Reconstruction of the gravitational wave signal h(t) during the Virgo science runs and independent validation with a photon calibrator

The Virgo detector is a kilometer-scale interferometer for gravitational wave detection located near Pisa (Italy). About 13 months of data were accumulated during four science runs (VSR1, VSR2, VSR3 and VSR4) between May 2007 and September 2011, with increasing sensitivity. In this paper, the method used to reconstruct, in the range 10 Hz-10 kHz, the gravitational wave strain time series h(t) from the detector signals is described. The standard consistency checks of the reconstruction are discussed and used to estimate the systematic uncertainties of the h(t) signal as a function of frequency. Finally, an independent setup, the photon calibrator, is described and used to validate the reconstructed h(t) signal and the associated uncertainties. The systematic uncertainties of the h(t) time series are estimated to be 8% in amplitude. The uncertainty of the phase of h(t) is 50 mrad at 10 Hz with a frequency dependence following a delay of 8 mu s at high frequency. A bias lower than 4 mu s and depending on the sky direction of the GW is also present.

Description and performance of track and primary-vertex reconstruction with the CMS tracker

A description is provided of the software algorithms developed for the CMS tracker both for reconstructing charged-particle trajectories in proton-proton interactions and for using the resulting tracks to estimate the positions of the LHC luminous region and individual primary-interaction vertices. Despite the very hostile environment at the LHC, the performance obtained with these algorithms is found to be excellent. For t (t) over bar events under typical 2011 pileup conditions, the average track-reconstruction efficiency for promptly-produced charged particles with transverse momenta of p(T) > 0.9GeV is 94% for pseudorapidities of vertical bar eta vertical bar < 0.9 and 85% for 0.9 < vertical bar eta vertical bar < 2.5. The inefficiency is caused mainly by hadrons that undergo nuclear interactions in the tracker material. For isolated muons, the corresponding efficiencies are essentially 100%. For isolated muons of p(T) = 100GeV emitted at vertical bar eta vertical bar < 1.4, the resolutions are approximately 2.8% in p(T), and respectively, 10 m m and 30 mu m in the transverse and longitudinal impact parameters. The position resolution achieved for reconstructed primary vertices that correspond to interesting pp collisions is 10-12 mu m in each of the three spatial dimensions. The tracking and vertexing software is fast and flexible, and easily adaptable to other functions, such as fast tracking for the trigger, or dedicated tracking for electrons that takes into account bremsstrahlung.

Isolated Bilateral Blowout Fracture With Extensive Pneumatization of the Maxillary Sinuses

The blowout fracture injuries are often associated with fractures of the zygomatic complex and other facial structures but can also occur in an isolated fashion. Isolated bilateral blowout fractures are uncommon and constitute a challenge with regard to both assessment and reconstruction. This article describes an uncommon case of isolated bilateral blowout fracture in a patient with extensive pneumatization of the maxillary sinuses.

Risk factors for facial melasma in women: a case-control study

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Scanning Electron Microscopy of Male Terminalia and Its Application to Species Recognition and Phylogenetic Reconstruction in the Drosophila saltans Group

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Calvarial Autogenous Bone Graft for Maxillary Ridge and Sinus Reconstruction for Rehabilitation With Dental Implants

Autogenous bone grafting is the gold-standard technique for bone augmentation procedures prior to implant placement. If the amount of available intraoral donor bone is insufficient, it is necessary to harvest bone graft from extraoral sites, such as calvaria. Although this technique is well established, only a few case reports show the histological analysis of the grafted bone at the moment of implant placement. This article reports the case of a 48-year-old female patient with a critical atrophic maxillary ridge reconstructed using autogenous calvarial bone graft prior to implant placement, with clinical and histological evaluation. Bone was collected under general anesthesia from the parietal bone. The outer cortical originated the bone blocks, and the medullar bone layer between was collected to be used in the sinus augmentation procedure, together with 5 of the bone blocks triturated. Six months after bone augmentation, 8 implants were placed in the grafted area and 2 biopsies were retrieved (anterior and the posterior regions), allowing the visualization of the bone-remodeling process in the grafted areas. The patient had a stable recovery. Our results showed that although necrotic bone could still be seen in the outer layer of the grafted area, the interface between this necrotic bone and the already remodeled bone was consistent with biocompatibility. Two-year radiographic evaluation showed success of the grafts and the implants in supporting an esthetic and functionally stable prosthesis. Summarizing, calvarial bone grafts are a viable alternative for the attainment of adequate bone volume prior to implant placement.

