(Table 3) Li concentrations and isotopic compositions in foraminiferal shells, carbonate sediments, and associated pore waters from ODP Sites 131-806 and 138-851

An improved procedure for lithium isotope analysis using Li3PO4 as the ion source has been investigated for application to geological samples. The 7Li/6Li ratio is measured using double rhenium filament thermal ionization mass spectrometry in which isotopic fractionation is minimized at high temperatures. The method produces a stable, high intensity Li+ ion beam that allows measurement of nanogram quantities of lithium. This results in a reduction in sample size of up to 1000 times relative to that required for the established Li2BO2+ method while maintaining a comparable precision of better than 1? (1 sigma). Replicate analyses of the NBS L-SVEC Li2CO3 standard yielded a mean value of 12.1047+/-0.0043 (n=21), which is close to the reported absolute value of 12.02+/-0.03. Intercalibration with a wide range of geological samples shows excellent agreement between the Li3PO4 and Li2BO2+ techniques. Replicate analyses of seawater and a fresh submarine basalt display high precision results that agree with previous measurements. Taking advantage of the high ionization efficiency of the phosphate ion source, we have made the first measurements of the lithium concentration (by isotope dilution) and isotopic composition of calcareous foraminiferal tests and other marine carbonates. Preliminary results indicate that substantial lithium exchange occurs between carbonate sediments and their interstitial waters. In addition, a possible link between lithium paleoceanography and paleoclimate during the last 1000 ky may be derived from planktonic foraminiferal tests. This highly sensitive technique can be applied in the examination of low lithium reservoirs and thereby provide insight into some fundamental aspects of lithium geochemistry.

(Appendix) Oxygen isotope record and carbonate mineralogy of the top part of ODP Hole 101-633A

Hole 633A was drilled in the southern part of Exuma Sound on the toe-of-slope of the southeastern part of Great Bahama Bank during ODP Leg 101. The top 55 m, collected as a suite of six approximately 9.5-m-long hydraulic piston cores, represents a Pliocene-Pleistocene sequence of periplatform carbonate ooze, a mixture of pelagic calcite (foraminifer and coccolith tests), some pelagic aragonite (pteropod tests), and bank-derived fine aragonite and magnesian calcite. A 1.6-m.y.-long hiatus was identified at 43.75 mbsf using calcareous nannofossil biostratigraphy and magnetostratigraphy. The 43.75-m-thick periplatform sequence above the hiatus is a complete late Pliocene-Quaternary record of the past 2.15 m.y. The d18O curve, primarily based on Globigerinoides sacculifera, clearly displays high-frequency/low-amplitude cycles during the early Pleistocene and low-frequency/high-amplitude cycles during the middle and late Pleistocene. Variations in aragonite content in the fine fraction of the periplatform ooze show a cyclic pattern throughout the Pleistocene, as previously observed in piston cores of the upper Pleistocene. These variations correlate well with the d18O record: high aragonite corresponds to light interglacial d18O values, and vice versa. Comparison of the d18O record and the aragonite curve helps to identify 23 interglacial and glacial oxygen-isotope stages, corresponding to 10.5 aragonite cycles (labeled A to K) commonly established during the middle and late Pleistocene (0.9 Ma-present). Strictly based on the aragonite curve, another 11 aragonite cycles, labeled L to V, were identified for the early Pleistocene (0.9 to 1.6 Ma). Mismatches between the d18O record and the aragonite curve occur mainly at some of the glacial-to-interglacial transitions, where aragonite increases usually lag behind d18O depletion. When one visually connects the minima on the Pleistocene aragonite curve, low-frequency (0.4 to 0.5 m.y.) supercycles seem to be superimposed on the high-frequency cycles. The timing of this supercycle roughly matches the timing of the Pleistocene carbonate preservation supercycles described in the Pacific, Indian, and Atlantic oceans. Mismatches between aragonite and d18O cycles are even more obvious for the late Pliocene (1.6 to 2.15 Ma). Irregular aragonite variations are observed for the late Pliocene, although after the onset of late Pleistocene-like glaciations in the North Atlantic Ocean 2.4 m.y. ago the d18O record has shown a mode of high-frequency/low-amplitude cycles. Initiation of climatically induced aragonite cycles occurs only at the Pliocene-Pleistocene transition, 1.6 m.y. ago. After that time, aragonite cycles are fully developed throughout the Quaternary. The 11-m-thick periplatform sequence below the hiatus represents a lower Pliocene interval between 3.75 and 4.45 Ma. The bottom half (4.25-4.45 Ma) has a fairly constant, high aragonite content (averaging 60%) and high sedimentation rates (28 m/m.y.) and corresponds to the end of the prolonged early Pliocene interglacial interval (4.1-5.0 Ma), established as a worldwide high sea-level stand. The second half (3.75-4.25 Ma), in which aragonite content decreases by successive steps, paralleled by a gradual 5180 enrichment in Globigerinoides sacculifera and low sedimentation rates (10 m/m.y), corresponds to the climatic deterioration established worldwide between 4.1 and 3.8 Ma, to a decrease of carbonate preservation observed in the equatorial Pacific Ocean, and to a global sea-level decline. Dolomite, a ubiquitous secondary component in the lower Pliocene, is interpreted as being authigenic and possibly related to diagenetic transformation of primary bank-derived fine magnesian calcite. Transformation of the primary mineralogical composition of the periplatform ooze was evidently minor, as the sediments have retained a detailed record of the Pliocene-Pleistocene climatic evolution. Clear evidence of diagenetic transformations in the periplatform ooze includes (1) the disappearance of magnesian calcite in the upper 20 m of Hole 633A, (2) the occurrence of calcite overgrowths on foraminiferal tests and microclasts at intermittent chalky core levels, and (3) the ubiquitous presence of authigenic dolomite in the lower Pliocene.

