Potentialities and practical limitations of absolute neutron dosimetry using thin films of uranium and thorium applied to the fission track dating

Neutron dosimetry using natural uranium and thorium thin films makes possible that mineral dating by the fission-track method can be accomplished, even when poor thermalized neutron facilities are employed. In this case, the contributions of the fissions of (235)U, (238)U and (232)Th induced by thermal, epithermal and fast neutrons to the population of tracks produced during irradiation are quantified through the combined use of natural uranium and thorium films.If the Th/U ratio of the sample is known, only one irradiation (where the sample and the films of uranium and thorium are present) is necessary to perform the dating. However, if that ratio is unknown, it can be determined through another irradiation where the mineral to be dated and both films are placed inside a cadmium box.Problems related with film manufacturing and calibration are discussed. Special attention is given to the utilization of thin films having very low uranium content. The problems faced suggest that it may be better to substitute these films by uranium doped standard glasses calibrated with thicker uranium films (thickness greater than 1.5 x 10(13) mu m).

Response of L-alanine and 2-methylalanine minidosimeters for K-Band (24 GHz) EPR dosimetry

Minidosimeters of L-alanine and 2-methylalanine (2MA) were prepared and tested as potential candidates for small radiation field dosimetry. To quantify the free radicals created by radiation a K-Band (24 GHz) EPR spectrometer was used. X-rays provided by a 6 MV clinical linear accelerator were used to irradiate the minidosimeters in the dose range of 0.5-30 Gy. The dose-response curves for both radiation sensitive materials displayed a good linear behavior in the dose range indicated with 2MA being more radiation sensitive than L-alanine. Moreover, 2MA showed a smaller LLD (lower limit detection) value. The proposed system minidosimeter/K-Band spectrometer was able to detect 10 Gy EPR spectra with good signal-to-noise ratio (S/N). The overall uncertainty indicates that this system shows a good performance for the detection of dose values of 20 Gy and above, which are dose values typically used in radiosurgery treatments. (c) 2007 Elsevier B.V. All rights reserved.

Piezo and pyroelectric radiation dosimetry

The authors review the use of photoacoustic and pyroelectric radiation dosimeters. They compare the characteristics and results obtained with a photoacoustic radiation dosimeter (PARD) and a pyroelectric radiation dosimeter (PERD). The PARD and the PERD can be used to measure the energy fluence rate of continuous X-ray beams. In the same way, the single-pulse photoacoustic radiation dosimeter and the single-pulse pyroelectric radiation dosimeter (PPERD) were compared. They can measure the energy fluence of a single pulse of X-radiation. A theoretical model to explain the results obtained with the PPERD is presented and compared with experimental results.

Dosimetry and cost of imaging osseointegrated implants with film-based and computed tomography

Thermoluminescent dosimeters were used to measure radiation doses at craniofacial sites in a tissue-equivalent phantom during film-based multidirectional tomography with the Tomax Ultrascan (Incubation Industries, Ivyland, Pa.) and during computed tomography with the Elscint Excel 2400 (Elscint Corp., Tel Aviv, Israel). Mean absorbed doses for presurgical mandibular and maxillary canine and molar implant assessments were converted to equivalent doses, which were then multipied by published weighting factors and summed to give effective doses. The computed tomgraphy device consistently delivered higher doses than the Tomax Ultrascan to all anatomic locations; the differences were most pronounced when only one or two implant sites were evaluated. The reasons for the dose disparities are considered both anatomically and procedurally. A survey of examination cost revealed film-based multidirectional tomography to be less expensive than computed tomography.

Group analysis method for fission track thermochronology

A methodology to obtain ages and thermal histories of sets of apatite samples from localities with geologically compatible characteristics is described. A methodology exploring the fact that samples with similar geological characteristics should present the same thermal history is proposed. This approach can contribute for the obtainment of more conclusive results by analysing fewer samples than it is necessary when the samples are individually analysed. In order to determine the ages, we use the absolute neutron dosimetry through thin films of natural uranium along with lambda(f) = 8.46 x 10(-17) a(-1). As an example of application of the proposed methodology, we analyse samples collected in a Brazilian region, Sao Francisco Craton, which experienced low tectonic activity. (C) 2008 Elsevier Ltd. All rights reserved.

