Effect of carbon content on the recrystallization kinetics of Nb-steels

A rapid method was used to study the effect of carbon content on the kinetics of post-deformation softening, t50, in Nb-steels. The hot deformation behaviour of austenite was not affected by carbon. However, the t50 was influenced by the carbon with different effects in different temperature regimes. At deformation temperatures above the non-recrystallization temperature, Tnr, carbon produced a small change in the softening behaviour. However, the t50 was significantly retarded with increasing carbon content at deformation temperatures lower than Tnr, due to Nb(C,N) precipitates.

The influence of heat treatment on the corrosion behaviour of as-spun amorphous Al88Ni6La6 alloy in 0.01 M NaCl solution

The effect of the heat treatment on the corrosion behaviour of amorphous Al₈₈Ni₆La₆ made by melt-spun has been investigated by electrochemical measurements. Heat treatment was carried out at 523 K and 673 K for 4 min and 15 min respectively. The evolution of the crystallization process after annealing was identified by differential scanning calorimeter (DSC) as well as X-ray diffraction. The XRD patterns show that the structure of samples heat-treated at higher temperature changes towards a crystal state. The results obtained from the polarization curves reveal that all Al₈₈Ni₆La₆ alloys exhibit spontaneously passivated behaviour. Furthermore, it is noted that the partially crystallized alloy has the best corrosion resistance in comparison with as-spun amorphous and fully crystallized alloys, while the fully crystallized sample shows deterioration in the corrosion resistance.

Effect of crystallization on corrosion resistance of Cu52.5Ti30Zr11.5Ni6 bulk amorphous alloy

The effects of crystallization on the corrosion resistance of a  Cu52.5Ti30Zr11.5Ni6 bulk amorphous alloy in 1 mol/L HCl, and 6 mol/L NaOH solutions were studied. The amorphous alloy was identified by  differential thermal analysis(DSC) and by X-ray diffraction(XRD). The partially and fully crystallized alloys were prepared by controlling the annealing  temperatures at 738 and 873 K for 1 and 12 min, respectively, and the corrosion resistances of those annealed alloys were compared with that of the amorphous alloy by immersion test and potentiodynamic measurements in 1 mol/L HCl and 6 mol/L NaOH solutions. The results show that the  partially crystallized alloy exhibits high corrosion resistance, whereas full crystallization results in deteriorated corrosion resistance compared with that of the as-cast amorphous alloy.

Effect of carbohydrate ingestion on glucose kinetics during exercise in the heat

Six endurance-trained men [peak oxygen uptake (VO₂) = 4.58 ± 0.50 (SE) l/min] completed 60 min of exercise at a workload requiring 68 ± 2% peak VO₂ in an environmental chamber maintained at 35°C (<50% relative humidity) on two occasions, separated by at least 1 wk. Subjects ingested either a 6% glucose solution containing 1 µCi [3-³H]glucose/g glucose (CHO trial) or a sweet placebo (Con trial) during the trials. Rates of hepatic glucose production [HGP = glucose rate of appearance (R_a) in Con trial] and glucose disappearance (R_d), were measured using a primed, continuous infusion of [6,6-^₂H]glucose, corrected for gut-derived glucose (gut R_a) in the CHO trial. No differences in heart rate, VO₂, respiratory exchange ratio, or rectal temperature were observed between trials. Plasma glucose concentrations were similar at rest but increased (P < 0.05) to a greater extent in the CHO trial compared with the Con trial. This was due to the absorption of ingested glucose in the CHO trial, because gut R_a after 30 and 50 min (16 ± 5 µmol · kg^-1 · min^-1) was higher (P < 0.05) compared with rest, whereas HGP during exercise was not different between trials. Glucose R_d was higher (P < 0.05) in the CHO trial after 30 and 50 min (48.0 ± 6.3 vs 34.6 ± 3.8 µmol · kg^-1 · min^-1, CHO vs. Con, respectively). These results indicate that ingestion of carbohydrate, at a rate of ~1.0 g/min, increases glucose Rd but does not blunt the rise in HGP during exercise in the heat.

