Tab. 1: Rates of advance of the frontal push-moraines of 19 lobes in front of an approx. 4.5 km long margin of the Kötlujökull

In the last years masses of ice, about 5 km long, have been protruding from the lowest part of an advancing glacier margin of the Kötlujökull in Southern Iceland. In the summer of 1983, they appeared as sediment-covered lobes, 10-60 m long, bordering the glacier rnargin like agarland. 1 to 3 push-rnoraines without ice core, rnostly sickle-shaped, occured first in the frontal parts of the lobes: behind thern came several ice-cored moraines with heights of up to several metres. The active ice in front of the precipice of the glacier is called the "glacier-foot" in this paper. The digging out of 9 lobes and the measuring of the advance of 19 lobes showed that in most cases this glacierfoot had split up at its distal end into several plate- or stem-shaped pieces of ice which were situated one upon the other, separated by moraine deposits and proceeding irregularly into the foreland at the rate of several mm/h, The sometimes different rate of advance in the same lobe and different rates of advanee in adjoining lobes (some being entirely inactive) point to a type of rnovement which is independent of the general advance of the glacier. Research in the winter of 1983/84 showed less activity in 3 examined lobes, but the activity had not ceased. The advancement of the lower parts of the glacier-foot into and across the sands of the foreland implies the following genesis of pushmoraines: Shoving off a plate of sand, folding it and pushing it over the foreland at average rates of up to 7,2 mm/h, according to the investigations in thc summer of 1983. At a certain stage of the folding process, new folds begin to develop in front of the old, and the old folds are shifted onto the backslope of thc folds in front of them until they are completely unired. In this way, "püe-moraines" arise, which become higher and higher. They include two or more folds declining towards the glacier. Systems of small moraines presumably of the same genesis occur on old moraine areas in front of the Kötlujökull. The possible cause of formation of a glacier-foot is discussed, and the moraines of the Kötlujökull are compared with certain pleistocene push-moraines.

(Table 1) Soil physical parameters of sediments obtained in the Lüchow-Dannenberg district, Lower Saxony

The mobility of the radionuclides of the elements Sr, I, Cs and Ce were investigated for three typical sands of Northern Germany under simulated natural, undersaturated flow conditions. The laboratory experiments include the determination of the flow parameters of the seepwater movement as well as the transport velocities of the radionuclides in the sands. For the three selected sands, the following mobility sequence/order has been established for the radionuclides: I < Sr < Cs < Ce

Mineralogical compositions of sediment samples from the San Francisco Bay coastal system

The mineralogical compositions of 119 samples collected from throughout the San Francisco Bay coastal system, including bayfloor and seafloor, area beaches, cliff outcrops, and major drainages, were determined using X-ray diffraction (XRD). Comparison of the mineral concentrations and application of statistical cluster analysis of XRD spectra allowed for the determination of provenances and transport pathways. The use of XRD mineral identifications provides semi-quantitative compositions needed for comparisons of beach and offshore sands with potential cliff and river sources, but the innovative cluster analysis of XRD diffraction spectra provides a unique visualization of how groups of samples within the San Francisco Bay coastal system are related so that sand-sized sediment transport pathways can be inferred. The main vector for sediment transport as defined by the XRD analysis is from San Francisco Bay to the outer coast, where the sand then accumulates on the ebb tidal delta and also moves alongshore. This mineralogical link defines a critical pathway because large volumes of sediment have been removed from the Bay over the last century via channel dredging, aggregate mining, and borrow pit mining, with comparable volumes of erosion from the ebb tidal delta over the same period, in addition to high rates of shoreline retreat along the adjacent, open-coast beaches. Therefore, while previously only a temporal relationship was established, the transport pathway defined by mineralogical and geochemical tracers support the link between anthropogenic activities in the Bay and widespread erosion outside the Bay. The XRD results also establish the regional and local importance of sediment derived from cliff erosion, as well as both proximal and distal fluvial sources. This research is an important contribution to a broader provenance study aimed at identifying the driving forces for widespread geomorphic change in a heavily urbanized coastal-estuarine system.

Description and geochemistry of DSDP Leg 55 Holes

One of the objectives of Leg 55 was to investigate the Tertiary history of sedimentation and environment on the Emperor Seamounts after their volcanic activity. For the three first sites, 430, 431, and 432, drilled on Ojin, Nintoku, and Yömei Seamounts, the Neogene sedimentary deposits are not well represented and are not typical pelagic sediments. Except for two holes (430A and 432), where we found calcareous oozes, the sediments are heterogeneous sands, gravels, and pebbly mudstones with a wide range in grain size and composition. Two phenomena characterize these deposits: the inheritance of volcaniclastic material and its alteration, and the authigenesis of secondary minerals including silicates, phosphates, and ferromanganese oxides formed under volcanic influence in a marine environment.

