Investigação estrutural e atividade tuberculostática de complexos de cobre(II) contendo isonicotinamida

Pós-graduação em Química - IQ

Novas espécies moleculares e supramoleculares de cobre (II) contendo aminas bidentadas: síntese, caracterização estrutural e investigação do comportamento vapocrômico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Coordinative versatility of a Schiff base containing thiophene: Synthesis, characterization and biological activity of zinc(II) and silver(I) complexes

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Direct preparation and characterization of copper pentacyanonitrosylferrate nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electrochemical sensor for sulfite determination based on a nanostructured copper-salen film modified electrode

The electrochemical preparation described herein involved the electrocatalytic oxidation of sulfite on a platinum electrode modified with nanostructured copper salen (salen=N,N'-ethylenebis(salicylideneiminato)) polymer films. The complex was prepared and electropolymerized at a platinum electrode in a 0.1 mol L-1 solution of tetrabutylammonium perchlorate in acetonitrile by cyclic voltammetry between 0 and 1.4V vs. SCE. After cycling the modified electrode in a 0.50 mol L-1 KCI solution, the estimated surface concentration was found to be equal to 2.2 x 10(-9) Mol cm(-2). This is a typical behavior of an electrode surface immobilized with a redox couple that can usually be considered as a reversible single-electron reduction/oxidation of the copper(II)/copper(III) couple. The potential peaks of the modified electrode in the electrolyte solution (aqueous) containing the different anions increase with the decrease of the ionic radius, demonstrating that the counter-ions influence the voltammetric behavior of the sensor. The potential peak was found to be linearly dependent upon the ratio [ionic charge]/[ionic radius]. The oxidation of the sulfite anion was performed at the platinum electrode at +0.9V vs. SCE. However, a significant decrease in the overpotential (+0.45V) was obtained while using the sensor, which minimized the effect of oxidizable interferences. A plot of the anodic current vs. the sulfite concentration for chronoamperometry (potential fixed = +0.45V) at the sensor was linear in the 4.0 x 10(-6) to 6.9 x 10(-5) mol L-1 concentration range and the concentration limit was 1.2 x 10(-6) mol L-1. The reaction order with respect to sulfite was determined by the slope of the logarithm of the current vs. the logarithm of the sulfite concentration. (C) 2009 Elsevier Ltd. All rights reserved.

Emprego de compostos organometálicos mononucleares de paládio(II) na ativação de macrófagos peritoneais de camundongos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The sensitization of the ligand-field state of the hexaammineruthenium(II) complex ion by organic compounds

The sensitized photolysis of [Ru(NH3)(6)](2+) by the organic dye rhodamine B and biacetyl was studied under conditions in which only the sensitizer absorbs. The reaction products resulting from ammonia aquation and Ru(II) to Ru(III) oxidation are the same for direct and sensitized photolysis. The energy transfer rate constant, calculated from the fluorescence quenching of rhodamine B, is similar to that estimated from the limiting quantum yield of the photosensitized photoaquation of the complex. Both reactions originate from a common reactive low-lying ligand-field (LF) state, which is also responsible for the direct photolysis reactions. This state, which leads directly to photoaquation, seems to have a certain charge transfer to solvent (CTTS) character, which is responsible for the photo-oxidation products. Sensitization is effective with rhodamine B (17 450 cm(-1)) and biacetyl (19 000 cm(-1)), whereas no reaction is observed with neutral red (16 900 cm(-1)). These results show that the excited state responsible for the photochemical reactions lies in the energy range between 16 900 cm(-1) and 17 700 cm(-1) and possesses spin-orbit character.

Supramolecular assemblies of cis-palladium complexes dominated by C-H center dot center dot center dot Cl interactions

Two cis-related palladium(II) complexes [PdCl(2)(PPh(3))(tu)] (1) and [PdCl(2)(tmen)] (2) {PPh(3) = triphenylphosphine, tu = thiourea, tmen = N,N,N,N-tetramethylethylenediamine} have been synthesized and characterized by elemental analysis, IR and NMR spectroscopies, and single crystal X-ray diffraction. In 1, N-H center dot center dot center dot Cl hydrogen bonds are responsible for the formation of a dimer which connects to an adjacent one through weak C-H center dot center dot center dot Cl interactions, yielding 1D tapes. The crystal packing of compound 2 consists of zigzag ribbons of [PdCl(2)(tmen)] self-assembled by C-H center dot center dot center dot Cl hydrogen bonds which also holds the chains together, giving rise to a 2D layered structure. (C) 2006 Elsevier B.V. All rights reserved.

