Estudo de reatores eletroquímicos para remoção de Cu2+ , Zn2+, Fenol e BTEX em água produzida

The production of water has become one of the most important wastes in the petroleum industry, specifically in the up stream segment. The treatment of this kind of effluents is complex and normally requires high costs. In this context, the electrochemical treatment emerges as an alternative methodology for treating the wastewaters. It employs electrochemical reactions to increase the capability and efficiency of the traditional chemical treatments for associated produced water. The use of electrochemical reactors can be effective with small changes in traditional treatments, generally not representing a significant additional surface area for new equipments (due to the high cost of square meter on offshore platforms) and also it can use almost the same equipments, in continuous or batch flow, without others high costs investments. Electrochemical treatment causes low environmental impact, because the process uses electrons as reagent and generates small amount of wastes. In this work, it was studied two types of electrochemical reactors: eletroflocculation and eletroflotation, with the aim of removing of Cu2+, Zn2+, phenol and BTEX mixture of produced water. In eletroflocculation, an electrical potential was applied to an aqueous solution containing NaCl. For this, it was used iron electrodes, which promote the dissolution of metal ions, generating Fe2+ and gases which, in appropriate pH, promote also clotting-flocculation reactions, removing Cu2+ and Zn2+. In eletroflotation, a carbon steel cathode and a DSA type anode (Ti/TiO2-RuO2-SnO2) were used in a NaCl solution. It was applied an electrical current, producing strong oxidant agents as Cl2 and HOCl, increasing the degradation rate of BTEX and phenol. Under different flow rates, the Zn2+ was removed by electrodeposition or by ZnOH formation, due the increasing of pH during the reaction. To better understand the electrochemical process, a statistical protocol factor (22) with central point was conducted to analyze the sensitivity of operating parameters on removing Zn2+ by eletroflotation, confirming that the current density affected the process negatively and the flow rate positively. For economical viability of these two electrochemical treatments, the energy consumption was calculated, taking in account the kWh given by ANEEL. The treatment cost obtained were quite attractive in comparison with the current treatments used in Rio Grande do Norte state. In addition, it could still be reduced for the case of using other alternative energy source such as solar, wind or gas generated directly from the Petrochemical Plant or offshore platforms

Qualidade de vida do servidor da Universidade Federal do Rio Grande do Norte em condição crônica de saúde

The study aimed to analyze the influence of chronic health conditions (CHC) on quality of life (QOL) of UFRN servers assaulted by CHC. It is a descriptive and cross-sectional study with prospective data and quantitative approach, accomplished in the ambulatory clinic of the Department of Server Assistance (DSA) of the Pro-Rectory of Human Resources, during three months. The sample was composed by accessibility, totaling 215 people, being 153 active and 62 inactive servers, in chronic health condition. The data were collected through the application of the sociodemographic characterization, health, environmental and laboral form, the Medical Outcome Study 36-Item Short Form (SF-36). The study was evaluated by the HUOL Ethics Committee (CAAE no. 0046.0.294.000.10), obtaining assent. The results were analyzed in the SPSS 15.0 program through the descriptive and inferential statistics. It was identified servants predominantly male (59,1%), under 60 years old, married or in stable union, Catholics, brown color, living in the capital and residents in own home. Regarding labor issues, there was a predominance of active servers technical-administrative with intermediate and medium level positions and small proportion of docents. Among the CHC, the non-communicable diseases - NCDs (95.8%) had a higher frequency, followed by persistent mental disorders - PMDs (18.6%) and, finally, the continuous and structural physical deficiency - CSPD (16.9 %). The QOL of servers was considered good, with a mean score of 72.5 points in the total score, with the most affected domains: physical (59.1), general health (66.2), bodily pain (66.3) and functional aspects (72.0). The mental health dimension (76.5) had a better average than the physical dimension (68.0 points). It was found that the decrease in QOL scores is significant statistically related to higher number of CHC (ρ <0.001), with no statistical significance regarding the functional situation (p = 0.259). The administrative technicians of elementary, primary, secondary levels and docents had the worst QOL scores. After the correlation analysis of CHC with the domains and dimensions of the SF-36, there was statistically significant, negative and weak correlation of the domains: functional aspect (ρ = 0.002, r = -0.207), physical aspects (ρ = 0.007; r = -0.183), vitality (ρ = 0.002, r = -0.213), social function (ρ = 0.000, r = -0.313), emotional aspects (ρ = 0.000, r = -0.293), mental health (ρ = 0.000 , r = -0.238), physical health dimension (ρ = 0.002, r = -0.210) and mental health dimension (ρ = 0.000, r = -0.298). The presence of PMD isolated or together, contributed to a lower SF-36 scores, being the domains variation of mean significant, except for bodily pain, general health and physical aspects. By correlating the categories of CHC and QOL, there was a weak correlation (r ≤ -0.376) and significant (ρ ≤ 0.011), mainly related to the NCD, PMDs and NCD + PMD, affecting the mental health, social function, emotional aspects, vitality and functional aspect domains. Front of the results, it was concludes that the servers quality of life is influenced by the CHC. Thus, it was inferred that the presence of CHC causes a negative effect on quality of life, leading the active and inactive servers to exposure their overall life activities and work over the years, due to the morbidity affected, mainly related to NCDs and PMDs. Descriptors: Quality of life. Chronic disease. Occupational Health. Nursing

