Technical and economic evaluation of different types of control of Brevipalpus phoenicis (Acari: Tenuipalpidae) in citrus leprosies management

The objective of this work was to evaluate the effect of acaricide applications and pruning of symptomatic branches in citrus leprosis management in Brazil. It was conducted in an orange plantation of the 'Pera' variety, grafted onto the 'Cleopatra' tangerine, in two seasons (2006-2007 and 2007-2008). The experimental design was randomized blocks in a factorial scheme consisting of the following factors: (A) acaricide, in three levels: spirodiclofen and cyhexatin applied in rotation, lime sulphur; no acaricides; (B) pruning to remove branches that showed symptoms of leprosis, with two levels: with pruning, without pruning. We carried out periodic assessments of Brevipalpus phoenicis (Geijskes) populations (vector of the leprosis virus), leprosis incidence and severity, fruit yield, and the economic feasibility of the applied strategies. Based on the results, we concluded that spirodiclofen and cyhexatin were more effective than lime sulphur in B. phoenicis control. Control with lime sulphur required more applications than spirodiclofen and cyhexatin in rotation, making it more expensive. Pruning of symptomatic branches used in isolation was not sufficiently effective to control leprosis and significantly increased control costs. Profits were higher when the control involved sprayings of spirodiclofen and cyhexatin in alternation, with or without pruning.

Optimised placement of control and protective devices in electric distribution systems through reactive tabu search algorithm

Optimised placement of control and protective devices in distribution networks allows for a better operation and improvement of the reliability indices of the system. Control devices (used to reconfigure the feeders) are placed in distribution networks to obtain an optimal operation strategy to facilitate power supply restoration in the case of a contingency. Protective devices (used to isolate faults) are placed in distribution systems to improve the reliability and continuity of the power supply, significantly reducing the impacts that a fault can have in terms of customer outages, and the time needed for fault location and system restoration. This paper presents a novel technique to optimally place both control and protective devices in the same optimisation process on radial distribution feeders. The problem is modelled through mixed integer non-linear programming (MINLP) with real and binary variables. The reactive tabu search algorithm (RTS) is proposed to solve this problem. Results and optimised strategies for placing control and protective devices considering a practical feeder are presented. (c) 2007 Elsevier B.V. All rights reserved.

Optimized Allocation of Control and Protective Devices in Electric Distribution Systems

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Patients' expectations and satisfaction of complete denture therapy and correlation with locus of control

P>Considering the importance of patients' satisfaction with complete denture therapy and the influence of psychosocial aspects and expectations regarding satisfaction with their dentures, the present study aimed to test for a correlation between locus of control profiles and expectations before and satisfaction after complete denture therapy. Sixty-four patients rated their expectations for aesthetic and functional results of complete denture therapy on a 10-cm visual analogue scale (VAS), using scores from 0 (worst results) to 10 (best results). A similar questionnaire was used regarding satisfaction after final denture adjustments. Patients also answered a locus of control questionnaire in the initial interview. anova and a chi-squared test were used to test for correlations among ratings, patient gender and locus of control profiles. The significance level adopted was 0 center dot 05. The expectation ratings before treatment were significantly lower than the post-treatment completion ratings, both for aesthetics (P < 0 center dot 001) and function (P = 0 center dot 004). There was no correlation between locus of control profiles and patients' ratings or between gender and VAS scores. No correlation was found between locus of control profiles and scores for expectations before and satisfaction after complete dentures.

Influence of distance, geometry and number of control stations on quality of local geodetic networks for the purpose of georeferencing of rural properties

The implementation of local geodetic networks for georeferencing of rural properties has become a requirement after publication of the Georeferencing Technical Standard by INCRA. According to this standard, the maximum distance of baselines to GNSS L1 receivers is of 20 km. Besides the length of the baseline, the geometry and the number of geodetic control stations are other factors to be considered in the implementation of geodetic networks. Thus, this research aimed to examine the influence of baseline lengths higher than the regulated limit of 20 km, the geometry and the number of control stations on quality of local geodetic networks for georeferencing, and also to demonstrate the importance of using specific tests to evaluate the solution of ambiguities and on the quality of the adjustment. The results indicated that the increasing number of control stations has improved the quality of the network, the geometry has not influenced on the quality and the baseline length has influenced on the quality; however, lengths higher than 20 km has not interrupted the implementation, with GPS L1 receiver, of the local geodetic network for the purpose of georeferencing. Also, the use of different statistical tests, both for the evaluation of the resolution of ambiguities and for the adjustment, have enabled greater clearness in analyzing the results, which allow that unsuitable observations may be eliminated.

Controllability of control systems on complex simple lie groups and the topology of flag manifolds

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of a semantically grained database system for distribution and control within design environments

This paper presents a technique to share the data stored in an object-oriented database aimed at designing environments. This technique shares data between two related databases, called the Original and Product databases, and is composed of three processes: data separation, evolution and integration. Whenever a block of data needs to be shared, it is spread into both databases, resulting in a block on the original database, and another into the Product database, with special links between them controlled by the Object Manager. These blocks do not need to be maintained identical during the evolution phase of the sharing process. Six types of links were defined, and by choosing one, the designer control the evolution and reintegration of the block in both databases. This process uses the composite object concept as the unit of control. The presented concepts can be applied to any data model with support to composite objects.

