138 resultados para Sudden stops
Resumo:
The bladder pressure necessary to cause vesicoureteral reflux (VUR) was measured in 16 female rats. Under general anesthesia, the ureters were exposed via an abdominal incission and a pressure catheter was placed near the uterovesical junction. Values of bladder distension and bladder pressure increase to cause VUR were obtained by injecting isotonic saline in one ureter until VUR in the opposite ureter was detected as a sudden pressure increase. After 5 min the same procedure was done on the contralateral side. This procedure was repeated eight times in each rat with a 15-min intermission. The bladder pressure at which VUR occurred was measured through a uretral catheter. Two groups were studied: G1, control, and G2, administration of intravenous metoclopramide (0.007 mg/100 g body weight) four times.
Resumo:
Sudden eccentricity increases of asteroidal motion in 3/1 resonance with Jupiter were discovered and explained by J. Wisdom through the occurrence of jumps in the action corresponding to the critical angle (resonant combination of the mean motions). We pursue some aspects of this mechanism, which could be termed relaxation-chaos: that is, an unconventional form of homoclinic behavior arising in perturbed integrable Hamiltonian systems for which the KAM theorem hypothesis do not hold. © 1987.
Resumo:
Transient non-Darcy forced convection on a flat plate embedded in a porous medium is investigated using the Forchheimer-extended Darcy law. A sudden uniform pressure gradient is applied along the flat plate, and at the same time, its wall temperature is suddenly raised to a high temperature. Both the momentum and energy equations are solved by retaining the unsteady terms. An exact velocity solution is obtained and substituted into the energy equation, which then is solved by means of a quasi-similarity transformation. The temperature field can be divided into the one-dimensional transient (downstream) region and the quasi-steady-state (upstream) region. Thus the transient local heat transfer coefficient can be described by connecting the quasi-steady-state solution and the one-dimensional transient solution. The non-Darcy porous inertia works to decrease the velocity level and the time required for reaching the steady-state velocity level. The porous-medium inertia delays covering of the plate by the steady-state thermal boundary layer. © 1990.
Resumo:
An experimental model and a mathematical model with the introduction of a ramp in the channel of Obenaus model are presented. The aim is to present a better reproduction of the real layer pollution deposited on the HV insulators. This better reproduction is obtained from two types of thickness variation: the introduction of a ramp (soft variation) and the introduction of a step (sudden variation). The computational simulations and the experimental data suggest that the introduction of the ramp is the better reproduction of the layer pollution. The ramp approximates to the real layer pollution more than the step.
Resumo:
The effect of feed restriction (0, 10, 20, 30, 40 and 50%) from 8 until 14 days post-hatching on performance, total mortality incidence and sudden death syndrome (SDS) rate was studied in male broilers during winter and summer.Ad libitum fed broilers had a better performance, but a higher total mortality rate (13.00% in winter, 3.67% in summer) and SDS (3.67% in winter, 0.67% in summer). All restricted groups had a lower mortality level in winter than the control group with a non linear response influenced by feed restriction. Birds submitted to 40% feed restriction showed the lowest mortality incidence (2.67%) followed by groups submitted to 30% (4.67%), 50% (5.33%) and 10% and 20% (7.67%) feed restriction. Birds fed ad libitum had the highest SDS incidence (3.67%, against .33, 1.00, .67, 1.33 and 1.33% at 10, 20, 30, 40, 50% feed restriction, respectively), but differences were not significant. In summer, incidences of total mortality and due to SDS were low and not influenced by feed restriction, either during the restrictive period itself (8 to 14 days) or during the total period of raising (1 to 49 days). In both seasons, the feed restricted birds showed compensatory gain only until three weeks post-restriction period. At 49 days, body weight and weight-gain were lower in feed restricted birds, but feed :gain ratio rate was improved. This resulted in better productivity index in winter, but not in summer. The feed restriction at 30 to 40% for seven days during the second week may decrease mortality in male broilers raised in winter without lowering productivity if the restriction is followed by at least three weeks of full feeding.
Resumo:
Two trials were carried out to test the susceptibility for metabolic disturbances of different strains of male broilers. In Trial 1, 1,890 male chickens were allotted in a randomized block design with seven treatments (Arbor Acres, Avian Farms, Cobb-500, Hubbard-Peterson, ISA, Naked Neck, and Ross) and six blocks of 45 chickens. Trial 2 involved 2,184 male chickens of six strains (Arbor Acres, Avian Farms, Cobb 500, Hubbard-Peterson, ISA Naked Neck, and Ross) allotted in seven complete blocks of 52 birds. The same management system was adopted for all birds, reared up to 42 d in an open house during late winter (Trial 1) or late autumn (Trial 2). The most marked differences observed among the strains tested was the lower BW and higher feed conversion of Naked Neck broilers. Total percentage mortalities were high among the most productive broilers, being more than 50% due to sudden death (SDS) and ascites syndrome (AS). No Naked Neck birds died as a consequence of these disturbances and the total mortalities were significantly lower (P ≤ 0.05) than the other strains. The ratio of right ventricle weight to total ventricle weight of the dead birds was over 0.25, except for Naked Neck birds, which presented a nonhypertrophic ratio. The two trials confirmed the relationship between high productivity and high incidence of SDS and AS and indicated that Naked Neck male broilers are resistant to these metabolic disturbances.
