Effectiveness of surface protection for resin-modified glass-ionomer materials

Objective: the purpose of this study was to evaluate the effectiveness of various surface treatments for resin-modified glass-ionomer restorative materials by determining dye uptake spectrophotometrically. Method and materials: Two hundred twenty-four specimens, 4.1 mm in diameter and 2.0 mm thick, were made of 3 materials: Vitremer, Fuji II LC, and Photac-Fil Aplicap. Specimens were divided into 15 groups. The positive and negative control specimens remained unprotected, while the experimental specimens were protected with Heliobond light-activated bonding resin, Colorama nail varnish, or surface coatings indicated by the manufacturers of the glass-ionomer materials. Finishing Gloss for Vitremer, Fuji Varnish for Fuji II LC, and Ketac Glaze for Photac-Fil. The disks were immersed in 0.05% methylene blue for 24 hours except for the negative control group, which was immersed in deionized water. After 24 hours, the disks were removed, washed, and individually placed in 1 mL of 65% nitric acid for 24 hours. The solutions were centrifuged and the spectrophotometric absorbance was determined at 606 nm. The dye uptake was expressed in micrograms of dye per milliliter, and the results were analyzed with the Kruskal-Wallis test. Results: There were no differences in dye uptake among the 3 resin-modified glass-ionomer restorative materials, however, all of them required surface protection. Conclusion: the best surface protection for the 3 evaluated materials was obtained with Heliobond light-activated bonding resin.

Vortices in superconductors with a columnar defect: Finite size effects

In the present work we investigate the behavior of a vortex in a long superconducting cylinder near to a columnar defect at the center. The derivations of the local magnetic field distribution and the Gibbs free energy will be carried out for a cylinder and a cavity of arbitrary sizes. From the general expressions, it is considered two particular limits: one in which the radius of the cavity is very small but the radius of the superconducting cylinder is kept finite; and one in which the radius of the superconducting cylinder is taken very large (infinite) but the radius of the cavity is kept finite. In both cases the maximum number of vortices which are allowed in the cavity is determined. In addition, the surface barrier field for flux entrance into the cavity is calculated. (c) 2005 Elsevier B.V. All rights reserved.

Oxygen mobility in SmBa2Cu3O7-delta measured by anelastic spectroscopy

Anelastic spectroscopy has been performed on a sample of superconducting oxide SmBa2Cu3O7-delta (SBCO) using a torsion pendulum operating with frequency around 10 Hz. A thermally activated relaxation peak is observed near 500 K with the activation enthalpy of 1.55 +/- 0.03 eV and the pre-exponential factor of approximately 10(-15) s, which is attributed to the mobility of non-stoichiometric oxygen by jumps in positions O1 and O5 of the lattice. (c) 2006 Elsevier B.V. All rights reserved.

Fractals de Rauzy

We study arithmetical and topological properties of a class of Rauzy Fractals. In particular, we give a parametrization of the boundaries of these sets and show that they are quasi-disks.

Design, manufacturing, and testing of a Nb3Sn coil employing Ti alloy as structural material

We describe the design, manufacturing, and testing results of a Nb3Sn superconducting coil in which TiAIV alloys were used instead of stainless steel to reduce the magnetization contribution caused by the heat treatment for the A-15 Nb-3 Sn phase formation that affects the magnetic field homogeneity. Prior to the coil manufacturing several structural materials were studied and evaluated in terms of their mechanical and magnetic properties in as-worked, welded, and heat-treated conditions. The manufacturing process employed the wind-and-react technique followed by vacuum-pressure impregnation(VPI) at 1 MPa atm. The critical steps of the manufacturing process, besides the heat treatment and impregnation, are the wire splicing and joint manufacturing in which copper posts supported by Si3N4 ceramic were used. The coil was tested with and without a background NbTi coil and the results have shown performance exceeding the design quench current confirming the successful coil construction.

HIGH-TEMPERATURE SUPERFLUIDITY WITH ABNORMAL FERMIONIC OCCUPANCY

We examine a Lipkin based two-level pairing model at finite temperature and in the thermodynamic limit. Whereas at T = 0 the model exhibits a superconducting ground state for sufficiently high values of the coupling constant, a partially superconducting phase in which some of the particles are paired, is found to survive at high temperatures in a special treatment. This phase is a mixture of abnormally-occupied eigenstates, which lie at higher energy, of the interactionless model Hamiltonian.

Gold electrodes from recordable CDs

Gold electrodes are widely used in electrochemistry and electroanalytical chemistry. The notable performance when used in stripping analysis of many ionic species and the extraordinary affinity of thio compounds for its surface make these electrodes very suitable for many applications. This paper reports a simple and novel way to construct gold electrodes (CDtrodes) using recordable CDs as the gold source. The nanometer thickness of the gold layer of recordable disks (50-100 mm) favors the construction of band nanoelectrodes with areas as small as 10(-6) cm(2). The plane surface can be easily used for the construction of conventional-sized gold electrodes for batch or now injection analysis or even to obtain electrodes as large as 100 cm(2). The low price of commercial recordable CDs allows a one way use. The evaluation and applicability of these electrodes in the form of nanoelectrodes, in batch and associated with flow cells, are illustrated in this paper.

