Geochemical investigation and determination of hiatuses on Voering Plateau sediment records

The sediments recovered on ODP Leg 104 have been reported to be characterized by hiatuses. The hiatuses were defined by biostratigraphy and were believed to be caused by erosion related to temporary changes of bottom current composition and velocity. They have been associated with major paleoenvironmental changes, reorganization of global deep water production, and increased bottom water flows. Because of the importance of hiatuses for ongoing research, we decided to closely investigate the sedimentation history for the most significant Pliocene and Miocene biostratigraphic hiatuses by sedimentologic and geochemical means. The sedimentologic studies include clay mineral distributions, grain size data, and organic carbon concentrations. The geochemical studies include determination of 87/86Sr ratios, 10Be and Ir concentrations. The results of the sedimentologic studies suggest either that paleoenvironmental changes associated with hiatuses are not represented in the preserved sediments, or that the hiatuses are an artifact of interpretation of the biostratigraphic data. Strontium isotopes indicate continuous sedimentation for the interval investigated at Site 642, an interpretation confirmed by the steady decline in 10Be. 87/86Sr ratios in the interval from above and below proposed hiatuses H 2.2/2.3 and H2.1/2.2 at Site 643 display stronger changes with depth than expected by steady sedimentation. Ir data for this same interval indicate reduced sedimentation rates. Combining both, sedimentologic and geochemical evidence, the proposed hiatuses could not be confirmed and may represent preservation artifacts.

Occurrence and chemistry of microtektites of ODP Site 121-758

The Toba lake event, the Australasian microtektite event, and the Cretaceous/Paleogene boundary were analyzed on the basis of foraminifers, carbonate content, trace elements, and spherules (microtektites). The Toba ash event, recovered in Hole 758C, may have had minor influences on the foraminiferal populations. The Australasian tektite event has probably some influence on foraminiferal ecology, because the larger specimens become scarce just above the microtektite layer. Microtektites recovered from Hole 758B closely resemble spherules recovered from several Cretaceous/Paleogene boundary localities in North America. The Cretaceous/Paleogene spherules, however, are usually larger and are completely altered to goyazite in the terrestrial environment and to smectite in a marine environment. The Cretaceous/Paleogene boundary of Hole 752B does not show obvious anomalous trace-element concentrations, and iridium concentrations are below our detection limits. The trace-element pattern is dominated by the alternation of chalk with volcanic ash layers above the Cretaceous/Paleogene boundary.

(Table 1) Elemental abundances in DSDP Core 86-577B-1

An Ir anomaly of 61 ng/cm**2 was found in Deep Sea Drilling Project Hole 577B at the same stratigraphic level as the Cretaceous/Tertiary boundary defined by nannoplankton. This close correspondence supports the asteroid-impact theory for the Cretaceous/Tertiary boundary extinctions.

Bromine and iodine concentrations in sediments and pore fluids of ODP Leg 112

At the Peruvian convergent margin, two distinct pore fluid regimes are recognized from differences in their Cl- concentrations. The slope pore fluids are characterized by low Cl- concentrations, but elevated Br- and I- concentrations due to biogenic production. The shelf pore fluids exhibit elevated Cl- and Br- concentrations due to diffusive mixing with an evaporitic brine. In the slope pore fluids, the Br-, I-, and NH4+ concentrations are elevated following bacterial decomposition of organic matter, but the I- concentrations are in excess of those expected based on mass balance calculations using NH4+ and Br- concentrations. The slope sediment organic matter, which is enriched in iodine from oxidationreduction processes at the oxygenated sediment-water interface, is responsible for this enrichment. The increases in dissolved I- and the I- enrichments relative to NH4+ and Br- correlate well with sedimentation rates because of differential trapping following regeneration. The pore-fluid I-/Br- ratios suggest that membrane ion fiitration is not a major cause of the decreases in Cl- concentrations. Other possible sources for low Cl- water, including meteoric water, clathrate dissociation, and/or mineral dehydration reactions, imply that the diluting component of the slope low-Cl- fluids has flowed at least 1 km through the sediment. The low bottom-water oxygenation in the shelf is responsible for the low (if any) enrichment of iodine in the shelf sediments. Fluctuations in bottom-water oxygen concentrations in the past, however, may be responsible for the observed variations in the sediment I/Br ratios. Comparison of Na+/Cl- and Br-/Cl- molar ratios in the pore fluids shows that the shelf high-Cl- fluid formed from mixing with a brine that formed from seawater concentrated by twelve to nineteen times and probably was modified by halite dissolution. This dense brine, located below the sediment sections drilled, appears to have flowed a distance >500 km through the sediment.