Optical Behavior of Conjugated Pt-Containing Polymetallaynes Exposed to Gamma-Ray Radiation Doses

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Dosimetric properties of UV irradiated calcium co-doped borate glass-ceramic

The thermoluminescence (TL) response of Dy and Li doped 20CaB(4)O(7)-80CaB(2)O(4) (Wt%) glass-ceramic irradiated with ultraviolet (UV) radiation was studied. In order to act as TL activator ions, the Dy and Li ions were included in the matrix during the melting process to increase its TL efficiency. A single crystalline CaB2O4 phase was present in the glass-ceramic as determined by X-ray diffraction (XRD). The glass-ceramic 20CaB(4)O(7)-80CaB(2)O(4):Dy,Li wt% (named 20CBO7:Dy,Li) is a newly prepared TL material. Its thermoluminescent dosimetric characteristics have shown a linear response under UV radiation exposure and a good TL signal reproducibility, thus proving to be a promising material for using as an ultraviolet radiation dosimeter. (C) 2007 Elsevier B.V. All rights reserved.

Glutaraldehyde-treated homologous vein graft as a vein substitute: experimental study in rabbits

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo comparativo entre protocolos para profilaxia da trombose venosa profunda: uma nova proposta

INTRODUÇÃO: O artigo compara os protocolos Davison-Caprini (americano) e Sandri (brasileiro) para profilaxia da trombose venosa profunda (TVP), buscando a elaboração de um novo protocolo, mais abrangente e aplicável. MÉTODO: Foi realizado um estudo prospectivo, durante um ano, abrangendo 212 pacientes, comparando os protocolos quanto à estratificação de risco de TVP, e ao tipo de profilaxia indicado. Um novo protocolo foi proposto, aplicado e comparado aos anteriores. RESULTADOS: Obteve-se um novo protocolo, denominado Sandri modificado, que restringe a heparina a um grupo seleto de pacientes, semelhante ao americano, mantendo-se adequado tanto para cirurgias estéticas quanto reparadoras. CONCLUSÕES: A baixa adesão, por parte dos cirurgiões plásticos, ao uso rotineiro da profilaxia de TVP, espelha a escassez de informação sobre o tema. O protocolo Sandri modificado busca melhorar a compreensão e a aplicabilidade da profilaxia da TVP na cirurgia plástica.

Controle de qualidade e dosimetria em equipamentos de tomografia computadorizada

OBJETIVO: Avaliação de condições dos equipamentos e dosimetria em setores de tomografia computadorizada utilizando protocolos de cabeça, abdome e coluna lombar em pacientes adultos (em três equipamentos distintos) e pediátricos com até um ano e meio de vida (em um dos equipamentos avaliados). MATERIAIS E MÉTODOS: Foram estimados o índice de dose em tomografia computadorizada e a dose média em cortes múltiplos, em exames com pacientes adultos, em três distintos equipamentos. Ainda foram estimadas as doses na superfície de entrada e as doses absorvidas em exame de cabeça para pacientes adultos e pediátricos em um dos equipamentos avaliados. RESULTADOS: Foram realizados testes de controle de qualidade, mecânicos, demonstrando que os equipamentos satisfazem as especificações de uso estabelecidas pelas normas vigentes. Os resultados da dosimetria mostraram que valores de dose média em cortes múltiplos excederam em até 109,0% os valores de níveis de referência, apresentando consideráveis variações entre os equipamentos avaliados neste estudo. As doses absorvidas obtidas com protocolos pediátricos são inferiores aos de pacientes adultos, apresentando redução de até 51,0% na tireoide. CONCLUSÃO: Neste estudo foram avaliadas as condições de operação de três equipamentos tomográficos, estabelecendo quais parâmetros devem ser trabalhados para a implantação de um programa de controle de qualidade nas instituições onde esta pesquisa foi desenvolvida.

A complete dosimetric characterization of two Sr-90-Y-90 dermatologic applicators

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Feasibility of oncoplastic techniques in the surgical management of locally advanced breast cancer

Background: Locally advanced breast cancer (LABC) is still common in developing countries. The association between neoadjuvant chemotherapy (NC) and oncoplastic surgery (OS) might provide an oncological treatment with satisfactory aesthetic results.Purpose: The goal was to demonstrate if oncoplastic surgical techniques can be utilized to treat LABC which was submitted to neoadjuvant chemotherapy.Methods: This prospective clinical trial included breast cancer patients, clinical stage III, who underwent established NC regimen. All patients underwent preoperative planning to control the tumor size and to define the surgical technique. A detailed analysis of the pathological specimen was performed.Results: 50 patients were assessed and surgically treated. Tumor size ranged from 3.0 to 14.0 cm (median 6.5 cm). Pathologic response was rated as stable, progressive, partial response, and complete response in 10%, 8%, 80% and 2% of the cases, respectively. Seventeen (34%) patients were submitted to OS. No patient had positive margins. Skin involvement was presented in 36% of pathologic specimen.Conclusions: Oncoplastic surgical techniques for selected patients decrease the rates of radical surgery despite large tumors. (www.clinicaltrials.gov, NCT00820690). (C) 2012 Surgical Associates Ltd. Published by Elsevier Ltd. All rights reserved.

