Spot-test identification and rapid quantitative sequential analysis of dipyrone

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sequential injection analysis system with spectrophotometric detection for determination of norfloxacin and ciprofloxacin in pharmaceutical formulations

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A flow-injection-ICP system sequential multielemental analysis with simultaneously mercury(II) preconcentration step

A flow-injection system for multielemental analysis with a mercury(II) preconcentration step using a resin Chelite-S(R)(Serva Feinbiochemica Heidelberg, Part No. 41709) packed minicolumn by inductively coupled plasma atomic emission spectroscopy is described. A mercury reductive elution procedure with a mixture of SnCl2/HCl was used, which allows use of 6 mol/L HCl solution instead of concentrated hydrochoric acid. The main parameters related to ICP operation, such as radio frequency power (950-1750 W), auxiliary argon flow (0.0-1.5 L/min) and spray chamber nebulizer pressure (15-35 psi), were studied. Optimization of the FIA system was reached by defining the best eluent carrier stream (1.4-2.8 mL/min), Hgdegrees carrier stream (10-40 mL min(-1)), loading time (0.5-4.0 min), sample flow rate (1.25-10.0 mL/min), temperature of reactor gas liquid separator (GLS) (25-75 degreesC) and eluent volume (50-350 muL). Throughput is around 30 samples per hour for analytical solutions within the range 50-2500 ng Hg(II)/L. Results from certified material showed good precision (RSD < 3%, n = 12) and no statistical difference was observed for real samples analyzed by AAS and by the proposed system.

Simple orbit determination using GPS based on a least-squares algorithm employing sequential givens rotations

A low-cost computer procedure to determine the orbit of an artificial satellite by using short arc data from an onboard GPS receiver is proposed. Pseudoranges are used as measurements to estimate the orbit via recursive least squares method. The algorithm applies orthogonal Givens rotations for solving recursive and sequential orbit determination problems. To assess the procedure, it was applied to the TOPEX/POSEIDON satellite for data batches of one orbital period (approximately two hours), and force modelling, due to the full JGM-2 gravity field model, was considered. When compared with the reference Precision Orbit Ephemeris (POE) of JPL/NASA, the results have indicated that precision better than 9 m is easily obtained, even when short batches of data are used. Copyright (c) 2007.

Batch, sequential and hybrid approaches to spacecraft sensor alignment estimation

Two Kalman-filter formulations are presented for the estimation of spacecraft sensor misalignments from inflight data. In the first the sensor misalignments are part of the filter state variable; in the second, which we call HYLIGN, the state vector contains only dynamical variables, but the sensitivities of the filter innovations to the misalignments are calculated within the Kalman filter. This procedure permits the misalignments to be estimated in batch mode as well as a much smaller dimension for the Kalman filter state vector. This results not only in a significantly smaller computational burden but also in a smaller sensitivity of the misalignment estimates to outliers in the data. Numerical simulations of the filter performance are presented.

Sequential spectrophotometric determination of chromium(III) and chromium(VI) using flow injection analysis

A flow injection analysis (FIA) procedure for the speciation of Cr(III) and Cr(VI) using the 1,5-diphenylcarbazide (DPC) method is presented. As Cr(III) does not interfere in the Cr(VI) - DPC reaction, both Cr(VI) and total chromium [after the on-line oxidation of Cr(III) by Ce(IV)] are sequentially determined. Cr(III) is obtained by difference. Under the experimental conditions described, the calibration graphs are linear up to 2 μg mh1 of Cr(VI) and 4 μg ml-1 of Cr(III). The detection limits found were 18 ng ml -1 for Cr(VI) and 55 ng ml-1 for Cr(III), at a signal to noise ratio of 3. The common interfering elements in the Cr(VI) - DPC reaction were investigated under dynamic FIA conditions. The FIA method was also compared with the conventional spectrophotometric procedure.

Sequential Determination of Cd, Cu and Pb in Tea Leaves by Slurry Introduction to Thermospray Flame Furnace Atomic Absorption Spectrometry

A simple procedure for the sequential determination of Cd, Cu and Pb in tea leaves by slurry introduction to thermospray flame furnace atomic absorption spectrometry was developed. Detection limits were 0.05 mg kg-1 for Cd, 2.1 mg kg-1 for Cu and 0.68 mg kg-1 for Pb using 0.67 % (m/v) slurries (100 mg/15 mL). © 2013 Springer Science+Business Media New York.