Avaliação da molhabilidade de soluções de tensoativos em aço inoxidável

With the increasing industrialization of the planet caused by globalization, it has become increasingly common to search for highly resistant and durable materials for many diverse branches of activities. Thus, production and demand for materials that meet these requirements have constantly increased with time. In view of this, stainless steel is presented as one of the materials which are suitable applications, due to many features that are interesting for several segments of the industry. Concerns of oil companies over heavy oil reservoirs have grown steadily for the last decades. Rheological properties of these oils impair their transport in conventional flow systems. This problem has created the need to develop technologies to improve flow and transport, reducing operation costs so as to enable oil production in the reservoir. Therefore, surfactant-based chemical systems are proposed to optimize transport conditions, effected by reduction of interfacial tensions, thereby enhancing the flow of oil in ducts and reducing load losses by friction. In order to examine such interactions, a study on the wettability of metallic surfaces has been undertaken, represented by measuring of contact angle of surfactant solutions onto flat plates of 304 stainless steel. Aqueous solutions of KCl, surfactants and mixtures of surfactants, with linear and aromatic hydrocarbon chain and ethoxylation degrees ranging between 20 to 100, have been tested. The wettability was assessed by means of a DSA 100 krüss goniometer. The influence of roughness on the wettability was also investigated by machining and polished the stainless steel plates with sandpapers of references ranging between 100 of 1200. The results showed that sanding and polishing plates result in decrease of wettability. As for the solutions, they have provided better wettability of the stainless steel than the KCl solutions tested. It was also been concluded that surfactant mixtures is an option to be considered, since they promote interactions that generate satisfactory contact angles for a good wettability on the stainless steel plate. Another conclusion refers to the influence of the ethoxylation degree of the nonionic surfactant molecules on wettability. It has been observed that contact angles decrease with decreasing ethoxylation degrees. This leads us to conclude that molecules with higher ethoxylation degree, being more hydrophobic, decrease the interaction of water with the ducts, thereby reducing friction and improving the flow

Veredas infinitas, Recepção italiana de Grandes sertões: veredas

L'obiettivo principale di questo lavoro è valutare le difficoltà di comprensione e di identificazione nella ricezione da parte della cultura italiana dell'opera Grande sertão: veredas, da quelle trovate, in modo pionieristico, dal traduttore italiano, a quelle che sono state percepite e indicate al momento della lettura dai critici, dagli accademici, dall'autore di questo lavoro e, soprattutto, dai lettori comuni, mostrando, allo stesso tempo, che i problemi avuti dagli italiani nella traduzione esistono, sotto certi aspetti, anche per i brasiliani urbani, poiché la dimensione linguistico-geografica presente nel romanzo è così peculiare, che perfino molti lettori di lingua portoghese ignorano il mondo plasmato dal linguaggio di Guimarães Rosa rivelando una esacerbazione della questione universale espressa nella formula "traduttori, traditori". Partendo da tutto ciò, abbiamo cercato di dimostrare che, sebbene la traduzione di Edoardo Bizzarri abbia raggiunto un eccellente risultato, l'opera rosiana, così come nella poesia e di più di qualsiasi altra narrativa, comporta, nel passaggio da un idioma all'altro, perdite irrimediabili, tanto relative all'armonia musicale e ritmica, quanto alla richezza semantica che si occulta nel testo originale

