Isotopic analyses of DSDP Hole 45-395A samples from veins containing gypsum (Table 1)

Gypsum and halite crystals, together with saponite and phillipsite, were found in a vein in a basalt sill 625 m below the sea floor at DSDP Site 395A, located 190 km west of the crest of the Mid-Atlantic Ridge. The delta34S value of the gypsum (+19.4?) indicates a seawater source for the sulfate. The delta18O values of the saponite (+19.9?) and phillipsite (+18.1?) indicate either formation from normal seawater at about 55°C or formation from delta18O-depleted seawater at a lower temperature. The gypsum (which could be secondary after anhydrite) was formed by reaction between Ca[2+] released from basalt and SO4[2-] in circulating seawater. The halite could have formed when water was consumed by hydration of basalt under conditions of extremely restricted circulation. A more probable mechanism is that the gypsum was originally precipitated as anhydrite at temperatures above 60°C. As the temperature dropped the anhydrite converted to gypsum. The conversion would consume water, which could cause halite precipitation, and would cause an increase in the volume of solids, which would plug the vein and prevent subsequent dissolution of the halite.

(Table 1) Gypsum, pyrite and glauconite at DSDP Hole 36-329

Authigenic gypsum, pyrite, and glauconite are disseminated throughout an unusually long (346 m) Miocene section of mixed biogenic carbonate and diatomaceous ooze drilled on the Falkland Plateau at DSDP Site 329 (water depth, 1519 m). The present organic carbon content of the sediment is low, ranging between 0.1 and 0.7%. Gypsum occurs as euhedral single or twinned crystals of selenite up to 5 mm in diameter, sometimes in the form of gypsum rosettes. These crystals are intact and unabraded, comprising up to 4% of the washed sample. The authigenic nature of the gypsum is demonstrated by the presence of diatoms and radiolarians embedded within the gypsum crystals. The gypsum co-occurs with pyrite and glauconite in these samples. The pyrite occurs as framboids, foraminiferal infillings, rods, and granular sheetlike masses composed of pyrite octahedra. The glauconite occurs as foraminiferal infillings and as free grains. The gypsum and pyrite were identified by energy-dispersive X-ray analysis and scanning electron micrographs. Some of the gypsum has grown on pyrite, indicating that it precipitated after the pyrite, perhaps in response to a change in pH conditions. The formation of the mineral suite can be explained by current models of in situ sulfide and sulfate precipitation coincident with diagenesis and oxidation of much of the original organic carbon.

(Table 1) Porewater analysis with respect to gypsum from different ODP holes

The stability of gypsum in marine sediments has been investigated through the calculation of its saturation index at the sediment in situ temperature and pressure, using the entire ODP/IODP porewater composition database (14416 samples recovered from sediments collected during 95 ODP and IODP Legs). Saturation is reached in sediment porewaters of 26 boreholes drilled at 23 different sites, during 12 ODP/IODP Legs. As ocean bottom seawater is largely undersaturated with respect to gypsum, the porewater Ca content or its SO4 concentration, or both, must increase in order to reach equilibrium. At several sites equilibrium is reached either through the presence of evaporitic gypsum layers found in the sedimentary sequence, and/or through a salinity increase due to the presence of evaporitic brines with high concentrations of Ca and SO4. Saturation can also be reached in porewaters of seawater-like salinity (~ 35 per mil), provided sulfate reduction is limited. In this case, saturation is due to the alteration of volcanogenic material which releases large amounts of Ca to the porewaters, where the Ca concentration can reach 55 times its seawater value as for example at ODP Leg 134 site 833. At a few sites, saturation is reached in hydrothermal environments, or as a consequence of the alteration of the basaltic basement. In addition to the well known influence of brines on the formation of gypsum, these results indicate that the alteration of sediments rich in volcanogenic material is a major process leading to gypsum saturation in marine sediment porewaters. Therefore, the presence of gypsum in ancient and recent marine sediments should not be systematically interpreted as due to hypersaline waters, especially if volcanogenic material is present.

