Enhanced stability in CO2 of Ta doped BaCe0.9Y 0.1O3-δ electrolyte for intermediate temperature SOFCs

The influence of Ta concentration on the stability of BaCe 0.9-xTaxY0.1O3-δ (where x=0.01, 0.03 and 0.05) powders and sintered samples in CO2, their microstructure and electrical properties were investigated. The ceramic powders were synthesized by the method of solid state reaction, uniaxially pressed and sintered at 1550 °C to form dense electrolyte pellets. A significant stability in CO2 indicated by the X-ray analysis performed was observed for the samples with x≥0.03. The electrical conductivities determined by impedance measurements in the temperature range of 550-750 °C and in various atmospheres (dry argon, wet argon and wet hydrogen) increased with temperature but decreased with Ta concentration. The highest conductivities were observed in the wet hydrogen atmosphere, followed by those in wet argon, while the lowest were obtained in the dry argon atmosphere for each dopant concentration. The composition with Ta content of 3 mol% showed satisfactory characteristics: good resistance to CO2 in extreme testing conditions, while a somewhat reduced electrical conductivity is still comparable with that of BaCe0.9Y0.1O3-δ. © 2012 Elsevier Ltd and Techna Group S.r.l.

Tilted and Short Implants Supporting Fixed Prosthesis in an Atrophic Maxilla: A 3D-FEA Biomechanical Evaluation

Purpose: This study compared the biomechanical behavior of tilted long implant and vertical short implants to support fixed prosthesis in an atrophic maxilla. Materials and Methods: The maxilla model was built based on a tomographic image of the patient. Implant models were based on micro-computer tomography imaging of implants. The different configurations considered were M4S, four vertical anterior implants; M4T, two mesial vertical implants and two distal tilted (45°) implants in the anterior region of the maxilla; and M6S, four vertical anterior implants and two vertical posterior implants. Numerical simulation was carried out under bilateral 150N loads applied in the cantilever region in axial (L1) and oblique (45°) (L2) direction. Bone was analyzed using the maximum and minimum principal stress (σmax and σmin), and von Mises stress (σvM) assessments. Implants were analyzed using the σvM. Results: The higher σmax was observed at: M4T, followed by M6S/L1, M6S/L2, M4S/L2, and M4S/L1 and the higher σvM: M4T/L1, M4T/L2 and M4S/L2, M6S/L2, M4S/L1, and M6S/L1. Conclusions: The presence of distal tilted (all-on-four) and distal short implants (all-on-six) resulted in higher stresses in both situations in the maxillary bone in comparison to the presence of vertical implants (all-on-four). © 2013 Wiley Periodicals, Inc.

Decreasing pH of mammary gland secretions is associated with parturition and is correlated with electrolyte concentrations in prefoaling mares

The objectives of this study were to determine pH of the mammary gland secretions and the corresponding electrolyte concentrations in prefoaling mares. Pregnant mares (seven primiparous and seven multiparous) were monitored daily from 310.320 days of gestation until parturition. Prefoaling mammary gland secretions were collected, and pH was immediately determined with a pH meter and pH strip test. An aliquot of prefoaling mammary secretions was frozen and stored until further analyses. After parturition, samples from day .4 to 0 (day of foaling) were thawed and electrolyte concentrations (ie, Ca2+, Mg2+, Na+, K+ and Cl-) were determined with an automated analyser. Data were analysed via a mixed model with the mare as a random effect. Correlations were determined between pH and electrolyte concentrations by the Pearson product-moment for each pair. There was significant reduction in pH of mammary secretions on the day of foaling (P<0.0001), and most mares (11/14) with a pH .7 foaled within 24 hours. There was high correlation between the two pH methods (r=0.93). Additionally, there were significant (P<0.05) increases in Ca2+ and K+ concentrations, and significant decreases in Na+ and Cl- concentrations from one day before to the day of foaling. The pH of mammary secretions was highly and significantly (P<0.001) correlated with Na + (r=0.87), Cl- (r=0.85), Ca2+ (r=-0.88); and K+(r=.0.80) concentrations, and moderately correlated with Mg 2+ (r=-0.58). Daily evening pH measure of the mammary gland secretions can predict foaling in most mares.