Tratamento eletroquímico de água produzida sintética para remoção de hidrocarbonetos policíclicos aromáticos

The aim of this work is the treatment of produced water from oil by using electrochemical technology. Produced water is a major waste generated during the process of exploration and production in the oil industry. Several approaches are being studied aiming at the treatment of this effluent; among them can be cited the biological process and chemical treatments such as advanced oxidation process and electrochemical treatments (electrooxidation, electroflotation, electrocoagulation, electrocoagulation). This work studies the application of electrochemical technology in the treatment of the synthetic produced water effluent through the action of the electron, in order to remove or transform the toxic and harmful substances from the environment by redox reactions in less toxic substances. For this reason, we used a synthetic wastewater, containing a mixture H2SO4 0,5M and 16 HPAs, which are: naphthalene, acenaphthylene, acenaphthene, fluorene, phenanthrene, anthracene, fluoranthene, pyrene, benzo (a) anthracene, chrysene, benzo(b)fluoranthene, benzo(k) fluoranthene, benzo(a)pyrene, indeno(1,2,3-cd)pyrene, dibenzo(a, h)anthracene, benzo(g, h, i)perylene. Bulk electrochemical oxidation experiments were performed using a batch electrochemical reactor containing a pair of parallel electrodes, coupled with a power supply using a magnetic stirrer for favoring the transfer mass control. As anodic material was used, a Dimensionally Stable Anode (DSA) of Ti/Pt, while as cathode was used a Ti electrode. Several samples were collected at specific times and after that, the analysis of these samples were carried out by using Gas Chromatography Coupled to Mass Spectrometry (GC - MS) in order to determine the percentage of removal. The results showed that it was possible to achieve the removal of HPAs about 80% (in some cases, more than 80%). In addition, as an indicator of the economic feasibility of electrochemical treatment the energy consumption was analyzed for each hour of electrolysis, and based on the value kWh charged by ANEEL, the costs were estimated. Thus, the treatment costs of this research were quite attractive

Estudo de reatores eletroquímicos para remoção de Cu2+ , Zn2+, Fenol e BTEX em água produzida

The production of water has become one of the most important wastes in the petroleum industry, specifically in the up stream segment. The treatment of this kind of effluents is complex and normally requires high costs. In this context, the electrochemical treatment emerges as an alternative methodology for treating the wastewaters. It employs electrochemical reactions to increase the capability and efficiency of the traditional chemical treatments for associated produced water. The use of electrochemical reactors can be effective with small changes in traditional treatments, generally not representing a significant additional surface area for new equipments (due to the high cost of square meter on offshore platforms) and also it can use almost the same equipments, in continuous or batch flow, without others high costs investments. Electrochemical treatment causes low environmental impact, because the process uses electrons as reagent and generates small amount of wastes. In this work, it was studied two types of electrochemical reactors: eletroflocculation and eletroflotation, with the aim of removing of Cu2+, Zn2+, phenol and BTEX mixture of produced water. In eletroflocculation, an electrical potential was applied to an aqueous solution containing NaCl. For this, it was used iron electrodes, which promote the dissolution of metal ions, generating Fe2+ and gases which, in appropriate pH, promote also clotting-flocculation reactions, removing Cu2+ and Zn2+. In eletroflotation, a carbon steel cathode and a DSA type anode (Ti/TiO2-RuO2-SnO2) were used in a NaCl solution. It was applied an electrical current, producing strong oxidant agents as Cl2 and HOCl, increasing the degradation rate of BTEX and phenol. Under different flow rates, the Zn2+ was removed by electrodeposition or by ZnOH formation, due the increasing of pH during the reaction. To better understand the electrochemical process, a statistical protocol factor (22) with central point was conducted to analyze the sensitivity of operating parameters on removing Zn2+ by eletroflotation, confirming that the current density affected the process negatively and the flow rate positively. For economical viability of these two electrochemical treatments, the energy consumption was calculated, taking in account the kWh given by ANEEL. The treatment cost obtained were quite attractive in comparison with the current treatments used in Rio Grande do Norte state. In addition, it could still be reduced for the case of using other alternative energy source such as solar, wind or gas generated directly from the Petrochemical Plant or offshore platforms