65 resultados para Pile caps
em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"
Resumo:
This work presents a comparative analysis about the behaviour of pile caps supported by 3 piles subjected to axial loading. Piles with 20 cm and 30 cm diameters were analysed. The main reinforcement was maintained in all the specimens, however, the arrangement of the secondary reinforcement varied. The main reinforcement consisted of steel bars connecting the piles. The secondary reinforcement was made up of: (a) bars going through the piles and through the projection of the column, (b) bars forming a network, and (c) vertical and horizontal stirrups. The main objective was the observation of the pile cap behaviour regarding the cracks and the modes of rupture. The real scale specimens were subjected to experimental tests until failure by rupture. Instruments were placed with the aim to obtain the displacement of the bases, the strains in the main and secondary reinforcement bars, in the compression struts, in the lower and upper nodal zones and in the sides of the caps. None of the caps reached failure by rupture with a load less than 1.12 times the theoretical load. The specimens ruptured due to the cracking of the compression strut and/or the yielding of the reinforcement bars in one direction.
Resumo:
During the construction of five residential buildings in the city of Taubate, State of São Paulo, it was possible to carry out one comprehensive investigation of the behavior of precast concrete piles in clay shales. This paper describes the results of Dynamic Load Tests (DLT's) executed in three piles with different diameters and with the same embedded length. The tests were monitored using the PDA(R) (Pile Driving Analyzer) and the pile top displacement was measured by pencil and paper procedure. From the curves of RMX versus DMX resulted from CASE(R) method, CAPWAPC(R) analyses were made for signals where the maximum mobilized soil resistance was verified. The results were compared with the predicted bearing capacity using the semi-empirical method of Decourt & Quaresma (1978) and Decourt (1982) based on SPT values and the description of the soil profile. Some comments related to the values of quake and damping used for clay shales in the analyses are also presented.
Resumo:
The uplift capacity of helical piles depends on the shear resistance of the soil above the helical plates. During helical pile installation, the soil traversed by the plates are sheared and displaced laterally, and consequently the soil structure is disturbed. Considering this fact, the aim of this paper is presenting the effect of helical piles installation in the soil mass by means of CPT tests carried out close to the soil cylinder above the pile helices. The CPT tests were performed at the CRHEA site from the Sao Carlos School of Engineering, Sao Carlos city, inland of Sao Paulo State, Brazil. In addition, an interpretation of CPT tests data for stratigrafic logging are presented and compared to Standard Penetration Tests (SPT) carried out at this site. This study showed that the CPT sleeve friction fs data were affected by the installation of helical pile in this particular tropical soil site. © 2013 Taylor & Francis Group.
Resumo:
Pós-graduação em Psicologia do Desenvolvimento e Aprendizagem - FC
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
O objetivo deste trabalho foi avaliar as modificações químicas, microbiológicas e sensoriais do leite caprino pasteurizado e congelado durante armazenamento por 90 dias. Foram realizadas análises para caracterização química da matéria prima utilizada nos experimentos (gordura, acidez Dornic, densidade, extrato seco total, pH e ácidos graxos livres-AGL) e caracterização microbiológica (contagem total, psicrotróficos, coliformes totais e fecais). Utilizou-se pasteurização lenta a 63°±1°C por 30 minutos para as amostras de leite seguido de armazenamento em freezer à temperatura de -18°C±1°C. Nos tempos 0, 30, 60 e 90 dias de congelamento foram efetuadas análises químicas (pH, acidez e AGL), microbiológicas (contagem total, psicrotróficos e coliformes) e sensoriais (sabor e aroma característico, sabor e odor estranho e aparência geral). Também, realizou-se análise sensorial do leite nos tempos zero e com 90 dias de armazenamento, após descongelamento e homogeneização em liquidificador por dois minutos. Foi observado que o congelamento prolongado do leite pasteurizado não alterou significativamente suas características químicas e microbiológicas. Apenas a acidez apresentou decréscimo significativo. No entanto, a qualidade do leite do ponto de vista sensorial apresentou modificações significativas, com perdas de sabor e aroma característicos e declínio acentuado da aparência geral durante o armazenamento. A homogeneização do leite em liquidificador, após o descongelamento melhorou a aparência geral e a aceitação do produto pela equipe de provadores.
Resumo:
A superfície interna das bisnagas fabricadas com alumínio não revestido e revestido com resina epóxi, utilizadas para acondicionar cremes, pomadas, géis, etc., foram avaliadas quimicamente e por métodos microbiológicos correlacionados com a aderência de microrganismos. A prova da porosidade e da resistência à remoção da resina foi observada por meio do microscópio eletrônico de varredura (Topcon FM300) e estereoscópio Leica (MZ12) acoplado a Sistema de Digitalização de Imagens. Para avaliar a ação dos microrganismos foram utilizados corpos-de-prova esterilizados (discos de 10mm de diâmetro), imersos em caldo Mueller Hinton (Difco) e colocados em tubos de polipropileno com tampa de rosca (Corning). Foram inoculados tubos com meio de cultura para cada uma das suspensões bacterianas (10(9)UFC/mL) de Streptococcus agalactiae, Staphylococcus aureus, Acinetobacter lwoffii e Candida albicans, incubados a 37°C, sob agitação constante durante 12 dias. O meio de cultura era trocado a cada 3 dias. Após esse período, os corpos-de prova foram removidos, processados e observados em microscópio eletrônico de varredura JEOL-JSM (T330A). A observação por meio do microscopio eletrônico de varredura mostrou a aderência e a formação de biofilme sobre a superfície de alumínio não revestido e revestido com resina epóxi.