Chemical composition and fluxes of deep sea suspended matter within and over the 9°50'N hydrothermal field, EPR

Results of geochemical studies of suspended matter from the water mass over the hydrothermal field at 9°50'N on the East Pacific Rise are reported. The suspended matter was sampled in background waters, in the buoyant plume, and in the near-bottom waters. Contents of Si, Al, P, Corg, Fe, Mn, Cu, Zn, Ni, Co, As, Cr, Cd, Pb, Ag, and Hg were determined. No definite correlations were found between the elements in the background waters. Many of the chemical elements correlated with Fe and associated with its oxyhydroxides in the buoyant plume. In the near-bottom waters trace elements are associated with Fe, Zn, and Cu (probably, with their sulfides formed during mixing of hydrothermal fluids with seawater). Chemical composition of sediment matter precipitated in a sediment trap was similar to the near-bottom suspended matter.

Permeability measurements on sheared and unsheared samples from different IODP Holes of Leg 316 and from IODP Hole 315-C0001E and ODP Hole 190-1174B

At subduction zones, the permeability of major fault zones influences pore pressure generation, controls fluid flow pathways and rates, and affects fault slip behavior and mechanical strength by mediating effective normal stress. Therefore, there is a need for detailed and systematic permeability measurements of natural materials from fault systems, particularly measurements that allow direct comparison between the permeability of sheared and unsheared samples from the same host rock or sediment. We conducted laboratory experiments to compare the permeability of sheared and uniaxially consolidated (unsheared) marine sediments sampled during IODP Expedition 316 and ODP Leg 190 to the Nankai Trough offshore Japan. These samples were retrieved from: (1) The décollement zone and incoming trench fill offshore Shikoku Island (the Muroto transect); (2) Slope sediments sampled offshore SW Honshu (the Kumano transect) ~ 25 km landward of the trench, including material overriden by a major out-of-sequence thrust fault, termed the "megasplay"; and (3) A region of diffuse thrust faulting near the toe of the accretionary prism along the Kumano transect. Our results show that shearing reduces fault-normal permeability by up to 1 order of magnitude, and this reduction is largest for shallow (< 500 mbsf) samples. Shearing-induced permeability reduction is smaller in samples from greater depth, where pre-existing fabric from compaction and lithification may be better developed. Our results indicate that localized shearing in fault zones should result in heterogeneous permeability in the uppermost few kilometers in accretionary prisms, which favors both the trapping of fluids beneath and within major faults, and the channeling of flow parallel to fault structure. These low permeabilities promote the development of elevated pore fluid pressures during accretion and underthrusting, and will also facilitate dynamic hydrologic processes within shear zones including dilatancy hardening and thermal pressurization.

(Table 1) Platinum group element abundanves in ODP Leg 135 samples

Ocean Drilling Program Leg 135 backarc basin lavas are characterized by anomalously high Au contents (1.0-11.4 ppb) and strongly fractionated relative platinum group element (PGE) abundances (Pd/Ir ratio, approximately 100). The Rh and Ir contents are very low, ranging from below detection (approximately 0.02 ppb) to 0.08 ppb. The Pd and Pt contents range from <0.3 to 4 ppb. Rh, Pd, and Pt values are consistently and significantly higher in Site 836 and 839 samples relative to those from Sites 834 and 835. Major, trace, and rare earth element (REE) data suggest Sites 836 and 839 have a more pronounced arc signature than Sites 834 and 835. No correlation exists between noble metal abundance and indices of alteration or fractionation (e.g., loss on ignition (LOI), Mg#, and Cr or Ni contents), suggesting that measured values and ratios are primary and reflect characteristics of the mantle source. The evaluation of Leg 135 noble metal data with respect to potential mantle-source components is hindered by the lack of data on magmas derived from such sources. However, analyses of the limited available data for the different magma types suggest that the characteristic enrichment of Leg 135 lavas in Au, relative to Pd and Cu, cannot be derived solely from simple MORB-type or ocean-island-type mantle, or mantle depleted by a previous melt extraction event. The Au-enriched signature of the Lau basin lavas could, however, be produced through the addition of a sedimentary component from the downgoing slab. Separation of Au from the PGE occurs within oceanic hydrothermal systems and gold values of the resultant precipitates are 2-3 orders of magnitude higher than other oceanic crustal components. Even small additions of this component from the downgoing oceanic crust to a supra-subduction zone mantle melt could account for the high mean Au/Pd ratios of the Leg 135 samples (Sites 834 and 835, Au/Pd = 5.04; Sites 836 and 839, Au/Pd = 2.26).

