Measurement of the oscillation frequency of B s mesons in the hadronic decay mode B s pi D s (phi pi) X with the D0 detector at the Fermilab Tevatron collider

The standard model (SM) of particle physics is a theory, describing three out of four fundamental forces. In this model the Cabibbo-Kobayashi-Maskawa (CKM) matrix describes the transformation between the mass and weak eigenstates of quarks. The matrix properties can be visualized as triangles in the complex plane. A precise measurement of all triangle parameters can be used to verify the validity of the SM. The least precisely measured parameter of the triangle is related to the CKM element |Vtd|, accessible through the mixing frequency (oscillation) of neutral B mesons, where mixing is the transition of a neutral meson into its anti-particle and vice versa. It is possible to calculate the CKM element |Vtd| and a related element |Vts| by measuring the mass differences Dmd (Dms ) between neutral Bd and bar{Bd} (Bs and bar{Bs}) meson mass eigenstates. This measurement is accomplished by tagging the initial and final state of decaying B mesons and determining their lifetime. Currently the Fermilab Tevatron Collider (providing pbar{p} collisions at sqrt{s}=1.96 TeV) is the only place, where Bs oscillations can be studied. The first selection of the "golden", fully hadronic decay mode Bs->Ds pi(phi pi)X at DØ is presented in this thesis. All data, taken between April 2002 and August 2007 with the DØ detector, corresponding to an integrated luminosity of int{L}dt=2.8/fb is used. The oscillation frequency Dms and the ratio |Vtd|/|Vts| are determined as Dms = (16.6 +0.5-0.4(stat) +0.4-0.3(sys)) 1/ps, |Vtd|/|Vts| = 0.213 +0.004-0.003(exp)pm 0.008(theor). These results are consistent with the standard model expectations and no evidence for new physics is observable.

Mechanical microcontacts of powder particles studied with the quartz crystal microbalance

Within this work, a particle-polymer surface system is studied with respect to the particle-surface interactions. The latter are governed by micromechanics and are an important aspect for a wide range of industrial applications. Here, a new methodology is developed for understanding the adhesion process and measure the relevant forces, based on the quartz crystal microbalance, QCM. rnThe potential of the QCM technique for studying particle-surface interactions and reflect the adhesion process is evaluated by carrying out experiments with a custom-made setup, consisting of the QCM with a 160 nm thick film of polystyrene (PS) spin-coated onto the quartz and of glass particles, of different diameters (5-20µm), deposited onto the polymer surface. Shifts in the QCM resonance frequency are monitored as a function of the oscillation amplitude. The induced frequency shifts of the 3rd overtone are found to decrease or increase, depending on the particle-surface coupling type and the applied oscillation (frequency and amplitude). For strong coupling the 3rd harmonic decreased, corresponding to an “added mass” on the quartz surface. However, positive frequency shifts are observed in some cases and are attributed to weak-coupling between particle and surface. Higher overtones, i.e. the 5th and 7th, were utilized in order to derive additional information about the interactions taking place. For small particles, the shift for specific overtones can increase after annealing, while for large particle diameters annealing causes a negative frequency shift. The lower overtones correspond to a generally strong-coupling regime with mainly negative frequency shifts observed, while the 7th appears to be sensitive to the contact break-down and the recorded shifts are positive.rnDuring oscillation, the motion of the particles and the induced frequency shift of the QCM are governed by a balance between inertial forces and contact forces. The adherence of the particles can be increased by annealing the PS film at 150°C, which led to the formation of a PS meniscus. For the interpretation, the Hertz, Johnson-Kendall-Roberts, Derjaguin-Müller-Toporov and the Mindlin theory of partial slip are considered. The Mindlin approach is utilized to describe partial slip. When partial slip takes place induced by an oscillating load, a part of the contact ruptures. This results in a decrease of the effective contact stiffness. Additionally, there are long-term memory effects due to the consolidation which along with the QCM vibrations induce a coupling increase. However, the latter can also break the contact, lead to detachment and even surface damage and deformation due to inertia. For strong coupling the particles appear to move with the vibrations and simply act as added effective mass leading to a decrease of the resonance frequency, in agreement with the Sauerbrey equation that is commonly used to calculate the added mass on a QCM). When the system enters the weak-coupling regime the particles are not able to follow the fast movement of the QCM surface. Hence, they effectively act as adding a “spring” with an additional coupling constant and increase the resonance frequency. The frequency shift, however, is not a unique function of the coupling constant. Furthermore, the critical oscillation amplitude is determined, above which particle detach. No movement is detected at much lower amplitudes, while for intermediate values, lateral particle displacement is observed. rnIn order to validate the QCM results and study the particle effects on the surface, atomic force microscopy, AFM, is additionally utilized, to image surfaces and measure surface forces. By studying the surface of the polymer film after excitation and particle removal, AFM imaging helped in detecting three different meniscus types for the contact area: the “full contact”, the “asymmetrical” and a third one including a “homocentric smaller meniscus”. The different meniscus forms result in varying bond intensity between particles and polymer film, which could explain the deviation between number of particles per surface area measured by imaging and the values provided by the QCM - frequency shift analysis. The asymmetric and the homocentric contact types are suggested to be responsible for the positive frequency shifts observed for all three measured overtones, i.e. for the weak-coupling regime, while the “full contact” type resulted in a negative frequency shift, by effectively contributing to the mass increase of the quartz..rnThe interplay between inertia and contact forces for the particle-surface system leads to strong- or weak-coupling, with the particle affecting in three mentioned ways the polymer surface. This is manifested in the frequency shifts of the QCM system harmonics which are used to differentiate between the two interaction types and reflect the overall state of adhesion for particles of different size.rn