Filmes nanoestruturados de fosfolipídios como sistemas miméticos de membrana biológica para aplicação em sensores via sers e espectroscopia de impedância

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Oral squamous carcinoma cells secrete RANKL directly supporting osteolytic bone loss

Objective: Local invasion of bone is a frequent complication of oral squamous cell carcinoma (OSCC). Development of these osteolytic lesions is mediated by osteoclasts. Receptor activation of NF-kappa B ligand (RANKL) signaling, counteracted by osteoprotegerin (OPG), regulates osteoclastogenesis. Previous studies in rodent models have demonstrated that inhibition of RANKL decreases tumor growth and lesions within bone. However, the contributory role of OSCC cells to this disease process has yet to be defined.Methods: RANKL expression was assessed in a panel of OSCC cell lines by qPCR, flow cytometry, and ELISA. Induction of osteoclastogenesis was assessed by co-culture with macrophages or with OSCC-derived conditioned medium. In an animal model of bone invasion, nude mice were injected intratibially with UMSCC-11B cells expressing a RANKL luciferase promoter to detect tumor-derived RANKL activity. Osteolytic lesions were analyzed by X-ray, micro-CT, and histological methods. RANKL expression was assessed in human OSCC tissues by immunohistochemistry.Results: We demonstrated that OSCCs express varied levels of all RANKL isoforms, both membrane-bound and soluble RANKL. Both co-culture and treatment with OSCC-conditioned media induced osteoclastogenesis. In mice, we demonstrated human RANKL promoter activity during bone invasion. Over the course of the experiment, animals suffered osteolytic lesions as RANKL-driven luciferase expression increased with time. After 8 weeks, human-derived RANKL was detected in areas of bone resorption by immunohistochemistry. Similar epithelial RANKL expression was detected in human OSCC tissues.Conclusion: These data demonstrate the ability of OSCCs to produce RANKL, directly altering the tumor microenvironment to increase osteoclastogenesis and mediate local bone invasion. (C) 2012 Elsevier Ltd. All rights reserved.

Microstrain Around Dental Implants Supporting Fixed Partial Prostheses Under Axial and Non-Axial Loading Conditions, In Vitro Strain Gauge Analysis

The current study used strain gauge analysis to perform an in vitro evaluation of the effect of axial and non-axial loading on implant-supported fixed partial prostheses, varying the implant placement configurations and the loading points. Three internal hexagon implants were embedded in the center of each polyurethane block with in-line and offset placements. Microunit abutments were connected to the implants using a torque of 20 N.cm, and plastic prosthetic cylinders were screwed onto the abutments, which received standard patterns cast in Co-Cr alloy (n = 10). Four strain gauges (SGs) were bonded onto the surfaces of the blocks, tangentially to the implants: SG 01 mesially to implant 1, SG 02 and SG 03 mesially and distally to implant 2, respectively, and SG 04 distally to implant 3. Each metallic structure was screwed onto the abutments using a 10-N.cm torque, and axial and non-axial loads of 30 kg were applied at 5 predetermined points. The data obtained from the strain gauge analyses were analyzed statistically through the repeated measures analysis of variance and the Tukey test, with a conventional level of significance of P < 0.05. The results showed a statistically significant difference for the loading point (P = 0.0001), with point E (nonaxial) generating the highest microstrain (327.67 mu epsilon) and point A (axial) generating the smallest microstrain (208.93 mu epsilon). No statistically significant difference was found for implant placement configuration (P = 0.856). It was concluded that the offset implant placement did not reduce the magnitude of microstrain around the implants under axial and non-axial loading conditions, although loading location did influence this magnitude.

Influence of environmental temperature and electrolyte balance on the performance of quails (Coturnix Coturnix Coturnix)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Studies on structural, morphological and electrical properties of Ce1-xErxO2-delta (x=0.05-0.20) as solid electrolyte for IT - SOFC

A series of four different powders ceria doped Ce1-xErxO2-delta (0.05 <= x <= 0.20) were synthesized by applying self-propagating reaction at room temperature (SPRT method). SPRT procedure is based on the self-propagating room temperature reaction between metal nitrates and sodium hydroxide, wherein the reaction is spontaneous and terminates extremely fast. The method is known to assure very precise stoichiometry of the final product in comparison with a tailored composition. XRPD, Raman spectroscopy, TEM and BET measurements were used to characterize the nanopowders at room temperature. It was shown that all obtained powders were single phase solid solutions with a fluorite-type crystal structure and all powder particles have nanometric size (about 3-4 nm). Densification was performed at 1550 degrees C, in an air atmosphere for 2 h. XRPD, SEM and complex impedance method measurements were carried out on sintered samples. Single phase form was evidenced for each sintered materials. The best value of conductivity at 700 degrees C amounted to 1.10 x 10(-2) Omega(-1) cm(-1) for Ce0.85Er0.O-3(2-delta) sample. Corresponding activation energies of conductivity amounted to 0.28 eV in the temperature range 500-700 degrees C. (C) 2015 Elsevier B.V. All rights reserved.

