Perfluorinated compounds in environmental matrices of Lake Victoria Gulf

ABSTRACT One of the major ecological challenges on Lake Victoria resources is the existence of “hot spots”, caused by human waste, urban runoff, and industrial effluents. The lake is tending towards eutrophication which is attributed to the increasing human population in its watershed. A report of the levels of perfluorooctane sulfonate and perfluorooctanoic acid in environmental matrices of Lake Victoria is presented, and the management implication of perfluorinated compounds and similar potential organic pollutants examined. Two widely consumed and economically important fish species namely Lates niloticus (Nile perch) and Oreochromis niloticus (Nile tilapia) were obtained from Winam gulf of Lake Victoria, Kenya, and analysed for perfluorooctane sulfonate and perfluorooctanoic acid in muscles and liver using liquid chromatography coupled with mass spectroscopy. Variability in the concentrations of perfluorooctanoic acid or perfluorooctane sulfonate in river waters (range perfluorooctanoic acid 0.4 – 96.4 ng/L and perfluorooctane sulfonate < 0.4 – 13.2 ng/L) was higher than for Lake waters (range perfluorooctanoic acid 0.4 – 11.7 ng/L and perfluorooctane sulfonate < 0.4 – 2.5 ng/L respectively). Significant correlations were tested between perfluorinated compounds levels in sediments, fish and water. Wastewater treatment plants and other anthropogenic sources have been identified as significant sources or pathways for the introduction of perfluoroalkyl compounds into Lake Victoria ecosystem. In this study, elevated concentrations of perfluorooctanoic acid and perfluorooctane sulfonate was found in two wastewater treatment plants (WWTPs) in Kisumu, City of Kenya. An alternative analytical method to liquid chromatography/ mass spectroscopy for analysis of perfluorocarboxylic acids in abiotic and biotic matrices where high concentrations are expected is also presented. Derivatisation of the acid group to form a suitable alkyl ester provided a suitable compound for mass spectroscopy detection coupled to gas chromatography instrumental analysis. The acid is esterified by an alkyl halide i.e benzyl bromide as the alkylating agent for Perfluorocarboxylic acids quantification. The study also involved degradability measurements of emerging perfluorinated surfactants substitutes. The stability of the substitutes of perfluorinated surfactants was tested by employing advanced oxidation processes, followed by conventional tests, among them an automated method based on the manometric respirometry test and standardized fix bed bioreactor [FBBR] on perfluorobutane sulfonate (PFBS), a fluoroethylene polymer, fluorosurfactant (Zonyl), two fluoraliphaticesters (NOVEC ™ FC4430 and NOVEC ™ FC4432) and 10-(trifluoromethoxy) decane-sulfonate. Most of these emmerging surfactants are well-established in the market and have been used in several applications as alternatives to PFOS and PFOA based surfactants. The results of this study can be used as pioneer information for further studies on the sources, behaviour and fate of PFOA and PFOS and other related compounds in both abiotic and biota compartments of Lake Victoria and other lakes. Further an overview in degradation of emerging perfluorinated compounds substitutes is presented. Contribution in method development especially for acid group based fluorosurfactants is presented. The data obtained in this study can particularly be considered when formulating policies and management measures for preservation and sustainability of Lake Victoria resources.

Exploring physical processes related to past climate proxies: lake sediments and stable water isotopes

