Compilation of scientific results of the OASIS project

Seamounts are of great interest to science, industry and conservation because of their potential role as 'stirring rods' of the oceans, their enhanced productivity, their high local biodiversity, and the growing exploitation of their natural resources. This is accompanied by rising concern about the threats to seamount ecosystems, e.g. through over-fishing and the impact of trawling. OASIS described the functioning characteristics of seamount ecosystems. OASIS' integrated hydrographic, biogeochemical and biological information. Based on two case studies. The scientific results, condensed in conceptual and mass balanced ecosystem models, were applied to outline a model management plan as well as site-specific management plans for the seamounts investigated. OASIS addressed five main objectives: Objective 1: To identify and describe the physical forcing mechanisms effecting seamount systems Objective 2: To assess the origin, quality and dynamics of particulate organic material within the water column and surface sediment at seamounts. Objective 3: To describe aspects of the biodiversity and the ecology of seamount biota, to assess their dynamics and the maintenance of their production. Objective 4: Modelling the trophic ecology of seamount ecosystems. Objective 5: Application of scientific knowledge to practical conservation.

Ferromagnetic fraction of Cretaceous and Cenozoic sediments at DSDP Holes 72-515B and 72-516F

Investigation of the ferromagnetic fraction of sediments from the Brazil Basin and Rio Grande Rise shows that its main constituents are magnetite and hematite. The magnetite is detrital, but the hematite is both detrital and chemical in origin. Magnetite is the main carrier of the natural remanent magnetization (NRM); therefore, the NRM is detrital remanent magnetization (DRM). In a number of cases, the change of magnetic parameters along the stratigraphic column permits some refinement of the previously defined boundaries of the lithologic units.

Micro-granulometry of sedimentary dykes, Kathmandu basin, Nepal

Soft-sediment deformation structures have been analyzed at six sites of the Kathmandu valley. Microgranulometric study (this Supplement and Fig. 3B of Mugnier et al., Tectonophysics, 2011) reveals that silty levels (60 to 80% silt) favor the development of soft-sediment deformation structures, while sandy levels (60 to 80% sand) are passively deformed. Nonetheless well sorted sand levels (more than 80% sand) generate over-fluid pressure during compaction if located beneath a silty cap, leading to fluidization and dike development. 3-D geometry of seismites indicates a very strong horizontal shearing during their development. Using a physical approach based on soil liquefaction during horizontal acceleration, we show that the fluidization zone progressively grows down-section during the shaking, but does not exactly begin at the surface. The comparison of bed-thickness and strength/depth evolution indicates three cases: i) no soft-sediment deformation occurs for thin (few centimeters) silty beds; ii) the thickness of soft-sediment deformation above sandy beds is controlled by the lithological contrast; iii) the thickness of soft-sediment deformation depends on the shaking intensity for very thick silty beds. These 3 cases are evidenced in the Kathmandu basin. We use the 30 cm-thick soft-sediment deformation level formed during the 1833 earthquake as a reference: the 1833 earthquake rupture zone extended very close to Kathmandu, inducing there MMI IX-X damages. A 90 cm-thick sediment deformation has therefore to be induced by an event greater than MMI X. From a compilation of paleo and historic seismology studies, it is found that the great (M ~ 8.1) historical earthquakes are not characteristic of the greatest earthquakes of Himalaya; hence earthquakes greater than M ~ 8.6 occurred. Kathmandu is located above one of the asperities that laterally limits the extent of mega-earthquake ruptures and two successive catastrophic events already affected Kathmandu, in 1255 located to the west of this asperity and in ~ 1100 to the east.

Finely dispersed fraction of particulate organic matter and primary production in sea water of the Equatorial East Pacific

Qualitative and quantitative evaluation of the finely dispersed fraction of particulate organic matter in sea water is given. It is demonstrated that in the euphotic zone of high productivity waters this fraction constitutes 86%, in waters with low productivity 61%, and in deep waters (>200 m) 53% of the organic carbon in particulate matter. Formation of the finely dispersed fraction and its role in distribution of energy in the detrital food chain of the ecosystem are discussed.

