Microscopic interactions in nanocomposite electrolytes

Nanocomposite electrolytes of a fully amorphous trifunctional polyether (3PEG) and poly- (methylene ethylene oxide) (PMEO) have been complexed with two lithium salts and nanoparticulate (~20 nm) fillers of TiO2 and Al2O3. Addition of the fillers to the polymer salt complexes shows a significant change in the conformational modes of both polymers, especially the D-LAM region between 200 and 400 cm-1, indicating a reduced segmental flexibility of the chain. These changes are more pronounced with the use of TiO2 than Al2O3. Incorporation of the nanoparticulate fillers to the electrolytes fails to influence the degree of ion association, suggesting that the number of charge carriers available for conduction in both polymers using both LiClO4 and LiCF3SO3 is not the source of any conductivity increase. Addition of the fillers, which was seen to increase the conductivity in PEO-based systems, generally lowers the conductivity in the present PMEO systems, while the addition of TiO2 has little or no effect except in the cases of 3PEG 1.5 and 1.25 mol/kg LiClO4. In this case, 10 wt % TiO2 provides a conductivity increase of half an order of magnitude at approximately 60 °C. We also report for the first time a Raman spectroscopy investigation into the PEO-based nanocomposite electrolytes. The present results are discussed in terms of the electrostatic interactions involving dielectric properties of the fillers, of special interest being the interactions between the polymer and the fillers and between the ionic species and the fillers, when the effect of crystallization can be ignored.

Aggregation, ageing and transport properties of surface modified fumed silica dispersions

We have investigated the aggregation, ageing and transport properties of surface modified silica dispersions in DMSO by photon correlation spectroscopy and conductivity measurements. The surface modification introduces Li+-ions that dissociate in the dispersion creating a single Li+-ion conducting electrolyte. We show that the surface modification changes the aggregation and ageing properties of the material. There is a pronounced ageing observed for the modified silica dispersions. At high concentrations of fumed silica a gel state is found, which in the case of the surface modified silica is a very weak gel that can be rejuvenated by ultrasonic treatment. The key parameter controlling the aggregation in this system is hydrogen bonding and the surface modification results in a very low number of sites for hydrogen bonding. In addition there is a contribution from repulsive electrostatic interactions in the surface modified silica dispersions due to the highly charged surfaces of these particles. Furthermore, the Li+-ion diffusion, at low silica concentration, is three orders of magnitude faster than that of the silica particles and in the gel state the silica particles are immobile. We also find that the Li+-ion diffusion is virtually independent of the silica concentration in the dispersions.

Immobilized artificial membrane chromatography : quantitative structure-retention relationships of structurally diverse drugs

The chromatographic capacity factors (log k‘) for 32 structurally diverse drugs were determined by high performance liquid chromatography (HPLC) on a stationary phase composed of phospholipids, the so-called immobilized artificial membrane (IAM). In addition, quantitative structure-retention relationships (QSRR) were developed in order to explain the dependence of retention on the chemical structure of the neutral, acidic, and basic drugs considered in this study. The obtained retention data were modeled by means of multiple regression analysis (MLR) and partial least squares (PLS) techniques. The structures of the compounds under study were characterized by means of calculated physicochemical properties and several nonempirical descriptors. For the carboxylic compounds included in the analysis, the obtained results suggest that the IAM-retention is governed by hydrophobicity factors followed by electronic effects due to polarizability in second place. Further, from the analysis of the results obtained of two developed quantitative structure-permeability studies for 20 miscellaneous carboxylic compounds, it may be concluded that the balance between polarizability and hydrophobic effects is not the same toward IAM phases and biological membranes. These results suggest that the IAM phases could not be a suitable model in assessing the acid-membrane interactions. However, it is not possible to generalize this observation, and further work in this area needs to be done to obtain a full understanding of the partitioning of carboxylic compounds in biological membranes. For the non-carboxylic compounds included in the analysis, this work shows that the hydrophobic factors are of prime importance for the IAM-retention of these compounds, while the specific polar interactions, such as electron pair donor−acceptor interactions and electrostatic interactions, are also involved, but they are not dominant.

