Crustal uplift rates of 4 GPS stations near Jakobshavn Isbrae (2006-2009)

We analyze 2006-2009 data from four continuous Global Positioning System (GPS) receivers located between 5 and 150 km from the glacier Jakobshavn Isbrae, West Greenland. The GPS stations were established on bedrock to determine the vertical crustal motion due to the unloading of ice from Jakobshavn Isbrae. All stations experienced uplift, but the uplift rate at Kangia North, only 5 km from the glacier front, was about 10 mm/yr larger than the rate at Ilulissat, located only ~45 km further away. This suggests that most of the uplift is due to the unloading of the Earth's surface as Jakobshavn thins and loses mass. Our estimate of Jakobshavn's contribution to uplift rates at Kangia North and Ilulissat are 14.6 ± 1.7 mm/yr and 4.9 ± 1.1 mm/yr, respectively. The observed rates are consistent with a glacier thinning model based on repeat altimeter surveys from NASA's Airborne Topographic Mapper (ATM), which shows that Jakobshavn lost mass at an average rate of 22 ± 2 km**3/yr between 2006 and 2009. At Kangia North and Ilulissat, the predicted uplift rates computed using thinning estimates from the ATM laser altimetry are 12.1 ± 0.9 mm/yr and 3.2 ± 0.3 mm/yr, respectively. The observed rates are slightly larger than the predicted rates. The fact that the GPS uplift rates are much larger closer to Jakobshavn than further away, and are consistent with rates inferred using the ATM-based glacier thinning model, shows that GPS measurements of crustal motion are a potentially useful method for assessing ice-mass change models.

Major and trace element composition of melts from the Gorely volcanic center, southern Kamchatka

Melt inclusions in olivine and plagioclase phenocrysts from rocks (magnesian basalt, basaltic andesite, andesite, ignimbrite, and dacite) of various age from the Gorely volcanic center, southern Kamchatka, were studied by means of their homogenization and by analyzing the glasses in 100 melt inclusions on an electron microprobe and 24 inclusions on an ion probe. The SiO2 concentrations of the melts vary within a broad range of 45-74 wt%, as also are the concentrations of other major components. According to their SiO2, Na2O, K2O, TiO2, and P2O5 concentrations, the melts are classified into seven groups. The mafic melts (45-53 wt% SiO2) comprise the following varieties: potassic (on average 4.2 wt% K2O, 1.7 wt% Na2O, 1.0 wt% TiO2, and 0.20 wt% P2O5), sodic (3.2% Na2O, 1.1% K2O, 1.1% TiO2, and 0.40% P2O5), and titaniferous with high P2O5 concentrations (2.2% TiO2, 1.1% P2O5, 3.8% Na2O, and 3.0% K2O). The melts of intermediate composition (53-64% SiO2) also include potassic (5.6% K2O, 3.4% Na2O, 1.0% TiO2, and 0.4% P2O5) and sodic (4.3% Na2O, 2.8% K2O, 1.3% TiO2, and 0.4% P2O5) varieties. The acid melts (64-74% SiO2) are either potassic (4.5% K2O, 3.6% Na2O, 0.7% TiO2, and 0.15% P2O5) or sodic (4.5% Na2O, 3.1% K2O, 0.7% TiO2, and 0.13% P2O5). A distinctive feature of the Gorely volcanic center is the pervasive occurrence of K-rich compositions throughout the whole compositional range (silicity) of the melts. Melt inclusions of various types were sometimes found not only in a single sample but also in the same phenocrysts. The sodic and potassic types of the melts contain different Cl and F concentrations: the sodic melts are richer in Cl, whereas the potassic melts are enriched in F. We are the first to discover potassic melts with very high F concentrations (up to 2.7 wt%, 1.19 wt% on average, 17 analyses) in the Kuriles and Kamchatka. The average F concentration in the sodic melts is 0.16 wt% (37 analyses). The melts are distinguished for their richness in various groups of trace elements: LILE, REE (particularly HREE), and HFSE (except Nb). All of the melts share certain geochemical features. The concentrations of elements systematically increase from the mafic to acid melts (except only for the Sr and Eu concentrations, because of active plagioclase fractionation, and Ti, an element contained in ore minerals). The paper presents a review of literature data on volcanic rocks in the Kurile-Kamchatka area in which melt inclusions with high K2O concentrations (K2O/Na2O > 1) were found. K-rich melts are proved to be extremely widespread in the area and were found on such volcanoes as Avachinskii, Bezymyannyi, Bol'shoi Semyachek, Dikii Greben', Karymskii, Kekuknaiskii, Kudryavyi, and Shiveluch and in the Valaginskii and Tumrok Ranges.

Heavy metal and petroleum product concentrations in waters at the Obskaya 1 drill site