Sintering and crystallite growth of nanocrystalline copper doped tin oxide

The effect of Cu2+ contents and of firing temperature on sintering and crystallite growth of nanocrystalline SnO2 xerogels was analyzed by thermoanalysis (mass loss (TG), linear shrinkage, and differential thermal analysis (DTA)), X-ray powder diffraction (XRPD), and EXAFS (extended X-ray absorption fine structures) measurements. Samples were prepared by two methods: (a) coprecipitation of a colloidal suspension from aqueous solution containing both Sn(IV) and Cu(II) ions and (b) grafting copper(II) species on the surface of tin pride gel. The thermoanalysis has shown that the shrinkage associated with the mass loss decreases by increasing the amount of copper. The EXAFS measurements carried out at the Cu K edge have evidenced the presence of copper in substitutional solid solution for the dried xerogel prepared with 0.7 mol % of copper, while for higher concentration of doping, copper has been observed also at the external surface of crystallites. The solid solution is metastable and copper migrates toward the surface during firing. The XRPD and DTA results have shown a recrystallization process near 320 degrees C, which leads to crystallite growth. The presence of copper segregated near the crystallite surface controls its growth.

Nitrosyl ruthenium complexes with general formula [RuCl3,(NO)(P-P)] (P-P={PPh(2)(CH2)(n)PPh(2)},n=1-3 and {PPh(2)-CH=CH-PPh(2)}). X-ray structure of [RuCl3(NO){PPh(2)(CH2)(3)PPh(2)}]

Ruthenium(II) complexes with general formula [RuCl3(NO)(P-P)] were obtained in the solid state, where P-P = PPh(2)(CH2)(n)PPh(2) (n = 1-3) and PPh(2)-CH = CH-PPh(2). The P-31 NMR spectra of these compounds measured in CH2Cl2 showed only singlets, consistent with a fac configuration containing two equivalent phosphorus atoms, However the X-ray diffraction data show that the [RuCl3(NO){PPh(2)(CH2)(3)PPh(2)}] complex crystallizes in a met configuration, where one of the phosphorus atoms is trans to the NO group, in a slightly distorted octahedral geometry. Copyright (C) 1996 Elsevier B.V. Ltd

Thermal behaviour of Tin(II) complex with 8-hydroxyquinolinate in the solid state

Tin(II) complexes with 8-hydroxyquinolinate in solid state have been obtained by adding aqueous ammonium to a solution containing stannous chloride and 8-hydroxiquinoline in medium of HCl and acetone up to pH 5 and 9, respectively. The products obtained show the same composition, Sn(C9H6ON)(2); however there are some differences regarding both the thermal behaviour in an oxidant atmosphere and morphology. These products were characterised by elemental and complexometric analysis, TG and DTA curves, infrared and X-ray diffractometry. TG curves show, above 448 K, the partial oxidation on air atmosphere of Sn(II) complexes to Sn(IV) complexes, SnO(C9H6ON)(2). This behaviour does not depend only on pH in which the compounds were obtained but also on the heating rate in TG curves. Sn(II) complexes volatilise almost completely on nitrogen atmosphere and partially on air atmosphere depending on the oxidation degree of the compound.

Synthesis and structural characterization of dichlorobis (1-phenyl-3-methylpyrazole) palladium(II) and diazidobis (1-phenyl-3-methylpyrazole) palladiium(II)

Mononuclear pyrazolyl Pd(II) complexes of the type [PdX2(phmPz)(2)] (X = Cl-, N-3(-)) have been prepared. The 1-phenyl-3-methylpyrazole displaces acetonitrile from [PdCl2(CH3CN)(2)] to form [PdCl2(PhMPz)(2)] (phmPz = 1-phenyl-3-methylpyrazole) (1). [Pd(N-3)(2)(PhmPz)(2)] (2) could be obtained by metathesis from [PdCl2(CH3CN)(2)] or by substitution of the chloride in (1) by the azide ion. Both complexes were characterized by elemental analysis, infrared spectroscopy, H-1 and C-13 NMR and by single crystal X-ray diffraction. The coordination geometry around Pd(II) in these complexes is nearly square-planar, with the ligands in a trans configuration.

