Growth regulator losses from cotton plants due to rainfall

Reguladores de crescimento aplicados às plantas de algodoeiro (Gossypium hirsutum L.) podem ser lavados em função da ocorrência de chuvas. Chuvas que ocorrem próximas à época de aplicação podem ocasionar elevada perda e necessidade de reaplicação dos produtos visando à taxa de crescimento desejada. Avaliou-se o efeito do intervalo de tempo entre a ocorrência de chuva simulada e a aplicação de cloreto de mepiquat e cloreto de chlormequat no algodoeiro no crescimento das plantas, além de estimar a necessidade de reaplicação dos reguladores. Plantas de algodão foram cultivadas em vasos de 12 L que permaneceram em casa de vegetação. Os reguladores de crescimento foram aplicados 40 dias após a emergência, quando 50% das plantas apresentavam botão floral. A chuva foi simulada 1, 2, 4, 6 e 24 horas após a aplicação dos reguladores. Determinou-se a altura das plantas antes da aplicação dos produtos e a cada 3 dias até o 30º dia. Na colheita, foi avaliado o número de ramos e estruturas reprodutivas, com posterior determinação da massa da matéria seca. Também foi determinado o crescimento acumulado e taxa de crescimento das plantas. Os dois reguladores reduziram a massa da matéria seca das plantas, independente do intervalo para ocorrência da chuva. O crescimento excessivo das plantas foi controlado, porém, com eficiência reduzida quanto menor o intervalo para simulação de chuva. em todos os períodos avaliados houve perda de produtos, com necessidade de reaplicação. A taxa de reaplicação de cloreto de mepiquat para os diferentes intervalos de chuva foi, em média, 17% maior.

Plant growth regulator losses in cotton as affected by adjuvants and rain

Nas maiores regiões algodoeiras no Brasil, chove mais de 1.500mm anuais, existindo risco de ocorrer lavagem de reguladores de crescimento aplicados às folhas do algodoeiro, antes que sejam absorvidos. O objetivo deste trabalho foi avaliar a lavagem dos reguladores de crescimento cloreto de mepiquat e cloreto de chlormequat de folhas de algodoeiro por chuva, ocorrendo em diferentes momentos após a aplicação. O trabalho foi realizado em casa de vegetação. Ambos os reguladores foram aplicados no aparecimento do primeiro botão floral, na dose de 15g ha-1 de i.a. com e sem adjuvante siliconado, e chuva simulada foi aplicada aos 0, 0,75; 1,5; 3,0; 6,0; 12,0 e 24 horas após a aplicação dos reguladores, mais um tratamento sem chuva. A adição de adjuvante siliconado melhorou a absorção dos produtos. A ocorrência de chuva até mesmo 24 horas após a aplicação dos reguladores pode lavar parte dos produtos das plantas de algodoeiro, com maior intensidade para o tratamento sem adjuvante. A redução da absorção do produto leva à necessidade de reaplicá-lo para que possa haver a sua ação, sem comprometer sua função.

Single-phase high power-factor boost ZCS pre-regulator operating in critical conduction mode

This paper presents a new single-phase interleaved high power factor boost pre-regulator operating in critical conduction mode, where the switches and boost diode performing zero-current commutations during its turn-off, eliminating the disadvantages related to the reverse recovery losses and electromagnetic interference problems of the boost diode, when operating in the continuous conduction mode. The interleaving technique is applied in the power cell, providing a significant input current ripple reduction in comparison to discontinuous mode of operation, due to its input current continuous conduction operation. This paper presents a complete modeling for the converter operating in critical conduction mode, resulting in an improved design procedure for interleaved techniques with high input power factor, a complete design procedure, and main simulation results from a design example with two interleaved cells rated at 1kW, 400V output voltage and 220V rms input voltage.