During recent years, the basins of the Kara Sea (Kamennomysskaya, Obskaya, and Chugor'yakhinskaya structures) in the Russian Federation have been considered as promising regions for oil and gas exploration and, simultaneously, as possible paths of relatively cheap pipeline and tanker transportation of hydrocarbons projected for recovery. On the other hand, exploration operations, recovery, and transportation of gas pose a considerable risk of accidents and environmental pollution, which causes a justified concern about the future state of the ecological system of the Gulf of Ob and the adjoining parts of the Kara Sea. Therefore, regular combined environmental investigations (monitoring) are the most important factor for estimating the current state and forecasting the dynamics of the development of estuary systems. The program of investigations (schedule, station network, and measured parameters) is standardized in accordance with the international practice of such work and accounts for the experience of monitoring studies of Russian and foreign researchers. Two measurement sessions were performed during ecological investigations in the region of exploration drilling: at the beginning at final stage of drilling operations and borehole testing; in addition, natural parameters were determined in various parts of the Ob estuary before the beginning of investigations. Hydrophysical and hydrochemical characteristics of the water medium were determined and bottom sediments and water were analyzed for various pollutants (petroleum products, heavy metals, and radionuclides). The forms of heavy-metal occurrence in river and sea waters were determined by the method of continuous multistep filtration, which is based on water component fractionation on membrane filters of various pore sizes. These investigations revealed environmental pollution by chemical substances during the initial stage of drilling operations, when remains of fuels, oils, and solutions could be spilled, and part of the chemical pollutants could enter the environment. Owing to horizontal and vertical turbulent diffusion, wave mixing, and the effect of the general direction of currents in the Ob estuary from south to north, areas are formed with elevated concentrations of the analyzed elements and compounds. However, the concentration levels of chemical pollutants are practically no higher than the maximum admissible concentrations, and their substantial dissipation to the average regional background contents can be expected in the near future. Our investigations allowed us to determine in detail the parameters of anthropogenic pollution in the regions affected by hydrocarbon exploration drilling in the Obskii and Kamennomysskii prospects in the Gulf of Ob and estimate their influence on the ecological state of the basin of the Ob River and the Kara Sea on the whole.

(Table 1) Estimated e-Nd(0) input calculated using the relative fraction of ODP Hole 105-647A amphibole grains originated from different provinces of the North America

Many marine radiogenic isotope records show both spatial and temporal variations, reflecting both the degree of mixing of distinct sources in the oceans and changes in the distribution of chemical weathering on the continents. However, changes in weathering and transport processes may themselves affect the composition of radiogenic isotopes released into seawater. The provenance of physically weathered material in the Labrador Sea, constrained through the use of Ar-Ar ages of individual detrital minerals, has been used to estimate the relative contributions of chemically weathered terranes releasing radiogenic isotopes into the Labrador Sea. A simple box-model approach for balancing observed Nd-isotope variations has been used to constrain the relative importance of localised input in the Labrador Sea, and the subsequent mixing of Labrador Sea Water into North Atlantic Deep-Water. The long-term pattern of erosion and deep-water formation around the North Atlantic seems to have been a relatively stable feature since 1.5 Ma, although there has been a dramatic shift in the nature of physical and chemical weathering affecting the release of Hf and Pb isotopes. The modelled Nd isotopes imply a relative decrease in water mass advection into the Labrador Sea between 2.4 and 1.5 Ma, accompanied by a decrease in the rate of overturning, possibly caused by an increased freshwater input into the Labrador Sea.

Fatty acid and stable isotope composition of calanoid copepods in the open eastern Atlantic Ocean during POLARSTERN cruise ANT-XXIX/1

The majority of global ocean production and total export production is attributed to oligotrophic oceanic regions due to their vast regional expanse. However, energy transfers, food-web structures and trophic relationships in these areas remain largely unknown. Regional and vertical inter- and intra-specific differences in trophic interactions and dietary preferences of calanoid copepods were investigated in four different regions in the open eastern Atlantic Ocean (38°N to 21°S) in October/November 2012 using a combination of fatty acid (FA) and stable isotope (SI) analyses. Mean carnivory indices (CI) based on FA trophic markers generally agreed with trophic positions (TP) derived from d15N analysis. Most copepods were classified as omnivorous (CI ~0.5, TP 1.8 to ~2.5) or carnivorous (CI >=0.7, TP >=2.9). Herbivorous copepods showed typical CIs of <=0.3. Geographical differences in d15N values of epi- (200-0 m) to mesopelagic (1000-200 m) copepods reflected corresponding spatial differences in baseline d15N of particulate organic matter from the upper 100 m. In contrast, species restricted to lower meso- and bathypelagic (2000-1000 m) layers did not show this regional trend. FA compositions were species-specific without distinct intra-specific vertical or spatial variations. Differences were only observed in the southernmost region influenced by the highly productive Benguela Current. Apparently, food availability and dietary composition were widely homogeneous throughout the oligotrophic oceanic regions of the tropical and subtropical Atlantic. Four major species clusters were identified by principal component analysis based on FA compositions. Vertically migrating species clustered with epi- to mesopelagic, non-migrating species, of which only Neocalanus gracilis was moderately enriched in lipids with 16% of dry mass (DM) and stored wax esters (WE) with 37% of total lipid (TL). All other species of this cluster had low lipid contents (< 10% DM) without WE. Of these, the tropical epipelagic Undinula vulgaris showed highest portions of bacterial markers. Rhincalanus cornutus, R. nasutus and Calanoides carinatus formed three separate clusters with species-specific lipid profiles, high lipid contents (>=41% DM), mainly accumulated as WE (>=79% TL). C. carinatus and R. nasutus were primarily herbivorous with almost no bacterial input. Despite deviating feeding strategies, R. nasutus clustered with deep-dwelling, carnivorous species, which had high amounts of lipids (>=37% DM) and WE (>=54% TL). Tropical and subtropical calanoid copepods exhibited a wide variety of life strategies, characterized by specialized feeding. This allows them, together with vertical habitat partitioning, to maintain high abundance and diversity in tropical oligotrophic open oceans, where they play an essential role in the energy flux and carbon cycling.

Primary geochemical analysis of a transect during METEOR cruise M76/1

The primary geochemical data of the transect visited during the cruise Meteor M76/1. The stations include GeoB 12802, 12803, 12808, 12811, and 12815. The geochemical data include pore-water ferrous ion, sulfate, dissolved inorganic carbon, methane, and molecular hydrogen.