Proxy data are essential for the investigation of climate variability on time scales larger than the historical meteorological observation period. The potential value of a proxy depends on our ability to understand and quantify the physical processes that relate the corresponding climate parameter and the signal in the proxy archive. These processes can be explored under present-day conditions. In this thesis, both statistical and physical models are applied for their analysis, focusing on two specific types of proxies, lake sediment data and stable water isotopes.rnIn the first part of this work, the basis is established for statistically calibrating new proxies from lake sediments in western Germany. A comprehensive meteorological and hydrological data set is compiled and statistically analyzed. In this way, meteorological times series are identified that can be applied for the calibration of various climate proxies. A particular focus is laid on the investigation of extreme weather events, which have rarely been the objective of paleoclimate reconstructions so far. Subsequently, a concrete example of a proxy calibration is presented. Maxima in the quartz grain concentration from a lake sediment core are compared to recent windstorms. The latter are identified from the meteorological data with the help of a newly developed windstorm index, combining local measurements and reanalysis data. The statistical significance of the correlation between extreme windstorms and signals in the sediment is verified with the help of a Monte Carlo method. This correlation is fundamental for employing lake sediment data as a new proxy to reconstruct windstorm records of the geological past.rnThe second part of this thesis deals with the analysis and simulation of stable water isotopes in atmospheric vapor on daily time scales. In this way, a better understanding of the physical processes determining these isotope ratios can be obtained, which is an important prerequisite for the interpretation of isotope data from ice cores and the reconstruction of past temperature. In particular, the focus here is on the deuterium excess and its relation to the environmental conditions during evaporation of water from the ocean. As a basis for the diagnostic analysis and for evaluating the simulations, isotope measurements from Rehovot (Israel) are used, provided by the Weizmann Institute of Science. First, a Lagrangian moisture source diagnostic is employed in order to establish quantitative linkages between the measurements and the evaporation conditions of the vapor (and thus to calibrate the isotope signal). A strong negative correlation between relative humidity in the source regions and measured deuterium excess is found. On the contrary, sea surface temperature in the evaporation regions does not correlate well with deuterium excess. Although requiring confirmation by isotope data from different regions and longer time scales, this weak correlation might be of major importance for the reconstruction of moisture source temperatures from ice core data. Second, the Lagrangian source diagnostic is combined with a Craig-Gordon fractionation parameterization for the identified evaporation events in order to simulate the isotope ratios at Rehovot. In this way, the Craig-Gordon model can be directly evaluated with atmospheric isotope data, and better constraints for uncertain model parameters can be obtained. A comparison of the simulated deuterium excess with the measurements reveals that a much better agreement can be achieved using a wind speed independent formulation of the non-equilibrium fractionation factor instead of the classical parameterization introduced by Merlivat and Jouzel, which is widely applied in isotope GCMs. Finally, the first steps of the implementation of water isotope physics in the limited-area COSMO model are described, and an approach is outlined that allows to compare simulated isotope ratios to measurements in an event-based manner by using a water tagging technique. The good agreement between model results from several case studies and measurements at Rehovot demonstrates the applicability of the approach. Because the model can be run with high, potentially cloud-resolving spatial resolution, and because it contains sophisticated parameterizations of many atmospheric processes, a complete implementation of isotope physics will allow detailed, process-oriented studies of the complex variability of stable isotopes in atmospheric waters in future research.rn

