Environmental effects on photosynthetic capacity of bean genotypes

Photosynthetic responses to daily environmental changes were studied in bean (Phaseolus vulgaris L.) genotypes 'Carioca', 'Ouro Negro', and Guarumbé. Light response curves of CO2 assimilation and stomatal conductance (g s) were also evaluated under controlled (optimum) environmental condition. Under this condition, CO2 assimilation of 'Carioca' was not saturated at 2,000 µmol m-2 s-1, whereas Guarumbé and 'Ouro Negro' exhibited different levels of light saturation. All genotypes showed dynamic photoinhibition and reversible increase in the minimum chlorophyll fluorescence yield under natural condition, as well as lower photosynthetic capacity when compared with optimum environmental condition. Since differences in g s were not observed between natural and controlled conditions for Guarumbé and 'Ouro Negro', the lower photosynthetic capacity of these genotypes under natural condition seems to be caused by high temperature effects on biochemical reactions, as suggested by increased alternative electron sinks. The highest g s values of 'Carioca' were observed at controlled condition, providing evidences that reduction of photosynthetic capacity at natural condition was due to low g s in addition to the high temperature effects on the photosynthetic apparatus. 'Carioca' exhibited the highest photosynthetic rates under optimum environmental condition, and was more affected by daily changes of air temperature and leaf-to-air vapor pressure difference.

Physiological analysis of leaf senescence of two rice cultivars with different yield potential

The objective of this work was to evaluate the physiological changes that occur in different leaves during the early and late grain-filling stages of two rice genotypes (Oryza sativa subsp. indica , BRS Pelota cultivar, and O. sativa subsp. japonica , BRS Firmeza cultivar), which present differences in grain yield potential. The plants were cultivated in greenhouse. Pigment content, chlorophyll fluorescence, electron transport and oxygen evolution rate were determined in the grain-filling stage, from the first to the forth leaf (top to bottom). Pigment content, photochemical efficiency of photosystem II and electron transport decreased significantly according to the position of leaves in 'BRS Pelota'. The BRS Firmeza cultivar shows higher pigment content and higher activity of the photosynthetic apparatus in comparison to 'BRS Pelota' during the grain-filling stage.

Study of the skin anatomy with high-frequency (22 MHz) ultrasonography and histological correlation

AbstractThe present essay is aimed at getting the radiologist familiar with the basic histological skin structure, allowing for a better correlation with sonographic findings. A high-frequency (22 MHz) ultrasonography apparatus was utilized in the present study. The histological analysis was performed after the skin specimens fixation with formalin, inclusion in paraffin blocks and subsequent staining with hematoxylin-eosin. The authors present a literature review showing the relationship between sonographic and histological findings in normal cutaneous tissue, and discuss the technique for a better performance of the sonographic scan. High-frequency ultrasonography is an excellent tool for the diagnosis of different skin conditions. However, as this method is operator-dependent, it is crucial to understand the normal skin structure as well as the correlation between histological and sonographic findings.

Projeto e construção de um bioreator para síntese orgânica assimétrica catalisada por saccharomyces cerevisiae (fermento biológico de padaria)

A model for the construction of a simple and cheap apparatus to be used as bioreactor for reactions catalyzed by baker's yeast (Saccharomyces cerevisiae) is described. The bioconversion and separation of cells from products and residual substrates are obtained at the same time. The reactions carried out in this type of reactor are faster than those catalyzed by immobilized cells. Yeast cells can be cultivated in this bioreactor operating with cell recycling at appropriated conditions using glucose and other nutrients.

Simulação do processo Solvay no laboratório didático

The Solvay Process is an important route for the industrial preparation of sodium carbonate from brine and CO2. However, experiments illustrating such process are performed only in a few chemistry courses, mainly because of the difficulties to precipitate out the intermediate product NaHCO3 within the 3 or 4 hours generally available for laboratory classes. In this article we describe a method that properly simulates the Solvay process using glass apparatus that can be found in any chemistry laboratory. The good yields and purity attainable, associated with the short time (~3 hours) required to get the sodium bicarbonate, account for the suitability of our method for chemistry or chemical engineering undergraduate students laboratory classes.

Automatização de um destilador d'água

A simple and inexpensive device to automate a water distilling apparatus is shown. It is composed by a magnetic floater placed in the water reservoir and a level control unit, which acts over the heating element circuit. In order to provide water saving, an electromagnetic valve is inserted in the water supply inlet. Some suggestions for the adaptation to other types of equipment are also offered.

Termoquímica na Unicamp: depoimento sobre uma jornada de 25 anos

This article describes the progress of a group of investigation on thermochemistry, which started in 1972. A homemade calorimeter was employed to provide quantitative support to the information on interative effect between lanthanide cations and halides or pseudohalides, in non-aqueous solvents, previously derived from conductometric titrations. However, the features of this instrument were not able to detect the thermal effects. Therefore, the great input to the group came from the acquisition of an LKB commercial apparatus, by the University in 1975. Considering the historical development of the coordination chemistry in Brazil, which was previously dedicated to strutural features of adducts, without focusing the energetic envolved in any coordinationcompound. Since starting the thermochemistry study, numerous masters and doctoral thesis covering more than a hundred adducts and a reasonable number of chelates, were presented systematizing data in order to understand the behavior of this kind of coordination compounds (C. Airoldi and A. P. Chagas, Coord. Chem. Rev. 1992, 119, 29). This knowledge enabled an extension of the study to include some heterogeneous systems formed by natural or synthetic materials like immobilized silica gel, lamellar phosphate, phosphonate or sulphate compounds, clays, polysaccharides, chrysotile, soils, etc. Many students are now engaged as staff members in Universities, Research Instituitions or other private institutions, developing many activities. Due to a multiplying effect on the formation of researchers, the group is now reaching the fourth generation.

