Improvement of link failure restoration utilising multi-protocol label switching (MPLS) as a means to maintain quality of service (QOS)

This paper proposes a practical approach to the enhancement of Quality of Service (QoS) routing by means of providing alternative or repair paths in the event of a breakage of a working path. The proposed scheme guarantees that every Protected Node (PN) is connected to a multi-repair path such that no further failure or breakage of single or double repair paths can cause any simultaneous loss of connectivity between an ingress node and an egress node. Links to be protected in an MPLS network are predefined and a Label Switched path (LSP) request involves the establishment of a working path. The use of multi-protection paths permits the formation of numerous protection paths allowing greater flexibility. Our analysis examined several methods including single, double and multi-repair routes and the prioritization of signals along the protected paths to improve the Quality of Service (QoS), throughput, reduce the cost of the protection path placement, delay, congestion and collision. Results obtained indicated that creating multi-repair paths and prioritizing packets reduces delay and increases throughput in which case the delays at the ingress/egress LSPs were low compared to when the signals had not been classified. Therefore the proposed scheme provided a means to improve the QoS in path restoration in MPLS using available network resources. Prioritizing the packets in the data plane has revealed that the amount of traffic transmitted using a medium and low priority Label Switch Paths (LSPs) does not have any impact on the explicit rate of the high priority LSP in which case the problem of a knock-on effect is eliminated.

Improvement of link failure restoration utilising MPLS as a means to maintain QoS

The availability of a network strongly depends on the frequency of service outages and the recovery time for each outage. The loss of network resources includes complete or partial failure of hardware and software components, power outages, scheduled maintenance such as software and hardware, operational errors such as configuration errors and acts of nature such as floods, tornadoes and earthquakes. This paper proposes a practical approach to the enhancement of QoS routing by means of providing alternative or repair paths in the event of a breakage of a working path. The proposed scheme guarantees that every Protected Node (PN) is connected to a multi-repair path such that no further failure or breakage of single or double repair paths can cause any simultaneous loss of connectivity between an ingress node and an egress node. Links to be protected in an MPLS network are predefined and an LSP request involves the establishment of a working path. The use of multi-protection paths permits the formation of numerous protection paths allowing greater flexibility. Our analysis will examine several methods including single, double and multi-repair routes and the prioritization of signals along the protected paths to improve the Quality of Service (QoS), throughput, reduce the cost of the protection path placement, delay, congestion and collision.

Quality time [QoS in 802.11e]

Wireless local area networks (WLANs) based on the IEEE 802.11 standard are now widespread. Most are used to provide access for mobile devices to a conventional wired infrastructure, and some are used where wires are not possible, forming an ad hoc network of their own. There are several varieties at the physical or radio layer (802.11, 802.11a, 802.11b, 802.11g), with each featuring different data rates, modulation schemes and transmission frequencies. However, all of them share a common medium access control (MAC) layer. As this is largely based on a contention approach, it does not allow prioritising of traffic or stations, so it cannot easily provide the quality of service (QoS) required by time-sensitive applications, such as voice or video transmission. In order to address this shortfall of the technology, the IEEE set up a task group that is aiming to enhance the MAC layer protocol so that it can provide QoS. The latest draft at the time of writing is Draft 11, dated October 2004. The article describes the yet-to-be-ratified 802.11e standard and is based on that draft.

Infotainment across access devices: the perceptual impact of multimedia QoS

The introduction of multimedia on pervasive and mobile communication devices raises a number of perceptual quality issues. However, limited work has been done examining the 3-way interaction between use of equipment, user perceptual quality and quality of service. Our work measures user perceptual quality with the quality of perception (QoP) metrics which comprises levels of informational transfer (objective) and user satisfaction (subjective) when users are presented with multimedia video clips at three different frame rates, using four different display devices. Finally, our results will show that variation in frame-rate does not impact a user’s level of information assimilation (IA), however, does impact a users’ perception of multimedia video ‘quality’.

Modelling QoS of a pervasive MVNO/M2M using semi-group theory

This paper aims to develop a mathematical model based on semi-group theory, which allows to improve quality of service (QoS), including the reduction of the carbon path, in a pervasive environment of a Mobile Virtual Network Operator (MVNO). This paper generalise an interrelationship Machine to Machine (M2M) mathematical model, based on semi-group theory. This paper demonstrates that using available technology and with a solid mathematical model, is possible to streamline relationships between building agents, to control pervasive spaces so as to reduce the impact in carbon footprint through the reduction of GHG.

