Forest disturbance map for the Carpathian ecoregion, 1984-2012

Detailed knowledge of forest cover dynamics is crucial for many applications from resource management to ecosystem service assessments. Landsat data provides the necessary spatial, temporal and spectral detail to map and analyze forest cover and forest change processes. With the opening of the Landsat archive, new opportunities arise to monitor forest dynamics on regional to continental scales. In this study we analyzed changes in forest types, forest disturbances, and forest recovery for the Carpathian ecoregion in Eastern Europe. We generated a series of image composites at five year intervals between 1985 and 2010 and utilized a hybrid analysis strategy consisting of radiometric change classification, post-classification comparison and continuous index- and segment-based post-disturbance recovery assessment. For validation of the disturbance map we used a point-based accuracy assessment, and assessed the accuracy of our forest type maps using forest inventory data and statistically sampled ground truth data for 2010. Our Carpathian-wide disturbance map achieved an overall accuracy of 86% and the forest type maps up to 73% accuracy. While our results suggested a small net forest increase in the Carpathians, almost 20% of the forests experienced stand-replacing disturbances over the past 25 years. Forest recovery seemed to only partly counterbalance the widespread natural disturbances and clear-cutting activities. Disturbances were most widespread during the late 1980s and early 1990s, but some areas also exhibited extensive forest disturbances after 2000, especially in the Polish, Czech and Romanian Carpathians. Considerable shifts in forest composition occurred in the Carpathians, with disturbances increasingly affecting coniferous forests, and a relative decrease in coniferous and mixed forests. Both aspects are likely connected to an increased vulnerability of spruce plantations to pests and pathogens in the Carpathians. Overall, our results exemplify the highly dynamic nature of forest cover during times of socio-economic and institutional change, and highlight the value of the Landsat archive for monitoring these dynamics.

Urban forest health survey on Roznik in Ljubljana in 2013 by two methods

Urban forest health was surveyed on Roznik in Ljubljana (46.05141 N, 14.47797 E) in 2013 by two methods: ICP Forests and UFMO. ICP Forests is most commonly used monitoring programme in Europe - the International Co-operative Programme on the Assessment and Monitoring of Air Pollution Effects on Forests, which is based on systematic grid. UFMO method - Urban Forests Management Oriented method was developed in the frame of EMoNFUr Project - Establishing a monitoring network to assess lowland forest and urban plantations in Lombardy and urban forest in Slovenia (LIFE10 ENV/IT/000399). UFMO is based on non-linear transects (GPS tracks). ICP forests monitoring plots were established in July 2013 in the urban forest Roznik in Ljubljana .The 32 plots are located on sampling grid 500 × 500 m. The grid was down-scaled from the National Forest Monitoring survey, which bases on national sample grid 4 × 4 km. With the ICP forests method the following parameters for each tree within the 15 plots were gathered according to the ICP forests manual for Visual assessment of crown condition and damaging agents: tree species, percentage of defoliation, affected part of the tree, specification of affected part, location in crown, symptom, symptom specification, causal agents / factors, age of damage, damage extent, and damage extent on the trunk. With the UFMO method, the following parameters for each tree that needed sylviculture measure (felling, pruning, sanitary felling, thinning, etc.) were recorded: tree species, breast diameter, causal agent / damaging factor, GPS waypoint and GPS track. For overall picture in the urban forest health problems, also other biotic and abiotic damaging factors that did not require management action were recorded.

Sampling sites, sampled birds and plants of young larch plantations in Tokachi district, eastern Hokkaido, northern Japan, 2011

Models and data used to describe species-area relationships confound sampling with ecological process as they fail to acknowledge that estimates of species richness arise due to sampling. This compromises our ability to make ecological inferences from and about species-area relationships. We develop and illustrate hierarchical community models of abundance and frequency to estimate species richness. The models we propose separate sampling from ecological processes by explicitly accounting for the fact that sampled patches are seldom completely covered by sampling plots and that individuals present in the sampling plots are imperfectly detected. We propose a multispecies abundance model in which community assembly is treated as the summation of an ensemble of species-level Poisson processes and estimate patch-level species richness as a derived parameter. We use sampling process models appropriate for specific survey methods. We propose a multispecies frequency model that treats the number of plots in which a species occurs as a binomial process. We illustrate these models using data collected in surveys of early-successional bird species and plants in young forest plantation patches. Results indicate that only mature forest plant species deviated from the constant density hypothesis, but the null model suggested that the deviations were too small to alter the form of species-area relationships. Nevertheless, results from simulations clearly show that the aggregate pattern of individual species density-area relationships and occurrence probability-area relationships can alter the form of species-area relationships. The plant community model estimated that only half of the species present in the regional species pool were encountered during the survey. The modeling framework we propose explicitly accounts for sampling processes so that ecological processes can be examined free of sampling artefacts. Our modeling approach is extensible and could be applied to a variety of study designs and allows the inclusion of additional environmental covariates.