Direct observation of defect levels in hexagonal BN by soft X-ray absorption spectroscopy

Formation of defects in hexagonal boron nitride under low-energy argon bombardment has been studied by near-edge X-ray absorption fine structure (NEXAFS) around B and N K-edges. Breaking of B-N bonds and creation of nitrogen vacancies has been identified from the B K-edge, followed by the formation of molecular nitrogen, N2, at interstitial positions. The presence of N2 produces a sharp resonance in the low-resolution NEXAFS spectra around N K-edge, showing the characteristic vibrational fine structure in high-resolution measurements. Several new peaks in NEXAFS spectra have been assigned to boron or nitrogen interstitials, in good agreement with theoretical predictions. © 2009 Elsevier B.V. All rights reserved.

Local structure and photocatalytic property of sol-gel synthesized ZnO doped with transition metal oxides

ZnO nanoparticles doped with up to 5 at% of Co and Mn were prepared using a co-precipitation method. The location of dopant ions and the effect of doping on the photocatalytic activity were investigated. The crystal structure of nanoparticles and local atomic arrangements around dopant ions were analyzed by X-ray absorption spectroscopy. The results showed that the Co ions substituted the Zn ions in the ZnO wurtzite phase structure and induced lattice shrinkage, while Mn ions were not completely incorporated in the crystal lattice. The photocatalytic activity under simulated sunlight was characterized by the decomposition of Rhodamine B dye molecules. It was revealed that Co-doping strongly reduced the photocatalytic activity but Mn-doping showed a weaker effect on the reduction of the photoactivity.

Surface structure of SnOxNy thin films deposited using a filtered cathodic arc for novel energy storage systems

Tin oxide/nitride (SnOxNy) thin films were synthesised using a filtered cathodic vacuum arc deposition system. These films were deposited at room temperature with increasing amounts of reactive nitrogen gas to alter the nanostructure. To understand the surface structure of the coatings several techniques were used including scanning electron microscopy (SEM), atomic force microscopy (AFM), x-ray photoelectron spectroscopy (XPS), x-ray diffraction (XRD) and x-ray absorption spectroscopy (XAS). Preliminary results have shown that a cathodic arc can be used to deposit smooth films which exhibit a mixed tin oxide/nitride structure.

Stoichiometric changes in lithium conducting materials based on Li1+xAlxTi2−x(PO4)3: impedance, X-ray and NMR studies

The lithium fast-ion conductor, Li_1+xAl_xTi_2−x(PO₄)₃ (LATP) has been modified via changes in stoichiometry during the processing steps. The resultant changes have been followed using ²⁷Al MAS NMR, X-ray powder diffraction and impedance spectroscopy. The most important changes were those of the form Li_1.3+4yAl_0.3Ti_1.7−y(PO₄)₃. It was possible to remove the AlPO₄ phase (both tridymite and berlinite polymorphs), as monitored by X-ray diffractograms and ²⁷Al NMR spectra. Consequently, these changes appear to result in increased grain boundary conductivity of the LATP material.

High-pressure structural transitions of Sc2O3 by X-ray diffraction, raman spectra, and ab initio calculations

The high-pressure behavior of scandium oxide (Sc₂O₃) has been investigated by angle-dispersive synchrotron powder X-ray diffraction and Raman spectroscopy techniques in a diamond anvil cell up to 46.2 and 42 GPa, respectively. An irreversible structural transformation of Sc₂O₃ from the cubic phase to a monoclinic high-pressure phase was observed at 36 GPa. Subsequent ab initio calculations for Sc₂O₃ predicted the phase transition from the cubic to monoclinic phase but at a much lower pressure. The same calculations predicted a second phase transition at 77 GPa from the monoclinic to hexagonal phase.