Thermal conductivity at DSDP Leg 60 Holes

A total of 1547 thermal conductivity values were determined by both the NP (needle probe method) and the QTM (quick thermal conductivity meter) on 1319 samples recovered during DSDP Leg 60. The NP method is primarily for the measurement of soft sedimentary samples, and the result is free from the effect of porewater evaporation. Measurement by the QTM method is faster and is applicable to all types of samples-namely, sediments (soft, semilithified, and lithified) and basement rocks. Data from the deep holes at Sites 453, 458, and 459 show that the thermal conductivity increases with depth, the rate of increase ranging from (0.18 mcal/cm s °C)/100 m at Site 459 to (0.72 mcal/cm s °C)/100 m at Site 456. A positive correlation between the sedimentary accumulation rate and the rate of thermal conductivity increase with depth indicates that both compaction and lithification are important factors. Drilled pillow basalts show nearly uniform thermal conductivity. At She 454 the thermal conductivity of one basaltic flow unit was higher near the center of the unit and lower toward the margin, reflecting variable vesicularity. Hydrothermally altered basalts at Site 456 showed higher thermal conductivity than fresh basalt because secondary calcite, quartz, and pyrite are generally more thermally conductive than fresh basalt. The average thermal conductivity in the top 50 meters of sediments correlates inversely with water depth because of dissolution of calcite, a mineral with high thermal conductivity, from the sediments as the water depth exceeds the lysocline and the carbonate compensation depth. Differences between the Mariana Trench data and the Mariana Basin and Trough data may reflect different abundances of terrigenous material in the sediment. There are remarkable correlations between thermal conductivity and other physical properties. The relationship between thermal conductivity and compressional wave velocity can be used to infer the ocean crustal thermal conductivity from the seismic velocity structure.

Interstitial water chemsitry at DSDP Leg 60 Holes

Interstitial water data obtained during Leg 60 show complex gradients at Site 453 in a sediment pond on the west side of the Mariana Trough. Concentrations of Ca, Mg, Sr, as well as of K and Li, suggest that slightly altered sea water penetrates below the sediments, most likely through brecciated igneous and metamorphic rocks, mainly gabbros, lying at the base of the pond. Interstitial water concentration gradients suggest that reactions involving igneous matter lead to increases in calcium and strontium in the pore fluids and to decreases in magnesium. Upward advection of water through the sediments does not appear to occur, so that the advected sea water most likely penetrates deeper into the breccias, perhaps leading to further hydrothermal activity elsewhere in this area. Interstitial water gradients at Sites 458 (conservative) and 459 suggest that reactions in the sediments and underlying basalts are responsible for increases in dissolved calcium and decreases in magnesium and potassium.

Description and chemical composition of ferromanganese encrustations and deposits in the Atlantic Ocean from R/V Atlantis II cruises 20, 42, 60, 85; R/V Chain cruise 35; R/V Knorr cruise 61 and RRS Shackleton cruise 75/1 stations

Chemical and mineralogical compositions of ferromanganese oxide coatings on rocks dredged from the New England Seamounts, the Sierra Leone Rise and the Mid-Atlantic Ridge near the Equator have been determined in an investigation of regional differences in Atlantic ferromanganese deposits. Most encrustations are clearly of hydrogenous origin, consisting mainly of todorokite and delta MnO2, but several recovered from the equatorial fracture zones may be hydrothermal accumulations. Differences in the chemistry of the water column and in growth rates of the ferromanganese coatings may be important in producing this regional contrast in composition. Fine-scale changes in element abundances within the encrustations indicate that the nature of the substrate has little influence on compositional variations.