Paleoclimate reconstruction using LA-ICP-MS analyses of ostracods and stalagmite

Als paläoklimatische Archive können unter anderem Stalagmiten und Klappen von Ostrakoden herangezogen werden. Bisher gab es noch keine veröffentlichten Ergebnisse räumlich hochaufgelöster Spurenelementverteilungen in einzelnen Ostrakodenklappen. Das gleiche gilt für die Bestimmung radiogener Blei-Isotope in Stalagmiten. Um klimatische Prozesse vergangener Zeiten zu untersuchen, wurde eine neue LA-ICP-MS (Laserablations – Massenspektrometrie mit induktiv gekoppeltem Plasma) Technik für hochaufgelöste in-situ Messungen von Spurenelementen und Bleiisotopen entwickelt. rnrnZunächst wurden geeignete Materialien für die Kalibrierung der Technik untersucht; als Proben dienten die Silikatreferenzgläser BAM-S005-A und BAM-S005B der Bundesanstalt für Materialforschung und –prüfung (BAM). Die Homogenität dieser Referenzgläser wurde mit LA-ICP-MS und den anderen mikroanalytischen Methoden EPMA (Elektronenmikrosonde) und SIMS (Ionensonde) überprüft. Die Ergebnisse zeigten, dass alle Haupt- und die meisten Spurenelemente in beiden Gläsern selbst im Mikrometerbereich homogen verteilt sind. Ausnahmen sind einige Spurenelemente, wie Cs, Cl, Cr, Mo und Ni, die heterogen in den Gläsern verteilt sind. Die Hauptelementzusammensetzung von BAM-S005-A und BAM-S005-B wurde mit Hilfe der EPMA bestimmt, wobei die Ergebnisse die Referenzwerte des BAM-Zertifikats bestätigten. Mit Ausnahme von Sr, Ba, Ce und Pb, stimmten die LA-ICP-MS-Spurenelementwerte mit den zertifizierten Werten innerhalb der angegebenen Fehlergrenzen überein. Gründe für die Diskrepanz der vier oben erwähnten Elemente sind noch unklar, aber sind möglicherweise durch fehlerhafte Referenzwerte zu erklären. Zusätzlich wurden 22 Spurenelemente gemessen, deren Gehalte von BAM nicht zertifiziert wurden. Aufgrund dieser Untersuchungen konnte festgestellt werden, dass beide BAM-Gläser für mikroanalytische Anwendungen geeignet sind.rnrnUm neuartige paläoklimatische Proxies im Calcit von Ostrakoden aus tibetanischen Seesedimenten zu untersuchen, wurde die Spurenelementvariabilität in einzelnen Ostrakodenklappen durch eine neue LA-ICP-MS-Technik bestimmt. Klappen von Ostrakoden der drei Arten (Leucocytherella sinensis Huang, 1982, ?Leucocythere dorsotuberosa Huang, 1982 und ?L. dorsotuberosa f. postilirata sensu Pang, 1985) wurden aus zwei Sedimentkernen des Nam Co Sees auf dem Hochplateau von Tibet gewonnen. Zwei LA-ICP-MS-Varianten, Spot- bzw. Linienanalyse, wurden verwendet, um die Elementkonzentrationen der Spurenelemente Mg, Sr, Ba, U und die der Seltenen Erdelemente (SEE) in den Klappen einzelner Ostrakoden zu bestimmen. Die Ergebnisse zeigten, dass die Linienanalyse präzisere Daten als die Spotanalyse liefert und sie wurde daher vorgezogen. Signifikante Unterschiede in der Spurenelementzusammensetzung zwischen den verschiedenen Arten der Ostrakoden wurden nicht gefunden. Variationen der Elementverhältnisse Mg/Ca und Sr/Ca in den Klappen stimmen mit veröffentlichten Seenspiegelschwankungen während des Holozäns überein, was zeigt, dass Mg- und Sr-Messungen in den Ostrakoden zur Untersuchung paläohydrochemischer Prozesse in diesem Gebiet herangezogen werden kann. Die gute Korrelation, die in dieser Arbeit zwischen Ba/Ca und Sr/Ca gefunden wurde, ist ein Hinweis darauf, dass der Einbau von Ba und Sr in die Klappen durch den gleichen Mechanismus erfolgte. Eine mögliche Beziehung zwischen dem U/Ca-Verhältnis in den Ostrakoden und den Redoxbedingungen auf dem Boden des Sees in der Vergangenheit wird diskutiert. Relativ geringe und konstante La/Ca-Verhältnisse wurden festgestellt, deren Ursache möglicherweise entweder auf der SEE-Charakteristik des Seewassers, auf biologischen Prozessen in den Ostrakoden oder auf Kontamination von Fe-Mn und/oder organischen Substanzen beruhen. Weitere Untersuchungen an Proben aus diesem Gebiet, speziell Klappen von lebenden Ostrakoden, sind notwendig, um den Gehalt von Ba, U und den SEE in Ostrakoden als paläoklimatische Proxies von Umweltbedingungen zu verwenden.