Raman scattering, differential scanning calorimetry and Nd3+ spectroscopy in alkali niobium tellurite glasses

Alkali niobium tellurite glasses have been prepared and some of their properties measured by differential scanning calorimetry and Raman scattering. The vitreous domain was established in the pseudo ternary phases diagram for the system TeO2-Nb2O5-(0.5K(2)O-0.5Li(2)O). Raman scattering shows that for samples in the TeO2 rich part of the phase diagram the vitreous structure is composed essentially of (TeO4) units connected by the vertices, as in the alpha-TeO2 crystal. The addition of alkali and niobium oxides causes depolymerization to occur with structures composed essentially of (TeO3) and (NbO6) units. Samples with the composition (mol%) 80TeO(2)-10Nb(2)O(5)-5K(2)O-5Li(2)O, stable against crystallization, were prepared containing up to 10% mol Nd3+. The addition of this oxide increases the rigidity of the vitreous network shifting characteristic temperatures to higher temperatures. For the 10% Nd3+ sample amorphous phase separation is assumed to exist from the observation of two glass transition temperatures. Spectroscopic properties such as Judd-Ofelt Omega(lambda) intensity parameters, radiative emission probabilities, and induced emission cross sections were calculated. From these results and also from the emission quenching observed as a function of Nd3+ concentration, we suggest that these glasses could be utilized in optical amplifying devices. (C) 1999 Elsevier B.V. B.V. All rights reserved.

The Serido Group of NE Brazil, a late Neoproterozoic pre- to syn-collisional basin in West Gondwana: insights from SHRIMP U-Pb detrital zircon ages and Sm-Nd crustal residence (T-DM) ages

The Serido Group is a deformed and metamorphosed metasedimentary sequence that overlies early Paleoproterozoic to Archean basement of the Rio Grande do Norte domain in the Borborema Province of NE Brazil. The age of the Serido Group has been disputed over the past two decades, with preferred sedimentation ages being either Paleoproterozoic or Neoproterozoic. Most samples of the Serido Formation, the upper part of the Serido Group, have Sm-Nd T-DM ages between 1200 and 1600 Ma. Most samples of the Jucurutu Formation, the lower part of the Serido Group, have T-DM ages ranging from 1500 to 1600 Ma; some basal units have T-DM ages as old as 2600 Ma, reflecting proximal basement. Thus, based on Sm-Nd data, most, if not all, of the Serido Group was deposited after 1600 Ma and upper parts must be younger than 1200 Ma.Cathodoluminescence photos of detrital zircons show very small to no overgrowths produced during ca. 600 Ma Brasiliano deformation and metamorphism, so that SHRIMP and isotope dilution U-Pb ages must represent crystallization ages of the detrital zircons. Zircons from meta-arkose near the base of the Jucurutu Formation yield two groups of ages: ca. 2200 Ma and ca. 1800 Ma. In contrast, zircons from a metasedimentary gneiss higher in the Jucurutu Formation yield much younger ages, with clusters at ca. 1000 Ma and ca. 650 Ma. Zircons from metasedimentary and metatuffaceous units in the Serido Formation also yield ages primarily between 1000 and 650 Ma, with clusters at 950-1000, 800, 750, and 650 Ma. Thus, most, if not all, of the Serido Group must be younger than 650 Ma. Because these units were deformed and metamorphosed in the ca. 600 Ma Brasiliano fold belt during assembly of West Gondwana, deposition probably occurred ca. 610-650 Ma, soon after crystallization of the youngest population of zircons and before or during the onset of Brasiliano deformation.The Serido Group was deposited upon Paleoproterozoic basement in a basin receiving detritus from a variety of sources. The Jucurutu Formation includes some basal volcanic rocks and initially received detritus from proximal 2.2-2.0 Ga (Transamazonian) to late Paleoproterozoic (1.8-1.7 Ga) basement. Provenance for the upper Jucurutu Formation and all of the Serido Formation was dominated by more distal and younger sources ranging in age from 1000 to 650 Ma. We suggest that the Serido basin may have developed as the result of late Neoproterozoic extension of a pre-existing continental basement, with formation of small marine basins that were largely floored by cratonic basement (subjacent oceanic crust has not yet been found). Immature sediment was initially derived from surrounding land; as the basin evolved much of the detritus probably came from highlands to the south (present coordinates). Alternatively, if the Patos shear zone is a major terrane boundary, the basin may have formed as an early collisional foredeep associated with south-dipping subduction. In any case, within 30 million years the region was compressed, deformed, and metamorphosed during final assembly of West Gondwana and formation of the Brasiliano-Pan African fold belts. (C) 2003 Elsevier B.V. All rights reserved.

