Isolamento e caracterização de candida albicans e outras leveduras de águas de recreação não marinha e de materiais clínicos

Candida albicans and other yeasts from recreational water or clinical materials were isolated. Sixty-six water samples, originating from eight swimming pools and five lakes with beaches were examined for the presence of these yeasts, by a membrane filter method and 'pour plate' technique. Sixty-two clinical materials from suspected cases of candidiasis were studied in the same period. Rhodotorula sp and C. albicans were more frequently isolated from lakes and swimming pools, respectively; C. albicans and C. parapsilosis from clinical materials. From 44 samples of C. albicans, 90,9% were serotype A, and 9,1%, serotype B; C. albicans from recreational waters belong only serotype A. No difference was observed in the M.I.C. of C. albicans strains from waters and clinical materials. All strains were susceptible to the antifungal drugs tested.

Liberação de mitomicina C - Influência de diferentes materiais

Purpose: To evaluate the quantity of Mitomycin C discharged from different materials with the same size, potentially used in the application of this medicine accessible in the surgery center of an Universitarian Hospital. Material and Method: It was studied 20 fragments with 5 to 5mm, from each 5 materials: Lyostypt, Weck sponge, absorbable cloth which is used to clean, cotton plate and of cotton swab concerning the saturation capacity and the quantity of mitomicyn discharged. In the first stage, it was studied the saturation capacity from each material. In the second stage, it was applied 0,1 ml solution of Mitomicyn C (0,5 mg/ml) and it was measured the biggest discharge halo in the filter paper and the discharged quantity (the difference between the weight before and after the medicine discharge). Results: The absorveble capacity from each material varied from 0,144 ml (absorbable cloth) to 0,216 ml Weck sponge. The discharge of Mitomicyn C was varied too, the biggest was the cotton plate and absorbable cloth. The Weck sponge and the cotton (of cotton swab) discharges the same quantity. Conclusion: The different materials discharged different quantities of Mitomicyn C. This can explain the different results of the trabeculectomy with Mitomicyn C. The surveys must inform not only the material used to apply the mitomycin C but the volume used too. Because the same values of mitomycin C liberation, cotton may substitute Weck sponje in trabeculectomy.

Comparação entre o sistema Autoścan-4 e métodos convencionais na identificação de bacilos Gram-negativos não fermentadores, isolados de materiais clínicos de pacientes em Presidente Prudente - SP

Ninety eight strains of glucose-nonfermenting Gram-negative bacilli were analyzed and isolated from several clinical materials of 95 patients admitted at the Dr. Domingos Leonardo Cerávolo University Hospital and three from outpatients. All of them were assisted in the Laboratory of Clinical Analysis of Unoeste University, Presidente Prudente, SP, from the period of October of 1999 to April of 2001. In this work, the level of agreement between the semi-automated commercial system AutoScan-4 and the conventional system for the identification of those bacteria were studied comparatively. There was agreement in 81 (82.7%), showing that both methodologies are useful for identification; partial agreement in six strains (6.1%) and disagreement in 11 (11.2%). The comercial system did not identify nine (9.2%) of the strains and reported them as very rare biotypes.

Estudo das características morfológicas dos pites nos materiais resistentes à corrosão

This paper has as a purpose a new alternative technique development to characterize pitting corrosion evolution, aiming classification, size and determination of morphological parameters which rule pits increase. In this case, the method will be applied to the 304 ABNT stainless steel, thermally treated and exposed to different times in salt spray. Different 304 steel conditions, rolled and thermally treated have exhibited similar geometry, predominantly conic, near-conic and irregular pits. On rolled steel, pits width increases faster than height; however, on thermally treated steel, pits are found to increase in height.

Padrão de sensibilidade aos antimicrobianos de bacilos gram-negativos não fermentadores isolados de materiais clínicos de pacientes em Presidente Prudente - SP

The aim of this study was the assessment of isolation frequency and antimicrobial susceptibility pattern of nonfermenting Gram-negative bacilli. Ninety eight strains of nonfermenting Gram-negative bacilli, isolated from several clinical materials of patients admited at the Dr. Domingos Leonardo Cerávolo University Hospital and at Dr. Odilo Antunes Siqueira State Hospital, as well as from every outpatient; assisted at Laboratory of Clinical Analysis of Unoeste University, Presidente Prudente, São Paulo, in the period of October 1999 to April 2001 were analyzed. The most frequent species were Pseudomonas aeruginosa (65.3%) and Acinetobacter baumannii (23.5%). The frequency of the other isolated species was smaller than 2.5%. In the antimicrobial susceptibility tests, the two species more prevalent showed high resistance. The antibiotic most active in vitro was the imipenem, with 79.6% in microdiluition method, and 76.6% in diffusion method, for Pseudomonas aeruginosa strains and 100.0% in both microdiluition and diffusion methods, for Acinetobacter baumannii. The cephalosporins of third generation, the ciprofloxacin and the aminoglycosides, presented percentage of susceptibility varying from 22.4 to 69.7%. These results bring implications to the emergency use of the antimicrobial agents in the treatment of patients with severe infection.

Experienciando Materiais Manipulativos para o Ensino e a Aprendizagem da Matemática

This paper presents some outcomes from research based on classroom experiences. The main themes are the use of mirrors, kaleidoscopes, dynamic geometry software, and manipulative material considering their possibilities for the teaching and learning of Euclidean and non-Euclidean geometries.

Esterilização de materiais termossensíveis através de aplicação de plasma gerado por descarga com barreira dielétrica (DBD)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Educação, visualidade e informação em materiais gráficos educativos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Em foco: professores de Artes e suas experiências com os materiais educativos Lá vai Maria Bem-vindo professor! arte br

Pós-graduação em Artes - IA

Pesquisa e desenvovimento de novos materiais microporosos e mesoporosos para uso em ressonância magnética nuclear por imagem como agentes de contraste

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desempenho e estabilidade de parâmetros bioquímicos em materiais de controle líquidos congelados e sólidos liofilizados

Pós-graduação em Biociências e Biotecnologia Aplicadas à Farmácia - FCFAR

Estudo de propriedades físicas de materiais adesivos ortodônticos

Pós-graduação em Ciência dos Materiais - FEIS

Cálculo de funções de Wannier eletrônicas para aplicações em ciência dos materiais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Simulação computacional de materiais com elétrons fortemente interagentes: DMRG aplicado a super-redes Hubbard com modulação de condução entre camadas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estrutura eletrônica de materiais orgânicos: moléculas antimalariais de sulfonamidas e anilinoquinolinas

Pós-graduação em Ciência e Tecnologia de Materiais - FC