Africanized honey bee (Apis mellifera) venom profiling: Seasonal variation of melittin and phospholipase A(2) levels

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Structural characterization and Curie temperature determination of a sodium strontium niobate ferroelectric nanostructured powder

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Supercritical fluid extraction for pesticide multiresidue analysis in honey: determination by gas chromatography with electron-capture and mass spectrometry detection

An analytical procedure using supercritical fluid extraction (SFE) and capillary gas chromatography with electron-capture detection was developed to determine simultaneously residues of different pesticides (organochlorine, organophosphorus, organonitrogen and pyrethroid) in honey samples. Fortification experiments were conducted to test conventional extraction (liquid-liquid) and optimize the extraction procedure in SFE by varying the CO2-modifier, temperature, extraction time and pressure. Best efficiency was achieved at 400 bar using acetonitrile as modifier at 90 degreesC. For the clean-up step, Florisil cartridges were used for both methods LLE and SFE. Recoveries for majority of pesticides from fortified samples of honey at fortification level of 0.01-0.10 mg/kg ranged 75-94% from both methods. Limits of detection found were less than 0.01 mg/kg for ECD and confirmation of pesticide identity was performed by gas chromatography-mass spectrometry in selected-ion monitoring mode. The multiresidue methods in real honey samples were applied and the results of developed methods were compared. (C) 2004 Elsevier B.V. All rights reserved.

Solid-liquid transition in Nb powder determined by third harmonic susceptibility

Measurements of the third harmonic of the AC-susceptibility were employed to determine the boundaries of the linear regime of the magnetic response of Nb powder. Non-linear contributions to the magnetic response reveal the occurrence of a structured phase, disappearing as the vortex lattice melts to the liquid state. A systematic study of the third harmonic was conducted to determine how its onset temperature depends on experimental parameters, such as the frequency and amplitude of the excitation field. The melting line (ML) has been extracted from the onset temperature measured at low-frequencies and low-excitation fields in the presence of DC magnetic fields. The study indicates that the ML can be described by a 3D vortex-glass model, except at lower fields, where the system experiences a depinning crossover, and the best description of the experimental data is provided by a 3D Bose-glass model. (c) 2008 Elsevier B. V. All rights reserved.

Magnetic response of superconducting mesoscopic-size YBCO powder

In this work it is reported the magnetic behavior of submicron and mesoscopic-size superconducting YBCO powders, prepared by a modified polymeric precursors method. The grain size and microstructure were analyzed using scanning electron microscopy ( SEM). Measurements of magnetization and AC-susceptibility as a function of temperature were performed with a quantum design SQUID magnetometer. Our results indicated significant differences on the magnetic propreties, in connection with the calcination temperature and the pressure used to pelletize the samples. This contribution is part of an effort to study vortex dynamics and magnetic properties of submicron and mesoscopic-size superconducting samples. (C) 2008 Elsevier B. V. All rights reserved.

Powder Diffraction of Components Subject to Corrosion in Fuse Cutouts with CeramicInsulation

Aiming identification of the components most affected by corrosion under saline environment conditions, we have carried out X-ray diffraction measurements in ceramic and bond materials, all in the powder form. The ceramic is analyzed before and after thermal annealing at 1000 degrees C, showing the same DRX peaks, although better defined after annealing. Identification suggests the presence of Al(6)Si(2)O(13) (Mullite) and SiO(2) (Quartz). Analysis of the junction (bond) material shows similar peaks, but a metallic preponderance is observed. Thermal annealing of the junction is done at much lower temperature, because it melts in the range 135 degrees C-170 degrees C, when a whitish smoke begins to show up along with strong sulfur odor.

Multiresidue determination of pesticides in honey samples by gas chromatography-mass spectrometry and application in environmental contamination

A simple and fast multiresidue method has been developed to determine 48 pesticides within the major groups of pesticides (organohalogen, organophosphorous, pyrethroids and organonitrogen) in representative samples of locally produced honey, in Bauru (State of São Paulo, Brazil) during 2003-2004. The recovery results found ranged from 76% to 95% and the limits of detection were lower than 0.01 mg/kg for gas chromatography with electron impact mass spectrometric detection in the selected ion monitoring mode (GC-MS-SIM). The results indicated that most pesticides found in the samples belonged to the organohalogen and organophosphorous groups and lower levels of residues of some organonitrogen and pyretroids were also detected. Malathion residues were detected in all the samples, in a high concentration, owing to its applications to control dengue mosquitoes in the area studied. (c) 2005 Elsevier Ltd. All rights reserved.

Production of a low young modulus titanium alloy by powder metallurgy

Titanium alloys have several advantages over ferrous and non-ferrous metallic materials, such as high strengthto-weight ratio and excellent corrosion resistance. A blended elemental titanium powder metallurgy process has been developed to offer low cost commercial products. The process employs hydride-dehydride (HDH) powders as raw material. In this work, results of the Ti-35Nb alloy sintering are presented. This alloy due to its lower modulus of elasticity and high biocompatibility is a promising candidate for aerospace and medical use. Samples were produced by mixing of initial metallic powders followed by uniaxial and cold isostatic pressing with subsequent densification by isochronal sintering between 900 up to 1600 °C, in vacuum. Sintering behavior was studied by means of microscopy and density. Sintered samples were characterized for phase composition, microstructure and microhardness by X-ray diffraction, scanning electron microscopy and Vickers indentation, respectively. Samples sintered at high temperatures display a fine plate-like alpha structure and intergranular beta. A few remaining pores are still found and density above 90% for specimens sintered in temperatures over 1500 °C is reached.

