Sinterização de filmes finos de LiNbO3 em forno microondas: estudo da influência da direção do fluxo de calor

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Epitaxial growth of LiNbO3 thin films in a microwave oven

Oriented LiNbO3 thin films were prepared using a polymeric precursor solution deposited on (0001) sapphire substrate by spin coating and crystallized in a microwave oven. Crystallization of the films was carried out in a domestic microwave oven. The influence of this type of heat treatment on the film orientation was analyzed by X-ray diffraction and electron channeling patterns, which revealed epitaxial growth of films crystallized at 550 and 650 degreesC for 10 min. A microstructural study indicated that the films treated at temperatures below 600 degreesC were homogeneous and dense, and the optical properties confirmed the good quality of these films. (C) 2003 Elsevier B.V. B.V. All rights reserved.

Effects of substrate temperature, substrate orientation, and energetic atomic collisions on the structure of GaN films grown by reactive sputtering

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Substrate Preparation Behaviors for the Cultivation of the Symbiotic Fungus in Leaf-Cutting Ants of the Genus Atta (Hymenoptera: Formicidae)

Our findings revealed two distinct patterns of substrate preparation: the pattern of leaf-cutting ants foraging on dicotyledons is marked by highly fragmented substrate resulting in a more advanced initial decomposition. The pattern of leaf-cutting ants harvesting grasses is characterized by large pieces of substrate, resulting in little initial decomposition. Ants foraging on both types of plants are apparently intermediary between the two patterns, although more similar to the patterns of those foraging on dicotyledons. Also, the behavior of scraping the substrate was described for the first time, it is very important for the removal of the epicuticular wax layer of the leaves helping the growth of the symbiotic fungus.

Biosurfactants production by yeasts using soybean oil and glycerol as low cost substrate

Biosurfactants are bioactive agents that can be produced by many different microorganisms. Among those, special attention is given to yeasts, since they can produce many types of biosurfactants in large scale, using several kinds of substrates, justifying its use for industrial production of those products. For this production to be economically viable, the use of residual carbon sources is recommended. The present study isolated yeasts from soil contaminated with petroleum oil hydrocarbons and assessed their capacity for producing biosurfactants in low cost substrates. From a microbial consortium enriched, seven yeasts were isolated, all showing potential for producing biosurfactants in soybean oil. The isolate LBPF 3, characterized as Candida antarctica, obtained the highest levels of production - with a final production of 13.86 g/L. The isolate LBPF 9, using glycerol carbon source, obtained the highest reduction in surface tension in the growth medium: approximately 43% of reduction after 24 hours of incubation. The products obtained by the isolates presented surfactant activity, which reduced water surface tension to values that varied from 34 mN/m, obtained from the product of isolates LBPF 3 and 16 LBPF 7 (respectively characterized as Candida antarctica and Candida albicans) to 43 mN/m from the isolate LPPF 9, using glycerol as substrate. The assessed isolates all showed potential for the production of biosurfactants in conventional sources of carbon as well as in agroindustrial residue, especially in glycerol.

Pseudomonas aeruginosa LBI production as an integrated process using the wastes from sunflower-oil refining as a substrate

Pseudomonas aeruginosa LBI produced surface active rhamnolipids when cultivated on waste from the sunflower-oil process under different conditions. These biosurfactants, which reduce the superficial and interfacial tensions between fluids, offer advantages over their chemical counterparts, especially because of their ecological acceptability. These molecules can be used in fields as diverse as chemical, pharmaceutical and petrochemical industries. In this work, we present the effect of C/N ratio on growth and production yield. The best production yields (Y-P/S) were achieved for C/N ratios (in g/g) of 8/1 (0.22) and 6.4/1 (0.23). The product concentration was very satisfactory (7.3 g/L) at C/N ratio of 8/1, especially when considering that the substrate was basically composed of wastes that would otherwise constitute an environmental disposal problem. (c) 2007 Elsevier Ltd. All rights reserved.

Shiitake (lentinula edodes) production on a sterilized bagasse substrate enriched with rice bran and sugarcane molasses

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of substrate and mechanical scarification on the germination of Syagrus oleracea (Arecaceae) seeds

The slow and uneven germination of Syagrus oleracea seeds represents a problem for its propagation, especially for commercial production. This work aimed to study the effects of substrate and mechanical scarification on the germination of S. oleracea seeds. Germination (% G), emergence rate (ER), leaf area (cm(2)), root length (cm), leaf dry mass (g) and root dry mass (g) were also determined. Non-scarified seeds sown in vermiculite germinated faster and showed higher germination (65%), as well as greater root length (16.55 cm). leaf dry mass (5.07 g) and root dry mass (12.41 g), when compared to the scarified seeds.