Aerosols in the Arctic

In this monograph on the basis of materials obtained by the author and his colleagues in Arctic expeditions of 1991-2005 and of published data results of studies effect of aerosols on environmental conditions and marine sedimentation in the Arctic are summarizes. Processes of aeolian transport and transformation of sedimentary material from sources to places of its accumulation in bottom sediments are described. Results of this study can be used to assess current state of ecosystem of Arctic seas and as a background for evaluation of possible human impact on nature during exploration of mineral resources of the Arctic shelf. For oceanographers, geochemists, geoecologists.

Average compositions and analyses range for clinopyroxene, olivines, orthopyroxene, and spinel from the MARK area at DSDP Site 45-395A, and ODP Site 153-920

Mineral compositions of residual peridotites collected at various locations in the Mid-Atlantic Ridge south of the Kane transform (MARK area) are consistent with generally smaller degrees of melting in the mantle near the large offset Kane transform than near the other, small offset, axial discontinuities in the area. We propose that this transform fault effect is due to along-axis variations in the final depth of melting in the subaxial mantle, reflecting the colder thermal regime of the ridge near the Kane transform. Calculations made with a passive mantle flow regime suggest that these along-axis variations in the final depth of melting would not produce the full range of crustal thickness variations observed in the MARK area seismic record. It is therefore likely that the transform fault effect in the MARK area is combined with other mechanisms capable of producing crustal thickness variations, such as along-axis melt migration, the trapping of part of the magma in a cold mantle root beneath the ridge, or active mantle upwelling.

The MEDESS-GIB drifters database

On September 9th 2014, an intensive drifter deployment was carried out in the Strait of Gibraltar. In the frame of the EU MED Program MEDESS-4MS, the MEDESS-GIB experiment consisted of the deployment of 35 satellite tracked drifters, mostly of CODE-type, equipped with temperature sensor sampling at a rate of 30 minutes. Drifters were distributed along and on both sides of the Strait of Gibraltar. The MEDESS-GIB deployment plan was designed as to ensure quasi-synoptic spatial coverage. To this end, 4 boats covering an area of about 680 NM2 in 6 hours were coordinated. As far as authors know, this experiment is the most important exercise in the area in terms of number of drifters released. Collected satellite-tracked data along drifter trajectories have been quality controlled and processed to build the here presented MEDESS-GIB data set.

Geochemistry of DSDP Hole 86-577B samples

THE chemical, mineralogical and isotopic characteristics of deposits at the Cretaceous/Tertiary (K/T) boundary are suggestive of a large impact event, the prime candidate (Sharpton et al., 1992, doi:10.1038/359819a0) being the Chicxulub crater in Yucatan, Mexico. Spinel-bearing spherules, which may be associated with such impacts, have been reported (Smit and Romein, 1985, doi:10.1016/0012-821X(85)90019-6) at several K/T boundary sites worldwide, but their origin is still uncertain. We have examined the spinel-bearing material recovered from K/T boundary deposits at site 577 in the Pacific Ocean (Heath et al., 1985, doi:10.2973/dsdp.proc.86.104.1985) and find two distinct populations of particles: spherules with dendritic spinel textures dispersed throughout the grains and irregularly shaped fragments with spinels essentially confined to the rim. The morphology and composition of the particles are characteristic of melted and partially melted meteoritic ablation debris, but their location is difficult to reconcile with an impact on the Yucatan peninsula, some 10,000 km away. We suggest instead that the spinel-bearing particles at site 577 are derived from the impact of a 2-km asteroid in the Pacific Ocean, and that several accretionary events of this type are required to explain the global distribution of spinel-bearing spherules at the K/T boundary.

Description, geochemistry, mineralogy and isotopes of sulfides from ODP Site 193-1189, PACMANUS field

Chemical and isotopic data for rare massive and semimassive sulfide samples cored at Site 1189 (Roman Ruins, PACMANUS) suggest their genetic relationship with sulfide chimneys at the seafloor. Sand collected from the hammer drill after commencement of Hole 1189B indicates that at least the lower section of the cased interval was occupied by material similar to the stockwork zone cored from 31 to ~100 meters below seafloor (mbsf) in this hole, but with increased content of barite, sphalerite, and lead-bearing minerals. Fractional crystallization of ascending hydrothermal fluid involving early precipitation of pyrite may explain vertical mineralogical and chemical zoning within the stockwork conduit and the high base and precious metal contents of Roman Ruins chimneys. A mineralized volcaniclastic unit cored deep in Hole 1189A possibly represents the lateral fringe of the conduit system. Lead isotope ratios in the sulfides differ slightly but significantly from those of fresh lavas from Pual Ridge, implying that at least some of the Pb within the Roman Ruins hydrothermal system derived from a deeper, more radiogenic source than the enclosing altered volcanic rocks.