56 resultados para bovine bone
Resumo:
Pós-graduação em Odontologia - FOA
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Objective: To compare with pristine sites bone resorption and soft tissue adaptation at implants placed immediately into extraction sockets (IPIES) in conjunction with deproteinized bovine bone mineral (DBBM) particles and a collagen membrane.Material and methods: The mesial root of the third premolar in the left side of the mandible was endodontically treated (Test). Flaps were elevated, the tooth hemi-sectioned, and the distal root removed to allow the immediate installation of an implant into the extraction socket in a lingual position. DBBM particles were placed into the defect and on the outer contour of the buccal bony ridge, concomitantly with the placement of a collagen membrane. A non-submerged healing was allowed. The premolar on the right side of the mandible was left in situ (control). Ground sections from the center of the implant as well as from the center of the distal root of the third premolar of the opposite side of the mandible were obtained. The histological image from the implant site was superimposed to that of the contralateral pristine distal alveolus, and dimensional variation evaluated for the hard tissue and the alveolar ridge.Results: After 3 months of healing, both histological and photographic evaluation revealed a reduction of hard and soft tissue dimensions.Conclusion: The contour augmentation performed with DBBM particles and a collagen membrane at the buccal aspects of implants placed IPIES was not able to maintain the tissue volume.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Introduction: The radiographic characteristics of a biomaterial, such as its density, may influence the evaluation of the results obtained following its clinical use. Objective: The aim of this study was to evaluate the radiographic density of biomaterials used as bone substitutes, inserted into dental sockets and bone defects in created in the jaws of pigs. The influence of a soft tissue simulator on the results was also evaluated. Material and method: Two and three-millimeter-deep bone defects were created in the pigs mandible and the right first molar extraction socket were used. Commercial samples of five biomaterials were tested: Hydroxyapatite, Lyophilized Bovine Bone, 45S5 bioglass (generic), PerioGlass and β-Tri-Calcium Phosphate, and compared to a positive (mandibular bone) and negative (empty alveolar bone defects) controls. Radiographic images were acquired with and without a 10 mm thick soft-tissue simulator. Result: The results for the extraction sockets showed no differences between the biomaterials and the negative control. For the bone defects, the depth of the defect density influenced the density, both in the negative control (p < 0.01) and biomaterials (p < 0.05) groups. The soft- tissue simulator did not alter the results. Conclusion: The type of the evaluated defect can interfere in the radiographic features presented by each biomaterial, while the simulation of soft tissues was not statistically significant.
Resumo:
AimThe aim of this study was to evaluate the healing of autologous bone block grafts or deproteinized bovine bone mineral (DBBM) block grafts applied concomitantly with collagen membranes for horizontal alveolar ridge augmentation.Material and methodsIn six Labrador dogs, molars were extracted bilaterally, the buccal bony wall was removed, and a buccal box-shaped defect created. After 3months, a bony block graft was harvested from the right ascending ramus of the mandible and reduced to a standardized size. A DBBM block was tailored to similar dimensions. The two blocks were secured with screws onto the buccal wall of the defects in the right and left sides of the mandible, respectively. Resorbable membranes were applied at both sides, and the flaps sutured. After 3months, one implant was installed in each side of the mandible, in the interface between grafts and parent bone. After 3months, biopsies were harvested and ground sections prepared to reveal a 6-month healing period of the grafts.Results776.2% and 5.9 +/- 7.5% of vital mineralized bone were found at the autologous bone and DBBM block graft sites, respectively. Moreover, at the DBBM site, 63 +/- 11.7% of connective tissue and 31 +/- 15.5% of DBBM occupied the area analyzed. Only 0.2 +/- 0.4% of DBBM was found in contact with newly formed bone. The horizontal loss was in a mean range of 0.9-1.8mm, and 0.3-0.8mm, at the autologous bone and DBBM block graft sites, respectively.ConclusionsAutologous bone grafts were vital and integrated to the parent bone after 6months of healing. In contrast, DBBM grafts were embedded into connective tissue, and only a limited amount of bone was found inside the scaffold of the biomaterial.