Enzymatic Logic Gates with Noise-Reducing Sigmoid Response

Biochemical computing is an emerging field of unconventional computing that attempts to process information with biomolecules and biological objects using digital logic. In this work we survey filtering in general, in biochemical computing, and summarize the experimental realization of an and logic gate with sigmoid response in one of the inputs. The logic gate is realized with electrode-immobilized glucose-6-phosphate dehydrogenase enzyme that catalyzes a reaction corresponding to the Boolean and functions. A kinetic model is also developed and used to evaluate the extent to which the performance of the experimentally realized logic gate is close to optimal.

CROCODYLOMORPH EGGS and EGGSHELLS FROM THE ADAMANTINA FORMATION (BAURU GROUP), UPPER CRETACEOUS of BRAZIL

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Northwestern overthrusting and related lateral escape during the Brasiliano orogeny north of the Patos lineament, Borborema province, northeast Brazil

The Borborema province (BP) of northeastern Brazil, located between the São Luís and São Francisco cratons, represents a branching system of Precambrian orogens of the South American platform. It is composed of segments of Archean and Proterozoic crust that were deformed by the convergence of the West African and São Francisco-Congo cratons during assembly of the Brasiliano collage (650 to 500 Ma), a period of intense orogenic activity considered to be the strongest and most pervasive tectonic event that affected the Precambrian of the South American platform. The tectonic and kinematic history of the Brasiliano/Panafrican orogeny is fundamental for reconstructing South American and African Precambrian geology. The correlation between Neoproterozoic tectonic processes occurring in both continents should use structural elements, of regional or local character, with identical kinematic and metamorphic conditions manifested in both basement and supracrustal units. North of the Patos shear zone, subhorizontal Brasiliano thrusts (0.65 to 0.58 Ga) affected the basement and the supracrustal Seridó belt with such related regional D1/D2 structures as foliation, lineation, isoclinal folds, and related metamorphism. Overprinting the previous structures, regional folding with a vertical S3 foliation and an associated strike-slip shear zone were developed (0.58 to 0.52 Ga). The metamorphism is similar for all deformation phases, ranging from upper-greenschist to amphibolite facies with mineral assemblages including biolite and garnet throughout the Seridó fold belt. We propose, on the basis of deformational and kinematic reconstructions, that the structural evolution of the Seridó fold belt was characterized by transition from a syn-collisional to a strike-slip regime. The transition between regimes occurred, progressively or instantaneously, by the switching of the maximum and intermediary strain axes of the strain ellipsoid. The entire tectonic history can be related to a frontal or oblique collision and lateral escape tectonics, with local, syn-collisional transpression and transtension. The Patos shear zone represents a final vertical shearing, juxtaposing different terranes of the northern and southern Borborema province.

Environment for teaching and development of mobile robot systems

Using robots for teaching is one approach that has gathered good results on Middle-School, High-School and Universities. Robotics gives chance to experiment concepts of a broad range of disciplines, principally those from Engineering courses and Computer Science. However, there are not many kits that enables the use of robotics in classroom. This article describes the methodologies to implement tools which serves as test beds for the use of robotics to teach Computer Science and Engineering. Therefore, it proposes the development of a flexible, low cost hardware to integrate sensors and control actuators commonly found on mobile robots, the development of a mobile robot device whose sensors and actuators allows the experimentation of different concepts, and an environment for the implementation of control algorithms through a computer network. This paper describes each one of these tools and discusses the implementation issues and future works. © 2010 IEEE.

Hardware implementation of type-2 programmable fuzzifier

The design of full programmable type-2 membership function circuit is presented in this paper. This circuit is used to implement the fuzzifier block of Type-2 Fuzzy Logic Controller chip. In this paper the type-2 fuzzy set was obtained by blurring the width of the type-1 fuzzy set. This circuit allows programming the height and the shape of the membership function. It operates in current mode, with supply voltage of 3.3V. The simulation results of interval type-2 membership function circuit have been done in CMOS 0.35μm technology using Mentor Graphics software. © 2011 IEEE.

Teaching and learning data structures supported by computers: An experiment using CADILAG tool

This paper aims to present the use of a learning object (CADILAG), developed to facilitate understanding data structure operations by using visual presentations and animations. The CADILAG allows visualizing the behavior of algorithms usually discussed during Computer Science and Information System courses. For each data structure it is possible visualizing its content and its operation dynamically. Its use was evaluated an the results are presented. © 2012 AISTI.

