Rare earth cinnamates and their corrosion inhibition mechanisms for AS1020 steel

Speciation of the inhibitors lanthanum 2-hydroxy cinnamate and lanthanum 3-hydroxy cinnamate in solution has been evaluated and compared to the speciation of lanthanum 4-hydroxy cinnamate. The results have been correlated with corrosion inhibition efficiency for AS1020 steel in an aqueous chloride solution using a combination of analytical tools such as nuclear magnetic resonance (NMR) spectroscopy, electrospray mass spectrometry (ESMS), potentiodynamic polarisation.

Synthesis and structural properties of Anhydrous Rare Earth Cinnamates, [RE(cinn)3]

Anhydrous rare earth tris(cinnamates) [RE(cinn)3] (RE = La–Lu, Y and Sc and cinnH = trans-cinnamic acid) were prepared by metathesis in water and by direct reaction of the metal with cinnamic acid in a 1,2,4,5-tetramethylbenzene flux at ca. 200 °C. X-ray crystal structure determinations and X-ray powder data show that, in the solid state, the larger lanthanoids (La–Dy) form an isomorphous polymeric series consisting of homoleptic nine-coordinate metal centres bonded to three chelating and bridging tridentate cinnamates. The late REIII cinnamate (RE = Dy, Ho–Lu, Y) complexes also form linear one-dimensional polymeric chains with all RE metal atoms being seven-coordinate. The cinnamates are either bound tridentate bridging in a μ-η2:η1 fashion, or μ-η1:η1syn-syn bidentate bridging. A structural break occurs at dysprosium which has been characterised in both crystallographic forms, and gives solely the late RE form when precipitated at 80 °C. ScIII cinnamate was also isolated as an analytically pure precipitate which was, again, found to be anhydrous in nature. A structural change was identified by powder XRD between the late REIII cinnamates and ScIII cinnamate.

The corrosion inhibition mechanism of new rare earth cinnamate compounds — electrochemical studies

A combination of linear polarisation resistance (LPR) and cyclic potentiodynamic polarisation (CPP) measurements demonstrated that the lanthanum-4 hydroxy cinnamate compound could inhibit both the cathodic and anodic corrosion reactions on mild steel surfaces exposed to 0.01 M NaCl solutions. However, the dominating response was shown to vary with inhibitor concentration. At the concentrations for which the highest level of protection was achieved, both REM-4 hydroxy cinnamate (REM being lanthanum and mischmetal) displayed a strong anodic behaviour for mild steel and their inhibition performance, including their resistance against localised attack, improved with time.

Electrochemical impedance spectroscopy (EIS) measurements and modelling were carried out so as to propose a simple electrical model and correlate the extracted parameters to the inhibition mechanism put forward for REM-cinnamate based compounds. The results supported the high corrosion inhibition performance of the compounds as well as the build-up of a protective film with time. Based on a two-layer model the results suggested that the upper layer of the inhibitor film seemed to offer less resistance to the diffusion of electrochemically active species than the highly resistive inner layer at the film/metal interface.

Corrosion mitigation of mild steel by new rare earth cinnamate compounds

Corrosion rate measurements based on weight loss (i.e., mild steel immersed for seven days in 0.01 M NaCl) and linear polarization resistance (LPR) techniques have shown that even low concentrations (200 ppm) of cerium and lanthanum cinnamates are able to significantly inhibit corrosion. Of all the compounds investigated in this work Ce(4-methoxycinnamate)3· 2 H2O and La(4-methoxycinnamate)3· 2 H2O compounds exhibited the greatest inhibition and, in comparison with the component inhibitors, a synergy was clearly observed. The mechanism of corrosion inhibition was investigated using cyclic potentiodynamic polarization (CPP) measurements. The results suggest that La(4-nitrocinnamate)3· 2 H2O and Ce(4-methoxycinnamate)3· 2 H2O behave as mixed inhibitors and improve the resistance of steel against localized attack.

Synthesis and characterisation of rare earth complexes supported by para-substituted Cinnamate Ligands

The preparations and characterisations of a range of lanthanoid 4-(R)-substituted (4-Rcinn, R = OH, OMe, NO2, Cl), known to have good anticorrosion properties, are reported. The crystal structure of [Ce(4-OHcinn)3(MeOH)2(H2O)]·MeOH is a polymer, in which the cerium atoms are nonacoordinate, and adjacent cerium atoms are bridged by either two bridging bidentate or two bridging tridentate carboxylate ligands. Each cerium atom also has one monodentate 4-hydroxycinnamate ligand, one aqua ligand, and two methanol ligands.