Lessons from the greenest city

In 2007, the City of Växjö in Sweden was voted the greenest city in Europe. Over an 18-year period, greenhouse gas emissions per resident have been reduced by 41%. How has Växjö achieved this impressive result and are there any lessons that could be transferred to Australian cities? This paper describes research which compares Växjö with the Victorian City of Ballarat. The research shows that per capita emissions for Ballarat are 133% higher than those in Växjö. Upgrading the typical Ballarat home to a 6-star rating, and installing a gas-boosted solar water heater and 4.0 kW PV system on the roof could reduce per capita emissions to similar levels to those in Växjö.

Design protection circuit for transformerless photovoltaic inverters in harsh climatic conditions

Transformerless inverters technology in photovoltaic systems offers many advantages, but there are some safety issues due to the solar panel parasitic capacitance. The parasitic capacitance value depends on many factors such as PV panels and frame structure, surface of the cells, distance between the cells, module frame, weather conditions (e.g., humidity) and the amount of dust covering the PV panel. Harsh climate like the one in the Central Queensland region is characterized by high temperature, high relative humidity. Due to the region’s high dew point, high humidity and heavy rain during the wet season, the water condensed over the PV array surface will affect the stray capacitance significantly and consequently, the system leakage current. Human safety in PV system is a key issue, which must be addressed when this technology is applied. Protection against electrical shock is essential while deploying such systems to avoid injury or loss of life. Furthermore, PV insulation varies with meteorological conditions such as, temperatures, humidity. Therefore, the protective circuit should have the capability to adapt to any changes in metrological variables. This paper explorers the effect of meteorological changes on the insulation parameters and leakage capacitance and design a tools for protection.

Simulation and evaluation of HERIC and H5 transformerless inverter topologies

Most of the inverters have an isolation transformer which prevents or limits fault current between AC and DC circuits under most fault conditions. If the transformer is excluded from the system, it would increase the PV system efficiency and decrease the size of its installations, which will lead to a lower cost for the whole investment. Thus, elimination of the transformer has to be considered carefully because a galvanic connection appears between the PV arrays and the ground in the absence of an isolation transformer. The galvanic connection causes the stray capacitance between the PV arrays structure and the ground to produce a leakage current. In this paper, a review of full bridge topology with bipolar and unipolar scheme and half bridge topology carried out in regard leakage current.in addition, HERIC and H5 topologies are simulated and leakage current in these topologies are evaluated.

Low cost MPPT controller for a photovoltaic-based microgrid

 Photovoltaic based microgrid have been increasingly investigated in recent years, ascribable to their fundamental advantages such as the infinite energy source, environmentally friendly aspect and low upkeep cost. However, in practice, they are still considered as an expensive and low output option of renewable energy resources. To extract the maximum possible power from the output of the PV system, a reliable maximum power point tracker (MPPT) is required. Numerous studies have been conducted to introduce the best MPPT techniques suitable for different types of PV systems. However, they are mostly able to track the MPP from the PV system when the output signals (Voltage and Current) of individual array are available. In this study, a meta-heuristic method, based on particle swarm optimization theory, is used to determine the actual MPP of PV system, including several PV arrays, by only single current sensor at the output terminal. The results of the proposed PSO based technique, for tracking the global MPP in a multidimensional search space, have been presented at the end of this paper.

Fog computing: a cloud to the ground support for smart things and machine-to-machine networks

Cloud services to smart things face latency and intermittent connectivity issues. Fog devices are positioned between cloud and smart devices. Their high speed Internet connection to the cloud, and physical proximity to users, enable real time applications and location based services, and mobility support. Cisco promoted fog computing concept in the areas of smart grid, connected vehicles and wireless sensor and actuator networks. This survey article expands this concept to the decentralized smart building control, recognizes cloudlets as special case of fog computing, and relates it to the software defined networks (SDN) scenarios. Our literature review identifies a handful number of articles. Cooperative data scheduling and adaptive traffic light problems in SDN based vehicular networks, and demand response management in macro station and micro-grid based smart grids are discussed. Security, privacy and trust issues, control information overhead and network control policies do not seem to be studied so far within the fog computing concept.