Flash floods and their effects on the development in El-Qaá plain area in South Sinai, Egypt

The arid regions are dominated to a much larger degree than humid regions by major catastrophic events. Although most of Egypt lies within the great hot desert belt; it experiences especially in the north some torrential rainfall, which causes flash floods all over Sinai Peninsula. Flash floods in hot deserts are characterized by high velocity and low duration with a sharp discharge peak. Large sediment loads may be carried by floods threatening fields and settlements in the wadis and even people who are living there. The extreme spottiness of rare heavy rainfall, well known to desert people everywhere, precludes any efficient forecasting. Thus, although the limitation of data still reflects pre-satellite methods, chances of developing a warning system for floods in the desert seem remote. The relatively short flood-to-peak interval, a characteristic of desert floods, presents an additional impediment to the efficient use of warning systems. The present thesis contains introduction and five chapters, chapter one points out the physical settings of the study area. There are the geological settings such as outcrop lithology of the study area and the deposits. The alluvial deposits of Wadi Moreikh had been analyzed using OSL dating to know deposits and palaeoclimatic conditions. The chapter points out as well the stratigraphy and the structure geology containing main faults and folds. In addition, it manifests the pesent climate conditions such as temperature, humidity, wind and evaporation. Besides, it presents type of soils and natural vegetation cover of the study area using unsupervised classification for ETM+ images. Chapter two points out the morphometric analysis of the main basins and their drainage network in the study area. It is divided into three parts: The first part manifests the morphometric analysis of the drainage networks which had been extracted from two main sources, topographic maps and DEM images. Basins and drainage networks are considered as major influencing factors on the flash floods; Most of elements were studied which affect the network such as stream order, bifurcation ratio, stream lengths, stream frequency, drainage density, and drainage patterns. The second part of this chapter shows the morphometric analysis of basins such as area, dimensions, shape and surface. Whereas, the third part points the morphometric analysis of alluvial fans which form most of El-Qaá plain. Chapter three manifests the surface runoff through rainfall and losses analysis. The main subject in this chapter is rainfall which has been studied in detail; it is the main reason for runoff. Therefore, all rainfall characteristics are regarded here such as rainfall types, distribution, rainfall intensity, duration, frequency, and the relationship between rainfall and runoff. While the second part of this chapter concerns with water losses estimation by evaporation and infiltration which are together the main losses with direct effect on the high of runoff. Finally, chapter three points out the factors influencing desert runoff and runoff generation mechanism. Chapter four is concerned with assessment of flood hazard, it is important to estimate runoff and tocreate a map of affected areas. Therefore, the chapter consists of four main parts; first part manifests the runoff estimation, the different methods to estimate runoff and its variables such as runoff coefficient lag time, time of concentration, runoff volume, and frequency analysis of flash flood. While the second part points out the extreme event analysis. The third part shows the map of affected areas for every basin and the flash floods degrees. In this point, it has been depending on the DEM to extract the drainage networks and to determine the main streams which are normally more dangerous than others. Finally, part four presets the risk zone map of total study area which is of high inerest for planning activities. Chapter five as the last chapter concerns with flash flood Hazard mitigation. It consists of three main parts. First flood prediction and the method which can be used to predict and forecast the flood. The second part aims to determine the best methods which can be helpful to mitigate flood hazard in the arid zone and especially the study area. Whereas, the third part points out the development perspective for the study area indicating the suitable places in El-Qaá plain for using in economic activities.

