Temporal correlator in YM32 and reflection-positivity violation

We consider numerical data for the lattice Landau gluon propagator obtained at very large lattice volumes in three-dimensional pure SU(2) Yang-Mills gauge theory (YM32). We find that the temporal correlator C(t) shows an oscillatory pattern and is negative for several values of t. This is an explicit violation of reflection positivity and can be related to gluon confinement. We also obtain a good fit for this quantity in the whole time interval using a sum of Stingl-like propagators.

Search for the standard model Higgs boson decaying to bottom quarks in pp collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Search for scalar bottom quarks and third-generation leptoquarks in p(p)over-bar collisions at root s=1.96 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Search for a heavy bottom-like quark in pp collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Search for Charged Higgs Bosons Decaying into Top and Bottom Quarks in pp Collisions

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Search for W ' boson resonances decaying to a top quark and a bottom quark

We search for the production of a heavy W ' gauge boson that decays to third generation quarks in 0: 9 fb(-1) of p (p) over bar collisions at root s = 1: 96 TeV, collected with the D0 detector at the Fermilab Tevatron collider. We find no significant excess in the final-state invariant mass distribution and set upper limits on the production cross section times branching fraction. For a left-handed W ' boson with SM couplings, we set a lower mass limit of 731 GeV. For right-handed W ' bosons, we set lower mass limits of 739 GeV if the W ' boson decays to both leptons and quarks and 768 GeV if the W ' boson decays only to quarks. We also set limits on the coupling of the W ' boson to fermions as a function of its mass.

Laüe back-reflection method for crystallographic orientation of a martensitic Cu-Zn-Al single crystal of the monoclinic system

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Ferroelectric and piezoelectric properties of bismuth titanate thin films grown on different bottom electrodes by soft chemical solution and microwave annealing

Bismuth titanate (Bi4Ti3O12, BIT) films were evaluated for use as lead-free piezoelectric thin films in micro-electromechanical systems. The films were grown by the polymeric precursor method on LaNiO3/SiO2/Si (1 0 0) (LNO), RuO2/SiO2/Si (1 0 0) (RuO2) and Pt/Ti/SiO2/Si (1 0 0) (Pt) bottom electrodes in a microwave furnace at 700 degrees C for 10 min. The domain structure was investigated by piezoresponse force microscopy (PFM). Although the converse piezoelectric coefficient, d(33), regardless of bottom electrode is around (similar to 40 pm/V), those over RuO2 and LNO exhibit better ferroelectric properties, higher remanent polarization (15 and 10 mu C/cm(2)), lower drive voltages (2.6 and 1.3 V) and are fatigue-free. The experimental results demonstrated that the combination of the polymeric precursor method assisted with a microwave furnace is a promising technique to obtain films with good qualities for applications in ferroelectric and piezoelectric devices. (c) 2006 Elsevier Ltd. All rights reserved.

Numerical and experimental analysis of natural convection in a cavity heated from below

In this work, an analysis of the natural convection flow caused by heat sources dissipating energy at a constant rate simulating electronic components mounted at the bottom surface of a cavity symmetrically cooled from the sides and insulated at the top is performed. This problem was studied numerically and experimentally for several aspect ratios (height/width), for different levels of dissipation in the sources, and for different side wall temperatures. Temperature and velocity fields were determined as well as the temperature variation along the surface where the sources are mounted and the average Nusselt number in the source surfaces. Numerical and experimental results were found to agree.

Fatigue-free behavior of Bi3.25La0.75Ti3O12 thin films grown on several bottom eletrodes by the polymeric precursor method

Fatigue-free Bi3.25La0.75Ti3O12 (BLT) thin films were grown on LaNiO3,RuO2, and La0.5Sr0.5CoO3 bottom electrodes in a microwave furnace at 700 degreesC for 10 min. The remanent polarization (P-r) and the drive voltage (V-c) were in the range of 11-23 muC/cm(2) and 0.86-1.56 V, respectively, and are better than the values found in the literature. The BLT capacitors did not show any significant fatigue up to 10(10) read/write switching cycles. (C) 2004 American Institute of Physics.

A hydride generation flow system for determination of arsenic and selenium by total reflection X-ray fluorescence spectrometry

In this work, a preconcentration and separation system based on continuous flow hydride generation is proposed to improve the determination of As and Se by total reflection X-ray fluorescence spectrometry. The generated hydrides are continuously separated from the liquid phase and collected in a chamber containing 250 mul of HCI/HNO3 1:1 (v/v) solution. Hydride generation conditions and collection of the hydrides were evaluated. Under optimised conditions, enrichment factors of 55 for As and 82 for Se were attained. Detection limits of 0.3 mug l(-1) for As and Se were obtained when 20 ml of sample was used. Analysis of a natural water standard reference material from National Institute of Standard and Technology (SRM-1640) was in agreement with the certified values at the 95% confidence level. (C) 2004 Elsevier B.V. All rights reserved.

Knowledge Representation and Orthophemism: A Reflection Aiming to a Concept

Characteristics of speech, especially figures of speech, are used by specific communities or domains, and, in this way, reflect their identities through their choice of vocabulary. This topic should be an object of study in the context of knowledge representation once it deals with different contexts of production of documents. This study aims to explore the dimensions of the concepts of euphemism, dysphemism, and orthophemism, focusing on the latter with the goal of extracting a concept which can be included in discussions about subject analysis and indexing. Euphemism is used as an alternative to a non-preferred expression or as an alternative to an offensive attribution-to avoid potential offense taken by the listener or by other persons, for instance, pass away. Dysphemism, on the other hand, is used by speakers to talk about people and things that frustrate and annoy them-their choice of language indicates disapproval and the topic is therefore denigrated, humiliated, or degraded, for instance, kick the bucket. While euphemism tries to make something sound better, dysphemism tries to make something sound worse. Orthophemism (Allan and Burridge 2006) is also used as an alternative to expressions, but it is a preferred, formal, and direct language of expression when representing an object or a situation, for instance, die. This paper suggests that the comprehension and use of such concepts could support the following issues: possible contributions from linguistics and terminology to subject analysis as demonstrated by Talamo et al. (1992); decrease of polysemy and ambiguity of terms used to represent certain topics of documents; and construction and evaluation of indexing languages. The concept of orthophemism can also serves to support associative relationships in the context of subject analysis, indexing, and even information retrieval related to more specific requests.

Fatigue and retention properties of Bi3.25La0.75Ti3O12 films using LaNiO3 bottom electrodes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Denisiuk-type reflection holography display with sillenite crystals for imaging and interferometry of small objects

A novel setup for imaging and interferometry through reflection holography with Bi12TiPO20(BTO) sillenite photorefractive crystals is proposed. A variation of the lensless Denisiuk arrangement was developed resulting in a compact, robust and simple interferometer. A red He-Ne laser was used as light source and the holographic recording occurred by diffusion with the grating vector parallel to the crystal [0 0 1]-axis. In order to enhance the holographic image quality and reduce noise a polarizing beam splitter (PBS) was positioned at the BTO input and the crystal was tilted around the [0 0 1]-axis. This enabled the orthogonally polarized transmission and diffracted beams to be separated by the PBS, providing the holographic image only. The possibility of performing deformation and strain analysis as well as vibration measurement of small objects was demonstrated. (C) 2007 Elsevier B.V. All rights reserved.