Association of matrix metalloproteinase inducer (EMMPRIN) with the expression of matrix metalloproteinases-1, -2 and -9 during periapical lesion development

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of immediate loading on healing of implants installed with different insertion torques - an experimental study in dogs

Objective: To evaluate the influence of different insertion torques on healing of implants loaded immediately or left unloaded.Material and methods: In six Labrador dogs, all mandibular premolars and molars were extracted. After 4 months of healing, flaps were elevated, and two implant sites were prepared at each side of the mandible. The distal sites were prepared conventionally while the mesial sites were underprepared by 0.3 mm. As a consequence, different final insertion torques of about 30 Ncm at the distal and >70 Ncm at the mesial sites were recorded. Healing abutments were applied to the left and transmucosal abutments to the right side. Flaps were sutured, crown preparation of the upper right second and third premolars was performed, and impressions were taken. Within 24 h, crowns were cemented both to implants and teeth in the right side of the mouth. After 4 months, the animals were sacrificed and ground sections obtained for histological evaluation.Results: A higher buccal bony crestal resorption and a more apical position of the coronal level of osseointegration were found at the loaded compared with the unloaded sites. MBIC% and percentages of peri-implant mineralized tissue (MB%) were higher at the loaded compared with the unloaded sites. Moreover, a higher MBIC% was found at the lower compared with the higher final insertion torque.Conclusions: Immediate loading does not seem to have a negative effect on osseointegration. High torque values for the immediate loading procedures were not necessary. Probably, low torque values, were sufficient to obtain primary stability and hence may provide better osseointegration than high torque value.

Hard and soft tissue changes around implants installed in regular-sized and reduced alveolar bony ridges. An experimental study in dogs

Objective: To study bony and soft tissue changes at implants installed in alveolar bony ridges of different widths.Material and methods: In 6 Labrador dogs, the mandibular premolars and first molars were extracted, and a buccal defect was created in the left side at the third and fourth premolars by removing the buccal bone and the inter-radicular and interdental septa. Three months after tooth extraction, full-thickness mucoperiosteal flaps were elevated, and implants were installed, two at the reduced (test) and two at the regular-sized ridges (control). Narrow or wide abutments were affixed to the implants. After 3 months, biopsies were harvested, and ground sections prepared for histological evaluation.Results: A higher vertical buccal bony crest resorption was found at the test (1.5 +/- 0.7 mm and 1.0 +/- 0.7 mm) compared to the control implants (1.0 +/- 0.5 mm and 0.7 +/- 0.4 mm), for both wide and narrow abutment sites. A higher horizontal alveolar resorption was identified at the control compared to the test implants. The difference was significant for narrow abutment sites. The peri-implant mucosa was more coronally positioned at the narrow abutment, in the test sites, while for the control sites, the mucosal adaptation was more coronal at the wide abutment sites. These differences, however, did not reach statistical significance.Conclusions: Implants installed in regular-sized alveolar ridges had a higher horizontal, but a lower vertical buccal bony crest resorption compared to implants installed in reduced alveolar ridges. Narrow abutments in reduced ridges as well as wide abutments in regular-sized ridges yielded less soft tissue recession compared to their counterparts.

Effect of the concentration of phenothiazine photosensitizers in antimicrobial photodynamic therapy on bone loss and the immune inflammatory response of induced periodontitis in rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Antiplatelet drugs reduce the immunoinflammatory response in a rat model of periodontal disease

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of Locally Administered Tiludronic Acid on Experimental Periodontitis in Rats

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Canine retraction and anchorage loss Self-ligating versus conventional brackets in a randomized split-mouth study

Objective: To evaluate the velocity of canine retraction, anchorage loss and changes on canine and first molar inclinations using self-ligating and conventional brackets.Materials and Methods: Twenty-five adults with Class I malocclusion and a treatment plan involving extractions of four first premolars were selected for this randomized split-mouth control trial. Patients had either conventional or self-ligating brackets bonded to maxillary canines randomly. Retraction was accomplished using 100-g nickel-titanium closed coil springs, which were reactivated every 4 weeks. Oblique radiographs were taken before and after canine retraction was completed, and the cephalograms were superimposed on stable structures of the maxilla. Cephalometric points were digitized twice by a blinded operator for error control, and the following landmarks were collected: canine cusp and apex horizontal changes, molar cusp and apex horizontal changes, and angulation changes in canines and molars. The blinded data, which were normally distributed, were analyzed through paired t-tests for group differences.Results: No differences were found between the two groups for all variables tested.Conclusions: Both brackets showed the same velocity of canine retraction and loss of anteroposterior anchorage of the molars. No changes were found between brackets regarding the inclination of canines and first molars.

