Comparison of the performance of natural latex membranes prepared with different procedures and PTFE membrane in guided bone regeneration (GBR) in rabbits

This work assessed the performance of membranes made of natural latex extracted from Hevea brasiliensis prepared with three different methods: polymerized immediately after collection without the use of ammonia (L1); polymerized after preservation in ammonia solution (L2); and polymerized after storage in ammonia, followed by Soxhlet technique for the extraction of substances (L3). Polytetrafluoroethylene (PTFE) membrane was used as control. Two 10-mm diameter bone defects were surgically made in the calvaria of thirty adult male New Zealand rabbits. Defects (total n = 60) were treated with guided bone regeneration (GBR) using L1, L2, L3 or PTFE membranes (n = 15 for each membrane). Ten animals were euthanized after 7, 20 and 60 days postoperatively so that five samples (n = 5) of each treatment were collected at each time, and bone regeneration was assessed microscopically. The microscopic analysis revealed defects filled with blood clot and new bone formation at the margins of the defect in all 7-day samples, while 20-day defects were mainly filled with fibrous connective tissue. After 60 days defects covered with L1 membranes showed a significantly larger bone formation area in comparison to the other groups (P < 0.05, ANOVA, Tukey). Additionally, bone tissue hypersensitization for L1 and PTFE membranes was also investigated in six additional rabbits. The animals were subjected to the same surgical procedure for the confection of one 10-mm diameter bone defect that was treated with L1 (n = 3) or PTFE (n = 3). Fifty-three days later, a second surgery was performed to make a second defect, which was treated with the same type of membrane used in the first surgery. Seven days later, the animals were euthanized and samples analyzed. No differences among L1 and PTFE samples collected from sensitized and non-sensitized animals were found (P > 0.05, Kruskal-Wallis). Therefore, the results demonstrated that latex membranes presented performance comparable to PTFE membranes, and that L1 membranes induced higher bone formation. L1 and PTFE membranes produced no hypersensitization in the bone tissue.

Hancornia speciosa latex for biomedical applications: physical and chemical properties, biocompatibility assessment and angiogenic activity

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evaluation of stryphnodendron sp. release using natural rubber latex membrane as carrier

Natural rubber latex from Hevea brasiliensis has interesting characteristics related to this work such as: it is easy to manipulate, low cost, can stimulate the natural angiogenesis, is a biocompatible material and presents high mechanical resistance. The aim of this study was to develop a novel sustained delivery system for Stryphnodendron sp. based on Natural Rubber Latex (NRL) membranes and to study the Stryphnodendron sp. delivery system behavior. Stryphnodendron sp., commonly known as barbatimao is extensively used in folk medicine for the treatment of diarrhoea, gynaecological problems and for healing wounds. The stem bark of this species is mentioned in the Brazilian Pharmacopeia with a content of at least 20% of tannins. Previous studies showed significant cicatrizant properties, anti-inflammatory activity and gastric anti-ulcerogenic effects for the stem bark crude extract. One possible way to accelerate the tissue repair process, it was incorporated the Stryphnodendron sp. extract in NRL membranes. Stryphnodendron sp extract was incorporated into the NRL, by mixing it in solution for in vitro protein delivery experiments. Results show that the NRL membrane can release Stryphnodendron sp. for up to 49.89% of its Stryphnodendron sp. content for up 400 h. The kinetics of the extract release could be fitted with double exponential function, with two characteristic times of 0.78 and 133.22 h. In this study, we demonstrated that the induced angiogenesis provided by NRL membranes combined with a controlled release of extract is relevant for biomedical applications.

Casearia sylvestris Swartz Extract Release Using Natural Rubber Latex Biomembranes as Carrier

The Natural Rubber Latex (NRL) from Hevea brasiliensis has shown promise in biomedical applications due to its low cost, easy handling, mechanical properties and biocompatibility, being used for bone regeneration and wound healing due to its natural stimulus to angiogenesis. The aim of this work was to incorporate Casearia sylvestris Sw. extract in NRL biomembranes and study its release behavior. The complex membrane-extract has as object of study a new approach of using C. sylvestris extract in the treatment of wounds, for possessing antiseptic activity, anti-inflammatory and analgesic properties. The C. sylvestris species (Salicaceae), popularly known as "guaçatonga", presents great distribution and is used in folk medicine as antiulcer, wound healing, anti-snake venom, properties which have been proven and related to clerodane diterpenes (casearins A-X). The release rate of C. sylvestris compounds from extract-membrane complex was monitored and analyzed using the method of optical spectroscopy (UV-VIS). The release varied with temperature ranging from 14 to 33 days, releasing more than 90%, with an interesting and promising biomedical application, such as wound healing and burns.

