Temperature Effect on the Structure and Formation Kinetics of Vinyltriethoxysilane-Derived Organic/Silica Hybrids

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of Dimerization on the Structure and Biological Activity of Antimicrobial Peptide Ctx-Ha

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

SrZrO3 powders obtained by chemical method: Synthesis, characterization and optical absorption behaviour

Strontium zirconate (SrZrO3) powders have been synthesized by the polymeric precursor method after heat treatment at different temperatures for 2 h in oxygen atmosphere. The decomposition of precursor powder was followed by thermogravimetric analysis, X-ray diffraction (XRD) and Fourier transform Raman (FT-Raman). The UV-vis absorption spectroscopy measurements suggested the presence of intermediary energy levels in the band gap of structurally disordered powders. XRD, Rietveld refinement and FT-Raman revealed that the powders are free of secondary phases and crystallizes in the orthorhombic structure. (C) 2007 Elsevier Masson SAS. All rights reserved.

Dielectric properties of Ca(Zr0.05Ti0.95)O-3 thin films prepared by chemical solution deposition

Ca(Zr0.05Ti0.95)O-3 (CZT) thin films were grown on Pt(1 1 1)/Ti/SiO2/Si(1 0 0) substrates by the soft chemical method. The films were deposited from spin-coating technique and annealed at 928 K for 4 h under oxygen atmosphere. CZT films present orthorhombic structure with a crack free and granular microstructure. Atomic force microscopy and field-emission scanning electron microscopy showed that CZT present grains with about 47 nm and thickness about 450 nm. Dielectric constant and dielectric loss of the films was approximately 210 at 100 kHz and 0.032 at 1 MHz. The Au/CZT/Pt capacitor shows a hysteresis loop with remnant polarization of 2.5 mu C/cm(2), and coercive field of 18 kV/cm, at an applied voltage of 6 V. The leakage current density was about 4.6 x 10(-8) A/cm(2) at 3 V. Dielectric constant-voltage curve is located at zero bias field suggesting the absence of internal electric fields. (c) 2006 Elsevier B.V. All rights reserved.

Synthesis of Ba0.5Sr0.5(Ti0.80Sn0.20)O-3 prepared by the soft chemical method

Single-phase Ba0.5Sr0.5(Ti0.80Sn0.20)O-3 (BST:Sn) powders with perovskite structure were prepared by the soft chemical method. Infrared data indicates that the BST:Sn powder is carbonate free while Raman analysis has shown that the transversal (TO) and longitudinal (LO) optical modes tend to disappear with tin addition. The electron diffraction pattern of the BST:Sn powder showed an interplanar distance of 3.94 angstrom characteristic of the pseudo-cubic structure. (c) 2007 Elsevier B.V. All rights reserved.

Temperature dependence of dielectric properties for Ba(Zr0.25Ti0.75)O-3 thin films obtained from the soft chemical method

Ba(Zr0.25Ti0.75)O-3(BZT) thin films prepared by the polymeric precursor method (PPM) were annealed at 500, 600, and 700 degrees C for 4h. All films crystallized in the perovskite structure present a crack-free microstructure. Dielectric properties of the BZT thin films were investigated as a function of frequency and applied voltage. The dielectric constant of the films were 36, 152 and 145 at 1 kHz, while the dielectric loss were 0.08, 0.08, and 0.12 at 1 MHz. (c) 2007 Elsevier B.V. All rights reserved.

Ferroelectric and dielectric properties of Ba0.5Sr0.5(Ti0.80Sn0.20)O-3 thin films grown by the soft chemical method

Polycrystalline Ba0.5Sr0.5(Ti0.80Sn0.20)O-3 (BST:Sn) thin films with a perovskite structure were prepared by the soft chemical method on a platinum-coated silicon substrate from spin-coating technique. The resulting thin films showed a dense structure with uniform grain size distribution. The dielectric constant of the films estimated from C-V curve is around 1134 and can be ascribed to a reduction in the oxygen vacancy concentration. The ferroelectric nature of the film indicated by butterfly-shaped C-V curves and confirmed by the hysteresis curve, showed remnant polarization of 14 mu C/cm(2) and coercive field of 74 kV/cm at frequency of 1 MHz. At the same frequency, the leakage current density at 1.0 V is equal to 1.5 x 10(-7) A/cm(2). This work clearly reveals the highly promising potential of BST:Sn for application in memory devices. (c) 2006 Elsevier B.V. All rights reserved.