Au-Ag三角纳米环单层膜的原位转化制备及SERS效应

A gold-silver nanoframe monolayer nanostructure was obtained on the glass slide using the in-situ sacrificial template reaction. First the silver nanoprisms(~79.2 nm edge length) were prepared as the sacrificial template and were assembled on the slides through electrostatic interactions. The chloroautric acid in-situ reacted with the silver nanoprisms as oxidant. We evaluated the effect of oxidation reaction time on the morphologies and the LSPR properties of the prepared nanoframes. The thickness of gold-silver framework can be adjusted from 29.3 nm to 16.2 nm. We applied the gold-silver framework monolayer as a new surface-enhanced Raman scattering(SERS) substrate for determining 4-aminothiophenol.

Electric contributions to magnetic force microscopy response from graphene and MoS2 nanosheets

Magnetic force microscopy (MFM) signals have recently been detected from whole pieces of mechanically exfoliated graphene and molybdenum disulfide (MoS2) nanosheets, and magnetism of the two nanomaterials was claimed based on these observations. However, non-magnetic interactions or artefacts are commonly associated with MFM signals, which make the interpretation of MFM signals not straightforward. A systematic investigation has been done to examine possible sources of the MFM signals from graphene and MoS2 nanosheets and whether the MFM signals can be correlated with magnetism. It is found that the MFM signals have significant non-magnetic contributions due to capacitive and electrostatic interactions between the nanosheets and conductive cantilever tip, as demonstrated by electric force microscopy and scanning Kevin probe microscopy analyses. In addition, the MFM signals of graphene and MoS2 nanosheets are not responsive to reversed magnetic field of the magnetic cantilever tip. Therefore, the observed MFM response is mainly from electric artefacts and not compelling enough to correlate with magnetism of graphene and MoS2 nanosheets.

Theoretical modeling and experimental validation of surface stress in thrombin aptasensor

Adsorption of target molecules on the immobilized microcantilever surface produced beam displacement due to the differential surface stress generated between the immobilized and non-immobilized surface. Surface stress is caused by the intermolecular forces between the molecules. Van der Waals, electrostatic forces, hydrogen bonding, hydrophobic effect and steric hindrance are some of the intermolecular forces involved. A theoretical framework describing the adsorption-induced microcantilever displacement is derived in this paper. Experimental displacement of thrombin aptamer-thrombin interactions was carried out. The relation between the electrostatic interactions involved between adsorbates (thrombin) as well as adsorbates and substrates (thrombin aptamer) and the microcantilever beam displacement utilizing the proposed mathematical model was quantified and compared to the experimental value. This exercise is important to aid the designers in microcantilever sensing performance optimization.

Selective removal of anionic dyes using poly (N, N -dimethyl amino ethylmethacrylate) functionalized graphene oxide

An in situ polymerization strategy was used to functionalize graphene oxide (GO) with poly(N,N-dimethyl amino ethylmethacrylate) (PDMAEMA) for the selective removal of anionic dyes. Various characterization methods demonstrate that PDMAEMA-grafted GO (GO-PDMAEMA) was successfully synthesized, and the high PDMAEMA content of 68.5% in GO-PDMAEMA changed the zeta potential significantly from -36.5 (GO) to 41.5 (GO-PDMAEMA). This change in the charge of GO-PDMAEMA greatly increased the adsorption capacities for anionic dye orange G (OG) compared to the pristine GO. The maximum adsorption capacity for anionic OG dye based on the Langmuir model is 609.8 mg g-1. The adsorption mechanism is believed to be a consecutive process of intra-particle diffusion and surface adsorption, with electrostatic interactions as the key driving force. The GO-PDMAEMA nanocomposite also showed excellent regeneration capacity and selectivity towards the separation of various anionic dyes (i.e. OG, Eosin yellow and Congo red) from an aqueous dye mixture. In conclusion, our method offers a promising strategy for developing new anionic dye adsorbents.