Multiple brain abscess from dental origin: Case report and literature review

Background: Brain abscess of dental origin is a rare situation and deserves attention due to its high mortality rate even when adequate treatment is done. Few reports are available when dental origin is the main cause of this infection. Case report: We present the case of a 70-year-old man diagnosed with cerebral abscess caused by apical lesions located at superior and inferior teeth. The three lesions containing pus were drained from anterior and posterior brain region and the laboratory evaluation revealed the presence of Streptococcus viridians and Bacteroides. Postoperative period was uneventful with excellent recovery after 1 year of surgery. Final diagnosis was able to be done due to excellent image exams availability like computer tomography and magnetic resonance using diffusion and perfusion techniques. Discussion: The early detection of this pathology with the correct diagnosis essential to give the patient the best treatment including antimicrobial drugs and drainage is of extreme importance. © 2011 Springer-Verlag.

Constrained intervals and interval spaces

Constrained intervals, intervals as a mapping from [0, 1] to polynomials of degree one (linear functions) with non-negative slopes, and arithmetic on constrained intervals generate a space that turns out to be a cancellative abelian monoid albeit with a richer set of properties than the usual (standard) space of interval arithmetic. This means that not only do we have the classical embedding as developed by H. Radström, S. Markov, and the extension of E. Kaucher but the properties of these polynomials. We study the geometry of the embedding of intervals into a quasilinear space and some of the properties of the mapping of constrained intervals into a space of polynomials. It is assumed that the reader is familiar with the basic notions of interval arithmetic and interval analysis. © 2013 Springer-Verlag Berlin Heidelberg.

A computer vision approach to quantify leaf anatomical plasticity: A case study on gochnatia polymorpha (less.) cabrera

Inferences about leaf anatomical characteristics had largely been made by manually measuring diverse leaf regions, such as cuticle, epidermis and parenchyma to evaluate differences caused by environmental variables. Here we tested an approach for data acquisition and analysis in ecological quantitative leaf anatomy studies based on computer vision and pattern recognition methods. A case study was conducted on Gochnatia polymorpha (Less.) Cabrera (Asteraceae), a Neotropical savanna tree species that has high phenotypic plasticity. We obtained digital images of cross-sections of its leaves developed under different light conditions (sun vs. shade), different seasons (dry vs. wet) and in different soil types (oxysoil vs. hydromorphic soil), and analyzed several visual attributes, such as color, texture and tissues thickness in a perpendicular plane from microscopic images. The experimental results demonstrated that computational analysis is capable of distinguishing anatomical alterations in microscope images obtained from individuals growing in different environmental conditions. The methods presented here offer an alternative way to determine leaf anatomical differences. © 2013 Elsevier B.V.

The functional biogeography of species: Biogeographical species roles of birds in Wallacea and the West Indies

Biogeographical systems can be analyzed as networks of species and geographical units. Within such a biogeographical network, individual species may differ fundamentally in their linkage pattern, and therefore hold different topological roles. To advance our understanding of the relationship between species traits and large-scale species distribution patterns in archipelagos, we use a network approach to classify birds as one of four biogeographical species roles: peripherals, connectors, module hubs, and network hubs. These roles are based upon the position of species within the modular network of islands and species in Wallacea and the West Indies. We test whether species traits - including habitat requirements, altitudinal range-span, feeding guild, trophic level, and body length - correlate with species roles. In both archipelagos, habitat requirements, altitudinal range-span and body length show strong relations to species roles. In particular, species that occupy coastal- and open habitats, as well as habitat generalists, show higher proportions of connectors and network hubs and thus tend to span several biogeographical modules (i.e. subregions). Likewise, large body size and a wide altitudinal range-span are related to a wide distribution on many islands and across several biogeographical modules. On the other hand, species restricted to interior forest are mainly characterized as peripherals and, thus, have narrow and localized distributions within biogeographical modules rather than across the archipelago-wide network. These results suggest that the ecological amplitude of a species is highly related to its geographical distribution within and across bio geographical subregions and furthermore supports the idea that large-scale species distributions relate to distributions at the local community level. We finally discuss how our biogeographical species roles may correspond to the stages of the taxon cycle and other prominent theories of species assembly. © 2013 The Authors.

Informática e democratização do ensino: o uso de computadores na rede pública do município de Araraquara

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Improving face recognition with multispectral fusion and support vector machines

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)