Surface Corrosion of Ti-16Si-4B Powder Alloy Implanted With Nitrogen by Plasma-Based Technique

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Honey consumption in the state of São Paulo: a risk to human health?

Infantile botulism was recognized in 1976 as a paralyzing disease caused by the ingestion of viable spores that would germinate and colonize the intestinal tract of infants, with local production and absorption of Clostridium botulinum toxin. The possible origins of botulinic spores are dust and honey, which has been identified as a dietary risk factor for infantile botulism. The objectives of the present study were to investigate 100 honey samples obtained in the state of São Paulo (Brazil) in terms of incidence of botulinic spores and of microbiologic quality, in agreement with Decree 367/9. All 100 samples analysed were negative for the presence of Salmonella, Shigella, total coliforms. C botulinum spores were present in 3 samples (3%) and molds and yeasts, in 64 samples (64%), but only 25 (25%) exceeded established criteria, with counts ranging from zero to 1.5 x 10(5) CFU/g. The presence of small sporogenic Gram-positive rods was observed in 42 (42%) of the 100 samples tested but these bacteria were not identified. (C) 2003 Elsevier Ltd. All rights reserved.

Determination of the properties of an experimental glass polyalkenoate cement prepared from niobium silicate powder containing fluoride

Objectives. The purpose of this paper is to modify the conventional calcium fluoro-aluminosilicate glass, which is used in the formation of glass ionomer cements (CIGs) by the niobium addition and to study the properties of GICs obtained.Materials and methods. Sol-gel process was used to prepare the powder at lower temperature than fusion method. Glass-ceramic powder obtained in this way was used to prepare the GICs. The properties such as working and setting times, microhardness and diametral tensile strength were evaluated for the experimental GICs and a commercial luting cement.Results. The ideal powder:liquid (P:L) ratio determined to prepare the experimental GICs was equal to 1:1. The cements prepared using this ratio showed working and setting times similar to the commercial GICs. in mechanical tests it was observed that microhardness and diametral tensile strength of the experimental GICs decreased significantly with the reduction of P:L ratio. on the other hand, the results obtained in microhardness tests indicated that the presence of niobium was a positive factor.Significance. The chemical process allows the development of glass-ceramic powder at 600 degrees C which is the goal of the present paper. It was concluded that GICs containing niobium might be used in dental applications and these results encourage further researches on other compositions. (c) 2007 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Behavioral responses evoked in honey bee workers by Dufour gland extracts (Hymenoptera : Apidae)

A series of experiments was performed to assess possible roles of the honey bee Dufour gland secretion. Bioassays with extracts of queen and worker glands from two colonies were made under artificial conditions, in which nestmate and non-nestmate forager workers were tested. The results demonstrate that forager workers display behavioral responses when exposed to Dufour gland extracts of nestmates, but remain indifferent when exposed to non-nestmate extracts. Also, the results demonstrate that forager workers are attracted by virgin queen gland extracts, and repelled by forager worker extracts. The data demonstrate that the Dufour gland secretion is colony- and caste-specific. The attractant remains in the nest. The repellent effect of forager worker extracts is interpreted as an alarm-like pheromone. The attractant effect of virgin queen extracts could be useful in the swarming process to attract scout bees to the eventual founder virgin queen or to attract old foragers to the virgin queen that remains in the nest.

Modes of cell death in the hypopharyngeal gland of the honey bee (Apis mellifera L)

Different modes of cell death have been revealed in the regressing hypopharyngeal glands of worker honey bees. The hypopharyngeal gland, which is well developed in young nursing bees to produce protein for larval food, was seen to regress naturally in foraging adult worker bees. A range of techniques including histology, cytochemistry, in situ TUNEL, Annexin V and Comet assays indicated that cells within the gland demonstrate progressive symptoms of apoptosis, necrosis and a vacuolar form of programmed cell death. The latter mode of cell death did not display chromatin margination, but was accompanied by an enhanced level of autophagic and hydrolytic activity in which a cytosolic source of acid phosphatase became manifest in the extra-cisternal spaces. Normal and annexin-positive cells were found to occur in the younger nursing bees, whilst necrosis and an aberrant vacuolar type of apoptosis predominated in the older foraging bees. The relevance of these results to the classification of programmed cell death is discussed. (C) 2000 Academic Press.

Differences in the number of some antennal sensilla of four honey bee (Apis mellifera) types and comparisons with the defensive behaviour

The number of sensilla coeloconica, ampullacea and campaniformia of flagellomeres 3 to 10 of the antennae of workers of four honey bee types (Italian, Caucasian, African and Africanized) was studied by scanning electron microscopy. Comparisons of the four bee types showed that only African and Africanized honey bees did not differ from one another with respect to the number of sensilla coeloconica and ampullacea of flagellomere 10. African and Africanized honey bees and Caucasian and Italian honey bees also did not differ from one another in terms of flagellomere 9. In the other flagellomeres there were no differences among bee types. Italian and Caucasian honey bees differed from Africanized honey bees in terms of number of sensilla campaniformia on flagellomere 6, and Caucasian honey bees differed from African and Africanized honey bees in terms of flagellomere 3. Five significant but random correlation values were obtained between number of antennal sensilla and defensive behaviour in Africanized honey bees. Thus,there is no relationship between antennal structures and defence behaviour.