Enhancement of transient stability limit and voltage regulation with dynamic loads using robust excitation control

In stressed power systems with large induction machine component, there exist undamped electromechanical modes and unstable montonic voltage modes. This article proposes a sequential design of an excitation controller and a power system stabiliser (PSS) to stabilise the system. The operating region, with induction machines in stressed power systems, is often not captured using a linearisation around an operating point, and to alleviate this situation a robust controller is designed which guaruntees stable operation in a large region of operation. A minimax linear quadratic Gaussian design is used for the design of the supplementary control to automatic voltage regulators, and a classical PSS structure is used to damp electromechanical oscillations. The novelty of this work is in proposing a method to capture the unmodelled nonlinear dynamics as uncertainty in the design of the robust controller. Tight bounds on the uncertainty are obtained using this method which enables high-performance controllers. An IEEE benchmark test system has been used to demonstrate the performance of the designed controller

Research of a new type rectifier and voltage-multiplier piezoelectric energy harvester circuit

Traditional rectifier circuit can convert AC to DC, but some disadvantages can't be avoided, such as small output current, high power consumption, low conversion efficiency. This paper designs a new type of rectifier voltage-multiplier circuit named MR MOS circuit. It uses a low let-through resistance MOS tube to replace the conventional rectifier diode, and adds the voltage-multiplying factor to the synchronous input port. Therefore, it can improve the rectifier effect and increase the output voltage. By the simulation result of Synopsys Saber Platform, it shows that the new type circuit can implement the rectification and voltage-multiplying by the simulating output pulse voltage of nano fiber made in Deakin University as the source of excitation. It can provide the basic theoretical of the piezoelectric energy harvester (PEH) development, and has certain reference significance to the development of piezoelectricity technology. © (2014) Trans Tech Publications.

High-performance supercapacitor electrode materials from cellulose-derived carbon nanofibers

Nitrogen-functionalized carbon nanofibers (N-CNFs) were prepared by carbonizing polypyrrole (PPy)-coated cellulose NFs, which were obtained by electrospinning, deacetylation of electrospun cellulose acetate NFs, and PPy polymerization. Supercapacitor electrodes prepared from N-CNFs and a mixture of N-CNFs and Ni(OH)2 showed specific capacitances of ∼236 and ∼1045 F g(-1), respectively. An asymmetric supercapacitor was further fabricated using N-CNFs/Ni(OH)2 and N-CNFs as positive and negative electrodes. The supercapacitor device had a working voltage of 1.6 V in aqueous KOH solution (6.0 M) with an energy density as high as ∼51 (W h) kg(-1) and a maximum power density of ∼117 kW kg(-1). The device had excellent cycle lifetime, which retained ∼84% specific capacitance after 5000 cycles of cyclic voltammetry scans. N-CNFs derived from electrospun cellulose may be useful as an electrode material for development of high-performance supercapacitors and other energy storage devices.

Development of a low actuation voltage electrostatic RF MEMS switch

The research focused on the design, fabrication and measurement of a low actuation voltage micro electro mechanical high frequency switch. The fabricated micro switch offers outstanding radio frequency parameters for a very large frequency band, with actuation voltage and switching time less than 20 volts and 3 micro seconds, respectively.