Curie temperatures and cell edges of ODP Leg 120 samples (Table 1)

Basalt samples recovered on Ocean Drilling Program Leg 120 from the Kerguelen Plateau were investigated by thermomagnetic analysis, X-ray diffraction, and ore microscopy. The basement samples could be divided into two groups based on Curie temperatures, cell-edge parameters, and optical magnetic mineralogy. Samples from Sites 748 and 750 underwent only low-temperature oxidation and displayed Curie temperatures for the titanomaghemites that ranged from 340° to 395°C. The basalts from Sites 747 and 749 mainly experienced high-temperature oxidation. High-temperature oxidation produced titanium-poor titanomagnetites with ilmenite-exsolution lamellae. Curie temperatures of the deuterically oxidized titanomaghemites varied from 490° to 620°C.

(Table 1) Sediment descriptions and age at DSDP Legs 5 and 63 Holes

Sediments from immediately above basalt basement and from between sections of basalt recovered from Deep Sea Drilling Project Legs 5 and 63 were analyzed by atomic absorption spectroscopy for Mg, Al, Si, Ca, Mn, Fe, Co, Ni, Cu, Zn, and Ba. All of these sediments showed enrichment in Fe and Mn over values typical of detritus supplied to the northeastern Pacific Ocean. X-ray diffractometry and differential chemical leaching indicate that up to 50% of the sediment, by weight, is in amorphous phases and that these phases are rich in Mn, Co, Cu, Ni, and Zn. Multivariate statistical analysis and normative partitioning of the chemical data indicate that much of the excess Fe and other transition elements in the sediment originate from hydrothermal sources.

(Table 1) 40Ar/39Ar geochronology at DSDP Hole 89-462A

40Ar/39Ar geochronological studies were performed on basalts taken from the bottom of Hole 462A. An age of 129.7 ± 4.6 Ma was obtained for two temperature fractions (800 and 1000°C) of Sample 462A-109-1, 106-108 cm. That age is between the age of the oceanic basement, as deduced from the magnetic anomaly data, and the age of interlayered sediment, as deduced from the sparse fossil content.

(Table 1) K and Ar content, and age determination of ODP Holes 126-792E and 126-793B

Results of conventional K-Ar dating on five samples from two sites from the Izu-Bonin forearc are presented. Two samples recovered from a volcanic edifice and overlying sediments drilled on the western side of the forearc basin (Site 792) indicate a basement age of 34 Ma. This is consistent with early Oligocene biostratigraphic ages from the overlying sediments. Three samples from the basement of Hole 793B at the center of the basin are not analytically distinguishable, with a best age of 27.1 +/- 0.6 Ma. This is slightly younger than the 30-33 Ma biostratigraphic and magnetostratigraphic estimates from the overlying sediments, suggesting that alteration processes have lowered the apparent K-Ar ages. These ages suggest that syn-rift volcanism occurred in a forearc location during the middle Oligocene.

(Table 1) Uranium and Thorium concentrations, activity ratios and calcium carbonate content of DSDP Site 54-424

The geochemical behaviour of uranium and thorium in metalliferous sediments and hydrothermal deposits has been widely studied and the main results have been summarised by Boström and Rydell. These isotopes may be used to clarify how the metal-rich solutions are introduced into sediment cover and seawater. Using radiochemistry followed by alpha spectrometry, we have measured uranium concentrations as high as several hundred p.p.m., which must clearly be associated with ocean ridge thermal activity, in sediments interbedded between the basaltic basement and the green hydrothermal mud at DSDP Site 424. These high uranium concentrations indicate the path followed by the hydrothermal fluid which, debouching at the sediment-water interface, formed the green mud.

