Application of cutting fluids in machining processes

In the last decade a lot has been discussed about the suitability of using cutting fluid in abundance to cool and lubricate machining processes. The use of cutting fluid generally causes economy of tools and it becomes easier to keep tight tolerances and to maintain workpiece surface properties without damages. In the other hand, it brings also some problems, like fluid residuals and human diseases. Because of them some alternatives has been sought to minimise or even avoid the use of cutting fluid in machining operations. Some of these alternatives are dry cutting and cutting with minimum quantity of fluid (MQF). The main goal of this work is to discuss these tendencies. Therefore, topics like kinds and methods of applications of modern cutting fluids and what are new in this area will unavoidably be considered. MQF and dry cutting techniques, their applications and where it is not possible to apply them will also be focused. To exemplify the topics, this work will describe some of the researches been developed in two important Brazilian Universities: State University of Campinas (UNICAMP) and Federal University of Uberlândia (UFU).

Influence of leaf retention on cutting propagation of Lavandula dentata L.

Vegetative propagation of lavender offers several advantages over sexual propagation, among them crop homogeneity and yield of higher quality essential oil. However, Lavandula species have been propagated mostly by seeds and are said to be recalcitrant to rooting when propagated by cuttings. During cutting propagation, one of the important variables that influence the rooting capacity of cuttings is the leaf retention. The objective of this work was to evaluate the influence of leaf retention on rooting of L. dentata cuttings. Apical cuttings of L. dentata of 10 cm in length, keeping approximately 1/3, 1/2 or 2/3 of their leaves were planted in commercial substrate Plantmax HT® under intermittent mist. After two months, averages of root number, length of the longest root, root fresh and dry weights, and the survival percentage were evaluated. Root length and fresh weight were statistically greater with 2/3 of leaf retention and when fewer leaves were kept on the cuttings, lower means of root dry weight was observed. Under the conditions applied in this study, greater leaf retention was better for rooting of L. dentata cuttings.

Biotyping, serotyping and ribotyping as epidemiological tools in the evaluation of Acinetobacter baumannii dissemination in hospital units, Sorocaba, São Paulo, Brazil

Dissemination of Acinetobacter baumannii strains in different units of a hospital in Sorocaba, São Paulo, Brazil was evaluated over a period of two years. By using biotyping, serotyping and ribotyping, 27 distinct clones were differentiated among 76 strains isolated between 1993-94, from clinical specimens of hospitalized patients. Two clones, 2:O4:A (biotype:serotype:ribotype) and 2:O29:A accounted for the majority of strains widely disseminated in the units during 1993. The introduction in the hospital setting, of a new clone, 6:O13:B, at the end of 1993 and its predominance through 1994 is discussed. Among 15 strains isolated from neonates, 6 (40%) belonged to the same clone, 2:O4:A. Interestingly, this clone was almost all recovered in neonatal intensive care unit, nursery and in pediatric unit. All strains were susceptible to imipenem and polymyxcin B. Multiresistant strains (up to 12 antimicrobial agents) accounted for 66.7% and 84.8% of the strains isolated in 1993 and in 1994, respectively.

Spatial distribution of dengue in the city of Cruzeiro, São Paulo State, Brazil: use of geoprocessing tools

The aim of this article is to identify patterns in spatial distribution of cases of dengue fever that occurred in the municipality of Cruzeiro, State of São Paulo, in 2006. This is an ecological and exploratory study using the tools of spatial analysis in the preparation of thematic maps with data from Sinan-Net. An analysis was made by area, taking as unit the IBGE census, the analysis included four months in 2006 which show the occurrence of the disease in the city. The thematic maps were constructed by TerraView 3.3.1 software, the same software provided the values of the indicators of Global Moran (I M) every month and the Kernel estimation. In the year 2006, 691 cases of dengue were georeferenced (with a rate of 864.2 cases/100,000 inhabitants); the indicators of Moran and p-values obtained were I M = 0.080 (March) p = 0.11; I M = 0.285 (April) p = 0.01; I M = 0.201 (May) p = 0.01 and I M = 0.002 (June) p = 0.57. The first cases were identified in the Northeast and Central areas of Cruzeiro and the recent cases, in the North, Northeast and Central. It was possible to identify census tracts where the epidemic began and how it occurred temporally and spatially in the city.

