Análise da rotação ombro-quadril e co-contração muscular do tronco durante um movimento de rotação axial com manuseio de carga

Pós-graduação em Engenharia Mecânica - FEG

Pre-emptive epidural ketamine or S(+)-ketamine in post-incisional pain in dogs: A comparative study

Objective-To compare the pre-emptive analgesic effects of epidural ketamine or S(+)-ketamine on post-incisional hyperalgesia.Study Design-Prospective randomized study.Animals-Twenty-four mongrel dogs (1-5 years, weighing 11.9 +/- 1.8 kg).Methods-Dogs were anesthetized with propofol (5 mg/kg intravenously) and a lumbosacral epidural catheter was placed. Dogs were randomly allocated to 3 groups, each with 8 dogs. The control group (CG) was administered saline solution (0.3 mL/kg); the ketamine group (KG) ketamine (0.6 mg/kg); and the S(+)-ketamine group (SG) S(+)-ketamine (0.6 mg/kg). The final volume was adjusted to 0.3 mL/kg in all groups. Five minutes after the epidural injection a surgical incision was made in the common pad of the right hind limb and was immediately closed with simple interrupted nylon suture. Respiratory (RR) and heart (HR) rates, rectal temperature (7, sedation (S), lameness score, and mechanical nociceptive threshold by von Frey filaments were evaluated before the propofol anesthesia and at 15, 30, 45, 60, 75, and 90 minutes and then at 2, 4, 6, 8, 12, and 24 hours after epidural injection.Results-There were no differences in RR, HR, T, or S between groups. Motor blockade of the hind limbs was observed during 20 +/- 3.6 minutes in KG and during 30.6 +/- 7.5 minutes in SG (mean SD). Mechanical force applied to obtain an aversive response was higher from 45 minutes to 12 hours in KG and from 60 to 90 minutes in SG, when compared with CG.Conclusions-Pre-emptive epidural ketamine induced no alterations in RR and FIR, and reduced post-incisional hyperalgesia for a longer time than did S(+) ketamine.Clinical Relevance-Although anesthetic and analgesic potency of S(+) ketamine is twice that of ketamine, the racemic form is seemingly better for post-incisional hyperalgesia. (C) Copyright 2004 by the American College of Veterinary Surgeons.

Qualidade física e fisiológica de semente de soja colhida com sistema de trilha axial sob diferentes velocidades de operação e rotações do cilindro trilhador

A colheita mecanizada é ferramenta fundamental no processo produtivo das grandes culturas; se não for realizada adequadamente, poderá resultar em danos mecânicos severos às sementes, acarretando, prejuízos significativos na colheita, particularmente devido à redução da qualidade. Visando a avaliar os danos causados na colheita mecanizada de soja, o presente trabalho teve como objetivo estudar o efeito do sistema de trilha axial sobre a percentagem de bandinhas, impurezas e sementes quebradas de soja cv. M-Soy 8001, em função da velocidade de trabalho e rotação do cilindro trilhador. O delineamento experimental utilizado foi o inteiramente casualizado, em parcelas subdivididas, avaliando-se duas rotações do cilindro trilhador (400 e 500 rpm) e três velocidades de operação (3,5; 4,5 e 5,5 km h-1), com três repetições. Os resultados obtidos indicam que as combinações de velocidade de operação e rotações do cilindro de trilha avaliadas não afetam as variáveis vigor, impurezas, bandinha, emergência em areia e índice de velocidade de germinação e que o aumento da rotação de 400 para 500 rpm ocasiona o aumento de sementes quebradas.

Comparison of different analysis techniques for the determination of muscle onset in individuals with patellofemoral pain syndrome

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Absence of gluonic components in axial and tensor mesons

A quarkonium-gluonium mixing scheme previously developed to describe the characteristic of the pseudoscalar mesons is applied to axial and tensor mesons. The parameters of the model are determined by fitting the eigenvalues of a mass matrix. The corresponding eigenvectors give the proportion of light quarks, strange quarks and glueball in each meson. However, the predictions of the model for the branching ratios and electromagnetic decays are incompatible with the experimental results. These results suggest the absence of gluonic components in the states of axial and tensor isosinglet mesons analyzed here.