Synthesis, crystal structure, spectroscopic and electrochemical characterization of the dinuclear complex {tetra-mu-[(+/-)-2-(p-methoxyphenoxy)-propionato-O,O']bis(aqua)dicopper(II)}

Structural, electrochemical and spectroscopic data of a new dinuclear copper(II) complex with (+/-)-2-(p- methoxyphenoxy) propionic acid are reported. The complex {tetra-mu-[(+/-)-2-(p-methoxyphenoxy)propionato-O,O']-bis( aqua) dicopper(II)} crystallizes in the monoclinic system, space group P2(1)/n with a = 14.149(1) angstrom, b = 7.495(1) angstrom, c = 19.827(1) angstrom, beta = 90.62(1) and Z = 4. X-ray diffraction data show that the two copper(II) ions are held together through four carboxylate bridges, coordinated as equatorial ligands in square pyramidal geometry. The coordination sphere around each copper ion is completed by two water molecules as axial ligands. Thermogravimetric data are consistent with such results. The ligand has an L' type shape due to the angle formed by the beta-carbon of the propionic chain and the linked p-methoxyphenoxy group. This conformation contributes to the occurrence of a peculiar structure of the complex. The complex retains its dinuclear nature when dissolved in acetonitrile, but it decomposes into the corresponding mononuclear species if dissolved in ethanol, according to the EPR measurements. Further, cyclic voltammograms of the complex in acetonitrile show that the dinuclear species maintains the same structure, in agreement with the EPR data in this solvent. The voltammogram shows two irreversible reduction waves at E-pc = -0.73 and -1.04 V vs. Ag/AgCl assigned to the Cu(II)/ Cu(I) and Cu(I)/Cu degrees redox couples, respectively, and two successive oxidation waves at E-pa = -0.01 and +1.41 V vs. Ag/AgCl, assigned to the Cu degrees/Cu(I) and Cu( I)/Cu( II) redox couples, respectively, in addition to the oxidation waves of the carboxylate ligand.

Study on the thermal behavior of the complexes of the type [PdX2(tdmPz)] (X = Cl-, Br-, I-, SCN-)

Four new mononuclear Pd(II) complexes of the type [PdX2(tdmPz)] {X = Cl- (1); Br- (2); I- (3); SCN- (4); tdmPz = 1-thiocarbamoyl-3,5-dimethylpyrazole} have been synthesized and characterized by elemental analysis, IR spectroscopy, H-1 and C-13{H-1}-NMR experiments. The thermal behavior of the complexes 1-4 has been investigated by means of thermogravimetry (TG) and differential thermal analysis (DTA). From the initial decomposition temperatures, the thermal stability of the complexes can be ordered in the sequence: 3 < 4 a parts per thousand 2 < 1. The final products of the thermal decompositions were characterized as metallic palladium by X-ray powder diffraction.

Kinetic studies on the reactions of Ru(II) tetraammines with CS2N- 3

The kinetics of the reactions of Ru(II) complexes with CS2N- 3 ions were studied spectrophotometrically. The formation rate constants data for trans-[Ru(NH3)4L(CS2N3)] are 2.2 × 102, 1.8 × 10 and 1.3 × 102 M-1 s-1 for L = SO2- 3, HSO- 3 and P(OEt)3), respectively [μ = 1.0 M (NaCF3COO), 25°C]. Under the same experimental conditions, the values of k-1 (specific rate for the aquation reaction) are 1.5 × 10-2, 5.0 × 10-2 and 4.5 × 10 s-1 for L = SO2- 3, HSO- 3 and P(OEt)3, respectively. The free-energy change (ΔG≠) for the systems where L = P(OEt)3 and SO2- 3 are in agreement within the experimental error. It was observed that the affinity of the CS2N- 3 ion decreases with the increasing π-acidity of the auxiliary ligand L. The order of affinity of the CS2N- 3 ion for the Ru(II) center studies is SO2- 3 > HSO- 3 > P(OEt)3 >SO2. © 1986.