A digital signal processor controlled smart battery charger for photovoltaic power systems

An off-grid photovoltaic power system requires an energy storage system, especially batteries, for mitigation of variability and intermittency problems, and for assured service reliability and availability. The longevity and reliability of such batteries depend on the effectiveness of the charging system. This paper presents the modelling, simulation and hardware implementation of a four-stage switch-mode charger based on the single-ended primary inductance converter. The digital signal processor based controller implements algorithms for the system's power balance control, maximum power point tracking to improve charging speed and efficiency, four-stage optimal charging, and system's protection. The protection algorithm provides over-charge, overdischarge, over-temperature and short circuit protection capabilities. The proposed system has the following advantages: ability to continuously charge the batteries even at reduced solar irradiation, higher efficiency, and use of adaptive thermally compensated set points for optimum performance. A prototype is built and experimental results are presented to validate the simulation results.

Experimental and simulation study of the impact of increased photovoltaic integration with the grid

The abundance, availability, and climate-friendly characteristics of solar photovoltaic (PV) energy encourage nations around the globe to adopt it to assist in overcoming global warming as well as build a sustainable society for the future. The intermittent nature of solar energy generation and the associated power electronic inverters with connected consumer loads creates a number of potential challenges in integrating large-scale PV into the grid that affects power quality of the distribution networks. This paper investigates the impacts of varying PV integration into the grid through experimental and simulation studies. Initially, several experiments were conducted with varying PV penetration and load conditions using the Renewable Energy Integration Facility at CSIRO, Newcastle, Australia. Later, a simulation model was developed that mimics the experimental facility used at CSIRO to investigate the adverse impacts on integrating large-scale PV into the grid using the power system simulation software PSS Sincal. Experimental and simulation analyses clearly indicate that integration of PV into the grid causes power quality issues such as voltage instability, harmonic injection, and low power factor into the networks and the level of these impacts increases with the increase of PV penetration. © 2014 AIP Publishing LLC.

Impact analysis study in a typical solar PV microgrid power system

Microgrid (MG) power system with Distributed Generation (DG) plays an important role to provide reliable, secure, and low carbon emission energy supply for communities, in case of any failure or disturbance of energy supply from the main grid. At the same time, DG also contributes to several technical issues in the MG distribution network. Power quality (PQ) issues are one of the main technical challenges when integrating Renewable Energy (RE) sources in MG network. In this paper, the PQ issues like; power variation, voltage deviation, and Total Harmonic Distortion (THD) have been addressed by an impact analysis study on a typical solar PV MG power system in both on-grid and off-grid mode of operation. Analysis results from the study will be helpful in developing an independent MG power system with improved PQ conditions.

An adaptive information grid architecture for recommendation system

This paper presents an adaptive information grid architecture for recommendation systems, which consists of the features of the recommendation rule and a co-citation algorithm. The algorithm addresses some challenges that are essential for further searching and recommendation algorithms. It does not require users to provide a lot of interactive communication. Furthermore, it supports other queries, such as keyword, URL and document investigations. When the structure is compared to other algorithms, the scalability is noticeably better. The high online performance can be obtained as well as the repository computation, which can achieve a high group-forming accuracy using only a fraction of web pages from a cluster.

Autonomic system management in mobile grid environments

Mobile device integration in grid environments is a challenge for many researchers. Due to the transient nature of mobile devices, service management is a critical, but often overlooked area of research. We propose a distributed broker responsible for the autonomic management of grid services. The broker provides self discovery and negotiation, self configuration and self healing for SOA based mobile grids. In this paper the design and prototype implementation of the broker is presented and the importance of autonomic grid service management is shown.

An autonomic management system for service oriented enterprise grid computing

Grid computing and service oriented architectures improve the way computational tasks are performed. Through this research a management system, utilising the autonomic characteristics of self discovery and negotiation, self configuration and self healing, was designed and implemented, ultimately removing the need for users to know the intricacies of these systems.