Segmentação de imagens utilizando competição e cooperação entre partículas

Este artigo apresenta uma proposta de extensão do modelo de aprendizado semi-supervisionado conhecido como Competição e Cooperação entre Partículas para a realização de tarefas de segmentação de imagens. Resultados preliminares mostram que esta é uma abordagem promissora.

Avaliação mecânica e microbiológica de resinas acrílicas reforçadas com partículas de sílica revestidas com prata

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Monitoramento do tempo de prensagem e do comportamento da temperatura através da espessura de painéis LVL (Laminated veneer lumber)

The aim of this study was to analyze the behavior of the flow of heat (temperature) through the thickness of panels LVL (Laminated veneer lumber) produced with phenol formaldehyde adhesive, in laboratorial and industrial scales. Experimental program was conducted with five LVL panels (three produced in laboratorial scale and two in industrial scale) with different arrangements of a mix of commercial veneers from tropical pinus from the south region of Sao Paulo State, Brazil, bonded using phenol formaldehyde adhesive. The temperature inside the panels during the pressing process was evaluated using thermocouples type T (cooper-constantan), installed mostly in the center of the glue lines and connected to a data acquisition system. The graphics of temperature as a function of the time showed a gradual increase of temperature up to pre-set values, remaining constant from them. The temperature reached at the center of the panels was adequate to promote the curing of the adhesive. These pre-set values were similar to the minimum values presented by other authors and manufacturers of these adhesives that affirm that temperatures above 100ºC at the center of laminated panels bonded with phenolic adhesives are sufficient to ensure proper cure of the resin. The time necessary for curing of the adhesives confirmed the validity of practical expressions provided by adhesive manufacturers.

Design Participativo para a Sustentabilidade: desenvolvimento de painéis modulares para fechamentos, utilizando bambu associado com terra e resíduos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Modelagem e simulação de transferência de calor em leito de partículas estacionárias sujeito a agitação intermitente

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Termodinâmica de um conjunto de partículas em um bilhar bidimensional dependente do tempo: um gás bidimensional simplificado

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Pseudomecânica: partículas de spins inteiros, semi-inteiros e fracionários

Pós-graduação em Física - IFT

Quantização de partículas com spin

Pós-graduação em Física - IFT

Segmentação interativa de imagens utilizando competição e cooperação entre partículas

Pós-graduação em Ciência da Computação - IBILCE

Estudo das propriedades ópticas de pós cerâmicos à base de Zn3Ga2Ge2O10: X% Cr3+ (X = 0 ; 0,5 ; 0,75 ; 1,0)

Ceramic powders based on Zn3Ga2Ge2O10: Cr3+ X% (X = 0.0; 0.5; 0.75; 1.0) were synthesized by solid-state reaction method. The gallium-zinc germanate doped with chromium presents an interesting property of phosphorescence, that means, it is capable of emitting light when excited by a source of radiation, and such emission remains for some time after stopping the source. For this reason, these materials can be widely applied in night-vision surveillance, (through the use of solar energy, for example), electronic devices screen, emergency routes signals, control panels indicators in dark environments, etc. In this job were considered different amounts of dopant in order to perform a comparison of structural and photoluminescent properties. For that, some analyses were performed on samples, such as XRD, FT-Raman, SEM, UV-vis and photoluminescence measurements (PL). Such analysis allowed to infer that the presence of chromium results in no phase transformation, so that the four compositions have the same set of phases: cubic, rhombohedral and hexagonal. Although the structure was not changed, chromium influences other properties / characteristics of these materials. Examples are: increase of band-gap, decrease of average particle size, small changes in binding energy checked by Raman and especially the increase of photoluminescent property. The chromium ions have great ease in replacing gallium ions in octahedral sites, resulting in emission of light with a wavelength of about 700 nm (infrared region), which is justified by the spin-forbidden 2E 4A2 transition. In other words, chromium is a favorable luminescent center, acting as a trap in the crystal structure, since it imprisons the excitation energy easily and releases it gradually, allowing the phosphorescence. It was observed that the composition ... (Complete abastract click electronic access below)

Utilização de painéis solares fotovoltaicos no segmento residencial

In order to diversify the global and national energy matrix and reduce harmful impacts on the environment caused by the emission of polluting gases into the atmosphere, the use of clean and renewable energy sources is presented as a good alternative. This work discusses the use of photovoltaic solar energy, a source that presents such characteristics. The photovoltaic system under study is the type distributed connected to the grid, in the residential segment. It is informed of its use in the global and national levels. They are also present their characteristics, electrical and electronic circuits that make up the equipment required for its operation and the design of a system to be installed in a residence

Um método numérico para a solução de problemas em física quântica de poucos corpos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mapeamento de áreas de risco à saúde pública por meio de métodos geoestatísticos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mathematical analysis of maximum power generated by photovoltaic systems and fitting curves for standard test conditions

The rural electrification is characterized by geographical dispersion of the population, low consumption, high investment by consumers and high cost. Moreover, solar radiation constitutes an inexhaustible source of energy and in its conversion into electricity photovoltaic panels are used. In this study, equations were adjusted to field conditions presented by the manufacturer for current and power of small photovoltaic systems. The mathematical analysis was performed on the photovoltaic rural system I- 100 from ISOFOTON, with power 300 Wp, located at the Experimental Farm Lageado of FCA/UNESP. For the development of such equations, the circuitry of photovoltaic cells has been studied to apply iterative numerical methods for the determination of electrical parameters and possible errors in the appropriate equations in the literature to reality. Therefore, a simulation of a photovoltaic panel was proposed through mathematical equations that were adjusted according to the data of local radiation. The results have presented equations that provide real answers to the user and may assist in the design of these systems, once calculated that the maximum power limit ensures a supply of energy generated. This real sizing helps establishing the possible applications of solar energy to the rural producer and informing the real possibilities of generating electricity from the sun.

A intermediação da noção de probabilidade na construção de conceitos relacionados à cinética química

Este trabalho procurou identificar como estudantes do Ensino Médio se apropriam de conceitos e elaboram determinados modelos inseridos em cinética química, especificamente o modelo cinético de colisão de partículas numa reação (Teoria das Colisões). Esta análise e as reflexões que a seguiram foram baseadas, sobretudo, nos estudos realizados por Piaget, Piaget e Inhelder, Jun e Fischbein. Utilizamos como documentos as transcrições das entrevistas (pré e pós-testes) realizadas individualmente com cada aluno. Inicialmente, os estudantes foram entrevistados (pré-testes) com o intuito de identificar a familiaridade com a noção de evento probabilístico ou aleatório. Numa segunda etapa (pós-testes), esse conhecimento (ou a ausência parcial/total dele) foi posto à prova numa tentativa de se estabelecerem relações com um conteúdo específico da Química (Teoria das Colisões). Os resultados obtidos apontam para grandes discrepâncias entre o modelo cinético de colisões elaborado pelos estudantes e aquele cientificamente aceito.