Design of a Takagi-Sugeno Fuzzy Regulator for a Set of Operation Points

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Potential of the insect growth regulator, fluazuron, in the control of Rhipicephalus sanguineus nymphs (Latreille, 1806) (Acari: Ixodidae): Determination of the LD95 and LD50

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A phase-shifting control for variable frequency multi-cells interleaved boost pre-regulator based on FPGA device

In this paper were investigated phase-shift control strategies applied to a four cells interleaved high input-power-factor pre-regulator boost rectifier, operating in critical conduction mode, using a non-dissipative commutation cells and frequency modulation. The digital control has been developed using a hardware description language (VHDL) and implemented using the XC2S200E-SpartanII-E/Xilinx FPGA, performing a true critical conduction operation mode for a generic number of interleaved cells. Experimental results are presented, in order to verify the feasibility and performance of the proposed digital control, through the use of a Xilinx FPGA device.

Effect of the insect growth regulator diflubenzuron on the predator Podisus nigrispinus (Heteroptera: Pentatomidae)

Podisus nigrispinus (Dallas) (Heteroptera: Pentatomidae) is a common natural predator of defoliating caterpillars in agricultural and forest systems. Insecticides acting as growth regulators of insect pests can indirectly affect their predators through consumption of contaminated prey. We examined the reproductive performance of P. nigrispinus fed on caterpillars of Anticarsia gemmatalis Hubner (Lepidoptera: Noctuidae) reared on soybean leaves exposed to the chitin synthesis inhibitor, diflubenzuron. Caterpillars of A. gemmatalis were fed for 12 h with treated soybean leaves and offered to adults of the predator P. nigrispinus over five consecutive days. The fertility of P. nigrispinus was reduced when feeding on diflubenzuron treated caterpillars, especially at the beginning of the reproductive period, but recovered 3 weeks later. The effects of diflubenzuron ingestion on the life table parameters of P. nigrispinus included an increase in the period taken to double the population size, and reductions in the intrinsic rate of population increase, generation duration, and net reproductive rate. Diflubenzuron therefore had an indirect negative effect on the reproduction and the population dynamics of the non-target predator P. nigrispinus. Clearly, its use in integrated pest management requires further evaluation.

Modeling of pre-regulator boost ZCS interleaved operating in critical conduction mode and with high power factor

This paper presents a new pre-regulator boost operating in the boundary area between the continuous and discontinuous conduction modes of the boost inductor current, where the switches and boost diode performing zero-current commutations during its turn-off, eliminating the disadvantages related to the reverse recovery losses and electromagnetic interference problems of the boost diode when operating in the continuous conduction mode. Additionally, the interleaving technique is applied in the power cell, providing a significant input current ripple reduction. It should be noticed that the main objective of this paper is to present a complete modeling for the converter operating in the critical conduction mode, allowing an improved design procedure for interleaved techniques with high input power factor, a complete dynamic analysis of the structure, and the possibility of implementing digital control techniques in closed loop.

An AC voltage regulator with high-power-factor, and control using a FPGA device

This paper presents the analysis, design, simulation, and experimental results for a high frequency high Power-Factor (PF) AC (Alternate Current) voltage regulator, using a Sepic converter as power stage. The control technique employed to impose a sinusoidal input current waveform, with low Total Harmonic Distortion (THD), is the sinusoidal variable hysteresis control. The control technique was implemented in a FPGA (Field Programmable Gate Array) device, using a Hardware Description Language (VHDL). Through the use of the proposed control technique, the AC voltage regulator performs active power-factor correction, and low THD in the input current, for linear and non-linear loads, satisfying the requirements of the EEC61000-3-2 standards. Experimental results from an example prototype, designed for 300W of nominal output power, 50kHz (switching frequency), and 127Vrms of nominal input and output voltages, are presented in order to validate the proposed AC regulator. © 2005 IEEE.

Voltage regulator modeling for the three-phase power flow in distribution networks

In this paper a three-phase power flow for electrical distribution systems considering different models of voltage regulators is presented. A voltage regulator (VR) is an equipment that maintains the voltage level in a predefined value in a distribution line in spite of the load variations within its nominal power. Three different types of connections are analyzed: 1) wye-connected regulators, 2) open delta-connected regulators and 3) closed delta-connected regulators. To calculate the power flow, the three-phase backward/forward sweep algorithm is used. The methodology is tested on the IEEE 34 bus distribution system. ©2008 IEEE.