Early loading of 6-mm-short implants with a moderately rough surface supporting single crowns: a prospective 5-year cohort study

AimTo evaluate prospectively the clinical and radiographic outcomes after 5years of early loading of 6-mm implants with a moderately rough (SLActive((R))) surface supporting single crowns in the posterior regions.Material and methodsThirty-five consecutive patients received 40 SLActive((R)) (Straumann) 6-mm implants with a diameter of 4.1mm (n=19) or 4.8mm (n=21). Insertion torque and resonance frequency analysis (RFA) were measured at implant installation. RFA was also measured at abutment connection. SynOcta abutments were tightened with 35Ncm after 6weeks of healing, and single porcelain fuse to metal crowns was cemented within 1week. Implant survival rate and marginal bone loss were evaluated at various time intervals until 5years after loading. The clinical crown/implant ratio was calculated as well.ResultsTwo of 40 implants were lost before loading (incorporation rate 95%), and no further implant loss or technical complications were encountered during the 5-year follow-up period. A mean marginal bone loss of 0.70.6mm was found after 5years of function. The clinical crown/implant ratio increased with time from 1.6 at the delivery of the prosthesis to 2 after 5years of loading.ConclusionSix millimeter implants with a SLActive((R)) moderately rough surface supporting single crowns in the posterior region and loaded after 6-7weeks maintained full function for at least 5year with low marginal bone resorption.

Incorporation of Ca, P, and Si on bioactive coatings produced by plasma electrolytic oxidation: The role of electrolyte concentration and treatment duration

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Strategic use of dietary electrolyte balance and ratio for broiler chickens

The literature reports dealing with the dietary electrolyte ratio (K+Cl)/ Na are rare, although the concept has been proposed by Mongin in 1981. Thus, its application appears to be limited as a nutritional strategy in feed formulation, which usually meets only the minimum nutritional recommendations in Na, K and Cl. The objective of this study was to evaluate the performance of broilers submitted to different dietary electrolyte balances (DEB) Na+K-Cl and dietary electrolyte ratio (DER) from 1 to 21 d of age. A total of 1575 male 1-d old broiler chicks were randomly assigned to 5 treatments with 9 replicates of 35 chicks each. The treatments consisted of diets with 5 relation of electrolytes, arising from combinations DEB/DER 150/3, 250/2, 250/3, 250/4 and 350/3, with use of NaCl, NaHCO3, KCl, K2SO4 and CaCl2. All diets were corn-soybean meal based and formulated to meet or exceed the NRC (1994) requirements. Chicks had ad libitum access to feed and water in floor pens with wood shavings as litter. Body weight, feed intake and feed conversion ratio were measured at 21 d of age. It was found that only the feed conversion was significantly affected (P = 0.0142) by the combinations of relation of electrolytes (DEB and DER). The supplementation levels in DEB and DER were made to fit the data into a surface analysis to allow increasing levels of DEB (150–350 mEq/kg) and narrow and broad ratio of DER (2–4). For the canonical analysis of response surface was obtained the stationary point for body weight (DEB = 255.77 mEq/kg, and DER = 2.73:1) the value was 942.02 g; for feed intake (DEB = 251.69 mEq / kg and DER = 3.51:1), the value was 1200.02 g; and for feed conversion (DEB = 254.62 mEq/kg and DER = 3.06:1) the value was 1.35. The results of this experiment indicated that the best performance was obtained with combinations of relation of electrolytes for DEB between 251 and 255 mEq/kg and DER between 2.73:1 and 3.5:1.

Green training supporting eco-innovation in three Brazilian companies: practices and levels of integration

Purpose – The purpose of this paper is to show results from the relationship between green/environmental training and the development of three projects of low-carbon eco-innovations in top Brazilian companies. Design/methodology/approach – This study includes three organizational projects for low-carbon eco-innovations in products (A, B and C) with the objective of reducing their impact on GHG emissions, the so-called low-carbon products. Data were collected from several sources of evidence, including in-depth interviews, document analyses and direct observations. Findings – The authors verified that the environmental training interface for mitigating climate change is relevant for the systematic development of low-carbon products in most of the cases studied. Originality/value – Low-carbon eco-innovations are a trend in the corporate world; however, there is not enough literature and practical evidence on this subject. Thus, this paper adds new evidence to the literature.