Water mass reconstruction by Nd isotopic analysis from Mid Atlantic oceanic sediments

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da evolução de pacientes com paralisia facial periférica submetidos a reabilitação

INTRODUÇÃO: A paralisia facial periférica (PFP) consiste no acometimento do sétimo nervo craniano, de forma aguda, podendo ser precedida por dor na região mastoidiana e resultando em paralisia completa ou parcial da mímica facial. É, na sua grande maioria, de causa idiopática ou apresenta diversas etiologias como diabetes mellitus, hipertensão arterial, herpes zoster, viroses, otites médias, infecções (lepra, sífilis, doença de Lyme), sarcoidose, traumatismo e tumores. Apesar da paralisia facial periférica ter sido descrita em 1821, por Sir Charles Bell, ainda hoje existe muita controvérsia a respeito da etiologia e tratamento. A incidência da PFP encontra-se entre 20 a 30 casos por 100 mil habitantes, com prevalência ligeiramente maior entre as mulheres. Baseado nessas premissas, este estudo teve por objetivo avaliar a evolução de pacientes com paralisia facial periférica submetidos a um protocolo de reabilitação. METODOLOGIA: No estudo foram incluídos 30 pacientes com diagnóstico de paralisia facial periférica idiopática, atendidos no Centro de Estudos e Reabilitação em Fisioterapia (CEAFIR), da FCT-UNESP, campus de Presidente Prudente. O presente estudo adotou como procedimento fisioterapêutico os protocolos I, II, III e IV. Antes de realizar qualquer técnica, abaixo mencionada, foi explicado ao paciente cada passo, para evitar surpreendê-lo. Conforme os pacientes apresentassem melhora e evoluções nas reavaliações elétricas, foram feitas recomendações de exercícios para mímica facial, em frente ao espelho. As repetições eram aumentadas gradativamente, posteriormente os mesmos exercícios, mas agora ativos resistidos. RESULTADOS: Os valores das variáveis reobase, cronaxia e acomodação, nos garantem que o protocolo usado permite avaliar a condução nervosa do facial, o grau de evolução da condução nervosa, bem como acompanhar... (Resumo completo, clicar acesso eletrônico abaixo)

Avaliação da prevalência do tipo de crescimento crânio facial nas diferentes más oclusões, de acordo com a classificação de angle

During the orthodontic correction planning in addition to dental-jaw correction, facial aesthetics is the orthodontist's and patient's major concern. To prevent facial aesthetics damage is really important to take into account the type of craniofacial growth: mesofacial (balanced), dolichofacial (vertical) or brachyfacial (horizontal). We evaluated 152 documentation files from the Department of Orthodontics of Dental University of Sao Jose dos Campos- UNESP in order to analyze what kind of growth occurs in most Class I malocclusions, Class II and Class III Angle of treated individuals from 6 to 12 years old. From the randomly collected samples, 15 of them belonged to Class I Angle malocclusions; 123 belonged to Angle Class II and 14 to Class III malocclusion. The results showed that in Class I, 66.67% were classified as dolicocephalic; in Class II, 64.23% were classified as dolicocephalic and in Class III, 50% were brachycephalic. We conclude that the dolichofacial was the type which ocurred the most, both in females and males and both in malocclusion Class I and Class II. The brachyfacial type most occurred in Class III malocclusion and the mesofacial type occurred in smaller numbers in the three malocclusions studied

Expressão gênica e protéica de receptores de estrogênio β e progesterona no melasma facial de mulheres e na pele sã adjacente

Pós-graduação em Patologia - FMB

Tendência de crescimento facial em ortodontia e ortopedia funcional dos maxilares

The knowledge of the facial growth trend is very important in orthodontic treatment. A lateral headfilm is recommended in all young patients undergoing a preorthodontic guidance program to anticipate the best time to begin any mechanical procedures and the possibilities to determine the type of facial growth trend. In type A it will be observed that the middle and lower face are growing forward and downward in unison, with no change in ANB angle. Type B growth trends reveals that growth is downward and forward, with the middle face growing forward more rapidly than the lower and in type C the lower face is growing downward and forward more rapidly than the middle face revealing a decrease in the size of the ANB angle.

