Fruit size, mineral composition and quality of trickle-irrigated tomatoes as affected by potassium rates

An experiment was conducted to determine the fruit size, mineral composition and quality of trickle-irrigated tomatoes as affected by potassium fertilizer rates. Six potassium (K) rates were applied as KCl, corresponding to 0, 48.4, 118.6, 188.8, 259.0 and 399.4 kg ha-1, with four replicates, following a randomized block design. Quadratic responses to K rates were observed for double extra large (diameter > 60 mm), extra large (56 to 60 mm) and large (52 to 56 mm) fruit yields. Maximum yields of these classes were achieved with K rates of 116, 190 and 233 kg ha-1, respectively. Fruit dry matter, phosphorus, sulfur and magnesium contents were not affected by K rates, but nitrate and K contents showed significant increments as K rates were increased. Vitamin C, total soluble solids, lycopene and beta-carotene contents in the fruits were not affected by K rates. Increments in the K rate lowered the fruit pH and increased total acids content.

Yield and mineral nutrition of soybean, maize, and Congo signal grass as affected by limestone and slag

The objective of this work was to evaluate the efficiency of superficial application of limestone and slag, and their effects on soil chemical attributes and on yield and mineral nutrition of soybean, maize, and Congo signal grass (Urochloa ruziziensis). The experiment was carried out in a Rhodic Hapludox under no tillage system. The treatments consisted of the use of limestone or slag (silicates of calcium and magnesium) to correct soil acidity, and of a control treatment without the use of soil correctives. Rates were calculated in order to raise soil base saturation up to 70%. Soybean was sown in November 2006 and maize in December 2007. Congo signal grass was sown right after the harvests of soybean and maize, and it was cropped during the off-seasons. Soil chemical attributes were evaluated at 6, 12, and 18 months after the application of the corrective materials. Slag is an efficient source for soil acidity correction, being able to raise the exchangeable base levels in the soil profile faster than lime. Both limestone and slag increase dry matter yield of Congo signal grass, and grain yield of soybean and maize. Slag is more effective in improving maize grain yield.

Sugars, organic acids, minerals and lipids in jabuticaba

The aim of this work was to determine the sugar, organic acid and mineral compositions of the whole fruit and fractions (skin, pulp and seed) of the Paulista (Plinia cauliflora) and Sabará (Plinia jaboticaba) jabuticaba tree genotypes, as well as the oil compositions of their skin and seeds. High levels of sugar, especially fructose, followed by glucose and sucrose, were encountered in the fruit. In the Paulista genotype, higher levels of total and reducing sugars were found in the pulp and skin, which was not observed when comparing the whole fruit of both genotypes. Five organic acids were found in the whole fruit and in the fractions of the two jabuticaba genotypes in quantitative order: citric acid > succinic acid > malic acid > oxalic acid > acetic acid. Potassium was the most abundant mineral found. This fruit was also shown to be rich in magnesium, phosphorus, calcium and copper. The seed oil had nearly the same constitution as the oil extracted from the skin in both genotypes and the major compounds were an unidentified phytosterol, palmitic, linoleic and oleic acids, and squalene.

Influence of rootstock on nutrient content in grape petioles

Genetic diversity of rootstocks can affect nutrient uptake and the nutrient status of grapevines. The rootstock influence on nutrient content in grape petioles was evaluated on three rootstocks competition experiments carried out at Vale do Rio do Peixe region, in the state of Santa Catarina, Brazil, with the cultivars Niagara Rosada, Concord, and Isabella, grafted on different rootstocks. Two soil liming depths were also evaluated in the Isabella experiment. The greatest rootstock effect was observed on K and Mg content and K/Mg ratio in the petioles. The Vitis vinifera x V. rotundifolia hybrid rootstocks VR 043-43 and VR 044-4 provided the highest K/Mg values and self rooted Isabella the lowest K/Mg ratio. The other tested rootstocks resulted in intermediate values. There was also significant effect on P content, but only in Niagara Rosada and Concord experiments. The depth of soil liming did not significantly affect K and Mg content in the Isabella experiment. The results indicate that rootstock must be considered for nutritional status evaluation and fertilizer recommendation regarding to K and Mg.