Eocene-Oligocene planktonic foraminifera of ODP Hole 135-841B

A middle Eocene to lower Oligocene sedimentary sequence was drilled at Site 841 in the Tonga forearc region during Ocean Drilling Program Leg 135. A 56-m-thick sequence of volcanic sandstone, spanning from Cores 135-841B-4IR to -47R (549.1 to 605 mbsf), unconformably overlies rhyolitic volcanic basement. The middle Eocene planktonic foraminifer assemblages (P Zone?), which occur in association with larger benthic foraminifers, include spinose species of Acarinina, Morozovella, and Truncorotaloides, but their abundance is low. Late Eocene and early Oligocene faunas are abundant and show the highest diversity of the Paleogene sequence drilled at this site. They have been assigned to Zones P15-16 and P18, respectively. The Eocene/Oligocene boundary was not recognized because of a hiatus in which Zone P17 (37.2-36.6 Ma) was missing. Another hiatus is recorded in the interval between the middle and late Eocene, spanning at least 1.8 Ma. Paleogene assemblages of Site 841 contain equal numbers of warm- and cool-water species, an attribute of the warm middle-latitude Paleogene fauna of the Atlantic Ocean. In particular, common to high abundances of cool-water taxa, such as Globorotaloides, Catapsydrax, Tenuitella, and small globigerinids, may be related to the opening of a shallow seaway south of Tasmania permitting the influx of cool Indian Ocean waters into the South Pacific before the late Eocene (approximately 37 Ma).

Major element oxides of minerals from a lava pond at ODP Site 206-1256

At Ocean Drilling Program Site 1256 (6°44.2'N, 91°56.1'W), during Leg 206, a thick massive unit was cored in two neighboring penetrations of the uppermost basement, Holes 1256C and 1256D. This thick massive lava flow, commonly referred to as the "Lava Pond," is identified as Unit 18 (>30 m thick) in Hole 1256C and Unit 1 (>74.2 m thick) in Hole 1256D (Wilson et al., 2003, doi:10.2973/odp.proc.ir.206.2003). In the coarse-grained basalt that comprises this lithological unit, low-temperature "background" alteration events are present. This report provides microprobe analyses of both primary and secondary minerals present in this massive lava pond. The analyses of typically magmatic minerals (titanomagnetite, plagioclase, and clinopyroxene) are given for comparison with secondary minerals.

Thermal conductivity at DSDP Leg 60 Holes

A total of 1547 thermal conductivity values were determined by both the NP (needle probe method) and the QTM (quick thermal conductivity meter) on 1319 samples recovered during DSDP Leg 60. The NP method is primarily for the measurement of soft sedimentary samples, and the result is free from the effect of porewater evaporation. Measurement by the QTM method is faster and is applicable to all types of samples-namely, sediments (soft, semilithified, and lithified) and basement rocks. Data from the deep holes at Sites 453, 458, and 459 show that the thermal conductivity increases with depth, the rate of increase ranging from (0.18 mcal/cm s °C)/100 m at Site 459 to (0.72 mcal/cm s °C)/100 m at Site 456. A positive correlation between the sedimentary accumulation rate and the rate of thermal conductivity increase with depth indicates that both compaction and lithification are important factors. Drilled pillow basalts show nearly uniform thermal conductivity. At She 454 the thermal conductivity of one basaltic flow unit was higher near the center of the unit and lower toward the margin, reflecting variable vesicularity. Hydrothermally altered basalts at Site 456 showed higher thermal conductivity than fresh basalt because secondary calcite, quartz, and pyrite are generally more thermally conductive than fresh basalt. The average thermal conductivity in the top 50 meters of sediments correlates inversely with water depth because of dissolution of calcite, a mineral with high thermal conductivity, from the sediments as the water depth exceeds the lysocline and the carbonate compensation depth. Differences between the Mariana Trench data and the Mariana Basin and Trough data may reflect different abundances of terrigenous material in the sediment. There are remarkable correlations between thermal conductivity and other physical properties. The relationship between thermal conductivity and compressional wave velocity can be used to infer the ocean crustal thermal conductivity from the seismic velocity structure.