Geochemistry of labile organic matter in sediments and interstitial waters of ODP Sites 107-651 and 107-653

Sediment and interstitial water from Sites 651 and 653 (ODP Leg 107) were investigated by organic geochemical methods to characterize labile organic compound classes (amino compounds and carbohydrates) and to evaluate their progressive diagenetic and thermal degradation in deep-sea sediments. Downhole distribution of dissolved organic carbon (DOC) appears related to redox zones associated with bacterial activity and of diagenetic recrystallization of biogenic tests and not so much to organic matter concentrations in ambient sediments. DOC ranges from 250 to 8300 µmol/L (3-100.1 ppm). Amino acids contribute 10%-0.3% of DOC; carbohydrates range from 78 to 5 µmol/L. Rate of degradation of amino acids by thermal effects and/or bacterial activity at both sites (significantly different in sedimentation rates: average 41 cm/1000 yr in the top 300 m at Site 651, average 3.9 cm/1000 yr in the Pliocene/Quaternary sequence at Site 653 to 220 mbsf) is more dependent on exposure time rather than on the depth within the sediment column. Variability in neutral, acidic, and basic amino acid fractions of total amino acids (with a range of 1.1-0.02 µmol/g sediment; up to 2.5% of organic carbon) varies with carbonate content and by differences in thermal stability of amino acids. Distribution patterns of monosaccharides are interpreted to result from differences in organic matter sources, sedimentation rates, and the degree of organic matter decomposition prior to and subsequent to burial. Total particulate carbohydrates range from 1.82 to 0.21 µmol/g sediment and contribute about 8% to the sedimentary organic matter. Investigation of trace metals in the interstitial waters did not show any correlation of either DOC, amino compounds, or carbohydrates.

(Table 1) Summary of basalt unit thickness, vesicularity, number of flow units, and average porosity at ODP Site 135-839

An inflatable drill-string packer was used at Site 839 to measure the bulk in-situ permeability within basalts cored in Hole 839B. The packer was inflated at two depths, 398.2 and 326.9 mbsf; all on-board information indicated that the packer mechanically closed off the borehole, although apparently the packer hydraulically sealed the borehole only at 398.2 mbsf. Two pulse tests were run at each depth, two constant-rate injection tests were run at the first set, and four were run at the second. Of these, only the constant-rate injection tests at the first set yielded a permeability, calculated as ranging from 1 to 5 * 10**-12 m**2. Pulse tests and constant-rate injection tests for the second set did not yield valid data. The measured permeability is an upper limit; if the packer leaked during the experiments, the basalt would be less permeable. In comparison, permeabilities measured at other Deep Sea Drilling Project and Ocean Drilling Program sites in pillow basalts and flows similar to those measured in Hole 839B are mainly about 10**-13 to 10**-14 m**2. Thus, if our results are valid, the basalts at Site 839 are more permeable than ocean-floor basalts investigated elsewhere. Based on other supporting evidence, we consider these results to be a valid measure of the permeability of the basalts. Temperature data and the geochemical and geotechnical properties of the drilled sediments all indicate that the site is strongly affected by fluid flow. The heat flow is very much less than expected in young oceanic basalts, probably a result of rapid fluid circulation through the crust. The geochemistry of pore fluids is similar to that of seawater, indicating seawater flow through the sediments, and sediments are uniformly underconsolidated for their burial depth, again indicating probable fluid flow. The basalts are highly vesicular. However, the vesicularity can only account for part of the average porosity measured on the neutron porosity well log; the remainder of the measured porosity is likely present as voids and fractures within and between thin-bedded basalts. Core samples, together with porosity, density, and resistivity well-log data show locations where the basalt section is thin bedded and probably has from 15% to 35% void and fracture porosity. Thus, the measured permeability seems reasonable with respect to the high measured porosity. Much of the fluid flow at Site 839 could be directed through highly porous and permeable zones within and between the basalt flows and in the sediment layer just above the basalt. Thus, the permeability measurements give an indication of where and how fluid flow may occur within the oceanic crust of the Lau Basin.