Evaluation of Bone Heating, Drill Deformation, and Drill Roughness After Implant Osteotomy: Guided Surgery and Classic Drilling Procedure

Purpose: This study evaluated and compared bone heating, drill deformation, and drill roughness after several implant osteotomies in the guided surgery technique and the classic drilling procedure. Materials and Methods: The tibias of 20 rabbits were used. The animals were divided into a guided surgery group (GG) and a control group (CG); subgroups were then designated (G0, G1, G2, G3, and G4, corresponding to drills used 0, 10, 20, 30 and 40 times, respectively). Each animal received 10 sequential osteotomies (5 in each tibia) with each technique. Thermal changes were quantified, drill roughness was measured, and the drills were subjected to scanning electron microscopy. Results: Bone temperature generated by drilling was significantly higher in the GG than in the CG. Drill deformation in the GG and CG increased with drill use, and in the CG a significant difference between GO and groups G3 and G4 was observed. In the GG, a significant difference between GO and all other groups was found. For GG versus CG, a significant difference was found in the 40th osteotomy. Drill roughness in both groups was progressive in accordance with increased use, but there was no statistically significant difference between subgroups or between GG and CG overall. Conclusion: During preparation of implant osteotomies, the guided surgery technique generated a higher bone temperature and deformed drills more than the classic drilling procedure. The increase in tissue temperature was directly proportional to the number of times drills were used, but neither technique generated critical necrosis-inducing temperatures. Drill deformation was directly proportional to the number of times the drills were used. The roughness of the drills was directly proportional to the number of reuses in both groups but tended to be higher in the GG group.

Post-processing of sequential indicator simulation realizations for modeling geologic bodies

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

In situ differentiation of labile/inert metal species in Brazilian tropical rivers by means of a time-controlled batch-procedure based on TEPHA resin

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biological indicators of stress in pacu (Piaractus mesopotamicus) after capture

Os efeitos da captura (perseguição, contenção em puçá e exposição aérea) no perfil sanguíneo do cortisol, glicose, cloreto, sódio, potássio, cálcio e na osmolaridade, hematócrito, hemoglobina, número de células vermelhas (CV) e volume corpuscular médio (VCM) foram investigados no pacu (Piaractus mesopotamicus). Um total de 132 peixes (49,7 ± 11,7 g) foi submetido à captura com 3 ou 5 minutos de exposição aérea. Nove peixes de cada tratamento foram amostrados 5, 15, 30, 60 minutos e 24 horas depois e outros nove peixes foram amostrados antes da captura e considerados controle. A captura resultou em aumento do cortisol e glicose no sangue 30 e 5 minutos depois da captura, respectivamente, independente do tempo de exposição aérea. Ambos os indicadores recuperaram os valores controle em 24 horas. Nos dois grupos de peixes, o cloreto plasmático diminuiu 60 minutos após captura e não recuperou os valores controle, enquanto o sódio sérico aumentou entre 15 e 30 minutos recuperando a condição controle em 24 horas. Não houve alteração significativa nos valores de potássio, cálcio, osmolaridade ou no hematócrito, hemoglobina, CV e VCM como consequência da captura. Os estressores sequenciais aplicados no pacu durante a captura ativaram o eixo cérebro-pituitária-interrenal (respostas do cortisol e glicose), mas a ativação do eixo cérebro-sistema simpático-células cromafins foi aparentemente moderada (respostas iônicas e hematológicas).

Sequential histopathology at the Rhipicephalus sanguineus tick feeding site on dogs and guinea pigs

The tick Rhipicephalus sanguineus is a very common parasite of dogs worldwide. Dogs seem unable to acquire resistance against this tick species, whereas guinea pigs demonstrate a very strong resistance following primary infestation. We studied the inflammatory reaction at the R. sanguineus tick feeding site on dogs and guinea pigs during primary and tertiary infestations at different time intervals after attachment. Biopsies were collected after 4, 24, 48 and 96 hours. Changes that were found in all experimental groups included a cone of cement around the mouthparts of the tick, epidermal hyperplasia, edema and inflammatory cell infiltration in the dermis directly underneath the tick attachment site. Dogs reacted to ticks mainly with neutrophils, particularly after repeated exposure. Mast cells and mononuclear leukocytes were also present. Guinea pigs reacted to R. sanguineus mainly with mononuclear cells, eosinophils and basophils. These cells were particularly numerous after repeated exposure to R. sanguineus. Our results suggest that basophils and eosinophils are involved in resistance of guinea pigs to R. sanguineus and that neutrophils in dogs have little effect against this tick species.

Alternative procedure for the cold test for soybean seeds

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Observational Characterization of the Downward Atmospheric Longwave Radiation at the Surface in the City of São Paulo

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)