HCV INFECTION THROUGH PERFORATING AND CUTTING MATERIAL AMONG CANDIDATES FOR BLOOD DONATION IN BELÉM, BRAZILIAN AMAZON

This study evaluated epidemiological factors for HCV infection associated with sharing perforating and cutting instruments among candidates for blood donation (CBD) in the city of Belém, Pará, Brazilian Amazon. Two definitions of HCV infection cases were used: anti-HCV positivity shown by EIA, and HCV-RNA detection by PCR. Infected and uninfected CBD completed a questionnaire about possible risk factors associated with sharing perforating and cutting instruments. The information was evaluated using simple and multiple logistic regressions. Between May and November 2010, 146 (1.1%) persons with anti-HCV antibodies and 106 (0.8%) with HCV-RNA were detected among 13,772 CBD in Belém. Risk factors associated with HCV infection based on the EIA (model 1) and PCR (model 2) results were: use of needles and syringes sterilized at home; shared use of razors at home, sharing of disposable razors in barbershops, beauty salons etc.; and sharing manicure and pedicure material. The models of HCV infection associated with sharing perforating and cutting instruments should be taken into account by local and regional health authorities and by those of other countries with similar cultural practices, in order to provide useful information to guide political and public strategies to control HCV transmission.

Revisiting the concept of hepatosplenic schistosomiasis and its challenges using traditional and new tools

Different aspects of hepatosplenic schistosomiasis are revisited here. Manson's schistosomiasis causes periportal fibrosis and portal hypertension in approximately 6% of infected subjects, usually with preservation of their hepatic function. The assessment of liver involvement is of major importance in determining the prognosis and risk of complications from schistosomiasis, such as upper digestive bleeding secondary to variceal rupture. For many years, the diagnosis of hepatosplenic schistosomiasis and liver fibrosis was made by abdominal palpation and the finding of liver and/or spleen enlargement. However, there is no consensus regarding the clinical parameters of the liver and spleen to be considered in this physical evaluation. For the last three decades, abdominal ultrasound (US) has become the best imaging technique to evaluate liver fibrosis caused by schistosomiasis mansoni. However, US is a subjective procedure and is therefore examiner-dependent. Magnetic resonance imaging (MRI) findings have provided valuable information in addition to ultrasound and clinical examination. The combination of a comprehensive history and physical examination, basic laboratory tests (a stool examination for Schistosoma mansoni eggs and a blood cell count), biomarkers for liver fibrosis/portal hypertension and imaging methods seem to offer the best approach for evaluating patients with this disease. In situations where research is involved or in patients with severe disease, MRI may be considered.

Computed tomography-guided cutting needle biopsy of pulmonary lesions

PURPOSE: To report the experience of a radiology department in the use of computed tomography - guided cutting needle biopsy of pulmonary nodules, by evaluating diagnostic yield and incidence of complications. METHODS: This is a retrospective analysis of 52 consecutive patients who underwent lung lesion biopsy guided by computed tomography, performed between May 1997 and May 2000. Thirty-five patients were male and 17 were female, with ages ranging from 5 to 85 years (median, 62 years). The size of the lesions ranged from 1.8 to 15 cm (median, 5.4 cm). RESULTS: In a total of 52 biopsies of lung lesions, 51 biopsies (98.1%) supplied appropriate material for histopathological diagnosis, with 9 diagnosed (17.3%) as benign and 42 (80.8%) as malignant lesions. Specific diagnosis was obtained in 44 (84.6%) biopsies: 4 benign (9.1%) and 40 (90.9%) malignant lesions. The sensitivity, specificity, and accuracy of the cutting needle biopsies for determining presence of malignancy were 96.8%, 100%, and 97.2%, respectively. Complications occurred in 9 cases (17.3%), including 6 cases (11.5%) of small pneumothorax, 1 (1.9%) of hemoptysis, 1 (1.9%) of pulmonary hematoma, and 1 (1.9%) of thoracic wall hematoma. All had spontaneous resolution. There were no complications requiring subsequent intervention. CONCLUSION: The high sensitivity and specificity of the method and the low rate of complications have established cutting needle biopsy as an efficient and safe tool for the diagnosis of lung lesions. In our hospital, cutting needle biopsy is considered a reliable procedure for the evaluation of indeterminate pulmonary nodules.

