Modeling of complex chemical reactions and macromolecular orientation phenomena in confined geometries

The cooperative motion algorithm was applied on the molecular simulation of complex chemical reactions and macromolecular orientation phenomena in confined geometries. First, we investigated the case of equilibrium step-growth polymerization in lamellae, pores and droplets. In such systems, confinement was quantified as the area/volume ratio. Results showed that, as confinement increases, polymerization becomes slower and the average molecular weight (MW) at equilibrium decreases. This is caused by the sterical hindrance imposed by the walls since chain growth reactions in their close vicinity have less realization possibilities. For reactions inside droplets at surfaces, contact angles usually increased after polymerization to compensate conformation restrictions imposed by confinement upon growing chains. In a second investigation, we considered monodisperse and chemically inert chains and focused on the effect of confinement on chain orientation. Simulations of thin polymer films showed that chains are preferably oriented parallel to the surface. Orientation increases as MW increases or as film thickness d decreases, in qualitative agreement with experiments with low MW polystyrene. It is demonstrated that the orientation of simulated chains results from a size effect, being a function of the ratio between chain end-to-end distance and d. This study was complemented by experiments with thin films of pi-conjugated polymers like MEH-PPV. Anisotropic refractive index measurements were used to analyze chain orientation. With increasing MW, orientation is enhanced. However, for MEH-PPV, orientation does not depend on d even at thicknesses much larger than the chain contour length. This contradiction with simulations was discussed by considering additional causes for orientation, for instance the appearance of nematic-like ordering in polymer films. In another investigation, we simulated droplet evaporation at soluble surfaces and reproduced the formation of wells surrounded by ringlike deposits at the surface, as observed experimentally. In our simulations, swollen substrate particles migrate to the border of the droplet to minimize the contact between solvent and vacuum, which costs the most energy. Deposit formation in the beginning of evaporation results in pinning of the droplet. When polymer chains at the substrate surface have strong uniaxial orientation, the resulting pattern is no longer similar to a ring but to a pair of half-moons. In a final stage, as an extension for the model developed for polymerization in nanoreactors, we studied the effect of geometrical confinement on a hypothetical oscillating reaction following the mechanism of the so called periodically forced Brusselator. It was shown that a reaction which is chaotic in the bulk may be driven to periodicity by confinement and vice-versa, opening new perspectives for chaos control.

Polymer-nanoparticle composites: from orientation phenomena to optoelectronic applications

Polymer-nanoparticle hybrids show synergistic effects, demonstrating both, the unique properties of nanosized structures and the good processability and functionalities of polymeric materials. This work shows the synthesis and application of block copolymers containing a soluble, functional block and a short anchor block, which efficiently binds to the surface of nanocrystals. We functionalized anisotropic, semiconducting nanoparticles, which can be dissolved in organic and polymeric matrices upon modification. The modified nanorods have the ability to form liquid crystalline phases, which behave similar to low molecular liquid crystals with a reversible clearing behaviour. These liquid crystalline phases could also be obtained in hole conducting matrices. For a macroscopic orientation of the nanorods, electric fields were applied and a switching (in analogy to known liquid crystals) to a homeotropic orientation was observed.rnBy introduction of dye molecules in the anchor block of a hole conducting block copolymer, all essential components of a solar cell can be combined in a single particle. Light absorption of the dye induces the injection of electrons into the particles, followed by a charging, that was monitored by a special AFM technique.rnLight emitting nanocrystals were functionalized analogously with a hole transporting polymer. The stability of the particles could be enhanced by the sterically stabilizing polymer corona and the particles showed improved properties in terms of processing. We applied these hybrid materials in light emitting devices, which showed better characteristics due to an improved hole injection and well dispersed emitting particles in the active device layer.rnThe work shows the broad spectrum of properties and applications based on the synergistic effects in hybrid and composite materials.

High-mass Drell-Yan cross-section and search for new phenomena in multi-electron/positron final states with the ATLAS detector