(Table 1) Heavy-mineral analyses for DSDP Leg 67 Holes from electron microprobe

Heavy and light minerals were examined in 29 samples from Sites 494, 498, 499, 500, and 495 on the Deep Sea Drilling Project Leg 67 Middle America Trench transect; these sites represent lower slope, trench, and oceanic crust environments off Guatemala. All samples are Quaternary except those from Hole 494A (Pliocene) and Hole 498A (Miocene). Heavy-mineral assemblages of the Quaternary sediments are characterized by an immature pyroxene-amphibole suite with small quantities of olivine and epidote. The Miocene sediments yielded an assemblage dominated by epidote and pyroxene but lacking olivine; the absence of olivine is attributed to selective removal of the most unstable components by intrastratal solution. Light-mineral assemblages of all samples are predominantly characterized by volcanic glass and plagioclase feldspar. The feldspar compositions are compatible with andesitic source rocks and frequently exhibit oscillatory zoning. The heavy- and light-mineral associations of these sediments suggest a proximal volcanic source, most probably the Neogene highland volcanic province of Guatemala. Sand-sized components from Site 495 are mainly biogenic skeletons and volcanic glass and, in one instance (Section 495-5-3), euhedral crystals of gypsum.

(Table 1) Counts and ratios of microfossils at DSDP Hole 64-480

We examined the relative abundance of various components in the coarse fraction (> 150 µm) from a selected portion of the DSDP Site 480 piston core. The components consist mainly of diatoms, radiolarians, benthic and planktonic foraminifers with minor amounts of sponge spicules, terrigenous material, volcanic glass(?), dehydrated gypsum crystals, and spines of unknown biological origin. The examination shows that the siliceous organisms abound in the laminated sediments and that the calcareous organisms are more abundant in the nonlaminated sediments. Seasonal upwelling is responsible for the deposition of laminated sediments. The upwelling creates a strong oxygen-minimum zone, restricting the occurrence of burrowing benthic organisms and benthic foraminifers.

(Table 1) Mineralogy at DSDP Leg 79 Holes

Four sites in the region of the Mazagan Plateau off northwest Africa were drilled during Leg 79 of the Deep Sea Drilling Project. Bulk mineralogy and clay mineralogy were analyzed from the Cenozoic sediments recovered from the four sites.

Geochemistry of the oceanic crust from ocean drilling samples

This book presents new data on chemical and mineral compositions and on density of altered and fresh igneous rocks from key DSDP and ODP holes drilled on the following main tectonomagmatic structures of the ocean floor: 1. Mid-ocean ridges and abyssal plains and basins (DSDP Legs 37, 61, 63, 64, 65, 69, 70, 83, and 91 and ODP Legs 106, 111, 123, 129, 137, 139, 140, 148, and 169); 2. Seamounts and guyots (DSDP Legs 19, 55, and 62 and ODP Legs 143 and 144); 3. Intraplate rises (DSDP Legs 26, 33, 51, 52, 53, 72, and 74 and ODP Legs 104, 115, 120, 121, and 183); and 4. Marginal seas (DSDP Legs 19, 59, and 60 and ODP Legs 124, 125, 126, 127, 128, and 135). Study results of altered gabbro from the Southwest Indian Ridge (ODP Leg 118) and serpentinized ultramafic rocks from the Galicia margin (ODP Leg 103) are also presented. Samples were collected by the authors from the DSDP/ODP repositories, as well as during some Glomar Challenger and JOIDES Resolution legs. The book also includes descriptions of thin sections, geochemical diagrams, data on secondary mineral assemblages, and recalculated results of chemical analyses with corrections for rock density. Atomic content of each element can be quantified in grams per standard volume (g/1000 cm**3). The suite of results can be used to estimate mass balance, but parts of the data need additional work, which depends on locating fresh analogs of altered rocks studied here. Results of quantitative estimation of element mobility in recovered sections of the upper oceanic crust as a whole are shown for certain cases: Hole 504B (Costa Rica Rift) and Holes 856H, 857C, and 857D (Middle Valley, Juan de Fuca Ridge).

Mineralogy at DSDP Sites 68-502 and 68-503

Eighty-four sediment samples from four holes at Site 502 and 54 samples from three holes at Site 503 were analyzed for mineral content by semiquantitative X-ray diffraction methods. Site 502 is located in the Western Caribbean, whereas Site 503 lies in the Eastern Pacific (probably on the north flank of the Galapagos Spreading Center). Both sites were chosen to yield continuous core sections for investigations of late Neogene and Quaternary biostratigraphy and magnetostratigraphy and to study events such as the closing of the Isthmus of Panama. Our X-ray diffraction work should provide a framework for further investigations - for example, determination of climatic changes in relationship to clay mineral composition or the influx of terrigeneous sediment components from South America before and after development of the Panama landbridge.