Slow component of VO2 kinetics: the effect of training status, fibre type, UCP3 mRNA and citrate synthase activity

Examines the relationship between the magnitude of the relative slow component (SC) of pulmonary oxygen uptake VO[sub 2], citrate synthase activity, UCP2 and UCP3 mRNA levels and muscle fiber composition in both endurance-trained and recreationally active subjects. Magnitude of the relative SC of the Tr group; Indicators of aerobic fitness; High negative correlations between the magnitude of the relative SC and citrate synthase activity and VO[sub 2] peak.

Plasma glucose kinetics during prolonged exercise in trained humans when fed carbohydrate

Nine endurance-trained men exercised on a cycle ergometer at ~68% peak O₂ uptake to the point of volitional fatigue [232 ± 14 (SE) min] while ingesting an 8% carbohydrate solution to determine how high glucose disposal could increase under physiological conditions. Plasma glucose kinetics were measured using a primed, continuous infusion of [6,6-²H]glucose and the appearance of ingested glucose, assessed from [3-³H]glucose that had been added to the carbohydrate drink. Plasma glucose was increased (P < 0.05) after 30 min of exercise but thereafter remained at the preexercise level. Glucose appearance rate (Ra) increased throughout exercise, reaching its peak value of 118 ± 7 µmol · kg^-1 · min^-1 at fatigue, whereas gut R_a increased continuously during exercise, peaking at 105 ± 10 µmol · kg^-1 · min^-1 at the point of fatigue. In contrast, liver glucose output never rose above resting levels at any time during exercise. Glucose disposal (R_d) increased throughout exercise, reaching a peak value of 118 ± 7 µmol · kg^-1 · min^-1 at fatigue. If we assume 95% oxidation of glucose R_d, estimated exogenous glucose oxidation at fatigue was 1.36 ± 0.08 g/min. The results of this study demonstrate that glucose uptake increases continuously during prolonged, strenuous exercise when carbohydrate is ingested and does not appear to limit exercise performance.

Receptor activation and 2 distinct COOH- terminal motifs control G-CSF receptor distribution and internalization kinetics.

We have studied the intracellular distribution and internalization kinetics of the granulocyte colony-stimulating factor receptor (G-CSF-R) in living cells using fusion constructs of wild-type or mutant G-CSF-R and enhanced green fluorescent protein (EGFP). Under steady-state conditions the G-CSF-R localized predominantly to the Golgi apparatus, late endosomes, and lysosomes, with only low expression on the plasma membrane, resulting from spontaneous internalization. Internalization of the G-CSF-R was significantly accelerated by addition of G-CSF. This ligand-induced switch from slow to rapid internalization required the presence of G-CSF-R residue Trp650, previously shown to be essential for its signaling ability. Both spontaneous and ligand-induced internalization depended on 2 distinct amino acid stretches in the G-CSF-R COOH-terminus: 749-755, containing a dileucine internalization motif, and 756-769. Mutation of Ser749 at position –4 of the dileucine motif to Ala significantly reduced the rate of ligand-induced internalization. In contrast, mutation of Ser749 did not affect spontaneous G-CSF-R internalization, suggesting the involvement of a serine-threonine kinase specifically in ligand-accelerated internalization of the G-CSF-R. COOH-terminal truncation mutants of G-CSF-R, found in severe congenital neutropenia, lack the internalization motifs and were completely defective in both spontaneous and ligand-induced internalization. As a result, these mutants showed constitutively high cell-surface expression.