Resumo:
Chrysomya albiceps, the larvae of which are facultative predators of larvae of other dipteran species, has been introduced to the Americas over recent years along with other Old World species of blowflies, including Chrysomya megacephala, Chrysomya putoria and Chlysomya rufifacies. An apparent correlate of this biological invasion has been a sudden decline in the population numbers of Cochliomyia macellaria, a native species of the Americas. In this study, we investigated predation rates on third instar larvae of C. macellaria, C. putoria and C. megacephala by third instar larvae of C. albiceps in no-choice, two-choice and three-choice situations. Most attacks by C. albiceps larvae occurred within the first hour of observation and the highest predation rate occurred on C. macellaria larvae, suggesting that C. albiceps was more dangerous to C. macellaria than to C. megacephala and C. putoria under these experimental conditions. The rates of larvae killed as a result of the predation, as well as its implications to population dynamics of introduced and native species are discussed.
Resumo:
Seven male broiler strains (Arbor Acres, Avian Farms, Cobb-500, Hubbard-Peterson, ISA, Naked Neck, and Ross) were compared for their growth rate, feed efficiency, and mortality due to sudden death and ascites. In addition, weekly plasma levels of thyroid hormones [3,3′,5-triiodothyronine (T3) thyroxine (T4), T3: T4 ratio, growth hormone (GH), and insulin-like growth factor-I (IGF-I)] were determined. The highly productive, commercial strains were very similar in their endocrine profiles but differed markedly from the Naked Neck chickens. Naked Neck chickens were characterized by higher plasma T3 and lower T4 levels at similar ages as well as when compared on the same body weight basis. The present findings support the hypothesis that the slightly hypothyroid state of high productive broilers renders them more sensitive to metabolic disorders. Naked Neck chickens also had higher plasma GH levels than those of their age-matched commercial broilers. The coefficient of variation for GH was highest for Naked Neck chickens, which is indicative for an amplified GH burst amplitude. It may be stated that changes in plasma thyroid hormone concentration in indirect response to selection for low feed conversion and fast growth may be causatively linked to susceptibility for metabolic disturbances such as sudden death syndrome and ascites.
Resumo:
As it follows from the classical analysis, the typical final state of a dark energy universe where a dominant energy condition is violated is a finite-time, sudden future singularity (a big rip). For a number of dark energy universes (including scalar phantom and effective phantom theories as well as specific quintessence models) we demonstrate that quantum effects play the dominant role near a big rip, driving the universe out of a future singularity (or, at least, moderating it). As a consequence, the entropy bounds with quantum corrections become well defined near a big rip. Similarly, black hole mass loss due to phantom accretion is not so dramatic as was expected: masses do not vanish to zero due to the transient character of the phantom evolution stage. Some examples of cosmological evolution for a negative, time-dependent equation of state are also considered with the same conclusions. The application of negative entropy (or negative temperature) occurrence in the phantom thermodynamics is briefly discussed.
Resumo:
Despite its importance for designing evaporators and condensers, a review of the literature shows that heat transfer data during phase change of carbon dioxide is very limited, mainly for microchannel flows. In order to give a contribution on this subject, an experimental study of CO 2 evaporation inside a 0.8 mm-hydraulic diameter microchannel was performed in this work. The average heat transfer coefficient along the microchannel was measured and visualization of the flow patterns was conducted. A total of 67 tests were performed at saturation temperature of 23.3°C for a heat flux of 1800 W/(m2°C). Vapor qualities ranged from 0.005 to 0.88 and mass flux ranged from 58 to 235 kg/(m2s). An average heat transfer coefficient of 9700 W/(m2°C) with a standard deviation of 35% was obtained. Nucleate boiling was found to characterize the flow regime for the test conditions. The dryout of the flow, characterized by the sudden reduction in the heat transfer coefficient, was identified at vapor qualities around 0.85. Flow visualization results showed three flow patterns. For low vapor qualities (up to about 0.25), plug flow was predominant, while slug flow occurred at moderated vapor qualities (from about 0.25 to 0.50). Annular flow was the flow pattern for higher vapor qualities. Copyright © 2006 by ABCM.