Climate change in Libya and desertification of Jifara Plain

The study was arranged to manifest its objectives through preceding it with an intro-duction. Particular attention was paid in the second part to detect the physical settings of the study area, together with an attempt to show the climatic characteristics in Libya. In the third part, observed temporal and spatial climate change in Libya was investigated through the trends of temperature, precipitation, relative humidity and cloud amount over the peri-ods (1946-2000), (1946-1975), and (1976-2000), comparing the results with the global scales. The forth part detected the natural and human causes of climate change concentrat-ing on the greenhouse effect. The potential impacts of climate change on Libya were ex-amined in the fifth chapter. As a case study, desertification of Jifara Plain was studied in the sixth part. In the seventh chapter, projections and mitigations of climate change and desertification were discussed. Ultimately, the main results and recommendations of the study were summarized. In order to carry through the objectives outlined above, the following methods and approaches were used: a simple linear regression analysis was computed to detect the trends of climatic parameters over time; a trend test based on a trend-to-noise-ratio was applied for detecting linear or non-linear trends; the non-parametric Mann-Kendall test for trend was used to reveal the behavior of the trends and their significance; PCA was applied to construct the all-Libya climatic parameters trends; aridity index after Walter-Lieth was shown for computing humid respectively arid months in Libya; correlation coefficient, (after Pearson) for detecting the teleconnection between sun spot numbers, NAOI, SOI, GHGs, and global warming, climate changes in Libya; aridity index, after De Martonne, to elaborate the trends of aridity in Jifara Plain; Geographical Information System and Re-mote Sensing techniques were applied to clarify the illustrations and to monitor desertifi-cation of Jifara Plain using the available satellite images MSS, TM, ETM+ and Shuttle Radar Topography Mission (SRTM). The results are explained by 88 tables, 96 figures and 10 photos. Temporal and spatial temperature changes in Libya indicated remarkably different an-nual and seasonal trends over the long observation period 1946-2000 and the short obser-vation periods 1946-1975 and 1976-2000. Trends of mean annual temperature were posi-tive at all study stations except at one from 1946-2000, negative trends prevailed at most stations from 1946-1975, while strongly positive trends were computed at all study stations from 1976-2000 corresponding with the global warming trend. Positive trends of mean minimum temperatures were observed at all reference stations from 1946-2000 and 1976-2000, while negative trends prevailed at most stations over the period 1946-1975. For mean maximum temperature, positive trends were shown from 1946-2000 and from 1976-2000 at most stations, while most trends were negative from 1946-1975. Minimum tem-peratures increased at nearly more than twice the rate of maximum temperatures at most stations. In respect of seasonal temperature, warming mostly occurred in summer and au-tumn in contrast to the global observations identifying warming mostly in winter and spring in both study periods. Precipitation across Libya is characterized by scanty and sporadically totals, as well as high intensities and very high spatial and temporal variabilities. From 1946-2000, large inter-annual and intra-annual variabilities were observed. Positive trends of annual precipi-tation totals have been observed from 1946-2000, negative trends from 1976-2000 at most stations. Variabilities of seasonal precipitation over Libya are more strikingly experienced from 1976-2000 than from 1951-1975 indicating a growing magnitude of climate change in more recent times. Negative trends of mean annual relative humidity were computed at eight stations, while positive trends prevailed at seven stations from 1946-2000. For the short observation period 1976-2000, positive trends were computed at most stations. Annual cloud amount totals decreased at most study stations in Libya over both long and short periods. Re-markably large spatial variations of climate changes were observed from north to south over Libya. Causes of climate change were discussed showing high correlation between tempera-ture increasing over Libya and CO2 emissions; weakly positive correlation between pre-cipitation and North Atlantic Oscillation index; negative correlation between temperature and sunspot numbers; negative correlation between precipitation over Libya and Southern Oscillation Index. The years 1992 and 1993 were shown as the coldest in the 1990s result-ing from the eruption of Mount Pinatubo, 1991. Libya is affected by climate change in many ways, in particular, crop production and food security, water resources, human health, population settlement and biodiversity. But the effects of climate change depend on its magnitude and the rate with which it occurs. Jifara Plain, located in northwestern Libya, has been seriously exposed to desertifica-tion as a result of climate change, landforms, overgrazing, over-cultivation and population growth. Soils have been degraded, vegetation cover disappeared and the groundwater wells were getting dry in many parts. The effect of desertification on Jifara Plain appears through reducing soil fertility and crop productivity, leading to long-term declines in agri-cultural yields, livestock yields, plant standing biomass, and plant biodiversity. Desertifi-cation has also significant implications on livestock industry and the national economy. Desertification accelerates migration from rural and nomadic areas to urban areas as the land cannot support the original inhabitants. In the absence of major shifts in policy, economic growth, energy prices, and con-sumer trends, climate change in Libya and desertification of Jifara Plain are expected to continue in the future. Libya cooperated with United Nations and other international organizations. It has signed and ratified a number of international and regional agreements which effectively established a policy framework for actions to mitigate climate change and combat deserti-fication. Libya has implemented several laws and legislative acts, with a number of ancil-lary and supplementary rules to regulate. Despite the current efforts and ongoing projects being undertaken in Libya in the field of climate change and desertification, urgent actions and projects are needed to mitigate climate change and combat desertification in the near future.