Characterization of the effects of macronutrient deficiencies in mangabeira seedlings

Knowledge of the mineral nutrition requirements of mangabeira (Hancornia speciosa Gomes) is relatively scarce and rudimentary because there is a lack of consistent data concerning its nutritional demands at different developmental stages. The aim of this research was to characterize the visual symptoms of macronutrient deficiencies and to evaluate the effects of these deficiencies on the growth, the production of dry matter, and the leaf content of mangabeira. To achieve this goal, a greenhouse experiment was conducted at the Goiano Federal Institute (Instituto Federal Goiano) in Rio Verde - GO, from January to June 2011 in which mangabeira plants were arranged in a random block design and grown in nutrient solutions. This experiment was replicated four times. The plants were treated with either a complete nutrient solution or a nutrient solution from which the individual macronutrient of interest (nitrogen (N), phosphorous (P), potassium (K), magnesium (Mg), calcium (Ca), or sulfur (S) had been omitted. The omission of a macronutrient from the nutrient solution resulted in morphological alterations that were characteristic symptoms of the particular nutritional deficiency and caused decreases in growth and dry matter mass production. The accumulation of macronutrients displayed the following order in mangabeira leaves: N>K>Ca>P>S>Mg.

Geração eletroquímica do hidreto de selênio em sistema de injeção em fluxo com detecção por espectrometria de absorção atômica com chama Ar-Glp

This paper presents a system for electrochemical hydride generation using flow-injection and atomic absorption spectrometry to determine selenium in biological materials. The electrolytic cell was constructed by assembling two reservoirs, one for the sample and the other for the electrolytic solution separated by a Nafion membrane. Each compartment had a Pt electrode. The sample and electrolyte flow-rates, acidic media, and applied current were adjusted to attain the best analytical performance and ensure the membrane lifetime. The atomisation system used a T quartz tube in an air-LPG flame. The composition of the flame, the observation height, and the argon flow rate used to carry the hydrides were critically investigated. The system allowed to perform thirty determinations per hour with a detection limit of 10 mug L-1 of Se. Relative standard deviations were in general lower than 1.5% for a solution containing 20.0 and 34.0 mug L-1 of Se in a typical sample digest. Accuracy was assessed analysing the certified materials: rice flour (NIST-1568) from National Institute of Standard and Technology and dried fish (MA-A-2), whole animal blood (A-2/1974) from the International Atomic Energy Agency.

Combinación de sistemas de flujo de baja y alta presion para la determinacion de Mg, Ca y Sr en salmueras por espectrofotometria de absorcion atomica con llama

This article describes the combination of low- and high-pressure flow systems for the determination of Magnesium, Calcium and Strontium by flame atomic absorption spectrometry (FAAS). In the low-pressure system a short C-18 RP column (length 0,5 cm) was utilized for the preconcentration/matrix separation step, xylenol orange was used as chelating agent and tetrabutylamonium acetate for ion pair formation. The hydraulic high pressure nebulization (HHPN) was used for sample transport and sample introduction in the high pressure system. The repeatabilities and detection limits for Mg, Ca and Sr were determined and compared with those obtained by pneumatic nebulization (PN). The results show that the detection limits obtained using the HHPN for Mg, Ca and Sr are between 1.5 to 2 times better than those obtained by PN when the signal transient was measured in area. The system presented a sampling frequency of 130 h-1 for direct determination of Mg, Ca or Sr in samples of saturated sodium chloride used in the production of chlorine and sodium hydroxide.

Baterias de níquel-hidreto metálico, uma alternativa para as baterias de níquel-cádmio

Nickel metal hydride (Ni-MH) batteries have emerged as an alternative for replacement of nickel-cadmium batteries, because of their more environmental compatibility and high energy capacity. In this article, we described the properties and applications for Ni-MH batteries, giving some emphasis on the metal-hydride electrode, including the description of composition, the charge storage capacity and the discharge profile. The key component of the nickel-metal hydride electrode is a hydrogen storage alloy whose composition is formulated to obtain a high stable material over a large number of charge-discharge cycles.

Redução de amidas por boranos

Despite the fact that boranes are frequently used in amide reductions, the reaction mechanisms of the involved are note well known. This work presents the results of a bibliographic search on probable amide reduction mechanisms and an analysis of the existing literature. Steric and electronic effects were considered in light of reactivity since it could be concluded that the formation of intermediates and products depends mainly on the substitution patterns of both the boron and nitrogen atoms. Otherwise, results described in the literature for the reactions of boranes, sodium borohydride, lithium aluminum hydride, alkylboranes or haloboranes with others functional groups such as carboxylic acids, esters, ketones and alkenes were analysed with the aim to obtain something about the N-substituted amide reactions employing boranes.

