gravel in the sediments, trawling effort and seabed current stress were the covariates most significantly correlated with the nature of the seabed habitats.

'Wet N2O oxidation' process and interface state density characterization of nanoscale nitrided SiO2 for flash memory application

In this paper we first present the 'wet N2O' furnace oxidation process to grow nitrided tunnel oxides in the thickness range 6 to 8 nm on silicon at a temperature of 800 degrees C. Electrical characteristics of MOS capacitors and MOSFETs fabricated using this oxide as gate oxide have been evaluated and the superior features of this oxide are ascertained The frequency response of the interface states, before and after subjecting the MOSFET gate oxide to constant current stress, is studied using a simple analytical model developed in this work.

Thermo-plastic instability in simple shear

A theoretical description of thermo-plastic instability in simple shear is presented in a system of equations describing plastic deformation, the first law of thermodynamics and Fourier's heat transfer rule. Both mechanical and thermodynamical parameters influence instability and it is shown that two different modes of instability may exist. One of them is dominated by thermal softening and has a characteristic time and length, connected to each other by thermal diffusion.A criterion combining thermal softening, current stress, density, specific heat, work-hardening, thermal conductivity and current strain rate is obtained and practical implications are discussed.

Automatic Insertion of Cohesive Elements for Delamination

Composite damage modelling with cohesive elements has initially been limited to the analysis of interface damage or delamination. However, their use is also being extended to the analysis of inplane tensile failure arising from matrix or fibre fracture. These interface elements are typically placed at locations where failure is likely to occur, which infers a certain a priori knowledge of the crack propagation path(s). In the case of a crack jump for example, the location of the jump is usually not obvious, and the simulation would require the placement of cohesive elements at all element faces. A better option, presented here, is to determine the potential location of cohesive elements and insert them during the analysis. The aim of this work is to enable the determination of the crack path, as part of the solution process. A subroutine has been developed and implemented in the commercial finite element package ABAQUS/Standard[1] in order to automatically insert cohesive elements within a pristine model, on the basis of the analysis of the current stress field. Results for the prediction of delamination are presented in this paper.

Intraplate earthquake swarm in Belo Jardim, NE Brazil: reactivation of a major Neoproterozoic shear zone (Pernambuco Lineament)

Intraplate earthquakes in stable continental areas have been explained basically by reactivation of pre-existing zones of weakness, stress concentration, or both. Zones of weakness are usually identified as sites of the last major orogeny, provinces of recent alkaline intrusions, or stretched crust in ancient rifts. However, it is difficult to identify specific zones of weakness and intraplate fault zones are not always easily correlated with known geological features. Although Northeastern Brazil is one of the most seismically active areas in the country (magnitudes 5 roughly every 5 yr), with hypocentral depths shallower than similar to 10 km and seismic zones as long as 30-40 km, no clear relationship with the known surface geology can be usually established with confidence, and a clear identification of zones of weakness has not yet been possible. Here we present the first clear case of seismic activity occurring as reactivation of an old structure in Brazil: the Pernambuco Lineament, a major Neoproterozoic shear zone. The 2004 earthquake swarm of Belo Jardim (magnitudes up to 3.1) and the recurrent activities in the nearby towns of Sao Caetano and Caruaru (magnitudes up to 4.0 and 3.8), show that the Pernambuco Lineament is a weak zone. A local seismic network showed that the Belo Jardim swarm of 2004 November occurred by normal faulting on a North dipping, E-W oriented fault plane in close agreement with the E-W trending structures within the Pernambuco Lineament. The Belo Jardim activity was concentrated in a 1.5 km (E-W) by 2 km (downdip) fault area, and average depth of 4.5 km. The nearby Caruaru activity occurs as both strike-slip and normal faulting, also consistent with local structures of the Pernambuco Lineament. The focal mechanisms of Belo Jardim, Caruaru and S. Caetano, indicate E-W compressional and N-S extensional principal stresses. The NS extension of this stress field is larger than that predicted by numerical models such as those of Coblentz & Richardson and we propose that additional factors such as flexural stresses from the nearby Sergipe-Alagoas marginal basin could also affect the current stress field in the Pernambuco Lineament.

Caracterização comportamental endócrina das fases ontogenéticas de sagüi comum (Callithrix jacchus)

The use of animal models in biomedical research is ever increasing. Models that use primates might also have advantages in terms of low maintenance costs and availability of biological knowledge, thereby favoring their use in different experimental protocols. Many current stress studies use animal models at different developmental stages since biological response differs during ontogeny. The aims of this study were to perform a detailed characterization of the developmental stages of common marmosets (Callithrix jacchus), a very important animal model used in biomedical research. Ten subjects, 6 females and 4 males, were followed from birth to initial adult age (16 months). Behavioral and fecal collection for measurement of adrenal (cortisol) and sex (progesterone, estradiol and androgens) hormones took place twice a week during the first month of life and once a week for the remainder of the study. Behavior was observed for 30 minutes in the morning (0700-09:00h) and afternoon (12:00-14:00h). Behavioral profile showed changes during ontogeny, characterizing the 4 developmental stages and the respective phases proposed by Leão et al (2009).. Differentiation of developmental stages was considered using the onset, end, change and stabilization of the behavioral profile parental care (weaning and carrying), ingestion (solid food), affiliation (social grooming) and autogrooming, agonism (scent marking and piloerection) and play behavior and endocrine profile. Infant weaning and carrying terminated within the infantile stage and the peak of solid food ingestion was recorded in the infantile III phase. Receiving grooming was recorded earlier than grooming performed by the infant and autogrooming. The first episode of scent marking was recorded in the 4th week and it was the least variable behavior, in terms of its onset, which, in almost all animals, was between the 5th and 7th week of life. Solitary play and play with the twin started around the 7th week and play with other members of the group started 8 weeks later. Sex hormone secretion started to differ from basal levels between the 21st and 23rd week of life, in males and females, suggesting that puberty occurs simultaneously in both sexes. Basal cortisol, even at an early age, was higher in females than in males. However, cortisol was not correlated with the juvenile stage, as expected, since this stage corresponds to the transition between infancy and adult age and most behaviors are intensified by this time. The behavioral and endocrine profile of subadult animals did not differ from that of the adults. These results provide more detailed parameters for the developmental process of C. jacchus and open new perspectives for the use of experimental approaches focused on the intermediate ontogenetic phases of this species