Computed tomography-guided biopsy of mediastinal lesions: fine versus cutting needles

PURPOSE: To report the experience of a radiology department in the use of computed tomography guided biopsies of mediastinal lesions with fine and cutting needles, describing the differences between them. The results of adequacy of the sample and histologic diagnoses are presented according to the type of needle used. METHODS: We present a retrospective study of mediastinal biopsies guided by computed tomography performed from January 1993 to December 1999. Eighty-six patients underwent mediastinal biopsy in this period, 37 with cutting needles, 38 with fine needles, and 11 with both types (total of 97 biopsies). RESULTS: In most cases, it was possible to obtain an adequate sample (82.5%) and specific diagnosis (67.0%). Cutting-needle biopsy produced a higher percentage of adequate samples (89.6% versus 75.5%, P = 0.068) and of specific diagnosis (81.3% versus 53.1%, P = 0.003) than fine-needle biopsy. There were no complications that required intervention in either group. CONCLUSION: Because they are practical, safe, and can provide accurate diagnoses, image-guided biopsies should be considered the procedure of choice in the initial exploration of patients with mediastinal masses. In our experience, cutting needles gave higher quality samples and diagnostic rates. We recommend the use of cutting needles as the preferred procedure.

The ceramic artifacts in archaeological black earth (terra preta) from lower Amazon region, Brazil: mineralogy

Several archaeological black earth (ABE) sites occur in the Amazon region. They contain fragments of ceramic artifacts, which are very important for the archaeological purpose. In order to improve the archaeological study in the region we carried out a detailed mineralogical and chemical study of the fragments of ceramic artifacts found in the two ABE sites of Cachoeira-Porteira, in the Lower Amazon Region. Their ceramics comprise the following tempers: cauixi, cariapé, sand, sand +feldspars, crushed ceramic and so on and are composed of quartz, clay equivalent material (mainly burned kaolinite), feldspars, hematite, goethite, maghemite, phosphates, anatase, and minerals of Mn and Ba. Cauixi and cariapé, siliceous organic compounds, were found too. The mineralogical composition and the morphology of their grains indicate a saprolite (clayey material rich on quartz) derived from fine-grained felsic igneous rocks or sedimentary rocks as source material for ceramic artifacts, where silica-rich components such cauixi, cariapé and/or sand (feldspar and rock fragments) were intentionally added to them. The high content of (Al,Fe)-phosphates, amorphous to low crystalline, must be product of the contact between the clayey matrix of pottery wall and the hot aqueous solution formed during the daily cooking of animal foods (main source of phosphor). The phosphate crystallization took place during the discharge of the potteries put together with waste of organic material from animal and vegetal origin, and leaving to the formation of the ABE-soil profile.

The ceramic artifacts in archaeological black earth (terra preta) from Lower Amazon Region, Brazil: chemistry and geochemical evolution

This paper carried out a chemical investigation of archaeological ceramic artifacts found in archaeological sites with Black Earth (ABE) in the Lower Amazon Region at Cachoeira-Porteira, State of Pará, Brazil. The ceramic artifacts, mostly of daily use, belong to Konduri culture (from 900 to 400 years BP). They are constituted of SiO2, Al2O3, Fe2O3, Na2O and P2O5; SiO2 and Al2O3 together add up to 80 % and indicate influence of acid rocks, transformed into clay minerals basically kaolinite. The relative high contents of P2O5 (2.37 % in average) come out as (Al,Fe)-phosphate, an uncommon fact in primitive red ceramics, but found in some roman and egyptian archaeological sites. The contents of the trace elements are similar or below the Earth's crust average. This chemical composition (except P2O5) detaches saprolite material derived acid igneous rocks or sedimentary ones as the main raw material of the ceramics. The contents of K, Na and Ca represent the feldspars and rock fragments possibly introduced into saprolitic groundmass, indicated by mineralogical studies. The presence of cauixi and cariapé as well as quartz sand was confirmed by optical microscope, SEM analyses and by the high silica contents of ceramic fragments. Phosphorus was possibly incorporated into groundmass during cooking of foods, and ABE soil profile formation developed on yellow Latosols. The raw materials and its tempers (cauixi, or cariapé, feldspar, crushed rocks, old ceramic artifacts and quartz fragments) are found close to the sites and therefore and certainly came from them.

Cutting balloon angioplasty for intrastent restenosis treatment

We describe here two patients with angiographic diagnosis of intrastent restenosis and regional myocardial ischemia. One stent restenosis was located in a native coronary artery and the other in a vein graft. Both were treated with cutting balloon angioplasty (CBA), inflated at low pressures. Angiographic success was obtained and both patients were discharged in the day after the procedure. Cutting balloon angioplasty using low inflation pressures achieved important luminal gains, in these two cases of intrastent restenosis. Further studies are necessary before the effectiveness of this procedure can be precisely defined.