Reaction pathway to the synthesis of anatase via the chemical modification of titanium isopropoxide with acetic acid

Anatase nanoparticles were obtained through a modified sol-gel route from titanium isopropoxide modified with acetic acid in order to control hydrolysis and condensation reactions. The modification of Ti(O(i)Pr)(4) with acetic acid reduces the availability of groups that hydrolyze and condense easily through the formation of a stable complex whose structure was determined to be Ti(OCOCH(3))(O(i)Pr)(2) by means of FTIR and (13)C NMR. The presence of this complex was confirmed with FTIR in the early stages of the process. A doublet in 1542 and 1440 cm(-1) stands for the asymmetric and symmetric stretching vibrations of the carboxylic group coordinated to Ti as a bidentate ligand. The gap of 102 cm(-1) between these signals suggests that acetate acts preferentially as a bidentate rather than as a bridging ligand between two titanium atoms. The use of acetic acid as modifier allows the control of both the degree of condensation and oligomerization of the precursor and leads to the preferential crystallization of TiO(2) in the anatase phase. A possible reaction pathway toward the formation of anatase is proposed on the basis of the intermediate species present in a 1:1 Ti(O(i)Pr)(4):CH(3)COOH molar system in which esterification reactions that introduce H(2)O into the reaction mixture were seen to be negligible. The Rietveld refinement and TEM analysis revealed that the powder is composed of isotropic anatase nanocrystallites.

Crystal structure of isotibolone: a major degradation product of tibolone

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Structure and ferro/piezoelectric properties of SrBi(4)Ti(4)O(15) films deposited on TiO(2) buffer layer

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

APTES-Modified RE2O3:Eu3+ Luminescent Beads: Structure and Properties

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Structure Elucidation and Absolute Stereochemistry of Isomeric Monoterpene Chromane Esters

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Chemical profile of the polar extract of Paepalanthus microphyllus (Guill.) Kunth (Eriocaulaceae)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biological Activity of Quinoline Alkaloids from Raulinoa echinata and X-ray Structure of Flindersiamine

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Variations in tree community composition and structure in a fragment of tropical semideciduous forest in southeastern Brazil related to different human disturbance histories

In an area of tropical seasonal semideciduous forest, the soil characteristics, floristic composition, physiognomic structure, and the distribution of three regeneration and three dispersal guilds were studied for four stands within the forest that had documented histories of varying degrees of human disturbance. The aim was to study forest regeneration in areas of preserved forest and secondary forest, with parts of both types of forest experiencing either 'intensive' or 'occasional' cattle trampling. The study was carried out in the Sebastiao Aleixo da Silva Ecological Station, Bauru, São Paulo State, Brazil. Two stands were called 'secondary' because they corresponded to forest tracts that were felled and occupied by crops and pastures in the past and then abandoned to forest regeneration ca. 40 years before this study. The other two stands, called 'preserved', corresponded to areas of the fragment where the forest has been maintained with only minor human impacts. The arboreal component of the tree community (diameter at breast height or dbh greater than or equal to 5 cm) was sampled in 20 plots of 40 m x 40 m, and the subarboreal component (diameter at the base of the stem or dbs < 5 cm and height greater than or equal to 0.5 m) in subplots of 40 m x 2 m. Physiognomic features, such as canopy height and density of climbing plants, were registered all over a 5 m x 5 m gridline laid on the sample plots. Soil bulk samples were collected for chemical and textural analyses. Most detected differences contrasted the secondary to the preserved forest stands. The soils of the secondary stands showed higher proportions of sand and lower levels of mineral nutrients and organic matter than those of the preserved stands, probably due to higher losses by leaching and erosion. Compared to the secondary stands, the preserved ones had higher proportions of tall trees, higher mean canopy height, lower species diversity, higher abundance of autochorous and shade-tolerant climax species, and lower abundance of pioneer and light-demanding climax species. Despite the high proportion of species shared by the preserved and secondary stands (108 out of 139), they differed consistently in terms of density of the most abundant species. on the other hand, the secondary and preserved stands held similar values for tree density and basal area, suggesting that 40 years were enough to restore these features. Effects of cattle trampling on the vegetation were detected for the frequency of trees of anemochorous and zoochorous species, which were higher in the stands under occasional and intensive cattle trampling, respectively. The density of thin climbers was lower in the stands with intensive trampling. (C) 2004 Elsevier B.V. All rights reserved.