Despolarizador eletrônico de eletrodos

This paper presents the design of a simple apparatus that periodically switches off both working and auxiliary electrodes short-circuiting them for a couple of seconds. Depolarization takes place and the initial current is re-established.

Um espectômetro de massas de tempo-de-vôo para o estudo da ionização de amostras gasosas por elétrons rápidos (0,5 - 1,0 keV)

A simple and inexpensive time-of-flight mass spectrometer, dedicated to the study of gas-phase ionization processes induced by high energy electrons (0.5 - 3.0 keV), is described. The spectrometer design is based on the Wiley-McLaren principle, with a total length of about 18 cm. As a demonstration of the performance of the apparatus, mass spectra for Ar, CH4, CO2, and SF6, obtained at 1 keV electron energy, are presented.

Determinação da massa molar por crioscopia: terc-butanol, um solvente extremamente adequado

We intend to divulge an easy experiment that permits the determination of molar masses of various compounds by cryoscopy. The major advantage of this is the use of the tert-butyl alcohol as a solvent, which requires simple apparatus and easy procedures. The melting point of this alcohol is around 25 ºC, which makes it easy to freeze and then melt the solutions. This solvent has a high cryoscopic constant and is miscible with both polar and non-polar compounds. The molar masses of acetone, water, chloroform, dichloro-methane, ethanol, hexane, carbon tetrachloride and toluene were determined. The results were good except for water. Even though there are reliable techniques of molar mass determination nowadays, this method is still frequently taught in undergraduate courses.

Extrações de óleos de sementes de citros e suas atividades sobre a formiga cortadeira Atta sexdens e seu fungo simbionte

Seeds Citrus oils (C. sinensis, C. limon and C. reticulata) extraction with hexane in a soxhlet apparatus and through supercritical fluid (CO2) were done. Besides triglycerides, the oils obtained with hexane comprised volatile compounds such as terpenes and fatty alcohols, esters, and aldehydes. However, the oils obtained by extraction with supercritical fluid presented only triglycerides. These results indicate that the extraction using supercritical fluid presents better selectivity. The activity of the oils on the development of the ant symbiotic fungus, Leucoagaricus gongylophorus, showed week activity and the topic insecticide assay showed better activity for the tangerine seed oil.

Avaliação da susceptibilidade magnética usando uma balança analítica

A simple system to measure the magnetic susceptibility of different materials is presented. The system uses an analytical scale with sensitivity on the order of micrograms and a permanent NdBFe magnet, based in the Rankine method. In this apparatus, the sample is placed near to the magnet that is fixed on the scale. Depending on the magnetic properties of the sample, an attractive or repulsive force will appear between the magnet and the magnetizing sample. Measuring this force, registered by the scale as a mass, the magnetic parameters such as: permeability and susceptibility of the sample can be determined. Despite it is simplicity the method is quantitative, precise and easily reproducible in many laboratories, what makes it attractive for teaching experiments.

Recuperação de bromo em soluções aquosas residuais

A laboratory procedure was devised to recover bromine from waste alkaline aqueous solutions used in the isotopic determination of N-15. The laboratory apparatus comprises two round bottom flasks (1 and 2 L), a dropping funnel, a gas bubbler, a gas regulator and glass fittings. The waste solution is acidified with sulfuric acid forming molecular bromine that is stripped out by a flow of nitrogen gas bubbled through the solution. This gas is then bubbled through a solution of lithium hydroxide generating lithium bromide and lithium hypobromite. The efficiency of bromine recovery was estimated to be 82±2%. This resulting solution was successfully reused in the isotopic determination of N-15. The procedure can recycle most of the bromine used in the laboratory saving resources and preserving the environment. The procedure can be adapted to recover bromine of other laboratory waste streams.

Constituintes químicos voláteis das flores e folhas do pau-brasil (Caesalpinia echinata, Lam.)

The volatile constituents obtained from a static cryogenic headspace of Caesalpinia echinata Lam. (Leguminosae) showed E-beta-ocimene as the major compound (57.2%), beside other monoterpenes, C6 derivatives like n-hexanal and (E)-2-hexenal and nitrogen compounds such as indole and methyl anthranilate. From the essential oil of the leaves obtained by hydrodistillation in a Clevenger apparatus, (E)-3-hexen-1-ol was identified as the major constituent while phenolic compounds were the most representative class of secondary metabolites.

Adaptação no método do peso da gota para determinação da tensão superficial: um método simplificado para a quantificação da CMC de surfactantes no ensino da química

The discussion based on surfactant cleaning action is commonly used in chemistry classrooms for the comprehension of theoretical concepts related to surface tension and micelle formation. The experimental quantification of surface tension of aqueous solutions of surfactants provides the practical instruments for this discussion. The present paper describes a simplification on the common apparatus employed for the drop-weight method, making the determination of surface tension accessible to any chemistry lab. The surface tension of various liquids and the critical micelle concentration, CMC, of three commercial surfactants were measured with this modified method, and proved to be consistent with literature values.