Grain-size distributions of the terrigenous fraction of two deep-sea sediment cores GeoB3375-1 and MD96-2094

In this study, we present grain-size distributions of the terrigenous fraction of two deep-sea sediment cores from the SE Atlantic (offshore Namibia) and from the SE Pacific (offshore northern Chile), which we 'unmix' into subpopulations and which are interpreted as coarse eolian dust, fine eolian dust, and fluvial mud. The downcore ratios of the proportions of eolian dust and fluvial mud subsequently represent paleocontinental aridity records of southwestern Africa and northern Chile for the last 120,000 yr. The two records show a relatively wet Last Glacial Maximum (LGM) compared to a relatively dry Holocene, but different orbital variability on longer time scales. Generally, the northern Chilean aridity record shows higher-frequency changes, which are closely related to precessional variation in solar insolation, compared to the southwestern African aridity record, which shows a remarkable resemblance to the global ice-volume record. We relate the changes in continental aridity in southwestern Africa and northern Chile to changes in the latitudinal position of the moisture-bearing Southern Westerlies, potentially driven by the sea-ice extent around Antarctica and overprinted by tropical forcing in the equatorial Pacific Ocean.

Quantitative component analysis of the coarse fraction of surface sediments from the Persian Gulf

In the Persian Gulf and the Gulf of Oman marl forms the primary sediment cover, particularly on the Iranian side. A detailed quantitative description of the sediment components > 63 µ has been attempted in order to establish the regional distribution of the most important constituents as well as the criteria governing marl sedimentation in general. During the course of the analysis, the sand fraction from about 160 bottom-surface samples was split into 5 phi° fractions and 500 to 800 grains were counted in each individual fraction. The grains were cataloged in up to 40 grain type catagories. The gravel fraction was counted separately and the values calculated as weight percent. Basic for understanding the mode of formation of the marl sediment is the "rule" of independent availability of component groups. It states that the sedimentation of different component groups takes place independently, and that variation in the quantity of one component is independent of the presence or absence of other components. This means, for example, that different grain size spectrums are not necessarily developed through transport sorting. In the Persian Gulf they are more likely the result of differences in the amount of clay-rich fine sediment brought in to the restricted mouth areas of the Iranian rivers. These local increases in clayey sediment dilute the autochthonous, for the most part carbonate, coarse fraction. This also explains the frequent facies changes from carbonate to clayey marl. The main constituent groups of the coarse fraction are faecal pellets and lumps, the non carbonate mineral components, the Pleistocene relict sediment, the benthonic biogene components and the plankton. Faecal pellets and lumps are formed through grain size transformation of fine sediment. Higher percentages of these components can be correlated to large amounts of fine sediment and organic C. No discernable change takes place in carbonate minerals as a result of digestion and faecal pellet formation. The non-carbonate sand components originate from several unrelated sources and can be distinguished by their different grain size spectrum; as well as by other characteristics. The Iranian rivers supply the greatest amounts (well sorted fine sand). Their quantitative variations can be used to trace fine sediment transport directions. Similar mineral maxima in the sediment of the Gulf of Oman mark the path of the Persian Gulf outflow water. Far out from the coast, the basin bottoms in places contain abundant relict minerals (poorly sorted medium sand) and localized areas of reworked salt dome material (medium sand to gravel). Wind transport produces only a minimal "background value" of mineral components (very fine sand). Biogenic and non-biogenic relict sediments can be placed in separate component groups with the help of several petrographic criteria. Part of the relict sediment (well sorted fine sand) is allochthonous and was derived from the terrigenous sediment of river mouths. The main part (coarse, poorly sorted sediment), however, was derived from the late Pleistocene and forms a quasi-autochthonous cover over wide areas which receive little recent sedimentation. Bioturbation results in a mixing of the relict sediment with the overlying younger sediment. Resulting vertical sediment displacement of more than 2.5 m has been