Substrate and Temperature Effects on the Germination of Dypsis leptocheilos (Hodel) Beentje & J. Dransf. (Arecaceae) Seeds

Dypsis leptocheilos is highly valued as an ornamental palm. Its propagation is done by seeds; however, there is little information about this process. The objective of this work was to study the substrate and temperature effects on the germination of D. leptocheilos seeds. The experiments were carried out at FCAV/UNESP, Campus of Jaboticabal, São Paulo State, Brazil. In order to study the substrate effects, four treatments were arranged (coconut fiber, sand, vermiculite and Plantmax (R)) at 30 degrees C. For the temperature effects, six treatments were performed (temperature at laboratory conditions (21.5 degrees C and 72% RU), 25 degrees C, 30 degrees C, 35 degrees C, 20-30 degrees C and 25-35 degrees C), having the coconut fiber as the substrate. The experimental design was completely randomized, with four replicates of 25 disseminules per plot (seeds with attached endocarp). Water replacement was managed to maintain 100% of the retention capacity of the substrates. The germination tests were observed every two days, and conducted over 148 days for the substrate effects, and over 152 days for the temperature effects, when no more seed germination was noted. In order to determine the germination percentage (% G) and the Germination Speed Index (GSI), the seed was considered germinated when the germinative button appeared. At the end of the experiments, leaf area (cm(2)), root and shoot length (cm), root and shoot dry mass (g) were also obtained. Statistical analysis was performed and means were compared by the Tukey test. Germination rate and speed in coconut fiber was higher at 25 and 30 degrees C. However, when other substrates were tested at 30 degrees C, the highest germination percentage was observed in vermiculite, which also sustained better results for the seed germination and for the characteristics related to shoots and roots.

Influence of the substrate in germination of lychee seeds

A lichia é considerada em todo o mundo como a rainha das frutas, por sua aparência e sabor delicado. Atualmente, a cultura vem despertando interesse, principalmente no Estado de São Paulo, onde, em virtude dos problemas enfrentados pelos agricultores, destacando-se os de laranja e cana-de-açúcar, a procura por alternativas agrícolas vem se intensificando ainda mais. A propagação através de sementes não é recomendada comercialmente, pois as plantas de pé-franco são geneticamente muito desuniformes e apresentam período juvenil muito longo, demorando até 10 anos para entrar em produção; no entanto, a semente pode ser utilizada para a obtenção de porta-enxertos. Observou-se que a germinação de sementes de lichia ocorre rapidamente, reforçando a importância do uso de um substrato adequado. Pela análise dos resultados obtidos, verifica-se que o substrato que aparentemente permitiu as melhores combinações de água e disponibilidade de oxigênio para as sementes - casca de arroz carbonizada e areia lavada, foi o que proporcionou valores de germinação mais rápidos e mais altos.

Development of seedlings of red pitaya (Hylocereus undatus Haw) in different substrate volumes

Com a procura cada vez maior de alternativas por parte dos produtores rurais e de frutas exóticas pelos consumidores, o mercado de frutíferas tem crescido consideravelmente. Neste contexto, a pitaya vem sendo procurada não apenas pelo exotismo de sua aparência, como também por suas características organoléticas. O presente trabalho foi realizado objetivando avaliar a influência do volume de substrato no desenvolvimento de mudas de pitaya vermelha, utilizando-se bandejas de poliestireno expandido com diferentes volumes de células: 10, 15, 30 e 65 mL. As avaliações, realizadas aos 90 dias, foram quanto: porcentagem de sobrevivência; ao número e altura dos cladódios (cm), ao comprimento da maior raiz (cm); às massas fresca e seca dos cladódios e das raízes (gramas). O delineamento experimental foi inteiramente casualizado. Os dados de porcentagem de sobrevivência foram transformados em arc sen para fins de análise estatística e as médias comparadas pelo teste de Tukey, a 5% de probabilidade. A sobrevivência e o desenvolvimento vegetativo das mudas de pitaya vermelha através de sementes foram diretamente proporcionais ao volume de substrato usado no experimento. Para formação de mudas de pitaya vermelha através de sementes é recomendado o uso de containeres com capacidade de 65 mL.

Kinetic Analysis of Substrate Utilization by Native and TNAP-, NPP1-, or PHOSPHO1-Deficient Matrix Vesicles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Evaluation of harvested mushrooms and viability of Agaricus bisporus growth using casing materials made from spent mushroom substrate

P>The present work evaluates of harvested mushroom and viability of Agaricus bisporus growth in several casing materials based on spent mushroom substrate. The experiment consisted of eight casing layer, which six were made with spent mushroom substrate. The results confirm the usefulness of reincorporating the spent substrate in new cultivation cycles as an ingredient of casing mixtures. In general, biological efficiency was high, three of the SMS based-casings surpassing the threshold value of 100 kg 100 kg-1 of compost. The high electrical conductivity of mixtures containing a large proportion of spent substrate limits the extent to which it can be used, although mixing it with other materials (such as peat) reduces these values to acceptable levels. In short, it makes economic and environmental sense to reuse spent mushroom substrate as an ingredient of alternative casing materials.

Botryosphaeran, a new substrate for the production of beta-1,3-glucanases by Botryosphaeria rhodina and Trichoderma harzianum Rifai

Botryosphaeria rhodina and Trichoderma harzianum Rifai were grown on botryosphaeran (an exopolysaccharide (EPS) of the beta-1,3; 1,6-D-Glucan type produced by B. rhodina) as sole carbon source with the objective of producing beta-glucanases of the beta-type. Conditions for beta-1,3-glucanase production by T harzianum were examined by a statistical response surface method, and showed maximal enzyme production at 5 days growth in media containing 1.5 g/1 of EPS. Good agreement was obtained between the experimental values of beta-1, 3-glucanase activity and the corresponding values predicted by the mathernatical model. The crude beta-1,3-glucanase preparations were active towards a number of different beta-1,3-glucans and beta-glucosides. The mycelium of B. rhodina also proved to be a good substrate for beta-1,3-glucanase production by both fungal species. (c) 2005 Published by Elsevier Ltd.