Efficacy of neuromuscular electrical stimulation in improving ankle kinetics during walking in children with cerebral palsy

Neuromuscular electrical stimulation (NMES) applied to the triceps surae muscle is claimed to be effective in improving gait in children with cerebral palsy. The main aim of this study was to determine the effect of NMES on the triceps surae muscle in improving the gait and function of children with cerebral palsy. Twelve children with spastic diplegia or hemiplegia were recruited and randomly assigned to the two experimental groups. The period of the study was 8 weeks (2-4-2 week design). The initial 2 weeks was the control period, in which usual treatment was given to both groups of patients with a pre- and post-treatment assessment. The middle 4 weeks was the experimental period, in which the Treadmill+NMES group received NMES plus treadmill walking training and the Treadmill group underwent treadmill walking training only. Assessment was performed at 2-week intervals. The final 2 weeks was the carryover period, in which treatment to be tested was stopped and reassessment performed again at the end of week 8. An additional treatment and post-treatment assessment were given at weeks 2, 4 and 6 to test for the immediate effect of treatment. Altogether, eight repeated measures with three-dimensional gait analysis and five clinical measurements using the gross motor function measure (GMFM) were performed. Kinetic changes in ankle moment quotient (AMQ) and ankle power quotient (APQ) were not significant either immediately or cumulatively in both groups. Improvement in trend was observed in both groups immediately but not cumulatively. Using the GMFM, functional changes were detected in standing (GMST, p < 0.001) and in walking (GMWK, p = 0.003) using a 'time' comparison. Significant interaction was also detected in GMWK using 'treatment by time' (p = 0.035). The difference between the two groups was not significant on 'treatment' comparison of both GMST and GMWK. Both groups showed improvement in GMST and GMWK cumulatively but there was no difference between the two groups. The effects in both groups could be carried over to 2 weeks after interventions stopped. Both the Treadmill+NMES and Treadmill groups showed improvement in functional outcomes. The trend in the changes of the GMFM score suggested that improvements were greater in the Treadmill+NMES group. There was also a trend showing some immediate improvement in AMQ and APQ.

Consistent model predictions for isothermal cure kinetics investigation of high performance epoxy prepregs

An accurate kinetics model is essential for understanding the curing mechanism and predicting the end properties of polymer materials. Graphite/epoxy AS4/ 8552 prepreg is a recent high-performance thermosetting composite modified with thermoplastic, which is being used in the manufacture of aircraft and military structures. The isothermal cures of this system along with another thermoplastic toughened high-performance prepreg, the T800H/3900-2 system, were investigated by real-time Fourier transform infrared (FTIR) spectroscopy. The cure rate was quantitatively analyzed based on the concentration profiles of both the epoxy and primary amine groups. Three autocatalytic models were used to determine kinetics parameters for both composite systems. The model which utilizes an empirical term, the final relative conversion (at different isothermal curing temperatures), describes the experimental data of both systems more satisfactorily than the model which applies a diffusion factor. The modeling results suggest that the curing of epoxy within both prepregs can be assumed to be a second order process.

The kinetics of two-stage formation of TiAl3 in multilayered Ti/Al foils prepared by accumulative roll bonding

The solid-state reactions of Ti/Al multilayered samples produced by Accumulative Roll Bonding (ARB) have been investigated using differential scanning calorimetry, X-ray diffraction and scanning electron microscopy. The kinetics of the formation of the intermetallic compound TiAl3 was highlighted. Experimental evidence and analysis of the data shows that, there was a two-stage process in the formation of TiAl₃ in the ARB Ti/Al reactive multilayered samples. Calorimetric and microstructural analyses also suggest that the interdiffusion of Al and Ti which led to solid solutions preceded the formation of intermetallic compounds. Despite the apparent chaos in the thickness of the ARB multilayered samples, the distribution of layer spacing did not become broad enough to lose the main features of the double exothermal behaviour. Isothermal DSC shows a larger Avarami constant in ARB Ti/Al multilayered structures than was found in Ti/Al thin films. A modified model based on thin films was set up to describe the kinetic characteristics of the formation of the intermetallic compound TiAl₃ in ARB samples.