Natural rubber latex: Study of a novel carrier for Casearia sylvestris swartz delivery

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Ciprofloxacin Release Using Natural Rubber Latex Membranes as Carrier

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Natural latex films as carrier for casearia sylvestris swartz extract associated with ciprofloxacin

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Genotoxic potential of the latex from cotton-leaf physicnut (Jatropha gossypiifolia L.)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

A new heterologous fibrin sealant as scaffold to recombinant human bone morphogenetic protein-2 (rhBMP-2) and natural latex proteins for the repair of tibial bone defects

Tissue engineering has special interest in bone tissue aiming at future medical applications Studies have focused on recombinant human bone morphogenetic protein-2 (rhBMP-2) and natural latex proteins due to the osteogenic properties of rhBMP-2 and the angiogenic characteristic of fraction 1 protein (P-1) extracted from the rubber tree Hevea brasiliensis. Furthermore, heterologous fibrin sealant (FS) has been shown as a promising alternative in regenerative therapies. The aim of this study was to evaluate these substances for the repair of bone defects in rats. A bone defect measuring 3 mm in diameter was created in the proximal metaphysis of the left tibia of 60 rats and was implanted with rhBMP-2 or P-1 in combination with a new heterologous FS derived from snake venom. The animals were divided into six groups: control (unfilled bone defect), rhBMP-2 (defect filled with 5 mu g rhBMP-2), P-1 (defect filled with 5 mu g P-1), FS (defect filled with 8 mu g FS), FS/rhBMP-2 (defect filled with 8 mu g FS and 5 mu g rhBMP-2), FS/P-1 (defect filled with 8 mu g FS and 5 mu g P-1). The animals were sacrificed 2 and 6 weeks after surgery. The newly formed bone projected from the margins of the original bone and exhibited trabecular morphology and a disorganized arrangement of osteocyte lacunae. Immunohistochemical analysis showed intense expression of osteocalcin in all groups. Histometric analysis revealed a significant difference in all groups after 2 weeks (p < 0.05), except for the rhBMP-2 and FS/rhBMP-2 groups (p > 0.05). A statistically significant difference (p < 0.05) was observed in all groups after 6 weeks in relation to the volume of newly formed bone in the surgical area. In conclusion, the new heterologous fibrin sealant was found to be biocompatible and the combination with rhBMP-2 showed the highest osteogenic and osteoconductive capacity for bone healing. These findings suggest a promising application of this combination in the regeneration surgery.

Evaluation of sodium diclofenac release using natural rubber latex as carrier

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Thermal degradation of both latex and latex cast films forming membranes: combined TG/FTIR investigation

Latex collected from natural rubber trees forming membranes can be used as biomaterials in several fields being the temperature a key parameter. Thermogravimetry (TG) coupled to Fourier transform infrared spectroscopy (FTIR) is a useful technique to investigate the thermal degradation of both latex and cast films (membranes), wich were obtained from Hevea brasiliensis (RRIM 600 clone) and used without stabilization. The membranes were prepared by casting the latex onto a glass substrate at 65 degrees C for 6 h. The thermal degradation was followed by FTIR spectra acquisition along the process, allowing the identification of the gaseous components evolved upon the thermal treatment. According to TG measurements, the main processes of thermal degradation of the latex and membranes occur at three temperature intervals for both.

Facing Hymenoptera venom allergy: from natural to recombinant allergens

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Natural rubber latex coated with calcium phosphate for biomedical application

Natural rubber latex (NRL) is a flexible biomembrane that possesses angiogenic properties and has recently been used for guided bone regeneration, enhancing healing without fibrous tissue, allergies or rejection. Calcium phosphate (Ca/P) ceramics have chemical, biological, and mechanical properties similar to mineral phase of bone, and ability to bond to the host tissue, although it can disperse from where it is applied. Therefore, to create a composite that could enhance the properties of both materials, NRL biomembranes were coated with Ca/P. NRL biomembranes were soaked in 1.5 times concentrated SBF solution for seven days, avoiding the use of high temperatures. SEM showed that Ca/P has been coated in NRL biomembrane, XRD showed low crystallinity and FTIR showed that is the carbonated type B. Furthermore, hemolysis of erythrocytes, quantified spectrophotometrically using materials (Ca/P, NRL, and NRL + Ca/P) showed no hemolytic effects up to 0.125 mg/mL (compounds and mixtures), indicating no detectable disturbance of the red blood cell membranes. The results show that the biomimetic is an appropriate method to coat NRL with Ca/P without using high temperatures, aiming a new biomembrane to improve guided bone regeneration.

Allergy to hematophagous arthropods bites

Allergies to hematophagous arthropod bites are inflammatory reactivity to arthropods salivary components. They vary in intensity and quality dependent upon the arthropod species and the individual immune response to specific proteins of the insect s saliva. Individuals who were not previously exposed show mild localized reactions not beyond those expected by pharmacological substances present in arthropods saliva. Allergic reactions are immunological in their nature and the diversity derived from hypersensitivity reactions with different levels of participation of the immune system components. Some are mainly derived from a humoral immune response, and others are based predominantly on T-lymphocyte-mediated. The majority of these undesired biological answers are self-limited, and few may cause a systemic reaction. This article intends to discuss the immunological ingredients of this evolutionary interaction.