Geochemistry and lithology of clayey nannofossil ooze turbidites and hemipelagites at ODP Holes 135-834A and 135-835A

The western Lau Basin, between the Central and Eastern Lau Spreading Centers and the Lau Ridge, contains several small, elongate, fault-bounded, partially sediment-filled sub-basins. Sites 834 and 835 were drilled in the oldest part of the Lau Basin in two of these small extensional basins close to the Lau Ridge, formed on late Miocene to early Pliocene oceanic crust. Both sites show a similar sediment sequence that consists of clayey nannofossil oozes and mixed sediments interbedded with epiclastic vitric sands and silts. The vitric sands and silts are largely restricted to the deeper part of the sediment column (early Pliocene-late Pliocene), and the upper part of the sediment column at both sites consists of a distinctive sequence of brown clayey nannofossil ooze, stained by iron and manganese oxyhydroxides (late Pliocene-Holocene). However, the clayey nannofossil ooze sequence at Site 835 is anomalously thick and contains several medium- to very thick beds of matrix-supported, mud-clast conglomerate (interpreted as muddy debris-flow deposits), together with large amounts of redeposited clayey nannofossil ooze and coherent rafted blocks of older hemipelagic material. Redeposited clayey nannofossil oozes can be distinguished from hemipelagic nannofossil oozes using several sedimentological criteria. These include variation in color hue and chroma, presence or absence of bioturbation, presence or absence of scattered foraminifers, grain-size characteristics, variability in calcium carbonate content, presence or absence of pumice clasts, and micropaleontology. Clayey nannofossil ooze turbidites and hemipelagites are also geochemically distinct, with the turbidites being commonly enriched in Mn, Ni, Pb, Zn, Cr, and P. The sediment sequence at Site 835 is dominated by allochthonous sediments, either muddy debris-flow deposits, coherent rafted blocks, or thick clayey nannofossil ooze turbidites. Since 2.9 Ma, only 25% of the 133 m of sediments deposited represents hemipelagic deposition, with an average sedimentation rate of 1.5 cm/k.y.. Allochthonous sediments were the main sediment type deposited during the Brunhes geomagnetic Epoch and make up 80% of the thickness of sediment deposited during this period. Short intervals of mainly hemipelagic deposition occurred from 0.4 to 0.9 Ma, 1.0 to 1.4 Ma, and 1.7 to 2.1 Ma. However, allochthonous sediments were again the dominant sediment type deposited between 2.1 and 2.5 Ma, with a large slide complex emplaced around 2.5 Ma. We conclude that the adjacent high ground, surrounding the basin in which Site 835 was drilled, was affected by marked instability throughout the late Pliocene and Pleistocene. In contrast, sedimentation at Site 834 during this period has been dominated by hemipelagic deposition, with redeposited sediments making up slightly less than 17% of the total thickness of sediment deposited since 2.3 Ma. However, there was a marked increase in frequency and magnitude of redeposited sediments at around 0.2 Ma at Site 834, which broadly corresponds to the onset of a major episode of turbidite and debris-flow emplacement beginning about 0.4 Ma at Site 835. This episode of instability at both sites may be the effect of the approach and passing of the Central Lau propagator at the latitude of Sites 834 and 835 at about 0.5 Ma.

Sedimentological and paleomagnetic investigations on two gravity cores and ODP sites 113-690 and 693 off Kapp Norvegia, Antarctic continental margin

Oligocene to Quaternary sediments were recovered from the Antarctic continental margin in the eastern Weddell Sea during ODP Leg 113 and Polarstern expedition ANT-VI. Clay mineral composition and grain size distribution patterns are useful for distinguishing sediments that have been transported by ocean currents from those that were ice-rafted. This, in turn, has assisted in providing insights about the changing late Paleogene to Neogene sedimentary environment as the cryosphere developed in Antarctica. During the middle Oligocene, increasing glacial conditions on the continent are indicated by the presence of glauconite sands, that are interpreted to have formed on the shelf and then transported down the continental slope by advancing glaciers or as a result of sea-level lowering. The dominance of illite and a relatively high content of chlorite suggest predominantly physical weathering conditions on the continent. The high content of biogenic opal from the late Miocene to the late Pliocene resulted from increased upwelling processes at the continental margin due to increased wind strength related to global cooling. Partial melting of the ice-sheet occurred during an early Pliocene climate optimum as is shown by an increasing supply of predominantly current-derived sediment with a low mean grain size and peak values of smectite. Primary productivity decreased at ~ 3 Ma due to the development of a permanent sea-ice cover close to the continent. Late Pleistocene sediments are characterized by planktonic foraminifers and biogenic opal, concentrated in distinct horizons reflecting climatic cycles. Isotopic analysis of AT. pachyderma produced a stratigraphy which resulted in a calculated sedimentation rate of 1 cm/k.y. during the Pleistocene. Primary productivity was highest during the last three interglacial maxima and decreased during glacial episodes as a result of increasing sea-ice coverage.