Facial type measurements influence on transverse dimensions of normal occlusion arches

Objective – To correlate facial type measurements of Caucasian individuals with transverse dimensions of normal occlusion arches. Methods – Twenty-one pairs of dental models were selected according to the following inclusion criteria: presence of all permanent teeth from 1 st molar to 1 st molar; normal occlusion; no prosthetic crowns; no previous orthodontic treatment and 2 mm or less of crow- dings or spacings. The cephalometric measurements of lateral cephalometric X-ray of the same individuals were taken and tabulat ed. To evaluate the repetition of arch measurements, paired Student’s t-test and Pearson's correlation coefficient were used. The r elationship between the measurements was analysed by using the Pearson’s correlation. Results – The repetition of the measurements showed high correlation and no systematic error. In the comparison between the measurements, a moderate negative correlation was observed b et- ween facial axis angle and the measurements Upper and Lower 6-6, whereas a positive correlation was observed between dentition height and the latter. Conclusion – It was observed a negative correlation between facial axis angle and upper and lower inter-molar distance as well as a positive correlation between dentition height and upper and lower inter-molar distance.

Avaliação cefalométrica das alterações do perfil facial naturais e induzidas pelos aparelhos de Herbst e Bionator no tratamento da má oclusão de classe II, divisão 1ª

The aim of this study was to evaluate the facial profile changes due to natural growth and induced by Herbst appliance and Bionator in the treatment of Class II, division 1 malocclusion. In order to do that, we used a sample of 90 lateral radiographs of 45 individuals in pre-pubertal stage, divided up in two experimental groups and one control. The first group, composed of 15 brazilian individuals, with initial mean age of 9.4 years, was treated with the Herbst appliance for a period of seven months. The second experimental group consisting of 15 brazilian individuals, initial mean age of 9.9 years has gone through bionator therapy for an average period of 21 months. The control group of 15 individuals, who were not treated orthodontically, comes up from the Burlington Growth Centre, University of Toronto, Canada. The intragroup comparison was performed using the Student t test and intergroup comparisons by ANOVA complemented by the Bonferroni test. The results have shown that only the group treated with the Herbst appliance presented significant changes in facial profile with improvement of its convexity and lower lip protrusion.

Treatment and complications of orbito-zygomatic fractures

The aim of the present study was to analyze the etiology, type and treatment employed in the orbito-zygomatic fractures (OZ). Also, postoperative complications are described and correlated with the type of treatment used. Fifty patients with OZ fractures were evaluated. Orbital fractures in which the zygomatic bone was not involved were excluded. Epidemiologic data and characteristics of treatment such as the type of material used for osteosynthesis, number of anatomical sites on which rigid internal fixation (RIF) was applied, surgical approaches and associated complications were recorded. The main causes of trauma were motorcycle and bicycle accidents, constituting 52% of the sample. The osteosynthesis system used was the 2.0 mm, except in four patients in whom the 1.5mm system was used for fixation at the infra-orbital rim. A total of 18% of the patients required reconstruction of the internal orbit and in all cases titanium mesh was used. 46% of the patients received RIF in three anatomical sites, most in the fronto-zygomatic suture, infra-orbital rim and zygomatic-maxillary buttress. The most frequent complication was paresthesia of the infra-orbital nerve (34 patients, 68%). Other findings were also discussed with the intent of better understanding the treatment of the OZ fractures.

Tratamiento de la deformidad facial causada por la hiperplasia condilar: relato de caso

The condylar hyperplasia is an acquired development anomaly, rare, characterized by an excessive and progressive growing, affecting neck, condilar head, body and the mandible bough, provoking an important facial asymmetry. In the article we present a case of male patient, 22-years-old, reclaiming of painful sintomatology in the region of temporomandibular joint and severe facial asymmetry. It was instituted an orthodontic-surgical treatment by means of orthognathic combined surgery and high condilectomy. After six years of post-surgical controlling, the patient is now in a good shape, without recurrence of facial asymmetry and condylar hyperplasia.