Mollusc biostratigraphy and Bolboforma abundance in sediments obtained near Gross Pampau, north Germany

A thirty-six meter thick section of Miocene mica clay of Gross Pampau was studied for molluscs and bolboformas. The molluscs define the regional substages of late Reinbekian to late Langenfeldian. The bolboformas enable the cross-correlation with the nannoplankton subdivision and the geological time scales of BERGGREN et al. (1995). New species are Periploma ariei, Ringicula tiedemanni, Bolboforma robusta badenensis, and Bolboforma contorta.

Abundance of plant macrofossils, mollusca and ostracoda in sediments obtained near Tessin, north Germany

A depression filled with Late Glacial and Holocene sediments was excavated during the geological exploration and recovery of a dump area near Tessin close to Rostock, and initiated the studies of the present paper. Pebble analysis of three exposed or respectively drilled till horizons as well as pollenanalytical, carpological and faunistical studies carried out allow the stratigraphical subdivision of the Quaternary sequence of the dump area. The basal till was probably the result of dead ice decay, and was lithostratigraphically assigned to the Pomerian Stage (qw2). The palynological results of boreholes RKS 19/93 and A/92 reveal pre-Allerod and other sediments instead of the expected interweichselian deposits. Based on the palynological and carpological findings, we correlated the beginning of the late glacial development in the locality with the end of the Meiendorf-lnterstadial sensu Menke in Bock et al. (1985, doi:10.3285/eg.35.1.18). The limnic-telmatic sedimentation could be observed pollen floristically probably starting with the Meiendorf-lnterstadial (Hippophae-Betula nana-phase) followed by the Bolling-(Betula nana-B. alba s.l.-Artemisia-Helianthemum-Poaceae-phase) and the Allerad-lnterstadial [Betula alba s.l.-(Pinus)-Cyperaceae-phase] lasting up to the Younger Dryas (Juniperus-Artemisia-Poaceae-phase). Sedimentation closed during the Younger Dryas with the accumulation of fine sands. It was reactivated later during the Holocene due to the anthropogene influence (Older and Younger Subatlantic, dampness of the depression by clearing).

Geochemistry and mineralogy of Eocene-Oligocene sediments of IODP Hole 302-M0002A

In 2004, Integrated Ocean Drilling Program Expedition 302 (Arctic Coring Expedition, ACEX) to the Lomonosov Ridge drilled the first Central Arctic Ocean sediment record reaching the uppermost Cretaceous (~430 m composite depth). While the Neogene part of the record is characterized by grayish-yellowish siliciclastic material, the Paleogene part is dominated by biosiliceous black shale-type sediments. The lithological transition between Paleogene and Neogene deposits was initially interpreted as a single sedimentological unconformity (hiatus) of ~26 Ma duration, separating Eocene from Miocene strata. More recently, however, continuous sedimentation on Lomonosov Ridge throughout the Cenozoic was proclaimed, questioning the existence of a hiatus. In this context, we studied the elemental and mineralogical sediment composition around the Paleogene-Neogene transition at high resolution to reconstruct variations in the depositional regime (e.g. wave/current activity, detrital provenance, and bottom water redox conditions). Already below the hiatus, mineralogical and geochemical proxies imply drastic changes in sediment provenance and/or weathering intensity in the hinterland, and point to the existence of another, earlier gap in the sediment record. The sediments directly overlying the hiatus (the Zebra interval) are characterized by pronounced and abrupt compositional changes that suggest repeated erosion and re-deposition of material. Regarding redox conditions, euxinic bottom waters prevailed at the Eocene Lomonosov Ridge, and became even more severe directly before the hiatus. With detrital sedimentation rates decreasing, authigenic trace metals were highly enriched in the sediment. This continuous authigenic trace metal enrichment under persistent euxinia implies that the Arctic trace metal pool was renewed continuously by water mass exchange with the world ocean, so the Eocene Arctic Ocean was not fully restricted. Above the hiatus, extreme positive Ce anomalies are clear signs of a periodically well-oxygenated water column, but redox conditions were highly variable during deposition of the Zebra interval. Significant Mn enrichments only occur above the Zebra interval, documenting the Miocene establishment of stable oxic conditions in the Arctic Ocean. In summary, extreme and abrupt changes in geochemistry and mineralogy across the studied sediment section do not suggest continuous sedimentation at the Lomonosov Ridge around the Eocene-Miocene transition, but imply repeated periods of very low sedimentation rates and/or erosion.