Simulation of active control using fuzzy logic applied to a pulse combustor

This work analyzes an active fuzzy logic control system in a Rijke type pulse combustor. During the system development, a study of the existing types of control for pulse combustion was carried out and a simulation model was implemented to be used with the package Matlab and Simulink. Blocks which were not available in the simulator library were developed. A fuzzy controller was developed and its membership functions and inference rules were established. The obtained simulation showed that fuzzy logic is viable in the control of combustion instabilities. The obtained results indicated that the control system responded to pulses in an efficient and desirable way. It was verified that the system needed approximately 0.2 s to increase the tube internal pressure from 30 to 90 mbar, with an assumed total delay of 2 ms. The effects of delay variation were studied. Convergence was always obtained and general performance was not affected by the delay. The controller sends a pressure signal in phase with the Rijke tube internal pressure signal, through the speakers, when an increase the oscillations pressure amplitude is desired. On the other hand, when a decrease of the tube internal pressure amplitude is desired, the controller sends a signal 180° out of phase.

Brachiaria decumbens supresses the initial growth of Coffea arabica

Brachiaria decumbens vem se tornando uma das plantas daninhas mais freqüentes na infestação de cafezais em formação, pois além de sua elevada agressividade e dificuldade de controle, está ocorrendo expansão das áreas cafeeiras para locais anteriormente ocupados por pastagens. Objetivou-se neste trabalho avaliar os efeitos desta planta daninha, em densidades crescentes, sobre o desenvolvimento inicial de mudas de café (Coffea arabica L. cv. Catuaí Amarelo). O experimento foi conduzido em condições semi-controladas, sem limitação de água. Uma muda de café foi transplantada em caixa de amianto com capacidade para 70 L, preenchida com terra coletada da camada arável de um Latossolo Vermelho. Os tratamentos constaram de diferentes densidades de transplante de capim-braquiária, a saber: 0, 4, 8, 12, 16, 20, 24, 36, 48 e 60 plantas m-2. O ensaio foi conduzido por um período experimental de 120 dias após o plantio (DAP). Todas as características analisadas foram afetadas negativamente pela interferência da planta daninha, mas as que se mostraram mais sensíveis a essa interferência foram à área foliar e a biomassa seca das folhas. Houve redução de 41,8% na área foliar do cafeeiro quando conviveu com o capim-braquiária a partir da densidade de 8 plantas m-2, chegando a 68,7% na densidade de 60 plantas m-2. Também a partir da densidade de 8 plantas m-2, a redução na biomassa seca das folhas em relação à testemunha foi de 41,4% e na densidade de 60 plantas m-2 chegou a 72,8%. Brachiaria decumbens, a partir da densidade de 8 plantas m-2, interfere negativamente sobre as mudas de café até os 120 DAP.

Biological control of Bradysia matogrossensis (Diptera : Sciaridae) in mushroom cultivation with predatory mites

Larvae of Sciaridae flies (Diptera) cause considerable damage to the mushroom Agaricus blazei (Murrill) ss. Heinemann in Brazil. Brazilian growers have had considerable difficulties in controlling this pest. The objective of this work was to test the effect of the predatory Laelapidae mite Stratiolaelaps scimitus (Womersley) as a control agent of Bradysia matogrossensis (Lane) in cultures of A. blazei. The work corresponded to an evaluation of the efficiency of that predator when released in boxes containing each about 15 L of commercial mushroom compost naturally infested with the pest. The results showed a significant effect of that predator on the population of B. matogrossensis. The release of either 665 or 1330 S. scimitus per box significantly reduced the pest population to levels that, according to grower's experience, apparently could not cause considerable damage. The positive results obtained warrant the conduction of complementary studies to determine the lowest rates of the predator that could still produce acceptable levels of control.

DETERMINATION of THE INDIRECT ORIENTATION of ORBITAL PUSHBROOM IMAGES USING CONTROL STRAIGHT LINES

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Two-colour photocurrent detection technique for coherent control of a single InGaAs/GaAs quantum dot

We present a two-colour photocurrent detection method for coherent control of a single InGaAs/GaAs self-assembled quantum dot. A pulse shaping technique provides a high degree of control over picosecond optical pulses. Rabi rotations on the exciton to biexciton transition are presented, and fine structure beating is detected via time-resolved measurements. (c) 2009 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

Control charts for monitoring the mean vector and the covariance matrix of bivariate processes

In this article, we propose new control charts for monitoring the mean vector and the covariance matrix of bivariate processes. The traditional tools used for this purpose are the T (2) and the |S| charts. However, these charts have two drawbacks: (1) the T (2) and the |S| statistics are not easy to compute, and (2) after a signal, they do not distinguish the variable affected by the assignable cause. As an alternative to (1), we propose the MVMAX chart, which only requires the computation of sample means and sample variances. As an alternative to (2), we propose the joint use of two charts based on the non-central chi-square statistic (NCS statistic), named as the NCS charts. Once the NCS charts signal, the user can immediately identify the out-of-control variable. In general, the synthetic MVMAX chart is faster than the NCS charts and the joint T (2) and |S| charts in signaling processes disturbances.

Effect of iron on enamel demineralization and remineralization in vitro

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effect of application time of APF and NaF gels on microhardness and fluoride uptake of in vitro enamel caries

Purpose : To evaluate the effect of time of fluoride application gel, acidulated or neutral, on in vitro enamel resistance to demineralization and fluoride uptake. Materials and Methods: One hundred and ninety-two human enamel blocks were used in this study and 144 were treated with fluoride gel, acidulated or neutral, for I or 4 minutes. Ninety-six blocks treated with fluoride and 24 control blocks were submitted to a high cariogenic challenge. After the pH-cycling, enamel demineralization was assessed by surface and cross-sectional microhardness. Fluoride in the enamel blocks was also determined after removing an enamel layer by etching acid. Results: Acidulated fluoride gel formed more fluoride in enamel than neutral gel (P < 0.05), and it was also more efficient in reducing the demineralization of the enamel blocks submitted to a cariogenic challenge than the neutral one (P < 0.05). It was found that the time of application was significant in terms of fluoride uptake, but it did not render the enamel more resistant to dernineralization.