A geração química de vapor em espectrometria atômica

The historical development of atomic spectrometry techniques based on chemical vapor generation by both batch and flow injection sampling formats is presented. Detection via atomic absorption spectrometry (AAS), microwave induced plasma optical emission spectrometry (MIP-OES), inductively coupled plasma optical emission spectrometry (ICP-OES) , inductively coupled plasma mass spectrometry (ICP-MS) and furnace atomic nonthermal excitation spectrometry (FANES) are considered. Hydride generation is separately considered in contrast to other methods of generation of volatile derivatives. Hg ¾ CVAAS (cold vapor atomic absorption spectrometry) is not considered here. The current state-of-the-art, including extension, advantages and limitations of this approach is discussed.

Eletrodeposição de irídio em tubo de grafite como modificador químico permanente em espectrometria de absorção atômica

A tubular electrochemical flow-cell for iridium deposition on the inner surface of pyrolytic graphite tube for permanent chemical modification is proposed. A transversal heated graphite tube was used as working electrode, a cylindrical piece of graphite inserted into the graphite tube as auxiliary electrode, and a micro Ag/AgCl(sat) as reference electrode. Iridium solution in 1.0 mol L-1 HCl, flowing at 0.55 mL min-1 for 60 min was used to perform the electrochemical modification. The applied potential to the flow-cell was - 0.700 V vs Ag/AgCl. Scanning electron microscopy images were taken for thermal and electrochemical modified graphite surface in order to evaluate the iridium distribution. Selenium hydride trapping was used to verify the performance of the proposed permanent chemical modifier.

Determinação de arsênio em águas contaminadas usando fluorescência de raios-X por energia dispersiva

This work proposes a simple, fast and inexpensive method to determine As in natural waters, using X-ray fluorescence. 50 µL of each sample containing 100 mg L-1 of yttrium as internal standard were deposited over a 2.5 µm thickness MylarTM film. The samples were dried at 50 °C for 2 h. X-ray spectra were obtained using an EDXRF apparatus. The accuracy was determined by analyte addition/recovery and by comparison with Hydride Generation Atomic Absorption Spectrometry (HG AAS). A recovery of about 100% was obtained and the results were in good agreement with HG AAS. The method showed a relative standard deviation of 6.8% and a detection limit of 10.5 µg L-1 of As.

Estudo do efeito do tratamento superficial por moagem sobre as propriedades das partículas de uma liga de hidreto metálico

This work reports results of studies on the electrochemical and structural properties of a Ti/Zr-based metal hydride alloy covered by Ni and LaNi4,7Sn0,3 powder additives by ball milling. The effect of this treatment is investigated for the activation time, hydrogen storage capacity and equilibrium pressure, cycling stability and the hydration/dehydration kinetics. Charge and discharge cycles show a significant decrease of the activation time due to an increase of the active area caused by the milling treatment, independent of the additive. However, other results have evidenced little effect of the milling surface treatment on the charge storage capacity, hydrogen equilibrium pressure, and hydration/dehydration kinetics, for both the Ni and LaNi4,7Sn0,3 covered materials.

Descrições de técnicas da química na produção de bens de acordo com os relatos dos naturalistas viajantes no Brasil colonial e imperial

European naturalists explored Brazil in long scientific expeditions and published accounts that make up a rich and still largely untapped historiographic source for the understanding of the history of chemistry. The production of indigo dye, the manufacture of limestone, extraction and purification of saltpeter and the production of salt are discussed. Lime was used to whitewash walls and, mixed with whale oil, as cement to glue stones in buildings of the colonial period. It was prepared by burning seashells in specifically designed ovens. Saltpeter was produced by reacting naturally occurring calcium and magnesium nitrate with potassium-rich wood ashes to yield KNO3. NaCl was obtained by evaporating seawater under the sun. Indigo, a native plant, was cultivated and processed to produce the renowned dye, which was exported to Europe.

Efeito do triacilglicerídeo de cadeia média, da fibra e do cálcio na disponibilidade de magnésio e de zinco pelo método in vitro e metodologia de superfície de resposta

Nutritional therapy with enteral diets became highly specialized in the last years. This work aims to study the effect of the components of a formulation, namely fiber, calcium and medium-chain triglycerides, for dialysability of minerals. Analysis of multiple variables was done using response surface methodology. The level curve showed that the tertiary interaction MCT-fiber-calcium was the one that presented the highest synergism in the formulation. The proportion of 33% MCT, 25% fiber and 42% calcium, gave the best formulation for availability of magnesium.