(Table II, page 668-669) Distribution of elements between minerals soluble in 1M Hydroxylamine hydrochloride (Reducible); in 1m HCL (Acid-soluble) and in the insoluble residue of manganese nodules

Attempts to classify pelagic sediments have been based either on appearance and composition, or on the ultimate origin of the components. In particular it appears feasible to distinguish minerals which crystallized in sea-water from those which formed in magmas, in hydrothermal solution, or by weathering under acidic conditions. It is the case of iron and manganese oxide mineral aggregates which constitute one of the major types of rock encountered on the ocean floor; according to Menard (unpublished) about 10% of the pelagic area of the Pacific is covered by such nodules. The nodules consist of intimately intergrown crystallites of different minerals among those identified, besides detrital minerals and organic matter, are opal, goethite, rutile, anatase, barite, nontronite, and at least three manganese oxide minerals of major importance. Arrhenius and Korkisch (1959) have attempted to separate from each other the different minerals constituting the nodules, in order to establish the details of their structure and the localization of the heavy metal ions. The results demonstrate (Table II) that copper and nickel are concentrated in the manganese oxide phases concentrated in the reducible fraction. Cobalt, part of the nickel and most of the chromium are distributed between these and the acid-soluble group of the non-manganese minerals, dominated by goethite and disordered FeOOH.

Chemical composition of rocks and minerals from the ophiolite complex in the Hunter Fracture Zone

A collection of dredge samples from the Hunter Fracture Zone includes holocrystalline massive and cumulose basic and ultrabasic rocks and volcanites of the ophiolite complex: from basalts to rhyolites. The ultrabasic rocks are largely serpentinized harzburgites and lherzolites; their relict mineralogy is typical of peridotite considered to be the refractory residue of partial melting of the mantle. Cumulate textured ultramafic rocks probably are related to the cumulate gabbro and granodiorite rather than to the residual mantle material. The gabbroic rocks are dominantly cumulate textured Pl-Opx-Cpx±Ol gabbronorite and Pl-Cpx±Ol gabbros; the mineral features of these rocks are the result of their crystallization at moderate pressure (in a moderate level magma chamber). The massive Pl-Cpx±Ol gabbros are less common. Green and brown-green Ca-amphibole has partially or totally replaced the clinopyroxene in many samples. There is an overlap in mineral chemistry between the cumulate rocks and the Opx-Cpx-Pl volcanic rocks and boninites. It is interpreted as an indication that the cumulate rocks were co-genetic with Opx-Cpx-Pl volcanic rocks and that they both constitute remnants of an island arc volcanic-plutonic series. The petrologic evidence indicates that ophiolite gabbroic rocks were derived from an island-arc rather than from a mid-ocean ridge.

Facies and diagenesis of organic matter in sediments at DSDP Leg 87

A series of upper Pliocene to Pleistocene sediment samples from DSDP Sites 582 and 583 (Nankai Trough, active margin off Japan) were investigated by organic geochemical methods including organic carbon determination, Rock- Eval pyrolysis, gas chromatography of extractable hydrocarbons, and kerogen microscopy. The organic carbon content is fairly uniform and moderately low (0.35 to 0.77%) at both sites, although accompanied by high sedimentation rates. The low organic matter concentrations are the result of the combined effect of several factors: low bioproductivity, oxic depositional environment, and dilution with lithogenic material. Organic petrography revealed a mixture of three maceral types: (1) fresh, green fluorescent alginites of aquatic origin probably transported by turbidites from the shelf edge, (2) gelified huminites and paniculate liptinites derived from the erosion of unconsolidated peat, and (3) highly reflecting inertinites derived from continental erosion. By a combination of organic petrography and Rock-Eval pyrolysis results, the organic matter is characterized as mainly type III kerogen with a slight tendency to a mixed type II-III. During Rock-Eval pyrolysis, a mineral matrix effect on the generated hydrocarbons was observed. The organic matter in all sediments has a low level of maturity (below 0.45% Rm) and has not yet reached the onset of thermal hydrocarbon generation according to several geochemical maturation parameters. This low maturity is in contrast to anomalously high extract yields at both sites and large hydrocarbon proportions in the extracts at Site 583. This contrast may be due to early generation of polar compounds and perhaps redistribution of hydrocarbons caused by subduction tectonics. Carbon isotope data of the interstitial hydrocarbon gases indicate their origin from bacterial degradation of organic matter, although only very few bacterially degraded maceral components were detected.