Resumo:
The results of dynamic instrumentation in two construction sites that used steel rails as pile foundation are presented in this paper. The first dynamic load tests were executed in piles made by single steel rails of the type TR32 and TR37. In the second group of dynamic tests, the piles were made by a composition of two and three steel rails of the same type TR37. The difficulties in placing the sensors, the effect of hammer blow eccentricity and the influence of the non-uniform welding along the pile length are presented in detail and discussed.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
2-Keto-3-deoxy-6-phosphogluconate (KDPG) aldolase from Pseudomonas putida is a key enzyme in the Entner-Doudoroff pathway which catalyses the cleavage of KDPG via a class I Schiff-base mechanism. The crystal structure of this enzyme has been refined to a crystallographic residual R = 17.1% (R-free = 21.4%). The N-terminal helix caps one side of the torus of the (betaalpha)(8)-barrel and the active site is located on the opposite, carboxylic side of the barrel. The Schiff-base-forming Lys145 is coordinated by a sulfate (or phosphate) ion and two solvent water molecules. The interactions that stabilize the trimer are predominantly hydrophobic, with the exception of the cyclically permuted bonds formed between Glu132 OE1 of one molecule and Thr129 OG1 of a symmetry-equivalent molecule. Except for the N-terminal helix, the structure of KDPG aldolase from P. putida closely resembles the structure of the homologous enzyme from Escherichia coli.
Resumo:
Este trabalho investiga o aspecto qualitativo da Reforma Psiquiátrica no interior do estado de São Paulo, por meio da análise dos discursos presentes no campo da Saúde Mental. Balizamo-nos no referencial da Atenção Psicossocial enquanto corpo teórico-prático e ético para transformação paradigmática em Saúde Mental. Como método, utilizamos entrevistas semi-dirigidas com coordenadores de CAPS e coordenadores municipais de Saúde Mental, e observações participantes, analisadas por meio do método dialético de análise de discurso. Foram encontradas três matrizes teóricas principais dos discursos (Psiquiatria Tradicional, Psiquiatria Preventivo-Comunitária, Atenção Psicossocial) coexistindo no espaço institucional. A vertente Preventivo-Comunitária mostrou-se bem instalada e superando técnica e teoricamente a Psiquiatria Tradicional, porém dificultando o avanço da Atenção Psicossocial em termos éticos.
Resumo:
O presente estudo é uma reflexão crítica sobre um estágio realizado para pensar o dispositivo Oficina na Atenção Psicossocial (CAPS), levantando, a partir da teoria psicanalítica lacaniana, questões que permitiram desenvolver um trabalho sobre o laço social de Lacan para refletir a posição de estagiários e usuários dentro da oficina e problematizar a melhor maneira de trabalhar quando tratamos de sujeitos constituídos pela foraclusão. A forma de trabalhar o sofrimento mental também é discutida a partir da clínica ampliada, que coloca a doença entre parênteses para enxergar o sujeito. A criação de uma oficina, destinada a sujeitos constituídos pela foraclusão, trabalha com a hipótese de reestruturação psíquica através da criação artística. Funcionaria como delírio para a saída do desmoronamento foraclusivo e na diminuição do gozoOutro. Considera-se a dimensão da enunciação, sempre atenta ao surgimento de significantes, com o objetivo de dar maior suporte aos usuários da instituição. O Dispositivo Oficina seria o lugar onde se realizaria esta importante forma de subjetivação.
Resumo:
The objective was to evaluate the differences between distinct types of litter material and their combinations in the dynamics of degradation on the organic matter fractions and the quality of the final compound. The treatments were established according to material used as substrate for broiler litter: treatment 1 - rice husks; 2 - sugar cane bagasse; 3 - wood shavings; 4 - wood shavings + sugar cane bagasse; 5 - rice husks + sugar cane bagasse; and 6 - Napier grass. The following variables were monitored: temperature, levels of total solids (TS), volatile solids (VS), mass and volume of the pile, fibrous fraction, and levels and reductions of N, P and K during the process. Piles formed with Napier grass and sugar cane bagasse presented the highest average temperatures during composting. The greater average reductions in TS and VS were attained in piles with sugar cane bagasse (68.12 and 73.07%, for TS and VS, respectively). The reductions of greatest volume occurred in piles with sugar cane bagasse (52.08%), followed by Napier grass (50.56%). Poultry litters composed of rice husks and wood shavings presented 13.21 and 10.23% of lignin, respectively, which contributed to the lower degradation of fibrous fraction and degradability. Substrates with lower lignin content were those with greatest organic matter degradation rate and had reduced losses of N levels during the process. Composting performance is affected by the initial substrate used to compose the poultry litter.