A mechanical analogous model for the power system with Automatic Voltage Regulator

This paper deals with the subject-matter of teaching immaterial issues like power system dynamics where the phenomena and events are not sense-perceptible. The dynamics of the power system are recognized as analogous to the dynamics of a simple mechanical pendulum taken into account the well-known classical model for the synchronous machine. It is shown that even for more sophisticated models including flux decay and Automatic Voltage Regulator the mechanical device can be taken as an analogous, since provided some considerations about variation and control of the pendulum length using certain control laws. The resulting mathematical model represents a mechanical system that can be built for use in laboratory teaching of power system dynamics. © 2010 Praise Worthy Prize S.r.l. - All rights reserved.

Optimal moment to change pressure regulator and sprayer kit on center pivot irrigation machines: a theoretical proposal

A theoretical model was developed in order to determine the optimal moment for substituting the sprayer and pressure regulator kit on a center pivot irrigation machine. The model is based on the hypothesis that pressure regulator and sprayer deterioration decrease irrigation uniformity. To compensate the deficit that happens at under irrigated areas, an increase on irrigation depth is required. The model considers: additional water consumption and energy costs, maintenance and labor costs, as well as yield losses associated with under or over irrigated areas. The sum of all these components is compared to buying and installing a new spray kit cost, allowing the farmer to decide the best moment to renovate the sprayer and pressure regulator kits on a center pivot irrigation machine based on economic criteria.

Optimal moment to change pressure regulator and sprayer kit on center pivot irrigation machines: application to a study case

A theoretical model developed by the authors for determining the optimal moment to substitute sprayer and pressure regulator kit on a center pivot irrigating potatoes and beans has been applied. The methodology compares the sum of the costs due to additional consumption of water and energy, maintenance and labor, as well as yield losses associated to areas with deficit or over irrigation to the costs due to buy and install a new sprinkling set on the pivot. The results showed that for a reduction of 3.07% of the Hermann and Hein’s Uniformity Coefficient (UCh), the substitution of the sprinkling module on the pivot is justified when potatoes and beans are cultivated.

Action of the insect growth regulator fluazuron, the active ingredient of the acaricide Acatak®, in Rhipicephalus sanguineus nymphs (Latreille, 1806) (Acari: Ixodidae)

The present study evaluated the efficacy of fluazuron (active ingredient of the acaricide Acatak®) and its effects on Rhipicephalus sanguineus nymphs fed on rabbits exposed to different doses of this insect growth regulator. Three different doses of fluazuron (20 mg/kg, 40 mg/kg, and 80 mg/kg) were applied on the back of hosts (via pour on), while distilled water was applied to the Control group. On the first day of treatment with fluazuron (24 h), hosts were artificially infested with R. sanguineus nymphs. Once fully engorged, nymphs were removed and placed in identified Petri dishes in Biochemical Oxygen Demand (BOD) incubator for 7 days. After this period, engorged nymphs were processed for ultramorphological analysis. The results revealed alterations in the ultramorphology of many chitinous structures (smaller hypostome and chelicerae, less sclerotized scutum, fewer sensilla, fewer pores, absence of grooves, marginal and cervical strips and festoons in the body, even the anal plaque was damaged) that play essential roles for the survivor of ticks and that can compromise the total or partial development of nymphs and emergence of adults after periodic molting. Our findings confirm the efficacy of fluazuron, a more specific and less aggressive chemical to the environment and human health, and that does not induce resistance, in nymphs of the tick R. sanguineus in artificially infested rabbits treated with this arthropod growth regulator (AGR), indicating that it could be used in the control of this stage of the biological cycle of the tick R. sanguineus. © 2013 Wiley Periodicals, Inc.

GENOTOXIC AND MUTAGENIC EFFECTS OF DIFLUBENZURON, AN INSECT GROWTH REGULATOR, ON MICE

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)