Evaluation of tensile tetention of Y-TZP crowns after long-term aging: Effect of the core substrate and crown surface conditioning

This study evaluated the effect of the core substrate type (dentin and composite resin) on the retention of crowns made of yttrium oxide stabilized tetragonal zirconia polycrystal (Y-TZP), submitted to three inner surface conditionings. For this purpose, 72 freshly extracted molars were embedded in acrylic resin, perpendicular to the long axis, and prepared for full crowns: 36 specimens had crown preparations in dentin; the remaining 36 teeth had the crowns removed, and crown preparations were reconstructed with composite resin plus fiber posts with dimensions identical to the prepared dentin. The preparations were impressed using addition silicone, and 72 Y-TZP copings for the tensile test were produced. Cementation was performed with a dual-cured cement containing phosphate monomers. For cementation, the crown preparation (dentin or resin) was conditioned with the adhesive system, and the ceramic was subjected to one of three surface treatments: isopropyl alcohol, tribochemical silica coating, or thin low-fusing glassy porcelain layer application plus silanization. After 24 hours, all specimens were submitted to thermocycling (6000 cycles) and placed in a special tensile testing device in a universal testing machine to determine failure loads. The failure modes of all samples were analyzed under a stereomicroscope. Two-way analysis of variance showed that the surface treatment and substrate type (alpha=0.05) affected the tensile retention results. The dentin substrate presented the highest tensile retention values, regardless of the surface treatment. When the substrate was resin, the tribochemical silica coating and low-fusing glaze application plus silanization groups showed the higher retention values.

Does the Method of Caries Induction Influence the Bond Strength to Dentin of Primary Teeth?

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Performance of a New One-step Multi-mode Adhesive on Etched vs Non-etched Enamel on Bond Strength and Interfacial Morphology

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Effect of thermo-mechanical load cycling on silorane-based composite restorations

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Treatment with tacrolimus enhances alveolar bone formation and decreases osteoclast number in the maxillae: A histomorphometric and ultrastructural study in rats

Recent studies have suggested that tacrolimus monotherapy is a beneficial therapeutic alternative for the normalization of cyclosporin- induced bone loss in animal models and humans. The mechanism accounting for this action is unclear at present. In the present study, we attempted to determine the effect of tacrolimus monotherapy on alveolar bone using histological, histomorphometrical and transmission electron microscopy (TEM).Groups of rats (n= 10 each) were treated with either tacrolimus (1mg/ kg/ day, s.c.) or drug vehicle for 60 days. Fragments containing maxillary molars were processed for light microscopy to investigate the alveolar bone volume, trabecular separation, number of osteoclasts and osteoblasts, and transmission electron microscopy to investigate their ultrastructural basic phenotype.Treatment with tacrolimus monotherapy during 60 days may induce increases in alveolar bone volume (BV/ TV,%; P < 0.05) and a non- significant decrease in trabecular separation (Tb. Sp, mm; P > 0.05), represented by a decrease in osteoclast number (N. Oc/ BS; P < 0.05) and maintenance of osteoblast number (N. Ob/ BS; P > 0.05). Osteoblasts were often observed as a continuous layer of active cells on the bone surface. Osteoclasts appeared to be detached from the resorbed bone surface, which was often filled by active osteoblasts and collagen- rich matrix. Moreover, osteoclasts in the treated group were frequently observed as inactive cells (without ruffled border, clear zone and detached from the bone surface).Within the limits of the present study, we conclude that tacrolimus leads to an increase in alveolar bone formation, which probably exerts action on osteoclasts. Tacrolimus could, therefore, play a crucial role in the control of both early osteoclast differentiations from precursors, as well as in functional activation.

Estudo in vitro da anatomia das projeções de esmalte cervical em dentes molares

The cervical enamel projection (CEP) is an anatomic variation that can be found in the cement enamel junction, it´s recognition and early diagnosis improves outcome the tooth involved, allowing greater efficiency in treatment. The knowledge of the location, grade and incidence of CEP is decisive on prevention and treatment of periodontal disease. It were studied 1200 molars (600 mandibular molars and 600 maxillary molars) separated from the collection of teeth on the Discipline of Anatomy in FOSJCampos - UNESP. Each group of 600 teeth was separated from the second side (300 teeth) and the second type (first, second or third molar). Each tooth had thoroughly inspected the cervical region, in all their faces, in order to verify the incidence and the grade of CEP in each surface. It was found that the CEP covered in 278 (23,17%) teeth was 146 (52,52%) mandibular molars and 132 (47,48%) maxillary molars. The CEPs were concentrated on a tooth surface in 222 (79,86%) teeth, in two surfaces 53 (19,06%) teeth, and in three surfaces in three (1,08%) teeth. From the total of 4.800 surfaces examined the CEPs were found in 337 surfaces, and 228 (67,66%) surfaces of the grade I, 60 (17,8%) grade II and 49 (14,54%) grade III. The buccal surface presented 207 (61,42%) CEP, the lingual surface in 57 (16,91%), the mesial surface in 35 (10,39%) and the distal surface in 38 (11,28%) CEP. The results of this study demonstrated that the CEPs have focused more on the mandibular teeth on only one surface of the tooth, the grade I was the most found and the buccal surface the most involved

Avaliação dos efeitos da terapia fotodinâmica com hipericina-glucamina no tratamento da doen ça periodontal induzida em ratos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Mudanças dento-esquelétics naturais e decorrentes do tratamento ortopédico da má oclusão de Classe II

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)