Cryopreservation of Agaricus blazei in liquid nitrogen using dmso as cryoprotectant

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Speciation of lead in seawater and river water by using Saccharomyces cerevisiae immobilized in agarose gel as a binding agent in the diffusive gradients in thin films technique

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electrical and Magnetic Characterization of BSCCO and YBCO HTS Tapes for Fault Current Limiter Application

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fault current test of a bifilar Bi-2212 bulk coil

A bifilar Bi-2212 bulk coil with parallel shunt resistor was tested under fault current condition using a 3 MVA single-phase transformer in a 220 V-60 Hz line achieving fault current peak of 8 kA. The fault current tests are performed from steady state peak current of 200 A by applying controlled short circuits up to 8 kA varying the time period from one to six cycles. The test results show the function of the shunt resistor providing homogeneous quench behavior of the HTS coil besides its intrinsic stabilizing role. The limiting current ratio achieves a factor 4.2 during 5 cycles without any degradation.

Use of Saccharomyces cerevisiae immobilized in agarose gel as a binding agent for diffusive gradients in thin films

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Evaluation of the Effects of Endodontic Materials on Fibroblast Viability and Cytokine Production

Introduction: Recently, a new sealer composed of Portland cement named Endo-CPM-Sealer was developed. The aim of this study was to investigate the effects of Endo-CPM-Sealer (EGEO SRL, Buenos Aires, Argentina), Sealapex (Sybron Endo, Glendora, CA), and Angelus MTA (Angelus, Londrina, Brazil) on cell viability and cytokine (interleukin [IL]-1 beta and IL-6) production by mouse fibroblasts. Methods: Millipore culture plate inserts with polyethylene tubes filled with materials were placed into 24-well cell culture plates with mouse fibroblasts. Cells cultured with only empty polyethylene tubes were used as the control. After 24 hours, 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyl tetrazolium bromide assay was used to evaluate the cell viability. For cytokine assay, mouse fibroblasts were incubated in 24-well flat-bottom plates with set material disks at the bottom. Cells cultured without the material disks served as the negative control. After 24 hours of incubation, culture media were collected for cytokine evaluation by using an enzyme-linked immunosorbent assay. The data were statistically analyzed by analysis of variance and Bonferroni correction. Results: Endo-CPM-Sealer, Sealapex, and Angelus MTA did not inhibit the cell viability. All materials induced IL-6 releasing, but the amount was not statistically significant compared with the control group. Angelus MTA induced IL-1 beta releasing significantly more than the control. Conclusions: All materials were not considered cytotoxic in fibroblast culture. (J Endod 2009;35:1577-1579)

Atividade predatória de Euseius citrifolius Denmark & Muma (Acari: Phytoseiidae) sobre Tenuipalpus heveae (Acari: Tenuipalpidae)

The rubber tree red false spider mite, Tenuipalpus heveae Baker, is an important pest of Hevea brasiliensis (Willd. ex. Adr. de Juss.) Muell. Arg. The phytoseiid mite Euseius citrifolius Dennmark & Muma has frequently been recorded on rubber tree crops. The objective of this work was to determine the predatory activity of E. citrifolius on the different life stages (egg, larva, nymph and adult) of T. heveae. The experiments were carried out in Petri dishes (9-cm diameter) containing a layer of wet cotton inside, onto which a disk of rubber tree leaf (2.5-cm diameter) was laid. The disks were taken from naturally infested leaves. Twenty specimens in the life stage that was to be tested were left on the disk and the others were eliminated; a predator life stage (larva, nymph or female) was obtained from a laboratory stock colony and put into each dish. For each tested life stage of E. citrifolius, 4 treatments (T. heveae life stages) and 20 replications were considered in a randomized block design. The observations were made after 24 hours for larvae and nymphs of the predator, and after 24, 48 and 72 hours for the females. E. citrifolius larvae and nymphs had a higher preference for T. heveae larvae followed by nymphs, eggs and adults. Within 72 hours, each predator female consumed 15.0 larvae, 14.5 nymphs, 7.4 adults or 2.2 eggs of T. heveae. It is concluded that E. citrifolius can feed on red false spider mites, the larva and nymph being the preferred stages.

Preferência alimentar de adultos de Metriona elatior Klug (Coleoptera: Chrysomelidae, Cassidinae) por diferentes híbridos de Solanum melogena Linnaeus (Solanaceae)

Feeding preference of adults of Metriona elatior Klug (Coleoptera: Chrysomelidae, Cassidinae) for different hybrids of Solanum melogena Linnaeus (Solanaceae). Metriona elatior Klug is a potential biocontrol agent for Solanum viarum Dunal (tropical soda apple), because larvae and adults feed on its leaves and this species shows a low dispersion rate. Specificity plays a major role in the feasibility of an organism as a biological control agent, especially in the inundative strategy. The feeding preference of M. elatior adults was evaluated to 14 eggplant (Solanum melogena Linnaeus) hybrids. Mass rearing was carried out under lab conditions, with the insect feeding directly on S. viarum leaves. The study started with dual and multiple choice tests in 24 and 48 hour feeding times, by offering leaf disks in Petri dish conditions. Survival and leaf consumption analysis were performed in newly adults in tropical soda apple and eggplant leaves kept turgid by immersing the petioles in water. The leaf area was measured before and after four days of insect exposure. M. elatior showed higher feeding preference, survival and consumption of the weed species, especially in comparison with the hybrid Ryoma. The highest feeding preference among the eggplant hybrids was observed in 'Minikuro Kowishiki'.