Enxerto dermoadiposo em cavidades anoftálmicas secundárias - estudo retrospectivo e revisão da literatura

Purpose: To evaluate the dermofat graft in the anophthalmic socket treatment. Methods: A retrospective study including 28 anophthalmic cavity carriers treated with dermofat graft was carried out. The patients were analyzed according to age, sex, socket contraction degree, first surgery performed, reason for graft choice, procedure's results and complications. The data were analyzed according to the frequency of occurrence. Results: Nineteen (67.8%) of the 28 analyzed patients were male. According to age the majority of patients were between 40 to 60 years old (13 patients - 46.4%) and the most common cause of eyeball loss was trauma (seven cases - 25%). Anophthalmic socket type III was the most frequently observed (32.1%). The evisceration was the first procedure in 13 cases, enucleation in 11 and skin graft was done in two patients. Two patients came to the service after evisceration and did not provide any information about the first surgery. The choice to use the dermofat graft was to replace volume at the socket of 12 patients (42.8%). Most of the patients (53.6%) had no complications and graft necrosis was the problem most frequently observed (32.1%). The surgery was considered good in 71.4% and not good in only 7.1%. Conclusion: the dermofat graft is an efficient and easy technique to reconstruct the anophthalmic cavity. The authors suggest this procedure must be introduced in the medical training services since it provide good results.

Comparison of synthetic hydroxyapatite and porous polyethylene implants in eviscerated rabbit eyes

Purpose: Synthetic hydroxyapatite and porous polyethylene (Polipore) spheres were placed in rabbits' eviscerated cavities to evaluate tissue reaction and volume maintenance.Methods. Fifty-six Norfolk albino rabbits underwent unilateral evisceration and implantation of synthetic hydroxyapatite (H group, 28 animals) or porous polyethylene spheres (P group, 28 animals). Postoperative reactions, animal behavior, and socket conditions were monitored. Light microscopy and morphometric evaluation with statistical analysis of the exenterated orbits were performed at 7, 15, 30, 60, 90, 120, and 180 days. Scanning electron microscopy was appraised 7, 60, and 180 days after surgery.Results: Two animals from the H group and 1 from the P group had extrusion 7 days after surgery. Throughout the experimental period, the synthetic hydroxyapatite caused more inflammation than the porous polyethylene material. Ingrowth in the sphere occurred 7 to 15 days after the surgery in both groups, and the tissue reaction became denser at approximate to60 to 90 days, when bony metaplasia began in the H group. Volume maintenance was better in the P group and with a smaller pseudocapsule surrounding the implanted sphere than in the H group.Conclusions: Clinical findings demonstrated mild inflammation inside the sphere and in the pseudocapsule surrounding it and better cavity volume maintenance in the P group animals. The authors consider porous polyethylene a more suitable material than synthetic hydroxyapatite for use in anophthalmic cavity reconstruction.

Influence of Cusp Inclination on Stress Distribution in Implant-Supported Prostheses. A Three-Dimensional Finite Element Analysis

Purpose: The aim of this study was to assess the influence of cusp inclination on stress distribution in implant-supported prostheses by 3D finite element method.Materials and Methods: Three-dimensional models were created to simulate a mandibular bone section with an implant (3.75 mm diameter x 10 mm length) and crown by means of a 3D scanner and 3D CAD software. A screw-retained single crown was simulated using three cusp inclinations (10 degrees, 20 degrees, 30 degrees). The 3D models (model 10d, model 20d, and model 30d) were transferred to the finite element program NeiNastran 9.0 to generate a mesh and perform the stress analysis. An oblique load of 200 N was applied on the internal vestibular face of the metal ceramic crown.Results: The results were visualized by means of von Mises stress maps. Maximum stress concentration was located at the point of application. The implant showed higher stress values in model 30d (160.68 MPa). Cortical bone showed higher stress values in model 10d (28.23 MPa).Conclusion: Stresses on the implant and implant/abutment interface increased with increasing cusp inclination, and stresses on the cortical bone decreased with increasing cusp inclination.