Conceptualisation of an application of adaptive synthetic socioeconomic agents for intelligent network control

The deployment of Quality of Service (QoS) techniques involves careful analysis of area including: those business requirements; corporate strategy; and technical implementation process, which can lead to conflict or contradiction between those goals of various user groups involved in that policy definition. In addition long-term change management provides a challenge as these implementations typically require a high-skill set and experience level, which expose organisations to effects such as “hyperthymestria” [1] and “The Seven Sins of Memory”, defined by Schacter and discussed further within this paper. It is proposed that, given the information embedded within the packets of IP traffic, an opportunity exists to augment the traffic management with a machine-learning agent-based mechanism. This paper describes the process by which current policies are defined and that research required to support the development of an application which enables adaptive intelligent Quality of Service controls to augment or replace those policy-based mechanisms currently in use.

Distributed multimedia quality: the user perspective

Distributed multimedia supports a symbiotic infotainment duality, i.e. the ability to transfer information to the user, yet also provide the user with a level of satisfaction. As multimedia is ultimately produced for the education and / or enjoyment of viewers, the user’s-perspective concerning the presentation quality is surely of equal importance as objective Quality of Service (QoS) technical parameters, to defining distributed multimedia quality. In order to extensively measure the user-perspective of multimedia video quality, we introduce an extended model of distributed multimedia quality that segregates quality into three discrete levels: the network-level, the media-level and content-level, using two distinct quality perspectives: the user-perspective and the technical-perspective. Since experimental questionnaires do not provide continuous monitoring of user attention, eye tracking was used in our study in order to provide a better understanding of the role that the human element plays in the reception, analysis and synthesis of multimedia data. Results showed that video content adaptation, results in disparity in user video eye-paths when: i) no single / obvious point of focus exists; or ii) when the point of attention changes dramatically. Accordingly, appropriate technical- and user-perspective parameter adaptation is implemented, for all quality abstractions of our model, i.e. network-level (via simulated delay and jitter), media-level (via a technical- and user-perspective manipulated region-of-interest attentive display) and content-level (via display-type and video clip-type). Our work has shown that user perception of distributed multimedia quality cannot be achieved by means of purely technical-perspective QoS parameter adaptation.

Stars in their eyes: what eye-tracking reveal about multimedia perceptual quality

Perceptual multimedia quality is of paramount importance to the continued take-up and proliferation of multimedia applications: users will not use and pay for applications if they are perceived to be of low quality. Whilst traditionally distributed multimedia quality has been characterised by Quality of Service (QoS) parameters, these neglect the user perspective of the issue of quality. In order to redress this shortcoming, we characterise the user multimedia perspective using the Quality of Perception (QoP) metric, which encompasses not only a user’s satisfaction with the quality of a multimedia presentation, but also his/her ability to analyse, synthesise and assimilate informational content of multimedia. In recognition of the fact that monitoring eye movements offers insights into visual perception, as well as the associated attention mechanisms and cognitive processes, this paper reports on the results of a study investigating the impact of differing multimedia presentation frame rates on user QoP and eye path data. Our results show that provision of higher frame rates, usually assumed to provide better multimedia presentation quality, do not significantly impact upon the median coordinate value of eye path data. Moreover, higher frame rates do not significantly increase level of participant information assimilation, although they do significantly improve overall user enjoyment and quality perception of the multimedia content being shown.

Mobile sink based fault diagnosis scheme for wireless sensor networks

Network diagnosis in Wireless Sensor Networks (WSNs) is a difficult task due to their improvisational nature, invisibility of internal running status, and particularly since the network structure can frequently change due to link failure. To solve this problem, we propose a Mobile Sink (MS) based distributed fault diagnosis algorithm for WSNs. An MS, or mobile fault detector is usually a mobile robot or vehicle equipped with a wireless transceiver that performs the task of a mobile base station while also diagnosing the hardware and software status of deployed network sensors. Our MS mobile fault detector moves through the network area polling each static sensor node to diagnose the hardware and software status of nearby sensor nodes using only single hop communication. Therefore, the fault detection accuracy and functionality of the network is significantly increased. In order to maintain an excellent Quality of Service (QoS), we employ an optimal fault diagnosis tour planning algorithm. In addition to saving energy and time, the tour planning algorithm excludes faulty sensor nodes from the next diagnosis tour. We demonstrate the effectiveness of the proposed algorithms through simulation and real life experimental results.

Modelling requirements of supplier selection for benchmarking service provision

Supplier selection has a great impact on supply chain management. The quality of supplier selection also affects profitability of organisations which work in the supply chain. As suppliers can provide variety of services and customers demand higher quality of service provision, the organisation is facing challenges for making the right choice of supplier for the right needs. The existing methods for supplier selection, such as data envelopment analysis (DEA) and analytical hierarchy process (AHP) can automatically perform selection of competitive suppliers and further decide winning supplier(s). However, these methods are not capable of determining the right selection criteria which should be derived from the business strategy. An ontology model described in this paper integrates the strengths of DEA and AHP with new mechanisms which ensure the right supplier to be selected by the right criteria for the right customer's needs.