Humic acids in bottom sediments of the Western Pacific

Elemental composition, functional groups, and molecular mass distribution were determined in humic acids from the Western Pacific abyssal and coastal bottom sediments. Humic acid structure was studied by oxidative degradation with alkaline nitrobenzene and potassium permanganate, p-coumaric, guaiacilic, and syringilic structural units typical for lignin of terrestrial plants were identified in humic acids by chromatographic analysis of oxidation products. Polysubstituted and polycondensed aromatic systems with minor proportion of aliphatic structures were basic structural units of humic acids in abyssal sediments.

Element abundances and Nd isotopic composition in boninite and tholeiite from DSDP Hole 60-458

Boninites are unusual high MgO-high SiO2 volcanic rocks found in several western Pacific island arcs. Their high Mg/(Mg + total Fe) (0.55-0.83) and compatible element contents (Ni = 70-450 ppm, Cr = 200-1800 ppm) indicate equilibration with mantle peridotite, but their low TiO2 contents (0.1-0.5%) indicate severe depletion of this source. K, Rb, Sr and Ba abundances in boninites are typical of primitive arc basalts, but ratios such as Ti/Zr and La/Yb are variable (Ti/Zr = 23-67, (La/Yb)e.f. = 0.6-4.7). Evidence for both enrichment and depletion of incompatible elements suggests that boninites are derived from refractory peridotite which has been metasomatically enriched in LREE, Zr, Sr, Ba and alkalis. Wide variations in 143Nd/144Nd (0.51262-0.51296) are correlated with La/Sm, Sm/Nd and Ti/Zr, which enables identification of components in the boninite source. Possible LREE depleted components have relative REE and Ti abundances like those in depleted peridotites and high 143Nd/144Nd ratios which reach MORB-like values. Possible LREE enriched components have relative REE abundances similar to those in metasomatized mantle peridotite nodules, and low 143Nd/144Nd ratios which indicate either sedimentary sources or mantle sources with recent to ancient LREE enrichment. Relative abundances of Ba and Sr in boninites decrease with increasing LREE enrichment and suggest a non-sedimentary source for the LREE enriched material. Enrichment in Ba, Sr and alkalis may result from a third component derived from subducted oceanic crust. Two models can account for the successive generation of boninites and arc tholeiites within a single area: 1) boninites can be derived from the peridotite residue of earlier arc tholeiite generation which is metasomatically enriched in LREE before boninite volcanism, or 2) arc tholeiites and boninites can be derived from a variably depleted peridotite source which has been pervasively enriched in LREE. Areas of fertile peridotite would yield tholeiites while refractory areas would yield boninites.

(Table 1) Percentage of non-opaque heavy minerals, heavy residue, magnetite, and opaque heavy minerals, DSDP Sites 58-445 and 58-446

Heavy-mineral analyses were made for 39 samples, 27 from DSDP Site 445 and 12 from Site 446. About one-fourth of the samples were so loose that they were easily disaggregated in water. The amount of heavy residue and the magnetite content of the heavy fraction were very high, 0.2 to 44 per cent and (on the average) more than 20 per cent, respectively. Among the non-opaque heavy minerals, common hornblende (0 to 80%) and augite (0 to 98%) are most abundant. Pale-green and bluish-green amphiboles (around 10%) and the epidote group (a few to 48%) are next in abundance. Euhedral apatite and biotite and irregularly shaped chromite are not abundant, but are present throughout the sequence. Hacksaw structure is developed in pale-green amphibole and augite. At Site 445, a fair amount of chlorite and a few glauconite(?) grains are present from Core 445-81 downward. The content of common hornblende and opaque minerals also changes from Core 445-81 downward. A geological boundary may exist between Cores 445-77 and 445-81. Source rocks of the sediments at both sites were basaltic volcanic rocks (possibly alkali suite), schists, and ultramafic rocks. The degree of lithification and amount of heavy residue, and the content of magnetite, non-opaque heavy minerals (excluding mafic minerals), and mafic minerals in the cores were compared with Eocene, Oligocene, and Miocene sandstones of southwest Japan. In many respects, the sediments at Sites 445 and 446 are quite different from those of southwest Japan. From the early Eocene to the early Miocene, the area of these sites belonged to a different geologic province than southwest Japan.