An analysis of side chain interactions and pair correlations within antiparallel β-sheets : the differences between backbone hydrogen-bonded and non-hydrogen-bonded residue pairs

Cross-strand pair correlations are calculated for residue pairs in antiparallel β-sheet for two cases: pairs whose backbone atoms are hydrogen bonded together (H-bonded site) and pairs which are not (non-H-bonded site). The statistics show that this distinction is important. When glycine is located on the edge of a sheet, it shows a 3:1 preference for the H-bonded site. Thestrongest observed correlations are for pairs of disulfide-bonded cystines, many of which adopt a close-packed conformation with each cystine in a spiral conformation of opposite chirality to its partner. It is likely that these pairs are a signature for the family of small, cystine-rich proteins. Most other strong positive and negative correlations involve charged and polar residues. It appears that electrostatic compatibility is the strongest factor affecting pair correlation. Significant correlations are observed for β- and γ-branched residues inthe non-H-bonded site. An examination of the structures showsa directionality in side chain packing. There is a correlation between (1) the directionality in the packing interactions of non-H-bonded β- and γ-branched residue pairs, (2) the handedness of the observed enantiomers of chiral β-branched side chains, and (3) the handedness of the twist of β-sheet. These findings have implications for the formation of β-sheets during protein folding and the mechanism by which the sheet becomes twisted

Contact electrification induced by monolayer modification of a surface and relation to acid-base interactions

Electrical charge separation following contact between two materials (contact electrification or the triboelectric effect) is well known to occur between different materials as a consequence of their different electronic structures. Here we show that the phenomenon occurs between two surfaces of the same material if one is coated with a single chemisorbed monolayer. We use the surface force apparatus to study contact electrification and adhesion between two silica surfaces, one coated with an amino-silane. The presence of this monolayer results in significantly enhanced adhesion between the surfaces, owing to electrostatic attraction following contact electrification, in accord with Derjaguin's electrostatic theory of adhesion. At the same time, the observed increase in adhesion is consistent with Fowkes' acid-base model (in which acid-base interactions between surface groups are considered to be the predominant factor determining adhesion), as the monolayer converts the originally acidic silica surface to a basic (amine-terminated) one. These observations demonstrate a link between acid- base interactions and contact electrification.

Electrical charge separation following contact between two materials (contact electrification or the triboelectric effect) is well known to occur between different materials as a consequence of their different electronic structures. Here we show that the phenomenon occurs between two surfaces of the same material if one is coated with a single chemisorbed monolayer. We use the surface force apparatus to study contact electrification and adhesion between two silica surfaces, one coated with an amino-silane. The presence of this monolayer results in significantly enhanced adhesion between the surfaces, owing to electrostatic attraction following contact electrification, in accord with Derjaguin's electrostatic theory of adhesion. At the same time, the observed increase in adhesion is consistent with Fowkes' acid-base model (in which acid-base interactions between surface groups are considered to be the predominant factor determining adhesion), as the monolayer converts the originally acidic silica surface to a basic (amine-terminated) one. These observations demonstrate a link between acid-base interactions and contact electrification.

The electrochemical surface forces apparatus : the effect of surface roughness, electrostatic surface potentials, and anodic oxide growth on interaction forces, and friction between dissimilar surfaces in aqueous solutions

We present a newly designed electrochemical surface forces apparatus (EC-SFA) that allows control and measurement of surface potentials and interfacial electrochemical reactions with simultaneous measurement of normal interaction forces (with nN resolution), friction forces (with μN resolution), and distances (with Å resolution) between apposing surfaces. We describe three applications of the developed EC-SFA and discuss the wide-range of potential other applications. In particular, we describe measurements of (1) force–distance profiles between smooth and rough gold surfaces and apposing self-assembled monolayer-covered smooth mica surfaces; (2) the effective changing thickness of anodically growing oxide layers with Å-accuracy on rough and smooth surfaces; and (3) friction forces evolving at a metal–ceramic contact, all as a function of the applied electrochemical potential. Interaction forces between atomically smooth surfaces are well-described using DLVO theory and the Hogg–Healy–Fuerstenau approximation for electric double layer interactions between dissimilar surfaces, which unintuitively predicts the possibility of attractive double layer forces between dissimilar surfaces whose surface potentials have similar sign, and repulsive forces between surfaces whose surface potentials have opposite sign. Surface roughness of the gold electrodes leads to an additional exponentially repulsive force in the force–distance profiles that is qualitatively well described by an extended DLVO model that includes repulsive hydration and steric forces. Comparing the measured thickness of the anodic gold oxide layer and the charge consumed for generating this layer allowed the identification of its chemical structure as a hydrated Au(OH)3 phase formed at the gold surface at high positive potentials. The EC-SFA allows, for the first time, one to look at complex long-term transient effects of dynamic processes (e.g., relaxation times), which are also reflected in friction forces while tuning electrochemical surface potentials.