Biogenic components, major, trace and rare earth elements of equatorial Pacific Ocean surface sediments (Table 1)

We have analyzed the major, trace, and rare earth element composition of surface sediments collected from a transect across the Equator at 135°W longitude in the Pacific Ocean. Comparing the behavior of this suite of elements to the CaCO3, opal, and Corg fluxes (which record sharp maxima at the Equator, previously documented at the same sampling stations) enables us to assess the relative significance of the various pathways by which trace elements are transported to the equatorial Pacific seafloor. The 1. (1) high biogenic source at the Equator, associated with equatorial divergence of surface water and upwelling of nutrient-rich water, and 2. (2) high aluminosilicate flux at 4°N, associated with increased terrigenous input from elevated rainfall at the Intertropical Convergence Zone (ITCZ) of the tradewinds, are the two most important fluxes with which elemental transport is affiliated. The biogenic flux at the Equator transports Ca and Sr structurally bound to carbonate tests and Mn primarily as an adsorbed component. Trace elements such as Cr, As, Pb, and the REEs are also influenced by the biogenic flux at the Equator, although this affiliation is not regionally dominant. Normative calculations suggest that extremely large fluxes of Ba and P at the Equator are carried by only small proportions of barite and apatite phases. The high terrigenous flux at the ITCZ has a profound effect on chemical transport to the seafloor, with elemental fluxes increasing tremendously and in parallel with Ti. Normative calculations, however, indicate that these fluxes are far in excess of what can be supplied by lattice-bound terrigenous phases. The accumulation of Ba is greater than is affiliated with biogenic transport at the Equator, while the P flux at the ITCZ is only 10% less than at the Equator. This challenges the common view that Ba and P are essentially exclusively associated with biogenic fluxes. Many other elements (including Mn, Pb, As, and REEs) also record greater accumulation beneath the ITCZ than at the Equator. Thus, adsorptive scavenging by terrigenous paniculate matter, or phases intimately associated with them, appears to be an extremely important process regulating elemental transport to the equatorial Pacific seafloor. These findings emphasize the role of vertical transport to the sediment, and provide additional constraints on the paleochemical use of trace elements to track biogenic and terrigenous fluxes.

Asian green mussels (Perna viridis) transplanted between Jakarta Bay and Lada Bay, West Java, Indonesia (April 2012 - November 2013)

The Asian green mussel Perna viridis is tolerant to environmental stress, but its robustness varies between populations from habitats that differ in quality. So far, it is unclear whether local adaptations through stressinduced selection or phenotypic plasticity are responsible for these inter-population differences. We tested for the relevance of both mechanisms by comparing survival under hypoxia in mussels that were transplanted from an anthropogenically impacted (Jakarta Bay, Indonesia) to a natural habitat (Lada Bay, Indonesia) and vice versa. Mussels were retrieved 8 weeks after transplantation and exposed to hypoxia in the laboratory. Additional hypoxia tests were conducted with juvenile mussels collected directly from both sites. To elucidate possible relationships between habitat quality and mussel tolerance, we monitored concentrations of inorganic nutrients, temperature, dissolved oxygen, salinity, phytoplankton density and the mussels' body condition index (BCI) for 20 months before, during and after the experiments. Survival under hypoxia depended mainly on the quality of the habitat where the mussels lived before the hypoxia tests and only to a small degree on their site of origin. Furthermore, stress tolerance was only higher in Jakarta than in Lada Bay mussels when the BCIs were substantially higher, which in turn correlated with the phytoplankton densities. We explain why phenotypic plasticity and high BCIs are more likely the causes of populationspecific differences in hypoxia tolerance in P. viridis than stress-induced selection for robust genotypes. This is relevant to understanding the role of P. viridis as mariculture organism in eutrophic ecosystems and invasive species in the (sub)tropical world.