Uma aplicacao da celula de comutacao ZVS-PWM-GEPAE ao conversor DC-AC

This work presents the design and procedure of a DC-to-AC converter using a ZVS Commutation Cell developed by Barbi and Martins (1991) and applied to the family of DC-to-DC PWM converters. Firstly, we show the cell applied to buck converter. The stages of operation and the main current and voltage equations of the resonant devices are presented. Next, we adapt the converter to the regenerative operation mode. Hence, the full bridge converter at low frequency operation is conected on the DC-to-DC stage (at high frequency) output ends (Seixas, 1993). Commutation of zero voltage for all switches, PWM at constant frequency and neither overvoltage nor additional current stress are observed by digital simulation. The design example and experimental results obtained by prototype rated at 275 V, 1 kW and 40 kHz are also presented.

The ZVS-PWM commutation cell applied to the DC-AC converter

This paper presents the analysis of a dc-ac converter using a zero-voltage-switching (ZVS) commutation cell. First, we show the cell applied to the buck converter. The stages of operation are presented along with the main current and voltage equations. Next, we adapt the converter to the regenerative-operation mode. Hence, the full-bridge converter at low-frequency operation is connected in the dc-dc output stage (at high frequency). The main switches commute at zero voltage. The converter operated at constant frequency with pulse-width modulation (PWM), and neither overvoltage nor additional current stress was observed by digital simulation. A design example and experimental results obtained by prototype, rated at 275 V and 1 kW, are also presented. © 1997 IEEE.

Experimental evaluation of the bridgeless interleaved boost PFC converter

This paper presents theoretical evaluation and experimental results to the proposed bridgeless interleaved boost PFC (power factor correction) converter. The application of bridgeless technique causes reduction of conduction losses, while the interleaving technique of the converter cells allows division of the current stress in semiconductor devices and reduction of weight and volume of the input EMI filter. In each cell of the converter, the inductor current operates in discontinuous conduction mode (DCM), which eliminates turn-on switching losses and the effects of reverse recovery in semiconductors, increasing the efficiency of the converter. The experimental results show the power factor of 0.96 for employed voltage ratio and an efficiency of 95.2 % for nominal load conditions. © 2012 IEEE.

Retificador boost entrelaçado com elevado fator de potência e sem ponte de diodos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

[Psychosomatic medicine and arterial hypertension - love it or leave it?]

Over the last two decades modern psychosomatic research has found multiple evidence for an impact of psychosocial factors on the control of arterial blood pressure as well as the development of arterial hypertension. This narrative review focuses first on the current stress concept and factors that influence the degree of blood pressure change following a psychosocial stressor. Second, relevant psychosocial factors associated with blood pressure are presented such as marital status, social support, socioeconomic status and work conditions. In addition, the influence of personality and cognition on blood pressure will be discussed. The second part focuses on the outcome of cognitive-behavioral therapies and relaxation techniques as a means to effectively control blood pressure. In conclusion, there is now good evidence showing that psychosocial factors and stressors may increase blood pressure. The working environment, the socioeconomic status as well as aspects of personality and cognitive factors like rumination may also impact blood pressure with to an extent that is clinically relevant. With respect to therapeutic options, cognitive-behavioral interventions, combined with relaxation techniques all fitting the needs of the individual patient best can offer a clinically meaningful contribution of an effective blood pressure control.

The Effect Of Social Support On Health As Moderated By Sex-Role Orientation

Previous research has established a significant association between social support and health; high levels of social support are consistently shown to both directly and indirectly improve health (Cohen, 1998, House et al. 1988, Rook, 2001, Schwarzer & Leppin 1989). Additional research has investigated the role of sex and gender differences in social support, health and the interaction between these variables (Barbee et al. 1993, Burda, Vaux & Schill 1984, Cleary, 1987, Rook, 2001, Shumaker & Hill, 1991). The present study aims to further examine the influence of sex-role orientation on social support and health. Forty-nine female participants completed a three-part survey assessing their sex-role orientation, perceived social support, current stress levels and physical health. Results revealed that both masculinity and femininity relate to social support network size and health outcomes. Masculinity and androgyny were significantly negatively associated with health problems, whereas undifferentiated individuals had higher rates of physical illness. These findings demonstrate the important role of gendered traits in social support and ultimately, physical health.