Development of a multi-species method by GC-coupling with inductively coupled plasma isotope dilution mass spectrometry for the simultaneous determination of alkylated lead, mercury and tin compounds

An accurate and sensitive species-specific GC-ICP-IDMS (gas chromatography inductively coupled plasma isotope dilution mass spectrometry) method for the determination of trimethyllead and a multi-species-specific GC-ICP-IDMS method for the simultaneous determination of trimethyllead, methylmercury, and butyltins in biological and environmental samples were developed. They allow the determination of corresponding elemental species down to the low ng g-1 range. The developed synthesis scheme for the formation of isotopically labeled Me3206Pb+ can be used for future production of this spike. The novel extraction technique, stir bar sorptive extraction (SBSE), was applied for the first time in connection with species-specific isotope dilution GC-ICP-MS for the determination of trimethyllead, methylmercury and butyltins. The results were compared with liquid-liquid extraction. The developed methods were validated by the analysis of certified reference materials. The liquid-liquid extraction GC-ICP-IDMS method was applied to seafood samples purchased from a supermarket. The methylated lead fraction in these samples, correlated to total lead, varied in a broad range of 0.01-7.6 %. On the contrary, the fraction of methylmercury is much higher, normally in the range of 80-98 %. The highest methylmercury content of up to 12 µg g-1 has been determined in shark samples, an animal which is at the end of the marine food chain, whereas in other seafood samples a MeHg+ content of less than 0.2 µg g-1 was found. Butyltin species could only be determined in samples, where anthropogenic contaminations must be assumed. This explains the observed broad variation of the butylated tin fraction in the range of <0.3-49 % in different seafood samples. Because all isotope-labelled spike compounds, except trimethyllead, are commercially available, the developed multi-species-specific GC-ICP-IDMS method has a high potential in future for routine analysis.

Confocal microscopy applied to the study of single entity fluorescence and light scattering

A sample scanning confocal optical microscope (SCOM) was designed and constructed in order to perform local measurements of fluorescence, light scattering and Raman scattering. This instrument allows to measure time resolved fluorescence, Raman scattering and light scattering from the same diffraction limited spot. Fluorescence from single molecules and light scattering from metallic nanoparticles can be studied. First, the electric field distribution in the focus of the SCOM was modelled. This enables the design of illumination modes for different purposes, such as the determination of the three-dimensional orientation of single chromophores. Second, a method for the calculation of the de-excitation rates of a chromophore was presented. This permits to compare different detection schemes and experimental geometries in order to optimize the collection of fluorescence photons. Both methods were combined to calculate the SCOM fluorescence signal of a chromophore in a general layered system. The fluorescence excitation and emission of single molecules through a thin gold film was investigated experimentally and modelled. It was demonstrated that, due to the mediation of surface plasmons, single molecule fluorescence near a thin gold film can be excited and detected with an epi-illumination scheme through the film. Single molecule fluorescence as close as 15nm to the gold film was studied in this manner. The fluorescence dynamics (fluorescence blinking and excited state lifetime) of single molecules was studied in the presence and in the absence of a nearby gold film in order to investigate the influence of the metal on the electronic transition rates. The trace-histogram and the autocorrelation methods for the analysis of single molecule fluorescence blinking were presented and compared via the analysis of Monte-Carlo simulated data. The nearby gold influences the total decay rate in agreement to theory. The gold presence produced no influence on the ISC rate from the excited state to the triplet but increased by a factor of 2 the transition rate from the triplet to the singlet ground state. The photoluminescence blinking of Zn0.42Cd0.58Se QDs on glass and ITO substrates was investigated experimentally as a function of the excitation power (P) and modelled via Monte-Carlo simulations. At low P, it was observed that the probability of a certain on- or off-time follows a negative power-law with exponent near to 1.6. As P increased, the on-time fraction reduced on both substrates whereas the off-times did not change. A weak residual memory effect between consecutive on-times and consecutive off-times was observed but not between an on-time and the adjacent off-time. All of this suggests the presence of two independent mechanisms governing the lifetimes of the on- and off-states. The simulated data showed Poisson-distributed off- and on-intensities, demonstrating that the observed non-Poissonian on-intensity distribution of the QDs is not a product of the underlying power-law probability and that the blinking of QDs occurs between a non-emitting off-state and a distribution of emitting on-states with different intensities. All the experimentally observed photo-induced effects could be accounted for by introducing a characteristic lifetime tPI of the on-state in the simulations. The QDs on glass presented a tPI proportional to P-1 suggesting the presence of a one-photon process. Light scattering images and spectra of colloidal and C-shaped gold nano-particles were acquired. The minimum size of a metallic scatterer detectable with the SCOM lies around 20 nm.

Methodenentwicklung zur Spurenanalyse organischer Biomarker in Speläothemen und Tropfwasser mittels Flüssigchromatographie-(HR-)Massenspektrometrie

Speläotheme und Tropfwasser spielen eine wichtige Rolle bei der Erforschung von Naturerscheinungen. Während sich bisherige Studien größtenteils auf anorganische Proxies konzentrieren, wächst das Interesse an organischen Biomarkern, vor allem Lipidbiomarkern.rnAufgrund dessen wurde eine neue Methode entwickelt, um Fettsäuren mit einer geradzahligen Kettenlänge C12-C20 in Speläothem- und Tropfwasserproben zu bestimmen. Dabei kam eine Festphasenextraktion mit anschließender HPLC-MS Messung zum Einsatz. Die Methode wurde auf mehrere Proben aus der Herbstlabyrinth-Adventhöhle angewendet. Die benötigte Probenmenge wurde im Vergleich zu früheren Studien von etwa 4 L auf 60-100 mL bei Tropfwasser und von 10-100 g auf ca. 0,5-3,5 g bei Stalagmitproben reduziert. Es konnte eine interne Variation der Analyten festgestellt werden. Korrelationen der Fettsäuren ließen vermuten, dass C12-C18 von der gleichen Quelle stammen, während C20 teilweise andere Quellen besitzt. Korrelationen mit δ13C verdeutlichten, dass es einen Zusammenhang zwischen der Vegetationsdichte und dem Vorkommen der Fett-säuren in dem Probenmaterial gibt. Vergleiche mit Mg Konzentrationen zeigten, dass die Niederschlagsmenge zwar den Transport der Fettsäuren mit dem Tropfwasser beeinflusst, allerdings nicht ihre ermittelte Konzentration in Stalagmitproben. Die ermittelten Ergebnisse ließen darauf schließen, dass eindeutigere Vegetations-Proxies als die Fettsäuren gefunden werden müssen. Ein erstmaliges non-target screening verdeutlichte, dass Lignine und Tannine als charakteristische Biomarker eingesetzt werden können.rn