Resumo:
Background: The principles of tissue regeneration to repair alveolar bone defects are based on the fabrication of a biologic barrier with different biomaterials. Therefore, the present study aimed to investigate the guided bone regeneration (GBR) by using membrane of demineralized bovine bone matrix (DBBM) on experimental defects in tibia of dogs. Methods: Four dogs were used and after anesthesia, shaving and antisepsis, two standardized bone defects were created on the right tibia of each animal with trephine drill. In the Control Group, the defects were filled with blood coagulum, while in the Treated Group, a membrane of DBBM was used to cover the defects. After 90 days, animals were sacrificed. Results: In the Treated Group, 67.4% of new bone formation was observed and, in the Control Group, 32.6% of the bone tissue reabsorbed when compared with initial bone volume. The membrane remained intact and no inflammatory tissue was observed on membrane/ bone interface. Conclusion: It was concluded that the use of DBBM is an osteoconductive material, presents biocompatibility and may be promise option to repair bone defects.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Pós-graduação em Odontologia - FOA
Resumo:
Pós-graduação em Ciências Odontológicas - FOAR
Resumo:
Bovine meat and bone meal (MBM) was widely used in animal diets until outbreaks of Bovine Spongiform Encefalopathy (BSE) occurred in some countries. It has not been confirmed yet whether or not BSE may be transmitted to man through chicken meat originated from poultry that had been fed diets containing MBM. Therefore, consumers nowadays express preference for meat originated from birds fed exclusively vegetable diets. This study analyzed samples of major breast muscle (Pectoralis major) using mass spectrometry of stable isotopes (carbon and nitrogen) as a means to assess the presence of MBM in broiler diets, a technique that might be used in the certification of poultry quality. A total of 150 day-old chicks were reared in five randomized treatments with increasing MBM dietary inclusion levels (0, 1, 2, 4 and 8%). on day 42, breast muscle samples were collected from three birds per treatment and used in the determination of 13C/12C and 15N/14N isotope ratios. The breast muscle isotope values were expressed as delta in parts per thousand (delta ). The following carbon isotope values (13C) were found: 18.74 ±0.11, 18.51 ±0.19, 18.24 ±0.10, -17.79 ±0.12, and -17.15 ±0.15 for 0, 1, 2, 4 and 8% MBM dietary levels, respectively. Nitrogen isotope values (15N) were 1.65 ±0.14, 1.65 ±0.28, 1.72 ±0.08, 1.95 ±0.16, and 2.52 ± 0.09 for 0, 1, 2, 4 and 8% MBM dietary levels, respectively. This study showed important differences in delta13C and delta15N values in breast meat, evidencing a simultaneous enrichment of this isotopic pair, which allowed tracing MBM in bird diets. Analysis of carbon and nitrogen stable isotopes may be used to ensure feeding with exclusively vegetable diets, and might also be used as a reliable evaluation tool in broiler meat certification. The diet with 1% inclusion level of MBM and the exclusively vegetable diet showed similar results.
Resumo:
Oocyte-secreted factors (OSFs) regulate differentiation of cumulus cells and are of pivotal relevance for fertility. Bone morphogenetic protein 15 (BMP15) and fibroblast growth factor 10 (FGF10) are OSFs and enhance oocyte competence by unknown mechanisms. We tested the hypothesis that BMP15 and FGF10, alone or combined in the maturation medium, enhance cumulus expansion and expression of genes in the preovulatory cascade and regulate glucose metabolism favouring hyaluronic acid production in bovine cumulus-oocyte complexes (COCs). BMP15 or FGF10 increased the percentage of fully expanded COCs, but the combination did not further stimulate it. BMP15 increased cumulus cell levels of mRNA encoding a disintegrin and metalloprotease 10 (ADAM10), ADAM17, amphiregulin (AREG), and epiregulin (EREG) at 12 h of culture and of prostaglandin (PG)-endoperoxide synthase 2 (PTGS2), pentraxin 3 (PTX3) and tumor necrosis factor alpha-induced protein 6 (TNFAIP6 (TSG6)) at 22 h of culture. FGF10 did not alter the expression of epidermal growth factor-like factors but enhanced the mRNA expression of PTGS2 at 4 h, PTX3 at 12 h, and TNFAIP6 at 22 h. FGF10 and BMP15 stimulated glucose consumption by cumulus cells but did not affect lactate production or levels of mRNA encoding glycolytic enzymes phosphofructokinase and lactate dehydrogenase A. Each growth factor increased mRNA encoding glucosamine:fructose-6-PO4 transaminases, key enzymes in the hexosamine pathway leading to hyaluronic acid production, and BMP15 also stimulated hyaluronan synthase 2 (HAS2) mRNA expression. This study provides evidence that BMP15 and FGF10 stimulate expansion of in vitro-matured bovine COCs by driving glucose metabolism toward hyaluronic acid production and controlling the expression of genes in the ovulatory cascade, the first acting upon ADAM10, ADAM17, AREG, and EREG and the second on downstream genes, particularly PTGS2. © 2013 Society for Reproduction and Fertility.