observed. This vertical mixing of relict sediment is also partially responsible for the present day grain size anomalies (coarse sediment in deep water) found in the Persian Gulf. The mainly aragonitic components forming the relict sediment show a finely subdivided facies pattern reflecting the paleogeography of carbonate tidal flats dating from the post Pleistocene transgression. Standstill periods are reflected at 110 -125m (shelf break), 64-61 m and 53-41 m (e.g. coare grained quartz and oolite concentrations), and at 25-30m. Comparing these depths to similar occurrences on other shelf regions (e. g. Timor Sea) leads to the conclusion that at this time minimal tectonic activity was taking place in the Persian Gulf. The Pleistocene climate, as evidenced by the absence of Iranian river sediment, was probably drier than the present day Persian Gulf climate. Foremost among the benthonic biogene components are the foraminifera and mollusks. When a ratio is set up between the two, it can be seen that each group is very sensitive to bottom type, i.e., the production of benthonic mollusca increases when a stable (hard) bottom is present whereas the foraminifera favour a soft bottom. In this way, regardless of the grain size, areas with high and low rates of recent sedimentation can be sharply defined. The almost complete absence of mollusks in water deeper than 200 to 300 m gives a rough sedimentologic water depth indicator. The sum of the benthonic foraminifera and mollusca was used as a relative constant reference value for the investigation of many other sediment components. The ratio between arenaceous foraminifera and those with carbonate shells shows a direct relationship to the amount of coarse grained material in the sediment as the frequence of arenaceous foraminifera depends heavily on the availability of sand grains. The nearness of "open" coasts (Iranian river mouths) is directly reflected in the high percentage of plant remains, and indirectly by the increased numbers of ostracods and vertebrates. Plant fragments do not reach their ultimate point of deposition in a free swimming state, but are transported along with the remainder of the terrigenous fine sediment. The echinoderms (mainly echinoids in the West Basin and ophiuroids in the Central Basin) attain their maximum development at the greatest depth reached by the action of the largest waves. This depth varies, depending on the exposure of the slope to the waves, between 12 to 14 and 30 to 35 m. Corals and bryozoans have proved to be good indicators of stable unchanging bottom conditions. Although bryozoans and alcyonarian spiculae are independent of water depth, scleractinians thrive only above 25 to 30 m. The beginning of recent reef growth (restricted by low winter temperatures) was seen only in one single area - on a shoal under 16 m of water. The coarse plankton fraction was studied primarily through the use of a plankton-benthos ratio. The increase in planktonic foraminifera with increasing water depth is here heavily masked by the "Adjacent sea effect" of the Persian Gulf: for the most part the foraminifera have drifted in from the Gulf of Oman. In contrast, the planktonic mollusks are able to colonize the entire Persian Gulf water body. Their amount in the plankton-benthos ratio always increases with water depth and thereby gives a reliable picture of local water depth variations. This holds true to a depth of around 400 m (corresponding to 80-90 % plankton). This water depth effect can be removed by graphical analysis, allowing the percentage of planktonic mollusks per total sample to be used as a reference base for relative sedimentation rate (sedimentation index). These values vary between 1 and > 1000 and thereby agree well with all the other lines of evidence. The "pteropod ooze" facies is then markedly dependent on the sedimentation rate and can theoretically develop at any depth greater than 65 m (proven at 80 m). It should certainly no longer be thought of as "deep sea" sediment. Based on the component distribution diagrams, grain size and carbonate content, the sediments of the Persian Gulf and the Gulf of Oman can be grouped into 5 provisional facies divisions (Chapt.19). Particularly noteworthy among these are first, the fine grained clayey marl facies occupying the 9 narrow outflow areas of rivers, and second, the coarse grained, high-carbonate marl facies rich in relict sediment which covers wide sediment-poor areas of the basin bottoms. Sediment transport is for the most part restricted to grain sizes < 150 µ and in shallow water is largely coast-parallel due to wave action at times supplemented by tidal currents. Below the wave base gravity transport prevails. The only current capable of moving sediment is the Persian Gulf outflow water in the Gulf of Oman.