The Standard Model of particle physics is a very successful theory which describes nearly all known processes of particle physics very precisely. Nevertheless, there are several observations which cannot be explained within the existing theory. In this thesis, two analyses with high energy electrons and positrons using data of the ATLAS detector are presented. One, probing the Standard Model of particle physics and another searching for phenomena beyond the Standard Model.rnThe production of an electron-positron pair via the Drell-Yan process leads to a very clean signature in the detector with low background contributions. This allows for a very precise measurement of the cross-section and can be used as a precision test of perturbative quantum chromodynamics (pQCD) where this process has been calculated at next-to-next-to-leading order (NNLO). The invariant mass spectrum mee is sensitive to parton distribution functions (PFDs), in particular to the poorly known distribution of antiquarks at large momentum fraction (Bjoerken x). The measurementrnof the high-mass Drell-Yan cross-section in proton-proton collisions at a center-of-mass energy of sqrt(s) = 7 TeV is performed on a dataset collected with the ATLAS detector, corresponding to an integrated luminosity of 4.7 fb-1. The differential cross-section of pp -> Z/gamma + X -> e+e- + X is measured as a function of the invariant mass in the range 116 GeV < mee < 1500 GeV. The background is estimated using a data driven method and Monte Carlo simulations. The final cross-section is corrected for detector effects and different levels of final state radiation corrections. A comparison isrnmade to various event generators and to predictions of pQCD calculations at NNLO. A good agreement within the uncertainties between measured cross-sections and Standard Model predictions is observed.rnExamples of observed phenomena which can not be explained by the Standard Model are the amount of dark matter in the universe and neutrino oscillations. To explain these phenomena several extensions of the Standard Model are proposed, some of them leading to new processes with a high multiplicity of electrons and/or positrons in the final state. A model independent search in multi-object final states, with objects defined as electrons and positrons, is performed to search for these phenomenas. Therndataset collected at a center-of-mass energy of sqrt(s) = 8 TeV, corresponding to an integrated luminosity of 20.3 fb-1 is used. The events are separated in different categories using the object multiplicity. The data-driven background method, already used for the cross-section measurement was developed further for up to five objects to get an estimation of the number of events including fake contributions. Within the uncertainties the comparison between data and Standard Model predictions shows no significant deviations.

Physiologische Konsequenzen eines gestörten Ceramid Stoffwechsels unter Beteiligung von Ceramidsynthase 3 und saurer Ceramidase = Physiological consequences of a disturbed ceramide metabolism due to altered activities of ceramide synthase 3 and acidic ceramidase

Tiefes Wissen über den Ceramid Stoffwechsel ist rudimentär für das Verständnis der Haut-Pathophysiologie (z.B. für atopische Dermatitis oder Psoriasis ) und unabdingbar für gezielte Therapieansätze. Wenn die zwei wichtigen Barriere Funktionen, gegen transepidermalen Wasserverlust und Pathogene Invasionen undicht werden, sind bestimmte Barriere Komponenten wie z.B. Ceramide stark verändert. In Haut und Hoden führt die Deletion der Ceramid-Synthase 3 zu einem Arrest der epidermalen Reifung und der Spermatogenese, welches ihre Bedeutung für eine intakte Barriere heraushebt. Sphingosin (So), ein Abbauprodukt von Cer, wurde als antimikrobielles Mittel identifiziert. So konnte das Wachstum von Candida albicans hemmen und die Invasion von Pathogenen in tiefere Hautschichten verringern, wodurch ihre mögliche Rolle in der Therapie von Hauterkrankungen gezeigt wurde. Auch eine neue Klasse von Ceramiden, die 1-O-acylceramide, wurde entdeckt. 1-O-acylceramide könnten zu einer funktionellen Wasserdurchlässigkeit Barriere beitragen, da sie zu den hydrophobesten der epidermalen Cers gehören. Die neutrale Glucosylceramidase scheint topologisch mit der 1-Oacylceramid Produktion verbunden zu sein, sowie die Enzyme der Diacylglycerol O-Acyltransferase-2 (DGAT2) Familie eine Rolle dabei spielen könnten. Die Identifizierung der für die 1-O-acylceramid Synthese verantwortlichen Enzyme wir Gegenstand weiterer Forschung sein, jedoch zeigten Untersuchungen an Mäusen, defizient für die saure Ceramidase (Farber-Krankheit), dass Makrophagen ein weiterer potenzieller Produktionsort sein könnten.

The physiological role of APP in the activation of neuroprotective signaling mechanisms

Accumulating evidence indicates that loss of physiological amyloid precursor protein (APP) function leads to enhanced susceptibility of neurons to cellular stress during brain aging. This study investigated the neuroprotective function of the soluble APP ectodomain sAPPα. Recombinant sAPPα protected primary hippocampal neurons and neuroblastoma cells from cell death induced by trophic factor deprivation. This protective effect was abrogated in APP-depleted neurons, but not in APLP1-, APLP2- or IGF1-R-deficient cells, indicating that expression of holo-APP is required for sAPPα-dependent neuroprotection. Strikingly, recombinant sAPPα, APP-E1 domain and the copper-binding growth factor-like domain (GFLD) of APP were able to stimulate PI3K/Akt survival signaling in different wildtype cell models, but failed in APP-deficient cells. An ADAM10 inhibitor blocking endogenous sAPPα secretion exacerbated neuron death in organotypic hippocampal slices subjected to metabolic stress, which could be rescued by exogenous sAPPα. Interestingly, sAPPα-dependent neuroprotection was unaffected in neurons of APP-ΔCT15 mice which lack the intracellular C-terminal YENPTY motif of APP. In contrast, sAPPα-dependent Akt signaling was completely abolished in APP mutant cells lacking the C-terminal G-protein interaction motif and by specifically blocking Gi/o-dependent signaling with pertussis toxin. Collectively, the present thesis provides new mechanistic insights into the physiological role of APP: the data suggest that cell surface APP mediates sAPPα-induced neuroprotection via Go-protein-coupled activation of the Akt pathway.