Geochemistry and structural formulas of heavy minerals from sands and sandstones of ODP Leg 126 samples

Lower Oligocene to Pleistocene volcaniclastic sands and sandstones recovered around the Izu-Bonin Arc during Ocean Drilling Program Leg 126 were derived entirely from Izu-Bonin Arc volcanism. Individual grains consist of volcanic glass, pumice, scoria, basaltic or andesitic fragments, plagioclase, pyroxene, and minor olivine and hornblende. In Pliocene-Pleistocene samples plagioclase and heavy minerals in the volcaniclastic sands and sandstones are present in the following abundances: plagioclase > orthopyroxene > clinopyroxene > pigeonite > olivine. In contrast, plagioclase and heavy minerals found in Oligocene-Miocene samples occur in the following order: plagioclase > clinopyroxene > orthopyroxene > hornblende. The low concentration of Al, Ti, and Cr in calcium-rich clinopyroxenes in Oligocene to Holocene sediments suggests that the sources of the volcaniclastic detritus were nonalkalic igneous rocks. There are, however, some distinctive differences in the chemical composition of pyroxene between the Pliocene-Pleistocene and Oligocene-Miocene volcaniclastic sands and sandstones. Orthopyroxene belongs to the hypersthene-ferrohypersthene series (Fe-rich) in Pliocene-Pleistocene sediments, and the bronzitehypersthene series (Mg-rich) in Oligocene-Miocene sediments. Clinopyroxene is characterized by augite and pigeonite in Pliocene-Pleistocene sediments, and by the diopside-augite series in Oligocene-Miocene sediments. Mineral assemblages and mineral chemistry of the volcaniclastic sands and sandstones reflect those of the volcanic source rocks. Therefore, the observed changes in mineralogy record the historical change in volcanism of the Izu-Bonin Arc. The mineralogy is consistent with the geochemistry of the volcaniclastic sands and sandstones and the geochemistry of forearc volcanic rocks of the Izu-Bonin Arc since the Oligocene.

(Table 2) Major and trace element content of ODP Leg 130 basalts

Estimated relative errors on major and minor elements are 1%. For trace elements, errors (% standard deviation at levels measured) are estimated at 1 % for Cr, 3% for Ni, 3% for Rb at 30 ppm, and >20% at < 10 ppm; 2% for Sr and V, and 4% for Y and Zr.

Eolian accumulation rates of ODP Leg 121 holes

The late Cenozoic history of eolian sedimentation in the eastern Indian Ocean was developed from samples recovered during drilling of Sites 752, 754, and 756. Temporal changes in the mass accumulation rate of eolian material reflect major climatic shifts in the southern African source region. A significant drop in dust mass flux values occurs near the end of the lower Oligocene. Younger sediments are characterized by a gradual reduction in dust accumulation rates until the middle Miocene after which values remain consistently low throughout the late Cenozoic, although a slight increase in eolian accumulation rate occurs near 2.5 Ma. This pattern of dust mass flux appears related to the supply of dust-sized particles in the source region and represents a shift in the climatic regime of southern Africa to increasingly more arid conditions throughout the late Cenozoic.

Heavy mineral abundance of ODP Leg 174A sites

The purpose of this paper is to report the heavy mineral content of Miocene to Pleistocene sequences drilled during Ocean Drilling Program Leg 174A on the New Jersey Shelf. Sandy intervals recovered from Holes 1071A, 1071F, 1072A, and 1073A were sampled for heavy mineral analysis. Because of the low core recovery of the sandy parts of the succession, sampling has been incomplete. In spite of the resulting restriction and because of major variations in heavy mineral assemblages, eight distinct heavy mineral associations could be defined. The data presented thus considerably extend the present knowledge on the lithology of the stratigraphic record as described by Austin, Christie-Blick, Malone, et al. (1998). In this chapter the heavy mineral associations and their assignment to particular sequences are described.

Isotopic and trace element composition of basalts from DSDP Leg 82 Holes

Sr and Nd isotopic composition of 23 basalts from Sites 556-559 and 561-564. are reported. The 87Sr/86Sr ratios in fresh glasses and leached whole rocks range from 0.7025 to 0.7034 and are negatively correlated with the initial 143Nd/ 144Nd compositions, which range from 0.51315 to 0.51289. The Sr and Nd isotopic compositions (in glasses or leached samples) lie within the fields of mid-ocean ridge basalts (MORB) and ocean island basalts (OIB) from the Azores on the Nd-Sr mantle array/fan plot. In general, there is a correlation between the trace element characteristics and the 143Nd/144Nd composition (i.e., samples with Hf/Ta>7 and (Ce/Sm)N<1 [normal-MORB] have initial 143Nd/144Nd>0.51307, whereas samples with Hf/Ta<7 and (Ce/Sm)N>1 (enriched-MORB) have initial 143Nd/144Nd compositions <0.51300). A significant deviation from this general rule is found in Hole 558, where the N-MORB can have, within experimental limits, identical isotopic compositions to those found in associated E-MORB. The plume-depleted asthenosphere mixing hypothesis of Schilling (1975), White and Schilling (1978) and Schilling et al. (1977) provides a framework within which the present data can be evaluated. Given the distribution and possible origins of the chemical and isotopic heterogeneity observed in Leg 82 basalts, and some other basalts in the area, it would appear that the Schilling et al. model is not entirely satisfactory. In particular, it can be shown that trace element data may incorrectly estimate the plume component and more localized mantle heterogeneity (both chemical and isotopic) may be important.