Unusual Yang-Lee edge singularity in the one-dimensional axial-next-to-nearest-neighbor Ising model

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of several TIG weld repairs on the axial fatigue strength of AISI 4130 aeronautical steel-welded joints

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Carbon fiber non-crimp multi-axial reinforcement and epoxy mono-component system composite: fatigue behavior

Fiber reinforced polymer composites have been widely applied in the aeronautical field. However, composite processing, which uses unlocked molds, should be avoided in view of the tight requirements and also due to possible environmental contamination. To produce high performance structural frames meeting aeronautical reproducibility and low cost criteria, the Brazilian industry has shown interest to investigate the resin transfer molding process (RTM) considering being a closed-mold pressure injection system which allows faster gel and cure times. Due to the fibrous composite anisotropic and non homogeneity characteristics, the fatigue behavior is a complex phenomenon quite different from to metals materials crucial to be investigated considering the aeronautical application. Fatigue sub-scale specimens of intermediate modulus carbon fiber non-crimp multi-axial reinforcement and epoxy mono-component system composite were produced according to the ASTM 3039 D. Axial fatigue tests were carried out according to ASTM D 3479. A sinusoidal load of 10 Hz frequency and load ratio R = 0.1. It was observed a high fatigue interval obtained for NCF/RTM6 composites. Weibull statistical analysis was applied to describe the failure probability of materials under cyclic loads and fractures pattern was observed by scanning electron microscopy. (C) 2010 Published by Elsevier Ltd.

Electromyographic preactivation pattern of the gluteus medius during weight-bearing functional tasks in women with and without anterior knee pain

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Topical (S)-ketamine for pain management of postherpetic neuralgia

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Refinement and initial validation of a multidimensional composite scale for use in assessing acute postoperative pain in cats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Maxillo-mandibular counter-clockwise rotation and mandibular advancement with TMJ Concepts (R) total joint prostheses Part III - Pain and dysfunction outcomes

47 end-stage TMJ patients with high occlusal plane angulation, treated with TMJ custom-fitted total joint prostheses and simultaneous maxillo-mandibular counter-clockwise rotation were evaluated for pain and dysfunction presurgery (T1) and at the longest follow-up (T2). Patients subjectively rated their facial pain/headache, TMJ pain, jaw function, diet and disability. Objective functional changes were determined by measuring maximum interincisal opening (MIO) and laterotrusive movements. Patients were divided according to the number of previous failed TMJ surgeries: Group 1 (0-1), Group 2 (2 or more). Significant subjective pain and dysfunction improvements (37-52%) were observed (<0.001). MIO increased 14% but lateral excursion decreased 60%. The groups presented similar absolute changes, but Group 2 showed more dysfunction at T1 and T2. For patients who did not receive fat grafts around the prostheses and had previous failure of proplast/teflon and or silastic TMJ implants, more than half required surgery for TMJ debridement and removal of foreign body giant cell reaction and heterotopic bone formation. End-stage TMJ patients can be treated in one operation with TMJ custom-made total joint prostheses and maxillo-mandibular counter-clockwise rotation, for correction of dentofacial deformity and improvement in pain and TMJ dysfunction; Group 1 patients had better results than Group 2 patients.

Postoperative periodontal pain prevention using two dexamethasone medication protocols: A double-blind, parallel-group, placebo-controlled randomized clinical trial

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Medical conditions and body pain in patients presenting orofacial pain

OBJETIVO: Verificar a frequência de problemas médicos autorrelatados e a frequência de áreas de dor no corpo em pacientes com dor orofacial, comparando-os a pacientes submetidos a tratamento odontológico de rotina. MÉTODOS: Os dados foram coletados dos arquivos da Clínica de Dor Orofacial (Grupo A, n=319) e de clínicas de tratamento odontológico rotineiro (Grupo B, n=84) da Faculdade de Odontologia de Araraquara, São Paulo, Brasil. Os indivíduos responderam a questionários e preencheram um mapa corporal indicando os locais de dor. RESULTADOS: O teste de Mann-Whitney demonstrou que o Grupo A apresentou uma média de relatos de problemas médicos superior ao Grupo B (p=0,004). Para ambos os grupos, o teste de correlação de Pearson demonstrou correlação positiva entre os problemas médicos e a frequência de áreas dolorosas (respectivamente, 0,478, p=0,001 e 0,246, p=0,000). CONCLUSÕES: O Grupo A relatou maior número de problemas médicos e houve correlação positiva entre a frequência desses problemas e a de áreas de dor para ambos os grupos.