Resumo:
Polycrystalline Nd1-xEuxNiO3 (0≤x≤0.5) compounds were synthesized in order to investigate the character of the metal-insulator (MI) phase transition in this series. Samples were prepared through the sol-gel route and subjected to heat treatments at ∼1000 °C under oxygen pressures as high as 80bar. X-ray diffraction (XRD) and neutron powder diffraction (NPD), electrical resistivity ρ(T), and magnetization M(T) measurements were performed on these compounds. The NPD and XRD results indicated that the samples crystallize in an orthorhombic distorted perovskite structure, space group Pbnm. The analysis of the structural parameters revealed a sudden and small expansion of ∼0.2% of the unit cell volume when electronic localization occurs. This expansion was attributed to a small increase of ∼0.003 of the average Ni-O distance and a simultaneous decrease of ∼-0.5° of the Ni-O-Ni superexchange angle. The ρ(T) measurements revealed a MI transition occurring at temperatures ranging from TMI∼193 to 336K for samples with x ≤ 0 and 0.50, respectively. These measurements also show a large thermal hysteresis in NdNiO3 during heating and cooling processes, suggesting a first-order character of the phase transition at TMI. The width of this thermal hysteresis was found to decrease appreciably for the sample Nd 0.7Eu0.3NiO3. The results indicate that cation disorder associated with increasing substitution of Nd by Eu is responsible for changing the first-order character of the transition in NdNiO3. © 2006 IOP Publishing Ltd.
Resumo:
In this work the color dependence of resin composites with the background color was evaluated. The objective was to measure since what thickness the color of the sample stops being influenced by the color of the background over which the resin is placed and the methodology used in experiment was based in analyzing the contrast of digital images of the sample over a black background. The results shown that since 0.8 mm the images contrast becomes almost constant; it prove that since this thickness the color of resin composite depends on the optical resin properties only. The experiment was repeated under three conditions of luminosity to evaluate the influence of it on the image contrast and the results obtained were identical.
Resumo:
Pulmonary thromboembolism (PTE) ranges from incidental, clinically unimportant thromboembolism to massive embolism with sudden death. Its treatment is well established in two groups of patients: heparin for those with normal systemic blood pressure without right ventricular dysfunction (RVD) and thrombolysis for those with RVD and circulatory shock. In an intermediate group of patients with systemic blood pressure stability combined with RVD, which is usually associated with worse outcome, the treatment is controversial. There are authors who strongly suggest thrombolysis while others contraindicate this procedure and recommend anticoagulation with heparin. This is a narrative review that includes clinical trials comparing thrombolysis and heparin for the treatment of PTE patients with systemic blood pressure stability and RVD published since 1973. The results show that there are only four trials on this subject with less than 500 patients. Many PTE patients with systemic blood pressure stability and RVD might benefit from thrombolysis but, on the other hand, the risk for hemorrhagic events may be increased. Large randomized clinical trials are required to clarify this. © 2008 Bentham Science Publishers Ltd.
Resumo:
Background: The large vestibular aqueduct syndrome (LVAS) is characterized by the enlargement of the vestibular aqueduct associated with sensorioneural hearing loss. The level of hearing loss varies and may be fluctuant, progressive or sudden. Vestibular symptoms may be present. The diagnosis is reached by imaging methods. Aim: To report an LVAS case. Method: A female infant was submitted to a computerized tomography of the ears and to audiologic tests. Results: Enlargement of the vestibular aqueduct of more than 1.5mm and sensorioneural hearing loss in the right ear were observed. Conclusion: With an early hearing evaluation it is possible to diagnose hearing loss, even in children were this loss is unilateral. Although the literature indicates that the diagnosis of LVAS occurs at a later age, in this case time etiologic diagnosis was enabled by computerized tomography.
Resumo:
Due to their high hardness and wear resistance, Si3N4 based ceramics are one of the most suitable cutting tool materials for machining cast iron, nickel alloys and hardened steels. However, their high degree of brittleness usually leads to inconsistent results and sudden catastrophic failures. This necessitates a process optimization when machining superalloys with Si3N4 based ceramic cutting tools. The tools are expected to withstand the heat and pressure developed when machining at higher cutting conditions because of their high hardness and melting point. This paper evaluates the performance of α-SiAlON tool in turning Ti-6Al-4V alloy at high cutting conditions, up to 250 m min-1, without coolant. Tool wear, failure modes and temperature were monitored to access the performance of the cutting tool. Test results showed that the performance of α-SiAl0N tool, in terms of tool life, at the cutting conditions investigated is relatively poor due probably to rapid notching and excessive chipping of the cutting edge. These facts are associated with adhesion and diffusion wear rate that tends to weaken the bond strength of the cutting tool.